scholarly journals Removal of phenolic compounds from aqueous solution by activated carbon cloths

1999 ◽  
Vol 39 (10-11) ◽  
pp. 201-205 ◽  
Author(s):  
C. Brasquet ◽  
E. Subrenat ◽  
P. Le Cloirec
Keyword(s):  
Aqueous Solution ◽  
Activated Carbon ◽  
Phenolic Compounds ◽  
Breakthrough Curves ◽  
Batch Reactors ◽  
Pressure Drops ◽  
Adsorption Capacities ◽  
Kinetic Coefficients ◽  
Initial Adsorption

Granular activated carbon (GAC) is easily used in water or wastewater treatment in order to remove organic micropollutants. Recently, a new presentation of activated carbon has been developed: fibrous activated carbon in the form of cloth or felt. This work investigates the adsorption onto activated carbon cloths (ACC) of various phenolic compounds from aqueous solution. Experiments were carried out in batch reactors with two ACCs (called CS 1501 and RS 1301) and their performances were compared with those of GAC. Initial adsorption kinetic coefficients were higher with fibers than with granules due to the direct connection of micropores to the external surface of fibers. Adsorption isotherms were also performed and modelized by Langmuir and Freundlich equations. Adsorption capacities were similar or higher with ACCs than with GAC. The behaviour of the ACC CS 1501 was also studied in a dynamic reactor. The breakthrough curves allowed the determination of high maximum adsorption capacities, 117 mg.g−1 for phenol. Pressure drops in ACC beds were measured and the influence of various parameters was shown: the activation step, the number of fabric layers, the space between two layers.

Adsorption of micropollutants onto fibrous activated carbon: association of ultrafiltration and fibers

1996 ◽  
Vol 34 (9) ◽  
pp. 215-222 ◽  
Author(s):  
C. Brasquet ◽  
J. Roussy ◽  
E. Subrenat ◽  
P. Le Cloirec
Keyword(s):  
Aqueous Solution ◽  
Mass Transfer ◽  
Activated Carbon ◽  
Water Treatment ◽  
Batch Reactor ◽  
Breakthrough Curves ◽  
Mass Transfer Resistance ◽  
Transfer Resistance ◽  
Adsorption Capacities ◽  
Original Approach

The adsorption of polluted solutions is performed by different kinds of activated carbon: grains, powder and fibers (cloth or felt). The adsorption is carried out in a batch reactor. Classic models are applied and kinetic constants are calculated. Results showed that the performance of fiber activated carbon (FAC) is significantly higher than that of granular activated carbon (GAC). Moreover, FAC's adsorption capacities of phenol are greater than GAC's. Therefore the application of FAC adsorbers may lead to smaller adsorption reactors. The breakthrough curves obtained with FAC adsorbers are particularly steep, suggesting a smaller mass transfer resistance than GAC. The adsorption zone in the FAC bed is about 3.4 mm and is not dependent on the flow rate within the range 0.67 - 2.07 m.h−1. The selectivity of the FAC between different size of soluble molecules is shown. Then, an Ultrafiltration (UF) membrane is coupled with FAC to remove successively macromolecules (humic substances) and phenols present together in an aqueous solution. This new and original approach to a water treatment compact process successfully put to use. Industrial developments are put forward.

Pollutant Adsorption onto Activated Carbon Membranes

1991 ◽  
Vol 23 (7-9) ◽  
pp. 1659-1666 ◽  
Author(s):  
M. Baudu ◽  
P. Le Cloirec ◽  
G. Martin
Keyword(s):  
Mass Transfer ◽  
Activated Carbon ◽  
Simple Model ◽  
Breakthrough Curves ◽  
Model Parameters ◽  
Batch Reactors ◽  
Carbon Membranes ◽  
Adsorption Capacities ◽  
Fluid Velocities ◽  
Porous Volume

Filtration of polluted aqueous solutions is performed by activated carbon membranes. The adsorption capacities are determined in batch reactors. Classic models are applied and kinetic constants are calculated. A comparison with grains and powders of activated carbon is made. The performances of the membranes in continously fed reactors are also studied. The breakthrough curves are plotted for different concentrations of organic compounds and fluid velocities. A simple model of mass transfer into the porous volume of the membrane is put forward and used to predict the outlet concentrations as a function of time. The model parameters are correlated to the fluid velocities and the inlet concentrations.

scholarly journals Removal of Orange G Dye from Aqueous Solution by Adsorption: A Short Review

