scholarly journals The susceptibility to pollution of groundwater occurring in a paper production area: Rio Claro (SP), Brazil

2014 ◽  
Author(s):  
D. M. Bonotto ◽  
J. R. Jiménez-Rueda ◽  
F. Y. Hiodo ◽  
F. B. Ribeiro
Keyword(s):  
Paper Production ◽  
Production Area

Economics of coated paper production made from deinked pulp

TAPPI Journal ◽  
2013 ◽  
Vol 12 (4) ◽  
pp. 19-27
Author(s):  
PATRICK HUBER ◽  
LAURENT LYANNAZ ◽  
BRUNO CARRÉ
Keyword(s):  
Mechanical Properties ◽  
Optimization Methods ◽  
Coating Process ◽  
Coated Paper ◽  
Paper Production ◽  
Base Paper

The fraction of deinked pulp for coated paper production is continually increasing, with some mills using 100% deinked pulp for the base paper. The brightness of the coated paper made from deinked pulp may be reached through a combination of more or less extensive deinking, compensated by appropriate coating, to optimize costs overall. The authors proposed general optimization methods combined with Kubelka-Munk multilayer calculations to find the most economical combination of deinking and coating process that would produce a coated paper made from DIP, at a given target brightness, while maintaining mechanical properties.

Resource efficiency in deinked pulp production: a review

TAPPI Journal ◽  
2014 ◽  
Vol 13 (11) ◽  
pp. 37-43 ◽  
Author(s):  
LIISA KOTANEN ◽  
MIKA KÖRKKÖ ◽  
ARI ÄMMÄLÄ ◽  
JOUKO NIINIMÄKI
Keyword(s):  
Waste Disposal ◽  
Resource Efficiency ◽  
Raw Material ◽  
Ecological Strategy ◽  
Recycled Paper ◽  
Paper Production ◽  
Recycled Pulp ◽  
Current State ◽  
The Cost ◽  
Pulp Production

The use of recovered paper as a raw material for paper production is by far the most economical and ecological strategy for the disposal of waste paper. However, paper production from recovered paper furnish generates a great amount of residues, and the higher the demand requirements for the end product, the higher the amount of rejected material. The reason for this is that the selectivity of the deinking process is limited; therefore, some valuable components are also lost in reject streams. The rejection of usable components affects the economics of recycled paper production. As the cost of waste disposal continues to increase, this issue is becoming more and more severe. This paper summarizes the current state of the resource efficiency in recycled pulp production and provides information on the volumes of rejected streams and the usable material within them. Various means to use these reject streams are also discussed, including the main findings of a recent thesis by the main author. This review summarizes current internal and external use of reject streams generated in the deinking operations.

Automatic warehouses in coated paper production line.

1990 ◽  
Vol 44 (2) ◽  
pp. 215-219
Author(s):  
Atsushi Umeyama
Keyword(s):  
Production Line ◽  
Coated Paper ◽  
Paper Production

Impact of Fertigation versus Controlled-release Fertilizer Formulations on Nitrate Concentrations in Nursery Drainage Water

2011 ◽  
Vol 21 (2) ◽  
pp. 176-180 ◽  
Author(s):  
P. Chris Wilson ◽  
Joseph P. Albano
Keyword(s):  
Water Quality ◽  
Controlled Release ◽  
Drainage Water ◽  
Plant Production ◽  
Fertilization Program ◽  
Median Concentration ◽  
Nitrate N ◽  
Production Area ◽  
Foliage Plant ◽  
Production Areas

Nitrate-nitrogen (N) losses in surface drainage and runoff water from ornamental plant production areas can be considerable. In N-limited watersheds, discharge of N from production areas can have negative impacts on nontarget aquatic systems. This study monitored nitrate-N concentrations in production area drainage water originating from a foliage plant production area. Concentrations in drainage water were monitored during the transition from 100% reliance on fertigation using urea and nitrate-based soluble formulations (SF) to a nitrate-based controlled-release formulation (CRF). During the SF use period, nitrate-N concentrations ranged from 0.5 to 322.0 mg·L−1 with a median concentration of 31.2 mg·L−1. Conversely, nitrate-N concentrations during the controlled-release fertilization program ranged from 0 to 147.9 mg·L−1 with a median concentration of 0.9 mg·L−1. This project demonstrates that nitrate-N concentrations in drainage water during the CRF program were reduced by 94% to 97% at the 10th through 95th percentiles relative to the SF fertilization program. Nitrate-N concentrations in drainage water from foliage plant production areas can be reduced by using CRF fertilizer formulations relative to SF formulations/fertigation. Similar results should be expected for other similar containerized crops. Managers located within N-limited watersheds facing N water quality regulations should consider the use of CRF fertilizer formulations as a potential tool (in addition to appropriate application rates and irrigation management) for reducing production impacts on water quality.

