scholarly journals The formation mechanism of authigenic chlorite in tight sandstone and its effect on tight oil adsorption during hydrocarbon filling

2021 ◽  
Vol 76 ◽  
pp. 39
Author(s):  
Qianshan Zhou ◽  
Chao Li ◽  
Guojun Chen ◽  
Chengfu Lyu ◽  
Xuefeng Qu ◽  
...  
Keyword(s):  
Thin Film ◽  
Electron Microscopy ◽  
Scanning Electron Microscopy ◽  
Thin Section ◽  
Tight Oil ◽  
Spatial Coupling ◽  
Particle Form ◽  
Intercrystalline Pores ◽  
Pore Lining ◽  
Scanning Electron

Authigenic chlorite, which is frequently found in sandstone, has a controlling effect on the reservoirs in which tight oil is adsorbed during hydrocarbon filling. In this study, the content, occurrence state, timing, mechanism and influence of authigenic chlorite on the micro-occurrence states of tight oil were studied using Thin Section (TS), Fluorescent Thin Section (FTS), X-Ray Diffraction (XRD), Field Emission-Scanning Electron Microscopy (FE-SEM), Environmental Scanning Electron Microscopy (ESEM), and Energy Dispersive Spectroscopy (EDS). The results indicate: (1) a spatial coupling between chlorite development, a brackish water delta front facies depositional environment, and biotite-rich arkosic sandstone. (2) Authigenic chlorite can be divided into three types: grain-coating chlorite, pore-lining chlorite, and rosette chlorite. Chlorite forms after early compaction but before other diagenetic phases, and grows via precipitation from pore waters that contain products released during the dissolution of volcanic rock fragments and biotites. Porewater is also pressure-released from feldspars and mudstone. (3) The micro-occurrence states of tight oil can be divided into five types: emulsion form, cluster form, throat form, thin-film form, and the isolated or agglomerated particle form. (4) During hydrocarbon filling, tight oil mainly occurs on the surface of grain-coating and pore-lining chlorite in the form of a thin film, the granular or agglomerated forms are mainly enriched within the intercrystalline pores within the authigenic chlorite, and the cluster forms are mainly enriched in dissolution pores. Isolated or agglomerated particles of tight oil primarily occur in the intercrystalline pores of the rosette chlorite. (5) The specific surface area and the authigenic chlorite’s adsorption potential of authigenic chlorite control the micro-occurrence of tight oil on the surface of the chlorite and in intercrystalline pores. The adsorption capacity of chlorite lies in the following order: pore-lining chlorite intercrystalline pores > rosette chlorite > chlorite in feldspar dissolution pores > pore-lining chlorite surface > grain-coating chlorite intercrystalline pores > grain-coating chlorite surface.

Electrostatic Adhesion Testing for the Evaluation of Metallization Adhesion

1997 ◽  
Vol 473 ◽  
Author(s):  
H. S. Yang ◽  
F. R. Brotzen ◽  
D. L. Callahan ◽  
C. F. Dunn
Keyword(s):  
Thin Film ◽  
Electron Microscopy ◽  
Scanning Electron Microscopy ◽  
Distribution Function ◽  
Quantitative Measurement ◽  
Multilayer Films ◽  
Adhesion Testing ◽  
Novel Technique ◽  
Electrostatic Adhesion ◽  
Scanning Electron

ABSTRACTQuantitative measurement of the adhesion strength of thin film metallizations has been achieved by a novel technique employing electrostatic forces to generate delaminating stresses. This technique has been used in testing the adhesion of Al-Cu, Cu, and Al multilayer films deposited on Si. Micro-blister-type failure is revealed by scanning electron microscopy. The delamination process and the geometry of the blister are discussed. The measured adhesion data fit a Weibull distribution function.

The Characteristic of Algal Reef Carbonate Sedimentary and Pore Structure in the Xisha Islands: Evidence from Halimeda

2014 ◽  
Vol 1065-1069 ◽  
pp. 3291-3294
Author(s):  
Xin Wei Zhao ◽  
Hui Zhi Hao
Keyword(s):  
Electron Microscopy ◽  
Scanning Electron Microscopy ◽  
Energy Spectrum ◽  
Middle Miocene ◽  
Carbonate Sediments ◽  
Network Systems ◽  
Xisha Islands ◽  
Intercrystalline Pores ◽  
Algal Reef ◽  
Scanning Electron

Halimeda is an important reef-building green alga. Scanning electron microscopy (SEM) and energy spectrum tests on green and white Halimeda collected from Shidao Island in the Xisha Islands show that carbonate is predominantly deposited in the cortexes and medullas, especially in the aragonite raphides of them, as the case of calcium carbonate. These modern carbonate sediments are then compared with their ancient counterparts that are collected from Xichen-1 well in the Yongle Atoll, where a large number of Halimeda segments have been recognized in about 100-m-long late Miocene-middle Miocene whole-coring succession. In addition, there are developed great numbers of algal-frame holes, including secondary dissolved pores and intercrystalline pores in the medullas and in aragonites between cysts, which have formed particular network systems and pore throats.