2020 ◽  
Vol 9 (1) ◽  
pp. 318-327
Keyword(s):  
Aqueous Solution ◽  
Activated Carbon ◽  
Low Cost ◽  
Short Review ◽  
Industrial Wastes ◽  
Present Review ◽  
Wastewater Remediation ◽  
Experimental Conditions ◽  
Adsorption Capacities ◽  
Orange G

Adsorption is a widely used technique for wastewater remediation. The process is effective and economical for the removal of various pollutants from wastewater, including dyes. Moreover, Besides commercial activated carbon, different low-cost materials such as agricultural and industrial wastes are now used as adsorbents. The present review focused on the removal of a teratogenic and carcinogenic dye, orange G (OG) via adsorption using several adsorbents, together with the experimental conditions and their adsorption capacities. Based on the information compiled, various adsorbents have shown promising potential for OG removal.

scholarly journals Removal of organochlorine pesticides from water using virgin and regenerated granular activated carbon

2010 ◽  
Vol 75 (4) ◽  
pp. 565-573 ◽  
Author(s):  
Mirjana Ninkovic ◽  
Rada Petrovic ◽  
Mila Lausevic
Keyword(s):  
Activated Carbon ◽  
Granular Activated Carbon ◽  
Breakthrough Curves ◽  
Water Production ◽  
Saturation Point ◽  
Chlorinated Pesticides ◽  
Halogenated Aromatic Hydrocarbons ◽  
Adsorption Capacities ◽  
Public Water Systems ◽  
Derivatives Of

Public water systems use granular activated carbon in order to eliminate pesticides. After saturation, the used activated carbon is regenerated and reused in order to reduce the costs of water production and minimize waste. In this study, the adsorption of 10 different chlorinated pesticides from water using columns packed with commercial virgin and regenerated granular activated carbon was simulated in order to compare their adsorption capacities for different chlorinated pesticides. The breakthrough curves showed that chlorinated pesticides from the group of hexachlorocyclohexane (HCH) were poorly adsorbed, followed by cyclodiens as averagely adsorbed and the derivatives of halogenated aromatic hydrocarbons (DDT) as strongly absorbed. However, the adsorption capacity of regenerated granular activated carbon was considerably lower for tested pesticides compared to the virgin granular carbon. In addition, rinsing of the pesticides after the saturation point is a far more efficient process on regenerated carbon.

scholarly journals Parabens Adsorption onto Activated Carbon: Relation with Chemical and Structural Properties

Molecules ◽  
2019 ◽  
Vol 24 (23) ◽  
pp. 4313 ◽  
Author(s):  
Astrid Roxanna Moreno-Marenco ◽  
Liliana Giraldo ◽  
Juan Carlos Moreno-Piraján
Keyword(s):  
Aqueous Solution ◽  
Activated Carbon ◽  
Surface Area ◽  
Endocrine Disruptor ◽  
Emerging Contaminants ◽  
Activated Carbons ◽  
Elaeis Guineensis ◽  
Acid Sites ◽  
Co2 Atmosphere

Parabens (alkyl-p-hidroxybenzoates) are antimicrobial preservatives used in personal care products, classified as an endocrine disruptor, so they are considered emerging contaminants. A raw version of activated carbons obtained from African palm shell (Elaeis guineensis) modified chemically by impregnation with salts of CaCl2 (GC2), MgCl2 (GM2) and Cu(NO3)2 (GCu2) at 2% wt/v and carbonized in CO2 atmosphere at 1173 K was prepared. The process of adsorption of methyl (MePB) and ethylparaben (EtPB) from aqueous solution on the activated carbons at 18 °C was studied and related to the interactions between the adsorbate and the adsorbent, which can be quantified through the determination of immersion enthalpies in aqueous solutions of corresponding paraben, showing the lowest-value carbon GM2, which has a surface area of 608 m2 × g−1, while the highest values correspond to the activated carbon GCu2, with a surface area of 896 m2 × g−1 and the highest content of surface acid sites (0.42 mmol × g−1), such as lactonic and phenolic compounds, which indicates that the adsorbate–adsorbent interactions are favored by the presence of these, with interaction enthalpies that vary between 5.72 and 51.95 J × g−1 for MePB adsorption and 1.24 and 52.38 J × g−1 for EtPB adsorption showing that the process is endothermic.

scholarly journals Synthesis of Activated Carbon Mesoporous from Coffee Waste and Its Application in Adsorption Zinc and Mercury Ions from Aqueous Solution

