The Effects of Preparation Conditions And Chemical Composition On CMAS Glass Ceramics With One Step Process

Based on the composition of Cr-doped solid waste, other oxides were added to adjust the composition to prepare glass-ceramics with on step composition, and the effect of heat treatment system (including temperature and holding time), chromium content, MnO and Fe2O3 doped on the crystallization and physical properties of glass-ceramics was studied. The samples were characterized by X-ray diffraction, differential thermal analysis and scanning electron microscopy. The results show that the best treatment conditions are 1090 ℃ for 4h, and the amount of dissolved chromium reaches 5%. The main crystallization phase is diopside and anorthite. The hardness and chemical stability of the material were measured. The doping of MnO and Fe2O3 increases the crystallization activation energy of glass ceramics, and makes the crystal phase more uniform as the SEM results. This experiment provides a theoretical basis for the preparation of CMAS glass ceramics from chromium containing solid waste.

Study on a New Process and its Kinetics of Iron Recovery and Glass-ceramics Preparation from Desulfurization Slag

The melting point and phase of slag was calculated with Factsage thermodynamics software, and base on this, taking desulfurization slag as the main raw material, which is leached by ammonium chloride as pretreatment. The composition of target slag system was adjusted with high aluminum powder coal ash and glass cullet, and then the reducing slag and metallic iron were separated by high temperature carbon thermal reaction. The prepared glass-ceramics with main crystal phases of diopside and nepheline were obtained by heat treatment, which shows that the new process is feasible. The crystallization activation energy was calculated by using Kissinger, Ozawa and Augis-Bennett method base on the differential heat curve. The results show that the crystallization activation energy is relatively high, and the crystal growth index n are all less than 3, which means that the crystallization capacity of the glass-ceramics is low. At the heating rate of 5 K/min, the n value of sample No. 3 is the largest, which is 2.7, and the mode of volumetric crystallization changes from two-dimensional to one-dimensional with the increase of heating rate, therefore, nucleating agent is needed in the preparation of glass-ceramics.

Characterization of Glass Insulating Thick Films with Ag Conductors for Multilayer Packages

In this paper, an insulating film was successfully prepared by sintering 35 wt % CaO-15 wt % Al2O3-10 wt % B2O3-40 wt % SiO2 glass at 875 °C. After sintering, the main component of the insulating film was glass-ceramics. The main crystal phase was CaAl2Si2O8, and the crystallization activation energy was 189.76 kJ/mol. After preparing the insulating film, its color turned yellow, and the diffusion of Ag was found by XPS and XRD data. When the temperature increased to 875 °C, the color of the insulating film became lighter, and the silver content decreased. The adhesion of the multilayer structure could reach 875 N. The dielectric constant of the insulating film in the multilayer structure was approximately 5, and the dielectric loss was 0.0011. After sintering, the dielectric strength of the insulating film could reach 13.11 kV/mm, which fully meets the requirements of a complex packaging structure.

Isothermal and Non-Isothermal Crystallization Kinetics of PVDF and PVDF/PMMA Blends

Background: poly(vinylidene fluoride) PVDF and PVDF/PMMA blends have been investigated with a focus on the crystal structure, immiscibility and mechanical properties. However, few reports were found on the crystallization behaviors of PVDF and PVDF/PMMA blends, especially on crystallization kinetics. The article is to report the research on isothermal and nonisothermal crystallization kinetics for PVDF and PVDF/PMMA blends using differential scanning calorimetry (DSC). Results: Besides crystallization temperature and isothermal crystallization activation energy, the Avrami equation exponent of PVDF in blends decreased compared with pure PVDF. The nonisothermal crystallization kinetics of PVDF and PVDF/PMMA (70:30) blends were investigated by Ozawa equation, Jeziorny method and crystallization rate constant (CRC) in detail. The nonisothermal crystallization energy of pure PVDF and its blends were determined by the Kissinger and Vyazovkin’s method. Conclusion: The nucleation and growth mechanism of PVDF in blends changed compared with pure PVDF. The Ozawa equation is not applicable in nonisothermal crystallization kinetics of PVDF and PVDF/PMMA blends. The decreasing of crystallization ability of PVDF in blends were found and confirmed by CRC and the decline of crystallization rate constant in Jeziorny method. Such is opposite to the results of Kissinger’s and Vyazovkin’s method, chances are that these two methods were not used to calculate the nonisothermal crystallization activation energy where the nucleation process was influenced.

