scholarly journals О вакансионной природе высокотемпературного фона внутреннего трения в твердых телах

2022 ◽  
Vol 92 (2) ◽  
pp. 242
Author(s):  
С.А. Гриднев ◽  
Ю.Е. Калинин
Keyword(s):  
Activation Energy ◽  
Glass Transition ◽  
High Temperature ◽  
Transition Temperature ◽  
Glass Transition Temperature ◽  
Internal Friction ◽  
Thermodynamic Equilibrium ◽  
Amorphous Structure ◽  
Constant Concentration ◽  
Exponential Increase

High-temperature internal friction in an amorphous CuTi alloy is investigated. Exponential regions with different activation energies are observed on the dependence of internal friction on temperature on both sides of the glass transition temperature. An exponential increase in the background of internal friction with temperature in both sites is associated with the migration of vacancy-like defects in the amorphous structure under the influence of mechanical stresses, while frozen defects of constant concentration migrate to the glass transition temperature. After the transition to a state of thermodynamic equilibrium , the concentration the number of migrating defects increases exponentially. Based on the experimental results of measuring the high-temperature background, estimates of the activation energy of migration and the formation of vacancies of similar defects in the amorphous structure of the alloy under study are made.

High-temperature carbon plastics based on thermoreactive polyimide binder

2020 ◽  
pp. 89-102
Author(s):  
M. I. Valueva ◽  
I. V. Zelenina ◽  
M. A. Zharinov ◽  
M. A. Khaskov
Keyword(s):  
Glass Transition ◽  
High Temperature ◽  
Transition Temperature ◽  
Glass Transition Temperature ◽  
Strength Properties ◽  
High Glass Transition Temperature ◽  
Reinforced Plastics ◽  
Carbon Plastics ◽  
Fundamental Possibility ◽  
Fiber Reinforced Plastics

The article presents results of studies of experimental carbon plastics based on thermosetting PMRpolyimide binder. Сarbon fiber reinforced plastics (CFRPs) are made from prepregs prepared by melt and mortar technologies, so the rheological properties of the polyimide binder were investigated. The heat resistance of carbon plastics was researched and its elastic-strength characteristics were determined at temperatures up to 320°С. The fundamental possibility of manufacturing carbon fiber from prepregs based on polyimide binder, obtained both by melt and mortar technologies, is shown. CFRPs made from two types of prepregs have a high glass transition temperature: 364°C (melt) and 367°C (solution), with this temperature remaining at the 97% level after boiling, and also at approximately the same (86–97%) level of conservation of elastic strength properties at temperature 300°С.

Viscoelastic Behavior of Segmented Elastomers

1967 ◽  
Vol 40 (4) ◽  
pp. 1105-1110 ◽  
Author(s):  
Stuart L. Cooper ◽  
Arthur V. Tobolsky
Keyword(s):  
Hydrogen Bonding ◽  
Glass Transition ◽  
High Temperature ◽  
Transition Temperature ◽  
Glass Transition Temperature ◽  
Viscoelastic Behavior ◽  
Temperature Transition ◽  
Hydrogen Bonding Interactions ◽  
Structural Nature ◽  
Hard Segments

Abstract Viscoelastic behavior of linear segmented elastomers was examined. The unusual properties found in spandex systems are also observable in hydrocarbon block co-polymers, indicating that hydrogen bonding interactions are perhaps not essential. Low temperature properties of segmented systems are governed by the structural nature of the associated flexible segments, which determines the value of the major glass transition temperature (Tg). It appears that an association of the hard segments provides a broad temperature range of enhanced rubbery modulus. This occurs between the major Tg and a secondary high temperature transition.

Experimental Research on Mechanical Behavior of GFRP Bars under High Temperature

2011 ◽  
Vol 71-78 ◽  
pp. 3591-3594 ◽  
Author(s):  
Xiao Lu Wang ◽  
Xiao Xiong Zha
Keyword(s):  
Glass Transition ◽  
High Temperature ◽  
Transition Temperature ◽  
Glass Transition Temperature ◽  
Epoxy Resin ◽  
High Temperatures ◽  
Glass Fibers ◽  
Ultimate Tensile Stress ◽  
Gfrp Bars ◽  
Tensile Test Result

Experimental results on tensile mechanics properties of GFRP bars at high temperatures are present in this paper. Thirty commercially produced GFRP tensile specimens of 8mm diameter were tested at high temperature ranging from 10°Cup to 500°C. Tensile test result indicates that, the ultimate tensile stress has significant reduction at two temperature zones, one is glass transition temperature of epoxy resin (80-120°C), with strength degradation 22%, the second is the soften temperature of glass fibers(about 400°C), the strength decrease drastically with almost linear rate and remained 33% residual strength at 500°C. The elastic modulus remained unchanged until glass transition temperature of epoxy resin, and the modulus declined linearly with the temperature elevating. Stress-strain relationships of GFRP bars exhibit liner performance even at high temperatures.