2012 ◽  
Vol 9 (2) ◽  
pp. 938-948 ◽  
Author(s):  
Liliana Giraldo ◽  
Juan Carlos Moreno-Piraján
Keyword(s):  
Aqueous Solution ◽  
Activated Carbon ◽  
Activated Carbons ◽  
Mercury Ions ◽  
Natural Properties ◽  
Coffee Waste ◽  
Adsorption Capacities ◽  
Coffee Residues ◽  
Large Pore Size ◽  
Nitrogen Conditions

We obtain activated carbons with high portion of meso pores using coffee residues as precursor for the application of adsorption of large adsorbates. Because of its natural properties, the coffee residue exhibited a large pore size. In this work, the coffee residue were impregnated with ZnCl2and KOH, and then carbonized under the nitrogen conditions and activated with CO2respectively. Obtained activated carbons are used in the adsorption of ions Hg(II) and Zn(II). These adsorbents are efficacious to remove these ions from aqueous solution, with monocomponent equilibrium adsorption capacities ranging from from 0.002 to 0.380 mmol∙g-1for Hg on ACK3 and from 0.002 to 0.330 mmol∙g-1for ACZ3. For Zn(II) on ACK2 from 0.002 to 0.300 mmol∙g-1, and from 0.001 to 0.274 mmol∙g-1for ACZ2.

Ultra-high Rhodamine B adsorption capacities from an aqueous solution by activated carbon derived from Phragmites australis doped with organic acid by phosphoric acid activation

RSC Advances ◽  
2016 ◽  
Vol 6 (47) ◽  
pp. 40818-40827 ◽  
Author(s):  
Zizhang Guo ◽  
Jian Zhang ◽  
Hai Liu
Keyword(s):  
Aqueous Solution ◽  
Activated Carbon ◽  
Oxalic Acid ◽  
Phosphoric Acid ◽  
Phragmites Australis ◽  
Rhodamine B ◽  
Activated Carbons ◽  
Acid Activation ◽  
Adsorption Capacities ◽  
Phosphoric Acid Activation

This study shows that oxalic acid (OA) and succinic acid (SA) were employed to modify Phragmites australis (PA)-based activated carbons (ACs) during phosphoric acid activation to improve Rhodamine B (RhB) removal from aqueous solutions.

scholarly journals A Study of the Interactions of Activated Carbon-Phenol in Aqueous Solution Using the Determination of Immersion Enthalpy

2018 ◽  
Vol 8 (6) ◽  
pp. 843 ◽  
Author(s):  
Ana Carvajal-Bernal ◽  
Fernando Gómez-Granados ◽  
Liliana Giraldo ◽  
Juan Moreno-Piraján
Keyword(s):  
Aqueous Solution ◽  
Activated Carbon ◽  
Immersion Enthalpy

Microwave Preparation of Modified Activated Carbons for Phenol Adsorption in Aqueous Solution

2013 ◽  
Vol 726-731 ◽  
pp. 1883-1889
Author(s):  
Brim Stevy Ondon ◽  
Bing Sun ◽  
Zhi Yu Yan ◽  
Xiao Mei Zhu ◽  
Hui Liu
Keyword(s):  
Aqueous Solution ◽  
Activated Carbon ◽  
Adsorption Capacity ◽  
Activated Carbons ◽  
Microwave Energy ◽  
Adsorptive Capacity ◽  
Obvious Effect ◽  
Phenol Adsorption ◽  
Adsorption Capacities ◽  
Modified Activated Carbons

Microwave energy was used to prepare modified activated carbons (GAC, GAC/MW, GAC/Ni, and GAC/Cu). The modified activated carbons were used for phenol adsorption in aqueous solution. The adsorption conditions were optimized. Adsorption capacities of the different modified activated carbons were evaluated. The effect of microwave pretreatment of activated carbons was investigated. A comparative study on the activated carbons adsorption capacities was also investigated. Under optimal conditions the results showed that there was no obvious effect on activated carbons adsorption when rising temperature and pH during the adsorption process. Stirring has a very high effect on the activated carbons adsorption capacity. The adsorption capacity of the modified activated carbons reaches 95%. MW/GAC, GAC/Ni and GAC/Cu adsorptive capacity was higher compared to the Granulated Activated Carbon (GAC) used as received. GAC treated with microwave energy has highest adsorption capacity. The adsorption capacity of GAC loaded with ion Ni2+ is higher than the activated carbon loaded with Cu2+. The untreated GAC has the lowest adsorption capacity. These results can be explained by the effect of microwave irradiation on GAC.The activated carbon loaded with Ni2+ adsorbs more microwave energy than the GAC loaded with Cu2+.

Sign in / Sign up

Export Citation Format

Share Document