scholarly journals Cadmium Removal from Giant Squid (Dosidicus gigas) Hydrolysate in Fixed-Bed Columns Packed with Iminodiacetic Resin: Tools for Scaling up the Process

2021 ◽  
Vol 19 (1) ◽  
pp. 442
Author(s):  
Carolina Calderón ◽  
Marcela Levío-Raimán ◽  
M. Cristina Diez
Keyword(s):  
Metal Removal ◽  
Cadmium Concentration ◽  
Fixed Bed ◽  
Breakthrough Curves ◽  
P Value ◽  
Total Efficiency ◽  
Dosidicus Gigas ◽  
Cadmium Removal ◽  
Fixed Bed Column ◽  
Giant Squid

Giant squid hydrolysate (GSH) elaborated from different batches from a fishing company was evaluated for cadmium removal. Fixed-bed column packed with iminodiacetic resin as adsorbent was used. GSH solution at different cadmium concentrations were fed in the fixed-bed column and breakthrough curves were evaluated. A high degree of metal removal from the solution was achieved and the saturation point (Ce/C0 ≤ 0.8) was achieved more quickly at higher concentrations of cadmium. The maximum capacity of adsorption (q0) was obtained using the Thomas model, where 1137.4, 860.4, 557.4, and 203.1 mg g−1 were achieved using GSH with concentrations of 48.37, 20.97, 12.13, and 3.26 mg L−1, respectively. Five cycles of desorption of the resin with HCl (1 M) backflow and regeneration with NaOH (0.5 M) were also evaluated, where no significant differences (p-value > 0.05) were observed between each cycle, with an average of 935.9 mg g−1 of qmax. The in-series columns evaluated reached a total efficiency of 90% on average after the third column in GSH with a cadmium concentration of 20.97 mg L−1. This kind of configuration should be considered the best alternative for cadmium removal from GSH. Additionally, the chemical composition of GSH, which was considered a quality parameter, was not affected by cadmium adsorption.

Biochar caged zirconium ferrite nanocomposites for the adsorptive removal of Reactive Blue 19 dye in a batch and column reactors and conditions optimizaton

2021 ◽  
Vol 0 (0) ◽  
Author(s):  
Shazia Perveen ◽  
Raziya Nadeem ◽  
Shaukat Ali ◽  
Yasir Jamil
Keyword(s):  
Experimental Data ◽  
Low Dose ◽  
Fixed Bed ◽  
Breakthrough Curves ◽  
Adsorption Efficiency ◽  
Fixed Bed Column ◽  
Flow Rates ◽  
Adsorptive Removal ◽  
Reactive Blue 19 ◽  
Pseudo Second Order

Abstract Biochar caged zirconium ferrite (BC-ZrFe2O5) nanocomposites were fabricated and their adsorption capacity for Reactive Blue 19 (RB19) dye was evaluated in a fixed-bed column and batch sorption mode. The adsorption of dye onto BC-ZrFe2O5 NCs followed pseudo-second-order kinetics (R 2 = 0.998) and among isotherms, the experimental data was best fitted to Sips model as compared to Freundlich and Langmuir isotherms models. The influence of flow-rate (3–5 mL min−1), inlet RB19 dye concentration (20–100 mg L−1) and quantity of BC-ZrFe2O5 NCs (0.5–1.5 g) on fixed-bed sorption was elucidated by Box-Behnken experimental design. The saturation times (C t /C o  = 0.95) and breakthrough (C t /C o  = 0.05) were higher at lower flow-rates and higher dose of BC-ZrFe2O5 NCs. The saturation times decreased, but breakthrough was increased with the initial RB19 dye concentration. The treated volume was higher at low sorbent dose and influent concentration. Fractional bed utilization (FBU) increased with RB19 dye concentration and flow rates at low dose of BC-ZrFe2O5 NCs. Yan model was fitted best to breakthrough curves data as compared to Bohart-Adams and Thomas models. Results revealed that BC-ZrFe2O5 nanocomposite has promising adsorption efficiency and could be used for the adsorption of dyes from textile effluents.

Adsorption of Methylene Blue from Solution by Natural Zeolite in Fixed-Bed Column: Effect of Bed Depth

2012 ◽  
Vol 518-523 ◽  
pp. 3115-3119
Author(s):  
Yan Qiang Li ◽  
Xiao Feng Ren ◽  
Shao Hua Chen ◽  
Xiu Rong Zhao ◽  
Run Ping Han
Keyword(s):  
Methylene Blue ◽  
Natural Zeolite ◽  
Fixed Bed ◽  
Breakthrough Curves ◽  
Form Solution ◽  
Column Height ◽  
Nonlinear Regression Analysis ◽  
Adsorption Ability ◽  
Fixed Bed Column ◽  
Linear And Nonlinear

The effect of bed depth on adsorption ability of natural zeolite to removal methylene blue (MB) from aqueous solution in the fixed-bed column was studied. The results showed that the increase in column height favored the MB removal form solution. The equilibrium uptake of MB onto unit mass zeolite increased with the bed depth growth. The experimental data were fitted to Yan model using linear and nonlinear regression analysis, respectively. The experimental points and the predicted curves using the Yan model were compared and the error analysis was performed. The results indicated that Yan model were good to predict the breakthrough curves and both two methods can be used to obtain the parameters of Yan model and to predict the breakthrough curves.

