scholarly journals Magnetic properties of cobalt microwires measured by piezoresistive cantilever magnetometry

2014 ◽  
Vol 1 (1) ◽  
Author(s):  
G. Tosolini ◽  
J. M. Michalik ◽  
R. Córdoba ◽  
J. M. de Teresa ◽  
F. Pérez-Murano ◽  
...  

AbstractWe present the magnetic characterization of cobalt wires grown by focused electron beam-induced deposition (FEBID) and studied using static piezoresistive cantilever magnetometry. We have used previously developed high force sensitive submicron-thick silicon piezoresistive cantilevers. High quality polycrystalline cobalt microwires have been grown by FEBID onto the free end of the cantilevers using dual beam equipment. In the presence of an external magnetic field, the magnetic cobalt wires become magnetized, which leads to the magnetic field dependent static deflection of the cantilevers. We show that the piezoresistive signal from the cantilevers, corresponding to a maximum force of about 1 nN, can be measured as a function of the applied magnetic field with a good signal to noise ratio at room temperature. The results highlight the flexibility of the FEBID technique for the growth of magnetic structures on specific substrates, in this case piezoresistive cantilevers.

Author(s):  
Yu.V. Maslennikov ◽  
◽  
◽  

There are a large number of sensors for measuring the magnetic field of biological objects. They are characterized by the type of the measured physical parameter (magnetic field strength, magnetic flux, etc.), the level of intrinsic sensitivity, and the frequency range of the recorded signals. The long-term practice of studying biomagnetic signals shows that only SQUID-based magnetometers and optically pumped magnetometers have sensitivity levels sufficient for recording biomagnetic signals with the required signal-to-noise ratio. This chapter reflects the main directions of using such magnetometers and methods of magnetic measurements in biomedical research, gives examples of existing technical solutions, and shows possible ways of their further development.


1978 ◽  
Vol 33 (7) ◽  
pp. 749-760 ◽  
Author(s):  
G. E. J. Eggermont ◽  
P. W. Hermans ◽  
L. J. F. Hermans ◽  
H. F. P. Knaap ◽  
J. J. M. Beenakker

In a rarefied polyatomic gas streaming through a rectangular channel, an external magnetic field produces a heat flux perpendicular to the flow direction. Experiments on this “viscom agnetic heat flux” have been performed for CO, N2, CH4 and HD at room temperature, with different orientations of the magnetic field. Such measurements enable one to separate the boundary layer contribution from the purely bulk contribution by means of the theory recently developed by Vestner. Very good agreement is found between the experimentally determined bulk contribution and the theoretical Burnett value for CO, N2 and CH4 , yet the behavior of HD is found to be anomalous.


2018 ◽  
Vol 2 (4) ◽  
pp. 68 ◽  
Author(s):  
Emil Chibowski ◽  
Aleksandra Szcześ ◽  
Lucyna Hołysz

Using neodymium ring magnets (0.5–0.65 T), the experiments on the magnetic field (MF) effects on water evaporation rate and surface tension were performed at room temperature (22–24 °C). In accordance with the literature data, the enhanced evaporation rates were observed in the experiments conducted in a period of several days or weeks. However, the evaporated amounts of water (up to 440 mg over 150 min) in particular experiments differed. The evaporated amounts depended partially on which pole of the ring magnet was directed up. The relatively strong MF (0.65 T) caused a slight decrease in surface tension (−2.11 mN/m) which lasted longer than 60 min and the memory effect vanished slowly. The surface tension data reduced by the MF action are reported in the literature, although contrary results can be also found. The observed effects can be explained based on literature data of molecular simulations and the suggestion that MF affects the hydrogen bonds of intra- and inter-clusters of water molecules, possibly even causing breakage some of them. The Lorentz force influence is also considered. These mechanisms are discussed in the paper.


2016 ◽  
Vol 34 (2) ◽  
pp. 313-322 ◽  
Author(s):  
Erika Palmerio ◽  
Emilia K. J. Kilpua ◽  
Neel P. Savani

Abstract. Planar magnetic structures (PMSs) are periods in the solar wind during which interplanetary magnetic field vectors are nearly parallel to a single plane. One of the specific regions where PMSs have been reported are coronal mass ejection (CME)-driven sheaths. We use here an automated method to identify PMSs in 95 CME sheath regions observed in situ by the Wind and ACE spacecraft between 1997 and 2015. The occurrence and location of the PMSs are related to various shock, sheath, and CME properties. We find that PMSs are ubiquitous in CME sheaths; 85 % of the studied sheath regions had PMSs with the mean duration of 6 h. In about one-third of the cases the magnetic field vectors followed a single PMS plane that covered a significant part (at least 67 %) of the sheath region. Our analysis gives strong support for two suggested PMS formation mechanisms: the amplification and alignment of solar wind discontinuities near the CME-driven shock and the draping of the magnetic field lines around the CME ejecta. For example, we found that the shock and PMS plane normals generally coincided for the events where the PMSs occurred near the shock (68 % of the PMS plane normals near the shock were separated by less than 20° from the shock normal), while deviations were clearly larger when PMSs occurred close to the ejecta leading edge. In addition, PMSs near the shock were generally associated with lower upstream plasma beta than the cases where PMSs occurred near the leading edge of the CME. We also demonstrate that the planar parts of the sheath contain a higher amount of strong southward magnetic field than the non-planar parts, suggesting that planar sheaths are more likely to drive magnetospheric activity.