Effect of Silver Nanoparticles on the Microstructure, Non-Isothermal Crystallization Behavior and Antibacterial Activity of Polyoxymethylene

Silver (Ag) nanoparticles were synthesized by a facile route in the presence of oleic acid and n-propylamine. It was shown that the average primary size of the as-synthesized Ag nanoparticles was approximately 10 nm and the surface of as-synthesized Ag nanoparticles was capped with monolayer surfactants with the content of 19.6%. Based on as-synthesized Ag nanoparticles, polyoxymethylene (POM)/Ag nanocomposites were prepared. The influence of Ag nanoparticles on non-isothermal crystallization behavior of POM was investigated by differential scanning calorimetry (DSC). The Jeziorny, Jeziorny-modified Avrami, Ozawa, Liu and Mo, Ziabicki and Kissinger models were applied to analyze the non-isothermal melt crystallization data of POM/Ag nanocomposites. Results of half time (t1/2), crystallization rate parameter (CRP), crystallization rate function (K(T)), kinetic parameter (F(T)), the kinetic crystallizability at unit cooling rate (GZ) and the crystallization activation energy (∆E) were determined. Small amounts of Ag nanoparticles dispersed into POM matrix were shown to act as heterogeneous nuclei, which could enhance the crystallization rate of POM, increase the number of POM spherulites and reduce POM spherulites size. However, the higher loading of Ag nanoparticles were easily aggregated, which restrained POM crystallization to some degree. Furthermore, the POM/Ag nanocomposites showed robust antibacterial activity against Escherichia coli and Staphylococcus aureus.

Influence of Crystallization Behavior of Gas Quenching Blast Furnace Slag on the Preparation of Amorphous Slag Beads

Slag beads with different crystal content could be obtained through the gas quenching blast furnace slag (BFS) process. In order to increase the additional value of the slag beads as much as possible, it was necessary to restrain the crystallization of the slag beads as much as possible. In this paper, the mineral types and crystallization temperatures of BFS with different basicities and cooling rates were studied by using Factsage thermodynamic software, XRD, and differential scanning calorimeter (DSC) experiments, which obtained the gas quenching temperature and the cooling rate needed to restrain crystallization behavior in the gas quenching process; The crystallization mechanism was studied by calculating crystallization activation energy (Ec) using the DSC experiment, at the same time, the thermodynamic results were verified. The proper basicity and cooling rate of BFS were found to be conducive to the preparation of amorphous slag beads. The results showed that the initial crystallization temperature decreased with decreasing the basicity and increasing the cooling rate, which could increase the amorphous content of slag beads in the gas quenching process. The crystallization activation energy (Ec) increased with decreasing basicity, which increased the crystallization barrier.

Study on the Crystallization Activation Energy of Poly (L-lactic acid) Nucleated with P-tert-butylcalix[8]arene

The crystallization activation energy (Δ E) of a polymer comprises the nucleation activation energy Δ F and the transport activation energy Δ E*. In this paper, the Δ E of poly (L-lactic acid) (PLLA) nucleated with nucleating agent p- tert-butylcalix[8]arene (tBC8) was calculated. The results showed that the Δ E of nucleated PLLA was 165.97 kJ/mol, which is higher than that of pure PLLA. The reason why Δ E of PLLA increased when incorporating nucleating agent was studied. The increment of glass transition temperature ( Tg) for nucleated PLLA revealed that the polymer chain mobility was restricted by tBC8, which was considered as the reason for the increase of Δ E*. Further, polyethylene glycol (PEG) was added to improve the chain mobility, thus eliminated the variation of the transport activation energy Δ E* caused by tBC8. Then the effect of the increment of crystallization temperature range on the increase of Δ F was also taken into consideration. It was concluded that both decreasing the mobility of chain segments and increasing the crystallization temperature range caused an increase of Δ E for PLLA/tBC8.

Structural effects on glass stability and crystallization

We report the correlation between glass stability, crystallization activation energy and the glass structure to one pure devitrite glass (Na2Ca3Si6O16), and two other glasses in which 4 mol% and 8 mol% of devitrite glass were replaced with TiO2 (Dev, 4Ti and 8Ti, respectively).

Isothermal and non-isothermal crystallization kinetics and predictive modeling in the solidification of poly(cyclohexylene dimethylene cyclohexanedicarboxylate) melt

Isothermal and non-isothermal crystallization kinetics of polycyclohexylene dimethylene cyclohexanedicarboxylate (PCCE) were investigated via differential scanning calorimetry (DSC). Isothermal melt crystallization kinetics were analyzed using the traditional Avrami equation. Non-isothermal melt crystallization kinetics data obtained from DSC were analyzed using the extended Avrami relation and a combination of the Avrami equation and the Ozawa relationship. The glass transition temperature, equilibrium melting point, isothermal crystallization activation energy, and non-isothermal crystallization activation energy were determined. Furthermore, a predictive method based on the Nakamura model was proposed and was used to describe the non-isothermal crystallization kinetics based on the isothermal experimental data. The results suggested that the original Nakamura equation was not successful in describing the non-isothermal crystallization of PCCE over a wide range of cooling rates. It was found that the non-isothermal crystallization kinetics of PCCE, over a wide range of cooling rates, could best be described by modifying the differential Nakamura equation to include a varied Avrami index.