scholarly journals A Review on Monitoring Solar System Parameters Using IoT

2022 ◽  
Vol 10 (1) ◽  
pp. 472-473
Author(s):  
Umang Deogade
Keyword(s):  
Energy Source ◽  
Renewable Energy Source ◽  
Renewable Energy ◽  
Solar Energy ◽  
Light Intensity ◽  
Monitoring System ◽  
Voltage Divider ◽  
Solar Panel ◽  
Solar Panels ◽  
Arduino Uno

Abstract: The most significant system for monitoring solar systems is the solar parameters monitoring system. Solar energy is a renewable energy source produced by solar panels. Solar energy is a renewable energy source produced by solar panels. Voltage, light intensity, and temperature are the parameters that the system measures. An Arduino Uno microcontroller board is used in the suggested monitoring system. Solar panel, LDR Sensor, LM 35, Arduino microcontroller, and resistors are used in the system. Light. LDR sensor is used to detect light intensity, L35 is used to measure temperature, and a voltage divider circuit is used to monitor voltage in this system. Keywords: Solar Panel, Monitoring, Renewable Energy, Solar Panel, Arduino Uno.

scholarly journals Potential Usage of Solar Energy as a Renewable Energy Source in Petukangan Utara, South Jakarta

2021 ◽  
Vol 17 (4) ◽  
Author(s):  
Eka Purwa Laksana ◽  
Yani Prabowo ◽  
Sujono Sujono ◽  
Rummi Sirait ◽  
Nifty Fath ◽  
...  
Keyword(s):  
Energy Source ◽  
Renewable Energy Source ◽  
Renewable Energy ◽  
Solar Energy ◽  
Cooling System ◽  
Solar Panel ◽  
Average Intensity ◽  
Solar Panels ◽  
Energy Potential ◽  
Tropical Country

Indonesia is a tropical country located on the equator. The average intensity of solar radiation in Indonesia is 4.8 kWh/m2. This makes Indonesia a country with new and ren ewable energy potential, one of which is solar panel technology. The first step that must be done in the process of installing solar panels in a place is to analyze the potential of solar energy. In this study, an analysis of the potential of solar energy as a new renewable energy source has been carried out at Budi Luhur University, North Petukangan, South Jakarta. Based on the research results, the maximum photovoltaic efficiency that can be achieved is 21.45%. During the day, the efficiency of the solar panels increases along with the ncrease in the value of the voltage obtained. However, the higher the panel temperature, the lower the efficiency of the solar panel. Therefore, a cooling system is needed to anticipate this.

DEVICE FOR CONVERTING SOLAR ENERGY INTO ELECTRICAL ENERGY, AS WELL AS FOR ACCUMULATING AND STORING ENERGY BY MEANS OF MOLTEN SALT (PROJECT)

2020 ◽  
Vol 6 (3) ◽  
pp. 53-57
Author(s):  
A. T. Abdukadirov ◽  
◽  
A. A. Shodiev
Keyword(s):  
Energy Source ◽  
Renewable Energy Source ◽  
Renewable Energy ◽  
Solar Energy ◽  
Molten Salt ◽  
Electrical Energy ◽  
Special Significance

This article describes the project of a device proposed by the authors for converting solar energy into electrical energy, as well as for accumulating and storing energy through molten salt. It describes the main details and principle of operation of this device and its special significance in the field of energy as a renewable energy source, which has the highest efficiency

The Field Test of Solar House of Building with Altitude of 5000m in Tibet

2013 ◽  
Vol 655-657 ◽  
pp. 1874-1878
Author(s):  
Wei Liu ◽  
Dan Liu ◽  
Bai Yi Li ◽  
Min Zheng
Keyword(s):  
Energy Source ◽  
Renewable Energy Source ◽  
Renewable Energy ◽  
Solar Energy ◽  
Field Test ◽  
Field Measurement ◽  
Living Standard ◽  
Cold Zone ◽  
Extreme Cold ◽  
Solar House

Solar energy is a renewable energy source nearly in exhaustible and pollution-free. Tibet provides little normal resource, however it is abundant with the richest solar energy in our country. Many researchers spent a lot of time to improve the living standard of peoples who lived there by utilizing solar energy, which contribute a lot to the development of Tibet, however, few researches related on the solar house in buildings located above 5000m. The field measurement of a solar house built above 5000m was carried and its effect was presented and analyzed in this paper, which could contribute the study of solar house in the condition of extreme cold zone and low pressure environment.

scholarly journals Isolated photovoltaic system for house: pre-sizing

2021 ◽  
Vol 7 (1) ◽  
pp. 25-32
Author(s):  
Jessica Katherine Moreira Veliz ◽  
Juan Francisco Velepucha Gualán ◽  
Felipe Alejandro León Mateo ◽  
Andy Ariel Guerrero Veléz ◽  
María Rodríguez Gámez
Keyword(s):  
Energy Source ◽  
Renewable Energy Source ◽  
Renewable Energy ◽  
Solar Energy ◽  
Photovoltaic Cells ◽  
Poor Quality ◽  
Photovoltaic System ◽  
Energy Service ◽  
Photovoltaic Solar Energy

