scholarly journals Prediction of Shallow Indentation Effects in a Rolling-Sliding EHL Contact Based on Amplitude Attenuation Theory

2017 ◽  
Vol 12 (1) ◽  
pp. 1-7 ◽  
Author(s):  
Petr Šperka ◽  
Ivan Křupka ◽  
Martin Hartl
Author(s):  
Petr Sperka ◽  
Ivan Krupka ◽  
Martin Hartl

The trend of decreasing of lubricant film thickness in tribological systems is one of the important features of current tribology stirred up by the quest for higher efficiency and energy saving. As a result, the influence of the surface micro geometry on the contact performance and machine component life increases steadily. This has led to a systematic effort to develop a theory that describes unifying mechanism governing the amplitude reduction of harmonic patterns in EHL contact known as amplitude attenuation principle [1–2]. This theory provides formulas that can serve as a simple tool to predict the deformed geometry inside the contact for arbitrary micro geometry when used in combination with a Fourier analysis. Therefore, it is possible to give a reasonable explanation of the basic phenomena involved in real rough surface EHL and mixed lubricated contacts.


2019 ◽  
Vol 210 ◽  
pp. 228-238 ◽  
Author(s):  
Kelsey Graber ◽  
Michelle Bosquet Enlow ◽  
Frank H. Duffy ◽  
Eugene D'Angelo ◽  
Georgios Sideridis ◽  
...  

2002 ◽  
Vol 45 (1) ◽  
pp. 21-30 ◽  
Author(s):  
M. A. Masen ◽  
C. H. Venner ◽  
P. M. Lugt ◽  
J. H. Tripp
Keyword(s):  
Lift Off ◽  

Author(s):  
Shawn Goodman ◽  
Sriram Boothalingam ◽  
Jeffery T Lichtenhan

Functional outcomes of medial olivocochlear reflex (MOCR) activation, such as improved hearing in background noise and protection from noise damage, involve moderate to high sound levels. Previous noninvasive measurements of MOCR in humans focused primarily on otoacoustic emissions (OAEs) evoked at low sound levels. Interpreting MOCR effects on OAEs at higher levels is complicated by the possibility of the middle-ear muscle reflex and by components of OAEs arising from different locations along the length of the cochlear spiral. We overcame these issues by presenting click stimuli at a very slow rate and by time-frequency windowing the resulting click-evoked (CE)OAEs into short-latency (SL) and long-latency (LL) components. We characterized the effects of MOCR on CEOAE components using multiple measures to more comprehensively assess these effects throughout much of the dynamic range of hearing. These measures included CEOAE amplitude attenuation, equivalent input attenuation, phase, and slope of growth functions. Results show that MOCR effects are smaller on SL components than LL components, consistent with SL components being generated slightly basal of the characteristic frequency region. Amplitude attenuation measures showed the largest effects at the lowest stimulus levels, but slope change and equivalent input attenuation measures did not decrease at higher stimulus levels. These latter measures are less commonly reported and may provide insight into the variability in listening performance and noise susceptibility seen across individuals.


Lubricants ◽  
2018 ◽  
Vol 6 (3) ◽  
pp. 80 ◽  
Author(s):  
Petr Sperka ◽  
Ivan Krupka ◽  
Martin Hartl

Prediction of minimum film thickness is often used in practice for calculation of film parameter to design machine operation in full film regime. It was reported several times that majority of prediction formulas cannot match experimental data in terms of minimum film thickness. These standard prediction formulas give almost constant ratio between central and minimum film thickness while numerical calculations show ratio which spans from 1 to more than 3 depending on M and L parameters. In this paper, an analytical formula of this ratio is presented for lubricants with various pressure–viscosity coefficients. The analytical formula is compared with optical interferometry measurements and differences are discussed. It allows better prediction, compared to standard formulas, of minimum film thickness for wide range of M and L parameters.


1976 ◽  
Vol 1 (15) ◽  
pp. 22 ◽  
Author(s):  
J.D.A. Van Hoften ◽  
S. Karaki

An experimental investigation was made to study wave-current interaction. Wave amplitude attenuation was measured along a laboratory wave channel to compare wave dissipation with and without flow. Mean, wave, and turbulent velocities were also measured to determine the modifications of the flow imposed by the gravity waves propogating with the current. The process of energy transfer in the wave current system was studied. Energy was found to be extracted from the waves, diffused downward and dissipated by an increase in bottom shear stress.


Sign in / Sign up

Export Citation Format

Share Document