Sorption of pesticides used in banana production on soils of Ecuador

Soil Research ◽  
2002 ◽  
Vol 40 (7) ◽  
pp. 1085 ◽  
Author(s):  
Tanya Cáceres ◽  
Guang-Guo Ying ◽  
Rai Kookana
Keyword(s):  
River Basin ◽  
Ecosystem Health ◽  
Production Systems ◽  
Parent Compound ◽  
Mean Value ◽  
Organic Carbon Content ◽  
Banana Production ◽  
Kd Values ◽  
Production Area ◽  
Impact Of Pesticides

There is concern about the migration and adverse impact of pesticides used in banana production systems in Ecuador on aquaculture and ecosystem health. Therefore, we studied the sorption of chlorothalonil, fenamiphos, and its 2 metabolites (fenamiphos sulfone and fenamiphos sulfoxide), by batch method on 6 surface soils from the Guayas River Basin (1–3�S, 79–81�W), a major banana production area of Ecuador. The sorption of chlorothalonil on the 6 soils was high and varied considerably as shown by the Kd values ranging from 68.50 to 152.60 L/kg. The sorption coefficients normalised with the organic carbon content of soil (Koc) for chlorothalonil ranged from 2330 to 7336 kg/L, with a mean value of 4012 kg/L. These Koc values are higher than those previously reported in the literature. The sorption of fenamiphos and its metabolites to the 6 soils varied among soils in a similar pattern. The Kd values ranged from 5.66 to 14.31�L/kg for fenamiphos, from 2.81 to 8.79 L/kg for fenamiphos sulfone, and from 0.77 to 4.00 L/kg for fenamiphos sulfoxide, respectively. In all of the soils the sorption coefficients of both metabolites of fenamiphos were lower than that for the parent compound. The Koc values ranged from 220 to 515 kg/L (mean value 371 kg/L) for fenamiphos, from 29 to 141 kg/L (mean value of 76 kg/L) for fenamiphos sulfoxide, and from 79 to 334 kg/L (mean value of 191 kg/L) for fenamiphos sulfone. Chlorothalonil had much stronger sorption than fenamiphos and its metabolites on the Ecuadorian soil. Due to lower sorption and therefore greater mobility and longer persistence of the fenamiphos metabolites, these compounds need adequate consideration during residue monitoring and assessment of potential off-site impacts on ecosystem health and aquaculture in the Guayas River Basin.

Biogas Production Using Anaerobic Digestion of Industrial Waste

2016 ◽  
Vol 832 ◽  
pp. 55-62
Author(s):  
Ján Gaduš ◽  
Tomáš Giertl ◽  
Viera Kažimírová
Keyword(s):  
Anaerobic Digestion ◽  
Industrial Waste ◽  
Large Scale ◽  
Biogas Production ◽  
Biogas Plant ◽  
Parallel Operation ◽  
Paper Production ◽  
Biochemical Conversion ◽  
Mixed Biomass ◽  
Economic Balance

In the paper experiments and theory of biogas production using industrial waste from paper production as a co-substrate are described. The main aim of the experiments was to evaluate the sensitivity and applicability of the biochemical conversion using the anaerobic digestion of the mixed biomass in the pilot fermentor (5 m3), where the mesophillic temperature was maintained. It was in parallel operation with a large scale fermentor (100 m3). The research was carried out at the biogas plant in Kolíňany, which is a demonstration facility of the Slovak University of Agriculture in Nitra. The experiments proved that the waste arising from the paper production can be used in case of its appropriate dosing as an input substrate for biogas production, and thus it can improve the economic balance of the biogas plant.

scholarly journals Burial and Exhumation History of the Lujing Uranium Ore Field, Zhuguangshan Complex, South China: Evidence from Low-Temperature Thermochronology

Minerals ◽  
2021 ◽  
Vol 11 (2) ◽  
pp. 116
Author(s):  
Yue Sun ◽  
Barry P. Kohn ◽  
Samuel C. Boone ◽  
Dongsheng Wang ◽  
Kaixing Wang
Keyword(s):  
Early Cretaceous ◽  
Late Cretaceous ◽  
South China ◽  
Thermal History ◽  
Fission Track ◽  
Thermal Evolution ◽  
Negative Relationship ◽  
The Tibetan Plateau ◽  
Uranium Ore ◽  
Production Area