Photovoltaic solar energy is a clean renewable energy source that allows obtaining electricity directly from solar radiation through semiconductor devices called photovoltaic cells. The present research aims to pre-design an isolated system for a house that can serve as a pattern for the electrification of houses that today do not have power in the province of Manabí. To carry out the proposal, the PVsyst was used, a tool for sizing the system, in addition to the bibliographic review, the qualitative-quantitative, and the inductive deductive. It was obtained as a result that photovoltaic solar energy is adequate to provide a solution to isolated homes that today do not have energy service, in addition to those that have a poor quality of service.

scholarly journals Solar Panel Measurement System using Arduino with Bluetooth

2021 ◽  
Vol 3 (1) ◽  
pp. 72
Author(s):  
Al Qindi M. Yusuf ◽  
Evanco Hollis N.P. Simangunsong ◽  
Indah Tria Wilyani ◽  
Iksan Bukhori
Keyword(s):  
Solar Energy ◽  
Light Intensity ◽  
Measurement System ◽  
Voltage Divider ◽  
Solar Panel ◽  
Digital Output ◽  
Analog Input ◽  
Two Parameters

This project aims to develop a measurement of solar energy using Arduino. In this research, two parameters that been measured are light intensity and the voltage. The light intensity was measured using light dependent resistor (LDR) sensor. The voltage was measured using the voltage divider because the voltage generated by the solar panel are large for the Arduino as receiver. These parameters as the input value for the Arduino and the output was display at the Arduino Bluetooth Controller. The Arduino Bluetooth controller display output of the light intensity and the voltage value. The purpose of using Arduino is to convert the analog input of parameter to the digital output and display via Bluetooth .

Research on the Application of Photo-Thermal Solar Energy Technology in Wooden Structure

2013 ◽  
Vol 409-410 ◽  
pp. 664-667
Author(s):  
Zhi Hui Bian ◽  
Tie Cheng Wang ◽  
Shi Yong Zhao ◽  
Su Juan Fu
Keyword(s):  
Energy Source ◽  
Renewable Energy Source ◽  
Renewable Energy ◽  
Solar Energy ◽  
Social Benefit ◽  
Energy Technology ◽  
Wooden Structure

The paper has an introduction of photo-thermal of solar energy technology in this project. At the same time, it analysis the necessity of carrying forward technique and the integration of wooden structure construction and as well as social benefit produced by renewable energy source technology.

scholarly journals Role and Factors of Solar Façades Shaping in Contemporary Architecture

2021 ◽  
Vol 20 (3) ◽  
pp. 043-056
Author(s):  
Janusz Marchwiński
Keyword(s):  
Energy Source ◽  
Renewable Energy Source ◽  
Renewable Energy ◽  
Solar Energy ◽  
Comparative Methods ◽  
Energy Aspect ◽  
Different Characteristics ◽  
Contemporary Architecture ◽  
The Relationship

The article deals with the issue of solar facades as the main external walls of a building, adapted to make use of solar energy. The aim of the article is to define the role of the facades and the factors that influence shaping thereof. The goal is of cognitive nature, whereas its implementation may contribute to strengthening the relationship between presumptions related to energy and architecture in the design of buildings. The need for the article results from the necessity to search for a possible balance between technical and humanistic spheres while shaping contemporary pro-ecological architecture, especially one aimed at receiving solar energy as a renewable energy source. In the article, both analytical and comparative methods are applied. The research was conducted on the example of four designs with solar facades of different characteristics, including two buildings planned by the author. The research results are observations that define relationship between the energy-related role of solar facades and urban, functional and aesthetic issues. These observations lead to the conclusion that the energy aspect, is not the only one to be considered while shaping solar facades in contemporary architecture. The solar facade combines both functional and artistic features.

scholarly journals ENERGIA RENOVÁVEL; UTILIZAÇÃO DE ENERGIA SOLAR PARA ACIONAMENTO DE TELHADO MÓVEL.

2021 ◽  
Vol 9 (209) ◽  
pp. 1-24
Author(s):  
Patricia Vianna dos Santos
Keyword(s):  
Energy Source ◽  
Solar Energy ◽  
Sustainable Energy ◽  
Electric Energy ◽  
Solar Panel ◽  
Solar Panels ◽  
The World ◽  
Frequency Inverter ◽  
Renewable And Sustainable Energy

The present work aims to exemplify a renewable and sustainable energy source as such the energy from sunlight to drive mobile coverage as a clean source of energy that does not cause damage to the environment, taking advantage of solar energy as a source of heat and light being one of the most propitious and reliable energies in the world. With the installation of solar panels at the roof top of houses, industries and plantations, the energy captured by the photovoltaic solar panel is sent to the load controller that powers the battery and the frequency inverter energizes the motor , allowing the activation of the cover with the objective of bringing greater comfort and satisfaction of our final client, people who want to have comfort in relation to their roofs, taking advantage of more than nature has to offer us, not only in homes but also in areas of leisure and entertainment, sheds, plantations and many other places that needs a roof, with the purpose of taking advantage of the sunlight, also saving the electric energy by making people aware of a more sustainable and renewable country. It is worth mentioning that in case of rain-sensitive plantations with the mobile cover, it will not be necessary to move to totally enclosed sheds, but in sheds using a structure such as that of the moving roof

Sign in / Sign up

Export Citation Format

Share Document