Crystals ◽  
2020 ◽  
Vol 10 (6) ◽  
pp. 547
Author(s):  
Si Wu ◽  
Yinghao Zhu ◽  
Junchao Xia ◽  
Pengfei Zhou ◽  
Haiyong Ni ◽  
...  

We have grown La 1.37 Sr 1.63 Mn 2 O 7 single crystals with a laser-diode-heated floating-zone furnace and studied the crystallinity, structure, and magnetoresistance (MR) effect by in-house X-ray Laue diffraction, X-ray powder diffraction, and resistance measurements. The La 1.37 Sr 1.63 Mn 2 O 7 single crystal crystallizes into a tetragonal structure with space group I4/mmm at room temperature. At 0 T, the maximum resistance centers around ∼166.9 K. Below ∼35.8 K, it displays an insulating character with an increase in resistance upon cooling. An applied magnetic field of B = 7 T strongly suppresses the resistance indicative of a negative MR effect. The minimum MR value equals −91.23% at 7 T and 128.7 K. The magnetic-field-dependent resistance shows distinct features at 1.67, 140, and 322 K, from which we calculated the corresponding MR values. At 14 T and 140 K, the colossal negative MR value is down to −94.04(5)%. We schematically fit the MR values with different models for an ideal describing of the interesting features of the MR value versus B curves.


2019 ◽  
Vol 33 (12) ◽  
pp. 1950113 ◽  
Author(s):  
I. M. Pazukha ◽  
Y. O. Shkurdoda ◽  
A. M. Chornous ◽  
L. V. Dekhtyaruk

A series of thin-film nanocomposites based on ferromagnetic metal Co and insulator SiO were prepared using an electron-beam method. The magnetoresistive and magnetic properties of these structures deposited at room temperature and then annealed to 700 K were investigated. The results showed that at the Co concentration 40 [Formula: see text]x [Formula: see text] 60 at.%, thin-film nanocomposites exhibit magnetoresistance (MR) that is conditional on spin-dependent tunnelling of electrons. This range of concentrations corresponds to the prepercolation area according to the magnetic investigations. For samples with x [Formula: see text] 70 at.%, the anisotropic character of MR peculiar to the homogeneous ferromagnetic materials appears. According to the magnetic properties study, this range of concentrations corresponds to the area after transition through the percolation threshold. The annealing process in temperature range from 300 K to 700 K in the magnetic field slightly influenced the magnetoresistive properties of the thin-film nanocomposites based on Co and SiO for all range of concentrations.


2017 ◽  
Vol 2017 ◽  
pp. 1-14 ◽  
Author(s):  
E. Chiaramello ◽  
S. Fiocchi ◽  
P. Ravazzani ◽  
M. Parazzini

This study focused on the evaluation of the exposure of children aging from five to fourteen years to 50 Hz homogenous magnetic field uncertain orientation using stochastic dosimetry. Surrogate models allowed assessing how the variation of the orientation of the magnetic field influenced the induced electric field in each tissue of the central nervous system (CNS) and in the peripheral nervous system (PNS) of children. Results showed that the electric field induced in CNS and PNS tissues of children were within the ICNIRP basic restrictions for general public and that no significant difference was found in the level of exposure of children of different ages when considering 10000 possible orientations of the magnetic field. A “mean stochastic model,” useful to estimate the level of exposure in each tissue of a representative child in the range of age from five to fourteen years, was developed. In conclusion, this study was useful to deepen knowledge about the ELF-MF exposure, including the evaluation of variable and uncertain conditions, thus representing a step towards a more realistic characterization of the exposure to EMF.


2013 ◽  
Vol 401-403 ◽  
pp. 1393-1396
Author(s):  
Xu Dong Guo ◽  
Chao Ruan ◽  
Bin Ge ◽  
Rong Guo Yan ◽  
Ying Liu

To track a capsule endoscope, a novel measuring method based on alternating magnetic field is presented. The signal-to-noise ratio of the magnetic sensor decreases sharply with the increasing tracking distance. Thus, a magnetic generator with automatic gain regulation is designed to improve the localization precision. It is composed of a microcontroller, a DA converter, a timer, a waveform synthesis circuit, a power amplifier, a sequence control circuit and excitation coils. First, the wireless magnetic sensor measures the strength of the magnetic field produced by the magnetic generator. Via radio frequency communication, the measured result is feedback to the comparator of the microcontroller. According to a deviation obtained by comparing the measured results with the reference value, the microcontroller outputs a digital signal to the DA converter to control the magnitude of the exciting current. The prototype of the system was developed and the experiment was performed. The experiment shows that the magnetic field generator can automatically adjust the strength of the exciting signal.


Sign in / Sign up

Export Citation Format

Share Document