scholarly journals Water use efficiency and yield of cowpea and nutrient loss in lysimeter experiment under varying water table depth, irrigation schedules and irrigation method

2017 ◽  
Vol 14 (2) ◽  
pp. 46-55 ◽  
Author(s):  
Binny Dasila ◽  
Veer Singh ◽  
HS Kushwaha ◽  
Ajaya Srivastava ◽  
Shri Ram
Keyword(s):  
Grain Yield ◽  
Water Use Efficiency ◽  
Nutrient Uptake ◽  
Water Use ◽  
Water Table ◽  
Root Length ◽  
Water Table Depth ◽  
Nutrient Loss ◽  
Lysimeter Experiment ◽  
Use Efficiency

Lysimeter experiment was conducted at Govind Ballabh Pant University of Agriculture & Technology, Pantnagar during summer season 2013 to study the effect of irrigation schedules and methods on yield, nutrient uptake and water use efficiency of cowpea as well as nutrient loss from silty clay loam soil under fluctuating water table conditions. The experiment was laid out in factorial randomized block design having three irrigation schedules at IW/CPE ratio of 0.3. 0.2 and 0.15 with two irrigation methods (flood and sprinkler) and at 30±1.5, 60±1.5 and 90±1.5 cm water tables replicated thrice. Maximum root length (129.4 cm) and root length density (0.395 cm/cm3) were obtained when irrigation was scheduled at IW: CPE 0.3 associated with 30±1.5 cm water table depth using sprinkler method. Increase in water table depth and IW: CPE ratio decreased water use efficiency where IW: CPE 0.3 produced highest grain yield (1411.6 kg ha-1) with the WUE of 1.15 kg ha mm-1. Significant nutrients uptake response was observed owing to variation in water table depth, irrigation schedules and methods. Analysis of lysimeter leached water showed that with deep drainage and more IW:CPE, leaching losses of N,P and K were more however water applied through sprinkler saved 20.1, 53.7 and 24.4% N, P and K, respectively, over flooded method. Irrigation given at IW: CPE 0.3 through sprinkler form at 60±1.5 cm water table depth favours the higher grain yield and nutrient uptake by crop whereas flooded irrigation with deep water table condition accelerated nutrient leaching.SAARC J. Agri., 14(2): 46-55 (2016)

The effects of salt and boron on growth of wheat

1992 ◽  
Vol 43 (5) ◽  
pp. 987 ◽  
Author(s):  
RE Holloway ◽  
AM Alston
Keyword(s):  
Grain Yield ◽  
Water Use Efficiency ◽  
Water Use ◽  
Root Length ◽  
Dry Matter ◽  
Sandy Loam ◽  
Dry Weight ◽  
Matter Production ◽  
Use Efficiency ◽  
Total Dry Weight

Wheat (Triticum aestivum L. cv. Warigal) was grown in a glasshouse in deep pots (0.125 x 0.125 x 1.2 m) containing sieved solonized brown soil (calcixerollic xerochrept) comprising 0.2 m sandy loam topsoil above 0.6 m treated calcareous sandy loam subsoil and a base layer of light clay 0.26 m thick. The subsoil was treated with a mixture of salts (0, 13, 39, 75 mmolc kg-1) and with boric acid (0, 20, 38 and 73 mg B kg-1) in factorial combination. The soil was initially watered to field capacity and water use was determined by regularly weighing the pots. The soil was allowed to dry gradually during the season, but the weights of the pots were not permitted to fall below that corresponding to 17% of the available water holding capacity of the soil. Tillering, dry weight of shoots and grain, and root length density were determined. Water-use efficiency was calculated with respect to total dry weight and grain production. Salt decreased tillering, dry matter production, grain yield, root length and water-use efficiency (total dry weight): it increased sodium and decreased boron concentrations in the plants. Boron decreased dry matter production (but not tillering), grain yield, root length and water-use efficiency (total dry weight and grain yield): it increased the concentrations of boron and decreased the concentration of sodium in the plants. At the concentrations of salt and boron used (which cover the range normally encountered in subsoils in much of Upper Eyre Peninsula), boron had more deleterious effects on wheat than did salt. Yield was depressed by salt at concentrations of sodium in the tissue commonly found in field-grown plants.

Effect of nitrogen fertiliser placement on grain protein concentration of wheat under different water regimes

1997 ◽  
Vol 48 (2) ◽  
pp. 241 ◽  
Author(s):  
M. Lotfollahi ◽  
A. M. Alston ◽  
G. K. McDonald
Keyword(s):  
Grain Yield ◽  
Water Use Efficiency ◽  
Water Use ◽  
Root Length ◽  
Protein Concentration ◽  
Root Length Density ◽  
Grain Protein ◽  
Grain Protein Concentration ◽  
Significant Difference ◽  
Use Efficiency

