scholarly journals Evaluation of the Effect of Chassis Dynamometer Load Setting on CO2 Emissions and Energy Demand of a Full Hybrid Vehicle

Energies ◽  
2021 ◽  
Vol 15 (1) ◽  
pp. 122
Author(s):  
Artur Jaworski ◽  
Maksymilian Mądziel ◽  
Krzysztof Lew ◽  
Tiziana Campisi ◽  
Paweł Woś ◽  
...  

Among the solutions that make it possible to reduce CO2 emissions in the transport sector, particularly in urban traffic conditions, are hybrid vehicles. The share of driving performed in electric mode for hybrid vehicles is highly dependent on motion resistance. There are different methods for determining the motion resistance function during chassis dynamometer testing, leading to different test results. Therefore, the main objective of this study was to determine the effect of the chassis dynamometer load function on the energy demand and CO2 emissions of a full-hybrid passenger car. Emissions tests according to the New European Driving Cycle (NEDC) were carried out on a chassis dynamometer for three different methods of determining the car’s resistance to motion. The study showed that adopting the motion resistance function according to different methods, results in differences in CO2 emissions up to about 35% for the entire cycle. Therefore, the authors suggest that in the case of tests carried out with chassis dynamometers, it is necessary to also provide information on the chassis dynamometer loading function adopted for the tests.

2021 ◽  
Author(s):  
KIRAN THAKARE ◽  
ABHAY SINGH ◽  
OBAID ASHRAF Shah ◽  
REVANTH KUMAR bathina ◽  
ASHISH KULKARNI

Energies ◽  
2019 ◽  
Vol 12 (3) ◽  
pp. 525 ◽  
Author(s):  
Edwin R. Grijalva ◽  
José María López Martínez

The emissions of CO2 gas caused by transport in urban areas are increasingly serious, and the public transport sector plays a vital role in society, especially when considering the increased demands for mobility. New energy technologies in urban mobility are being introduced, as evidenced by the electric vehicle. We evaluated the positive environmental effects in terms of CO2 emissions that would be produced by the replacement of conventional urban transport bus fleets by electric buses. The simulation of an electric urban bus conceptual model is presented as a case study. The model is validated using the speed and height profiles of the most representative route within the city of Madrid—the C1 line. We assumed that the vehicle fleet is charged using the electric grid at night, when energy demand is low, the cost of energy is low, and energy is produced with a large provision of renewable energy, principally wind power. For the results, we considered the percentage of fleet replacement and the Spanish electricity mix. The analysis shows that by gradually replacing the current fleet of buses by electric buses over 10 years (2020 to 2030), CO2 emissions would be reduced by up to 92.6% compared to 2018 levels.


Energies ◽  
2021 ◽  
Vol 14 (19) ◽  
pp. 6195
Author(s):  
Barouch Giechaskiel ◽  
Dimitrios Komnos ◽  
Georgios Fontaras

The EU aims to substantially reduce its greenhouse gas emissions in the following decades and achieve climate neutrality by 2050. Better CO2 estimates, particularly in urban conditions, are necessary for assessing the effectiveness of various regional policy strategies. In this study, we measured the CO2 emissions of a Euro 6d-temp gasoline direct injection (GDI) vehicle with a three-way catalyst (TWC) and a gasoline particulate filter (GPF) at ambient temperatures from −30 °C up to 50 °C with the air-conditioning on. The tests took place both on the road and in the laboratory, over cycles simulating congested urban traffic, dynamic driving, and uphill driving towing a trailer at 85% of the maximum payloads of both the car and the trailer. The CO2 values varied over a wide range depending on the temperature and driving conditions. Vehicle simulation was used to quantify the effect of ambient temperature, vehicle weight and road grade on the CO2 emissions. The results showed that vehicle energy demand was significantly increased under the test conditions. In urban trips, compared to the baseline at 23 °C, the CO2 emissions were 9–20% higher at −10 °C, 30–44% higher at −30 °C, and 37–43% higher at 50 °C. Uphill driving with a trailer had 2–3 times higher CO2 emissions. In motorway trips at 50 °C, CO2 emissions increased by 13–19%. The results of this study can help in better quantification of CO2 and fuel consumption under extreme conditions. Additional analysis on the occurrence of such conditions in real-world operation is advisable.


Energies ◽  
2021 ◽  
Vol 14 (6) ◽  
pp. 1631
Author(s):  
Kazimierz Lejda ◽  
Artur Jaworski ◽  
Maksymilian Mądziel ◽  
Krzysztof Balawender ◽  
Adam Ustrzycki ◽  
...  