Study on the Crystallization Activation Energy of Poly (L-lactic acid) Nucleated with P-tert-butylcalix[8]arene

2018 ◽  
Vol 26 (2) ◽  
pp. 169-175
Author(s):  
Yaoqi Shi ◽  
Liang Wen ◽  
Zhong Xin
Keyword(s):  
Activation Energy ◽  
Lactic Acid ◽  
Glass Transition ◽  
Transition Temperature ◽  
Glass Transition Temperature ◽  
Crystallization Temperature ◽  
Nucleating Agent ◽  
Crystallization Activation Energy ◽  
Temperature Range ◽  
Chain Mobility

The crystallization activation energy (Δ E) of a polymer comprises the nucleation activation energy Δ F and the transport activation energy Δ E*. In this paper, the Δ E of poly (L-lactic acid) (PLLA) nucleated with nucleating agent p- tert-butylcalix[8]arene (tBC8) was calculated. The results showed that the Δ E of nucleated PLLA was 165.97 kJ/mol, which is higher than that of pure PLLA. The reason why Δ E of PLLA increased when incorporating nucleating agent was studied. The increment of glass transition temperature ( Tg) for nucleated PLLA revealed that the polymer chain mobility was restricted by tBC8, which was considered as the reason for the increase of Δ E*. Further, polyethylene glycol (PEG) was added to improve the chain mobility, thus eliminated the variation of the transport activation energy Δ E* caused by tBC8. Then the effect of the increment of crystallization temperature range on the increase of Δ F was also taken into consideration. It was concluded that both decreasing the mobility of chain segments and increasing the crystallization temperature range caused an increase of Δ E for PLLA/tBC8.

scholarly journals The Glass Transition Temperature and Temperature Dependence of Activation Energy of Viscous Flow of Ovalbumin

2016 ◽  
Vol 39 (1) ◽  
pp. 13-25
Author(s):  
Karol Monkos
Keyword(s):  
Activation Energy ◽  
Glass Transition ◽  
Transition Temperature ◽  
Glass Transition Temperature ◽  
Viscous Flow ◽  
Solvent Interactions ◽  
Model Free ◽  
Free Volume Model ◽  
Wide Range ◽  
Different Temperatures

Abstract The paper presents the results of viscosity determinations on aqueous solutions of ovalbumin at a wide range of concentrations and at temperatures ranging from 5°C to 55°C. On the basis of these measurements and three models of viscosity for glass-forming liquids: Avramov’s model, free-volume model and power-law model, the activation energy of viscous flow for solutions and ovalbumin molecules, at different temperatures, was calculated. The obtained results show that activation energy monotonically decreases with increasing temperature both for solutions and ovalbumin molecules. The influence of the energy of translational heat motion, protein-protein and protein-solvent interactions, flexibility and hydrodynamic radius of ovalbumin on the rate of decrease in activation energy with temperature has been discussed. One of the parameters in the Avramov’s equation is the glass transition temperature Tg. It turns out that the Tg of ovalbumin solutions increases with increasing concentration. To obtain the glass transition temperature of the dry ovalbumin, a modified Gordon-Taylor equation is used. Thus determined the glass transition temperature for dry ovalbumin is equal to (231.8 ± 6.1) K.

The Influence of Gamma Radiation on the Glass Transition of Hydroxyapatite/Poly L-Lactide Composite

2007 ◽  
Vol 555 ◽  
pp. 497-502
Author(s):  
Dejan Miličević ◽  
S. Trifunović ◽  
N. Ignjatović ◽  
E. Suljovrujić
Keyword(s):  
Activation Energy ◽  
Glass Transition ◽  
Transition Temperature ◽  
Glass Transition Temperature ◽  
Structural Relaxation ◽  
Absorbed Dose ◽  
Gel Permeation Chromatography ◽  
Chain Scission ◽  
Scanning Calorimetry ◽  
Dsc Measurements

Hydroxyapatite/poly L-lactide (HAp/PLLA) is a composite biomaterial which has been widely utilized for substitution and reparation of the hard bone tissue. It is well known that gamma irradiation has been successfully employed in the modification/sterilization of such porous composites and that it has advantages over other procedures. In this study, differential scanning calorimetry (DSC) measurements were made to investigate the influence of the radiation on glass transition behavior and structural relaxation, as well as to estimate the activation energy for this process. The apparent activation energy ΔH* for structural relaxation in the glass transition region was determined on the basis of the heating rate dependence of the glass transition temperature Tg. Furthermore, the results were correlated with those obtained by gel permeation chromatography (GPC). Our findings support the fact that the radiation-induced chain scission in the PLLA phase is the main reason for the decrease of the glass transition temperature and/or activation energy with the absorbed dose.

On the Possibility to Observe a Compensation Effect around the Glass Transition Temperature

2006 ◽  
Vol 514-516 ◽  
pp. 1462-1466
Author(s):  
Rodica M. Neagu ◽  
José N. Marat-Mendes ◽  
Eugen R. Neagu
Keyword(s):  
Activation Energy ◽  
Glass Transition ◽  
Transition Temperature ◽  
Glass Transition Temperature ◽  
Compensation Effect ◽  
Depolarization Current ◽  
Exponential Factor ◽  
Relaxation Parameters ◽  
Maximum Current ◽  
Thermally Stimulated Depolarization

Compensation has been reported for the relaxation parameters: the activation energy W and the pre-exponential factor τ0, determined from the Thermal Sampling of Thermally Stimulated Depolarization Current technique. Below the glass transition it is assumed that the relaxation time follows an Arrhenius equation. In the vicinity of glass transition temperature an experimental thermogram may be analyzed using the Vogel-Fulcher-Tamman-Hesse (VFTH) or the Williams- Landel -Ferry equation. In this article we use the VFTH relationship to study the compensation effect in the range of glass transition. For an elementary peak obtained by TS there is a relationship between the activation energy W, the temperature of the maximum current Tm, the VFTH temperature, the compensation temperature Tc and the compensation time τ c. We employ this relationship for a basic analysis of the compensation effect in the temperature range around Tg. By numerical simulations, and assuming parameters similar to those measured experimentally, we show that it is possible to observe a compensation point in some well defined conditions

Sign in / Sign up

Export Citation Format

Share Document