scholarly journals Biodeterioration of Optical Glass Induced by Lubricants Used in Optical Instruments Technology

2010 ◽  
Vol 59 (4) ◽  
pp. 295-300 ◽  
Author(s):  
MAGDALENA BARTOSIK ◽  
ZOFIA ŻAKOWSKA ◽  
KRYSTYNA CEDZIŃSKA ◽  
KAZIMIERZ ROŻNIAKOWSKI
Keyword(s):  
Aspergillus Niger ◽  
Laser Light ◽  
Optical Glass ◽  
Glass Plate ◽  
Culture Fluid ◽  
Analysis Method ◽  
Optical Instruments ◽  
Surface Measurements ◽  
Auxiliary Material ◽  
Beam Transmittance

The process of biodeterioration of optical glass was studied after being induced by an auxiliary material (lubricant 4CKP) used in the production of optical instruments. It was determined that the lubricant can initiate growth of conidia of Aspergillus niger fungus. Acid spawn metabolites cause deterioration of the glass surface. Measurements of laser light beam transmittance through the glass plate and the AAS chemical analysis method of the post-culture fluid allowed to determine that glass with a high SiO2 content is most resistant to corrosion caused by the growth of A. niger fungi spawn.

LD-pumped high-power continuous-wave Pr3+:YLF deep red lasers at 718.5 and 720.8 nm

Laser Physics ◽  
2021 ◽  
Vol 32 (2) ◽  
pp. 025801
Author(s):  
Xiangrui Liu ◽  
Zhuang Li ◽  
Chengkun Shi ◽  
Bo Xiao ◽  
Run Fang ◽  
...  
Keyword(s):  
Output Power ◽  
High Power ◽  
Slope Efficiency ◽  
Laser Emission ◽  
Continuous Wave ◽  
Optical Glass ◽  
Maximum Output Power ◽  
Glass Plate ◽  
Maximum Output ◽  
First Time

Abstract We demonstrated 22 W LD-pumped high-power continuous-wave (CW) deep red laser operations at 718.5 and 720.8 nm based on an a-cut Pr3+:YLF crystal. The output power of both polarized directions reached the watt-level without output power saturation. A single wavelength laser operated at 720.8 nm in the π-polarized direction was achieved, with a high output power of 4.5 W and high slope efficiency of approximately 41.5%. To the best of our knowledge, under LD-pumped conditions, the laser output power and slope efficiency are the highest at 721 nm. By using a compact optical glass plate as an intracavity etalon, we suppressed the π-polarized 720.8 nm laser emission. And σ-polarized single-wavelength laser emission at 718.5 nm was achieved, with a maximum output power of 1.45 W and a slope efficiency of approximately 17.8%. This is the first time that we have achieved the σ-polarized laser emission at 718.5 nm generated by Pr3+:YLF lasers.

scholarly journals Erratum for: Characteristics of optical glass plate refractive index sensor based on surface plasmon resonance

2015 ◽  
Vol 57 (4) ◽  
pp. 1023-1023
Author(s):  
Cien-Jen Tang ◽  
Chen-Hung Lin ◽  
Li-Jen Hsiao ◽  
Wei-Tsung Chen ◽  
Cheng-Chung Jaing ◽  
...  
Keyword(s):  
Refractive Index ◽  
Surface Plasmon Resonance ◽  
Surface Plasmon ◽  
Plasmon Resonance ◽  
Optical Glass ◽  
Glass Plate ◽  
Refractive Index Sensor

Characteristics of optical glass plate refractive index sensor based on surface plasmon resonance

2014 ◽  
Vol 56 (12) ◽  
pp. 3009-3012
Author(s):  
Cien-Jen Tang ◽  
Chen-Hung Lin ◽  
Li-Jen Hsiao ◽  
Wei-Tsung Chen ◽  
Cheng-Chung Jaing ◽  
...  
Keyword(s):  
Refractive Index ◽  
Surface Plasmon Resonance ◽  
Surface Plasmon ◽  
Plasmon Resonance ◽  
Optical Glass ◽  
Glass Plate ◽  
Refractive Index Sensor