The problem of global warming and the related climate change requires solutions to reduce greenhouse gas emissions, in particular CO2. As a result, newly manufactured cars consume less fuel and emit lower amounts of CO2. In terms of exhaust emissions and fuel consumption, old cars are significantly inferior to the more recent models. In Poland, for instance, the average age of passenger cars is approximately 13 years. Therefore, apart from developing new solutions in the cars produced today, it is important to focus on measures that enable the reduction in CO2 emissions in older vehicles. These methods include the adaptation of used cars to run on gaseous fuels. Natural gas is a hydrocarbon fuel that is particularly preferred in terms of CO2 emissions. The article presents the results of research of carbon oxides emission (CO, CO2) in the exhaust gas of a passenger car fueled by petrol and natural gas. The emissions were measured under the conditions of the New European Driving Cycle (NEDC) test and in real road tests. The test results confirm that compared to petrol, a CNG vehicle allows for a significant reduction in CO2 and CO emissions in a car that is several years old, especially in urban traffic conditions.


Energies ◽  
2019 ◽  
Vol 12 (16) ◽  
pp. 3168 ◽  
Author(s):  
Erahman ◽  
Reyseliani ◽  
Purwanto ◽  
Sudibandriyo

The high energy demand and CO2 emissions in the road transport sector in Indonesia are mainly caused by the use of passenger cars. This situation is predicted to continue due to the increase in car ownership. Scenarios are arranged to examine the potential reductions in energy demand and CO2 emissions in comparison with the business as usual (BAU) condition between 2016 and 2050 by controlling car intensity (fuel economy) and activity (vehicle-km). The intensity is controlled through the introduction of new car technologies, while the activity is controlled through the enactment of fuel taxes. This study aims to analyze the energy demand and CO2 emissions of passenger cars in Indonesia not only for a period in the past (2010–2015) but also based on projections through to 2050, by employing a provincially disaggregated bottom-up model. The provincially disaggregated model shows more accurate estimations for passenger car energy demands. The results suggest that energy demand and CO2 emissions in 2050 will be 50 million liter gasoline equivalent (LGE) and 110 million tons of CO2, respectively. The five provinces with the highest CO2 emissions in 2050 are projected to be West Java, Banten, East Java, Central Java, and South Sulawesi. The projected analysis for 2050 shows that new car technology and fuel tax scenarios can reduce energy demand from the BAU condition by 7.72% and 3.18% and CO2 emissions by 15.96% and 3.18%, respectively.


2021 ◽  
Vol 13 (4) ◽  
pp. 2225
Author(s):  
Ralf Peters ◽  
Janos Lucian Breuer ◽  
Maximilian Decker ◽  
Thomas Grube ◽  
Martin Robinius ◽  
...  

Achieving the CO2 reduction targets for 2050 requires extensive measures being undertaken in all sectors. In contrast to energy generation, the transport sector has not yet been able to achieve a substantive reduction in CO2 emissions. Measures for the ever more pressing reduction in CO2 emissions from transportation include the increased use of electric vehicles powered by batteries or fuel cells. The use of fuel cells requires the production of hydrogen and the establishment of a corresponding hydrogen production system and associated infrastructure. Synthetic fuels made using carbon dioxide and sustainably-produced hydrogen can be used in the existing infrastructure and will reach the extant vehicle fleet in the medium term. All three options require a major expansion of the generation capacities for renewable electricity. Moreover, various options for road freight transport with light duty vehicles (LDVs) and heavy duty vehicles (HDVs) are analyzed and compared. In addition to efficiency throughout the entire value chain, well-to-wheel efficiency and also other aspects play an important role in this comparison. These include: (a) the possibility of large-scale energy storage in the sense of so-called ‘sector coupling’, which is offered only by hydrogen and synthetic energy sources; (b) the use of the existing fueling station infrastructure and the applicability of the new technology on the existing fleet; (c) fulfilling the power and range requirements of the long-distance road transport.


2021 ◽  
Vol 5 (1) ◽  
pp. 25
Author(s):  
Souhir Abbes

In this paper, we use the Logarithmic Mean Divisia Index (LMDI) to apply decomposition analysis on Carbon Dioxide (CO2) emissions from transport systems in seven Eastern European countries over the period between 2005 and 2015. The results show that “economic activity” is the main factor responsible for CO2 emissions in all the countries in our sample. The second factor causing increase in CO2 emissions is the “fuel mix” by type and mode of transport. Modal share and energy intensity affect the growth of CO2 emissions but in a less significant way. Finally, only the “population” and “emission coefficient” variables slowed the growth of these emissions in all the countries, except for Slovenia, where the population variable was found to be responsible for the increase in CO2 emissions. These results not only contribute to advancing the existing literature but also provide important policy recommendations.


Sign in / Sign up

Export Citation Format

Share Document