The Zhuguangshan complex hosts the main uranium production area in South China. We report (U-Th)/He and fission track thermochronological data from Triassic–Jurassic mineralized and non-mineralized granites and overlying Cambrian and Cretaceous sandstone units from the Lujing uranium ore field (LUOF) to constrain the upper crustal tectono-thermal evolution of the central Zhuguangshan complex. Two Cambrian sandstones yield reproducible zircon (U-Th)/He (ZHe) ages of 133–106 Ma and low effective uranium (eU) content (270–776 ppm). One Upper Cretaceous sandstone and seven Mesozoic granites are characterized by significant variability in ZHe ages (154–83 Ma and 167–36 Ma, respectively), which show a negative relationship with eU content (244–1098 ppm and 402–4615 ppm), suggesting that the observed age dispersion can be attributed to the effect of radiation damage accumulation on 4He diffusion. Correspondence between ZHe ages from sandstones and granites indicates that surrounding sedimentary rocks and igneous intrusions supplied sediment to the Cretaceous–Paleogene Fengzhou Basin lying adjacent to the LUOF. The concordance of apatite fission track (AFT) central ages (61–54 Ma) and unimodal distributions of confined track lengths of five samples from different rock units suggest that both sandstone and granite samples experienced a similar cooling history throughout the entire apatite partial annealing zone (~110–60 °C). Apatite (U-Th-Sm)/He (AHe) ages from six non-mineralized samples range from 67 to 19 Ma, with no apparent correlation to eU content (2–78 ppm). Thermal history modeling of data suggests that the LUOF experienced relatively rapid Early Cretaceous cooling. In most samples, this was followed by the latest Early Cretaceous–Late Cretaceous reheating and subsequent latest Late Cretaceous–Recent cooling to surface temperatures. This history is considered as a response to the transmission of far-field stresses, involving alternating periods of regional compression and extension, related to paleo-Pacific plate subduction and subsequent rollback followed by Late Paleogene–Recent India–Asia collision and associated uplift and eastward extrusion of the Tibetan Plateau. Thermal history models are consistent with the Fengzhou Basin having been significantly more extensive in the Late Cretaceous–Early Paleogene, covering much of the LUOF. Uranium ore bodies which may have formed prior to the Late Cretaceous may have been eroded by as much as ~1.2 to 4.8 km during the latest Late Cretaceous–Recent denudation.

Perceptions of geographical indication labels as quality indicators inside and outside the labels’ area of influence: the case of spring fruits

2021 ◽  
pp. 1-7
Author(s):  
Rabadán Adrián ◽  
Martínez-Carrasco Laura ◽  
Brugarolas Margarita ◽  
Bernabéu Rodolfo
Keyword(s):  
Logistic Regression ◽  
Regression Analysis ◽  
Quality Indicators ◽  
Added Value ◽  
Geographical Indications ◽  
Geographical Indication ◽  
Protected Designation Of Origin ◽  
Rural Environments ◽  
Production Area ◽  
Area Of Influence

Abstract Geographical indications (GIs) are valuable attributes that enhance the competitiveness of agri-food products, generate added value and revitalize rural environments. The aim of this work was to analyze the attributes spring fruit consumers associate with GIs when they decide to purchase these products. Moreover, the changes in these associations with the increasing distance between the region of production and the place of consumption were also evaluated. We specifically analyzed two GIs used for spring fruits: the protected geographical indication for Mountain Cherries from Alicante (Spain) and the protected designation of origin for Loquats from Callosa d'En Sarriá (Spain). Data were analyzed using logistic regression analysis. The results show the significant association in consumers' minds between the preference for GI fruit and the importance attributed to the place of production (origin). The association of different attributes with the GI fruit label is product dependent as the number of attributes associated in the case of cherries (origin, organic, color and variety) is higher than for loquats (origin and variety). Regarding the distance between the production area and the place of consumption, our findings suggest that the closer the consumer is to the GI area of influence, the more attributes they associate with these labels. In this regard, increasing the knowledge of the GI labels beyond their area of influence could boost the demand for these products as consumers would be aware of the different quality attributes concentrated in that label.

Sign in / Sign up

Export Citation Format

Share Document