The Role of VLBI in the Establishment of Coordinate Systems

1975 ◽  
Vol 26 ◽  
pp. 293-295 ◽  
Author(s):  
I. Zhongolovitch
Keyword(s):  
General Solution ◽  
Future Development ◽  
Rational Approach ◽  
Radio Telescopes ◽  
Coordinate Systems ◽  
Tectonic Plates ◽  
Astronomical Observations ◽  
Optical Instruments ◽  
Fundamental Polyhedron

Considering the future development and general solution of the problem under consideration and also the high precision attainable by astronomical observations, the following procedure may be the most rational approach:1. On the main tectonic plates of the Earth’s crust, powerful movable radio telescopes should be mounted at the same points where standard optical instruments are installed. There should be two stations separated by a distance of about 6 to 8000 kilometers on each plate. Thus, we obtain a fundamental polyhedron embracing the whole Earth with about 10 to 12 apexes, and with its sides represented by VLBI.

Chronic Laser Exposure Effects on Rabbit Retina

1972 ◽  
Vol 30 ◽  
pp. 54-55
Author(s):  
Burton B. Silver ◽  
Theodore Lawwill
Keyword(s):  
Laser Irradiation ◽  
Laser Light ◽  
Broad Band ◽  
Argon Laser ◽  
Atropine Sulfate ◽  
Ultrastructural Changes ◽  
Laser Exposure ◽  
Rabbit Retina ◽  
Histological Changes ◽  
Threshold Doses

Dutch-belted 1 to 2.5 kg anesthetized rabbits were exposed to either xenon or argon laser light administered in a broad band, designed to cover large areas of the retina. For laser exposure, the pupil was dilated with atropine sulfate 1% and pheny lephrine 10%. All of the laser generated power was within a band centered at 5145.0 Anstroms. Established threshold for 4 hour exposures to laser irradiation are in the order of 25-35 microwatts/cm2. Animals examined for ultrastructural changes received 4 hour threshold doses. These animals exhibited ERG, opthalmascopic, and histological changes consistent with threshold damage.One month following exposure the rabbits were killed with pentobarbitol. The eyes were immediately enucleated and dissected while bathed in 3% phosphate buffered gluteraldehyde.

Immunogold labeling of Pneumocystis carinii for Electron microscopy

1991 ◽  
Vol 49 ◽  
pp. 270-271
Author(s):  
Michael P. Goheen ◽  
Marilyn S. Bartlett ◽  
James W. Smith
Keyword(s):  
Electron Microscopy ◽  
Pneumocystis Carinii ◽  
Severe Pneumonia ◽  
Culture Fluid ◽  
Immunogold Labeling ◽  
Antigenic Sites ◽  
Transmission Electron ◽  
Response To Chemotherapy ◽  
Acquired Immunodeficiency ◽  
Immunodeficiency Syndrome

Studies of the biology of Pneumocystis carinii (PC) are of increasing importance because this extracellular pathogen is a frequent source of severe pneumonia in patients with acquired immunodeficiency syndrome (AIDS) and is a leading cause of mortality in these patients. Immunoelectron microscopic localization of antigenic sites on the surface of PC would improve the understanding of these sites and their role in pathenogenisis of the disease and response to chemotherapy. The purpose of this study was to develop a methodology for visualizing immunoreactive sites on PC with transmission electron microscopy (TEM) using immunogold labeled probes.Trophozoites of PC were added to spinner flask cultures and allowed to grow for 7 days, then aliquots of tissue culture fluid were centrifuged at 12,000 RPM for 30 sec. Pellets of organisims were fixed in either 1% glutaraldehyde, 0.1% glutaraldehyde-4% paraformaldehyde, or 4% paraformaldehyde for 4h. All fixatives were buffered with 0.1M Na cacodylate and the pH adjusted to 7.1. After fixation the pellets were rinsed in 0.1M Na cacodylate (3X), dehydrated with ethanol, and immersed in a 1:1 mixture of 95% ethanol and LR White resin.