Two experiments were conducted in pots 105 cm deep and 11 cm in diameter to determine the effects of subsoil nitrogen (N) on grain yield and grain protein concentration (GPC) of wheat (Triticum aestivum L. cv. Molineux). In both experiments, KNO3 was applied in solution at different times and depths in the profile. In the first experiment, in which a sandy soil low in available N was used, application of 150 mg N at 60 cm, 2 weeks after anthesis, significantly increased grain yield and GPC. The N was taken up gradually by the plant after N was applied. Adding N to the subsoil increased root growth and this resulted in increased water use and water use efficiency. Although there was an increase in the rate of N uptake by the roots, the main factor that influenced the utilisation of subsoil N was the root length density. In the second experiment, the effects of depth and time of N application, and of a reduction in post-anthesis water supply, were determined. A more fertile soil was used than the one in the first experiment. There were 5 KNO3 treatments: nil N; 150 mg N applied to the topsoil at sowing; 75 mg N to the topsoil and 75 mg N to the subsoil (60 cm depth) at sowing; 150 mg N to the subsoil at sowing; 75 mg N to the topsoil at sowing and 75 mg N to the subsoil 1 week after anthesis. The effect of post-anthesis water stress was assessed by allowing the topsoil to dry and then supplying half the amount of water used by the well-watered control treatment at 60 cm in half of the pots. Adding N increased yield and GPC but there was no significant difference in yield and GPC between the different N treatments. When N was applied to the topsoil only, most of it was used by the wheat plants or leached to the subsoil by anthesis; post-anthesis uptake of N depended on the amount of N in the subsoil. Adding N, irrespective of the depth of placement or time of application, increased water use and water use efficiency. In both experiments, increasing the availability of N in the soil after anthesis reduced the amount of N that was remobilised from the roots and stem to the grain. The recovery of applied N in both experiments was high (about 80%). These experiments have shown that N available in the subsoil after anthesis can be used very efficiently and can contribute to both grain yield and GPC. A critical factor in the efficient use of this N appears to be root length density in the subsoil.

Effects of Ridge Mulching with Side-dressing on Grain Yield, Protein Content and Water Use Efficiency in Dryland Wheat

2017 ◽  
Vol 43 (6) ◽  
pp. 899 ◽  
Author(s):  
Ming HUANG ◽  
Zhao-Hui WANG ◽  
Lai-Chao LUO ◽  
Sen WANG ◽  
Ming BAO ◽  
...  
Keyword(s):  
Grain Yield ◽  
Water Use Efficiency ◽  
Protein Content ◽  
Water Use ◽  
Use Efficiency

scholarly journals Optimizing Grain Yield and Water Use Efficiency Based on the Relationship between Leaf Area Index and Evapotranspiration

Agriculture ◽  
2021 ◽  
Vol 11 (4) ◽  
pp. 313
Author(s):  
Guoqiang Zhang ◽  
Bo Ming ◽  
Dongping Shen ◽  
Ruizhi Xie ◽  
Peng Hou ◽  
...  
Keyword(s):  
Grain Yield ◽  
Water Use Efficiency ◽  
Leaf Area Index ◽  
Water Use ◽  
Plant Density ◽  
Maize Yield ◽  
Area Index ◽  
Irrigation Level ◽  
Use Efficiency ◽  
The Relationship

Achieving optimal balance between maize yield and water use efficiency is an important challenge for irrigation maize production in arid areas. In this study, we conducted an experiment in Xinjiang China in 2016 and 2017 to quantify the response of maize yield and water use to plant density and irrigation schedules. The treatments included four irrigation levels: 360 (W1), 480 (W2), 600 (W3), and 720 mm (W4), and five plant densities: 7.5 (D1), 9.0 (D2), 10.5 (D3), 12.0 (D4), and 13.5 plants m−2 (D5). The results showed that increasing the plant density and the irrigation level could both significantly increase the leaf area index (LAI). However, LAI expansion significantly increased evapotranspiration (ETa) under irrigation. The combination of irrigation level 600 mm (W3) and plant density 12.0 plants m−2 (D4) produced the highest maize yield (21.0–21.2 t ha−1), ETa (784.1–797.8 mm), and water use efficiency (WUE) (2.64–2.70 kg m−3), with an LAI of 8.5–8.7 at the silking stage. The relationship between LAI and grain yield and evapotranspiration were quantified, and, based on this, the relationship between water use and maize productivity was analyzed. Moreover, the optimal LAI was established to determine the reasonable irrigation level and coordinate the relationship between the increase in grain yield and the decrease in water use efficiency.

scholarly journals Increase maize productivity and water use efficiency through application of potassium silicate under water stress

2021 ◽  
Vol 11 (1) ◽  
Author(s):  
M. A. Gomaa ◽  
Essam E. Kandil ◽  
Atef A. M. Zen El-Dein ◽  
Mamdouh E. M. Abou-Donia ◽  
Hayssam M. Ali ◽  
...  
Keyword(s):  
Grain Yield ◽  
Water Use Efficiency ◽  
Water Deficit ◽  
Water Use ◽  
Field Experiments ◽  
Foliar Application ◽  
Potassium Silicate ◽  
Water Deficit Stress ◽  
Maize Productivity ◽  
Use Efficiency

AbstractIn Egypt, water shortage has become a key limiting factor for agriculture. Water-deficit stress causes different morphological, physiological, and biochemical impacts on plants. Two field experiments were carried out at Etay El-Baroud Station, El-Beheira Governorate, Agriculture Research Center (ARC), Egypt, to evaluate the effect of potassium silicate (K-silicate) of maize productivity and water use efficiency (WUE). A split-plot system in the four replications was used under three irrigation intervals during the 2017 and 2018 seasons. Whereas 10, 15, and 20 days irrigation intervals were allocated in main plots, while the three foliar application treatments of K-silicate (one spray at 40 days after sowing; two sprays at 40 and 60 days; and three sprays at 40, 60, and 80 days, and a control (water spray) were distributed in the subplots. All the treatments were distributed in 4 replicates. The results indicated that irrigation every 15 days gave the highest yield in both components and quality. The highly significant of (WUE) under irrigation every 20 days. Foliar spraying of K-silicate three times resulted in the highest yield. Even under water-deficit stress, irrigation every fifteen days combined with foliar application of K-silicate three times achieved the highest values of grain yield and its components. These results show that K-silicate treatment can increase WUE and produce high grain yield requiring less irrigation.

Sign in / Sign up

Export Citation Format

Share Document