scholarly journals KARAKTERISASI KAPASITOR BARIUM STRONTIUM TITANAT (BST) Ba0,75 Sr0,25 TiO3 , YANG DIBUAT MENGGUNAKAN METODE SOL-GEL

2019 ◽  
Vol 16 (1) ◽  
pp. 65
Author(s):  
Rahmi Dewi ◽  
Tiara Pertiwi ◽  
Krisman Krisman
Keyword(s):  
Thin Film ◽  
Electron Microscopy ◽  
Scanning Electron Microscopy ◽  
Dielectric Constant ◽  
Impedance Spectroscopy ◽  
Strontium Titanate ◽  
Barium Strontium Titanate ◽  
Sol Gel ◽  
Barium Strontium ◽  
Scanning Electron

The thin film of Barium Strontium Titanate (BST) has been studied withcomposition ofby using sol-gel method that annealed in temperature of 600oC and 650oC. The thin film of BST is characterized by using Field Emission Scanning Electron Microscopy (FESEM) and an impedance spectroscopy. The results of  FESEM characterization for samples in temperature of 600oC and 650oC are 55.83 nm and 84.88 nm in thickness respectively. The result of impedance spectroscopy characterization given frequency values obtained by the impedance value of real and imaginary.The capacitance value at a frequency of 20 Hz from a thin film of BST in temperature of 600oC and 650oC are 69.36Fand138.70F. The dielectric constant of the thin film of BST in temperature of 600oC and 650oC are 22.17 dan 131.56 respectively.

Synthesis and Film Investigation of Titania

2013 ◽  
Vol 832 ◽  
pp. 128-131
Author(s):  
Sharipah Nadzirah ◽  
Uda Hashim
Keyword(s):  
Thin Film ◽  
Electron Microscopy ◽  
Thin Films ◽  
Scanning Electron Microscopy ◽  
Titanium Dioxide ◽  
Sol Gel ◽  
Titanium Butoxide ◽  
Before And After ◽  
Scanning Electron ◽  
Spin Coater

Titania or titanium dioxide (TiO2) thin film has been synthesized via sol-gel method with monoethanolamine (MEA) as a catalyst. The mixing of titanium butoxide as a precursor, ethanol as a solvent and MEA were stirred using magnetic stirrer under ambient temperature [. The TiO2solution prepared then was deposited on SiO2substrates using spin-coater and the coated films were annealed at 600°C. Finally, both before and after annealed TiO2thin films were characterized using Field Emission Scanning Electron Microscopy (FESEM). The obtained results show the different TiO2particles formation before and after annealed.

Research on Diagenesis of Volcanic Reservoirs in YS2,3 Well Fields

2014 ◽  
Vol 893 ◽  
pp. 720-723
Author(s):  
Cheng Zhi Liu ◽  
Jing Yao Zhang ◽  
Yang Wan
Keyword(s):  
Electron Microscopy ◽  
Scanning Electron Microscopy ◽  
Volcanic Rock ◽  
Thin Section ◽  
Destructive Effect ◽  
Comprehensive Utilization ◽  
Formation And Evolution ◽  
Volcanic Reservoirs ◽  
Rock Lithology ◽  
Scanning Electron

Based on the comprehensive utilization of core, thin section identification, scanning electron microscopy and other technical means, through the YS2, 3 well fields of volcanic rock lithology and lithofacies analysis; understand that the formation and evolution of volcanic reservoirs play a constructive role and destructive effect ，which has important guiding significance[1,2].

Charge dynamics in aluminum oxide thin film studied by ultrafast scanning electron microscopy

2018 ◽  
Vol 187 ◽  
pp. 93-97 ◽  
Author(s):  
Maurizio Zani ◽  
Vittorio Sala ◽  
Gabriele Irde ◽  
Silvia Maria Pietralunga ◽  
Cristian Manzoni ◽  
...  
Keyword(s):  
Thin Film ◽  
Electron Microscopy ◽  
Scanning Electron Microscopy ◽  
Aluminum Oxide ◽  
Oxide Thin Film ◽  
Charge Dynamics ◽  
Scanning Electron

Approaches to Solution Deposited Flexible Composite Vapor Barrier Films

2009 ◽  
Vol 1195 ◽  
Author(s):  
Jeffrey A. Gerbec ◽  
Jimmy Granstrom ◽  
Hunaid Nulwala ◽  
Luis M. Campos ◽  
Craig Hawker
Keyword(s):  
Thin Film ◽  
Electron Microscopy ◽  
Scanning Electron Microscopy ◽  
Compressive Stress ◽  
Interfacial Adhesion ◽  
Ambient Pressure ◽  
Silica Sol ◽  
Multilayered Structures ◽  
Barrier Films ◽  
Scanning Electron

AbstractLiquid resin hybridized silica sol-gels and thiol-ene elastomers were evaluated as compatible materials to form thin film, flexible multilayered structures. Liquid resins are cast and cured in air and ambient pressure on the order of minutes. Scanning Electron Microscopy (SEM) reveals homogeneous interfaces and robust interfacial adhesion under tensile and compressive stress. Thickness of the hybrid glass and thiol-ene films range from 0.80μm to 1.5μm and 8 μm to 16 μm respectively.

Sign in / Sign up

Export Citation Format

Share Document