Effects of compression during formation on the microstructure of composite hydroxylapatite/plaster implants for bone reconstruction

1988 ◽  
Vol 46 ◽  
pp. 750-751
Author(s):  
J. Hanker ◽  
K. Cowden ◽  
R. Noecker ◽  
P. Yates ◽  
N. Georgiade ◽  
...  
Keyword(s):  
Cosmetic Surgery ◽  
Glass Plate ◽  
Surgical Reconstruction ◽  
Equal Weight ◽  
Sintered Ceramic ◽  
Setting Times ◽  
Excess Water ◽  
Mixture Prior ◽  
Mechanical Strengths ◽  
Calcium Sulfate Hemihydrate

Composites of plaster of Paris (PP) and hydroxylapatite (HA) particles are being applied for the surgical reconstruction of craniofacial bone defects and for cosmetic surgery. Two types of HA particles are being employed, the dense sintered ceramic (DHA) and the porous, coralline hydroxylapatite (PHA) particles. Excess water is expressed out of the moistened HA/PP mixture prior to implantation and setting by pressing it in a non-tapered syringe against a glass plate. This results in implants with faster setting times and greater mechanical strengths. It was therefore of interest to compare samples of the compressed versus noncompressed mixtures to see whether or not any changes in their microstructure after setting could be related to these different properties.USG Medical Grade Calcium Sulfate Hemihydrate (which has the lowest mortar consistency of any known plaster) was mixed with an equal weight of Interpore 200 particles (a commercial form of PHA). After moistening with a minimum amount of water, disc-shaped noncompressed samples were made by filling small holes (0.339 in. diameter x 0.053 in. deep) in polypropylene molds with a microspatula.

Correlation Between Cellular Functions and Morphological Changes of Human Trophoblast in Vitro

1975 ◽  
Vol 33 ◽  
pp. 600-601
Author(s):  
John C. Garancis ◽  
Robert O. Hussa ◽  
Michael T. Story ◽  
Donald Yorde ◽  
Roland A. Pattillo
Keyword(s):  
Electron Microscopy ◽  
Cellular Proliferation ◽  
Morphological Changes ◽  
Culture Fluid ◽  
Cellular Functions ◽  
Human Trophoblast ◽  
Transmission Electron ◽  
Marked Activity ◽  
Malignant Trophoblast

Human malignant trophoblast cells in continuous culture were incubated for 3 days in medium containing 1 mM N6-O2'-dibutyryl cyclic adenosine 3':5'-monophosphate (dibutyryl cyclic AMP) and 1 mM theophylline. The culture fluid was replenished daily. Stimulated cultures secreted many times more chorionic gonadotropin and estrogens than did control cultures in the absence of increased cellular proliferation. Scanning electron microscopy revealed remarkable surface changes of stimulated cells. Control cells (not stimulated) were smooth or provided with varying numbers of microvilli (Fig. 1). The latter, usually, were short and thin. The surface features of stimulated cells were considerably different. There was marked increase of microvilli which appeared elongated and thick. Many cells were covered with confluent polypoid projections (Fig. 2). Transmission electron microscopy demonstrated marked activity of cytoplasmic organelles. Mitochondria were increased in number and size; some giant forms with numerous cristae were observed.

Estimation of the noise in TEM image recorded on “imaging plate”

1987 ◽  
Vol 45 ◽  
pp. 748-749
Author(s):  
T. Oikawa ◽  
N. Mori ◽  
T. Katoh ◽  
Y. Harada ◽  
J. Miyahara ◽  
...  
Keyword(s):  
Low Dose ◽  
Quantum Noise ◽  
Laser Light ◽  
Imaging Plate ◽  
Total System ◽  
Electron Dose ◽  
X Ray ◽  
Image Recording ◽  
Recording Material ◽  
Highly Sensitive

The “Imaging Plate”(IP) is a highly sensitive image recording plate for X-ray radiography. It has been ascertained that the IP has superior properties and high practicability as an image recording material in a TEM. The sensitivity, one of the properties, is about 3 orders higher than that of conventional photo film. The IP is expected to be applied to low dose techniques. In this paper, an estimation of the quantum noise on the TEM image which appears in case of low electron dose on the IP is reported.In this experiment, the JEM-2000FX TEM and an IP having the same size as photo film were used.Figure 1 shows the schematic diagram of the total system including the TEM used in this experiment. In the reader, He-Ne laser light is scanned across the IP, then blue light is emitted from the IP.

Sign in / Sign up

Export Citation Format

Share Document