Fixed-Bed Adsorption Column Studies for the Removal of Methyl Orange from Water Using Polyethyleneimine-Graphene Oxide Polymer Nanocomposite Beads

2021 ◽  
Vol 891 ◽  
pp. 31-36
Author(s):  
Jirah Emmanuel T. Nolasco ◽  
Camille Margaret S. Alvarillo ◽  
Joshua L. Chua ◽  
Ysabel Marie C. Gonzales ◽  
Jem Valerie D. Perez
Keyword(s):  
Graphene Oxide ◽  
Methyl Orange ◽  
Large Scale ◽  
Scale Up ◽  
Fixed Bed ◽  
Breakthrough Curves ◽  
Design Parameters ◽  
Column Studies ◽  
Fixed Bed Column ◽  
Adsorption Column

Continuous fixed-bed column studies were performed using nanocomposite beads made up of chitosan, polyethyleneimine, and graphene oxide as adsorbents for the removal of methyl orange (MO) in water. The effects of different operating parameters such as initial MO concentration (5, 10, and 15 ppm), bed height (10, 17.5, and 25 cm), and flow rate (27, 43, and 58 mL/min) were investigated using an upward-flow fixed-bed column set-up. The breakthrough curves generated were fitted with Adams-Bohart, Thomas, Yoon-Nelson, and Yan et al. models. The results showed that Yan et al. model agreed best with the breakthrough curves having an R2 as high as 0.9917. Lastly, design parameters for a large-scale adsorption column were determined via scale-up approach using the parameters obtained from column runs.

scholarly journals Sorption of Ag+ and Cu2+ by Vermiculite in a Fixed-Bed Column: Design, Process Optimization and Dynamics Investigations

2018 ◽  
Vol 8 (11) ◽  
pp. 2221 ◽  
Author(s):  
Olga Długosz ◽  
Marcin Banach
Keyword(s):  
Flow Rate ◽  
Continuous Process ◽  
Fixed Bed ◽  
Copper Ion ◽  
Cost Effective ◽  
Breakthrough Curves ◽  
Fixed Bed Column ◽  
Column System ◽  
Total Percentage ◽  
Bed Height

Vermiculite has been used for the removal of Cu 2 + and Ag + from aqueous solutions in a fixed-bed column system. The effects of initial silver and copper ion concentrations, flow rate, and bed height of the adsorbent in a fixed-bed column system were investigated. Statistical analysis confirmed that breakthrough curves depended on all three factors. The highest inlet metal cation concentration (5000 mg/dm3), the lowest bed height (3 cm) and the lowest flow rate (2 and 3 cm3/min for Ag + and Cu 2 + , respectively) were optimal for the adsorption process. The maximum total percentage of metal ions removed was 60.4% and 68.7% for Ag+ and Cu2+, respectively. Adsorption data were fitted with four fixed-bed adsorption models, namely Clark, Bohart–Adams, Yoon–Nelson and Thomas models, to predict breakthrough curves and to determine the characteristic column parameters. The adsorbent was characterized by SEM, FTIR, EDS and BET techniques. The results showed that vermiculite could be applied as a cost-effective sorbent for the removal of Cu 2 + and Ag + from wastewater in a continuous process.

scholarly journals Mathematical modeling and experimental breakthrough curves of cephalosporin C adsorption in a fixed-bed column

2011 ◽  
Vol 46 (6) ◽  
pp. 1270-1277 ◽  
Author(s):  
Carlos André V. Burkert ◽  
Geraldo N.O. Barbosa ◽  
Marcio A. Mazutti ◽  
Francisco Maugeri
Keyword(s):  
Mathematical Modeling ◽  
Fixed Bed ◽  
Breakthrough Curves ◽  
Cephalosporin C ◽  
Fixed Bed Column

scholarly journals Iron Oxide-Coated Gravel Fixed Bed Column Study Performance to Remove Mixed Metals from Landfill Leachate

2019 ◽  
Vol 122 ◽  
pp. 01002 ◽  
Author(s):  
Ibrahim Yildiz ◽  
Banu Sizirici
Keyword(s):  
Iron Oxide ◽  
Fixed Bed ◽  
Breakthrough Curves ◽  
Fixed Bed Column ◽  
Desorption Process ◽  
Column Study ◽  
Regeneration Capability ◽  
Synthetic Leachate ◽  
Adsorption Desorption ◽  
Study Performance

Iron oxide-coated gravel as an adsorbent was employed in continuous fixed bed column study to remove Fe(II), Ni(II), and Zn(II) simultaneously in synthetic leachate samples. Experimental and modeled adsorption capacities derived from the breakthrough curves showed the adsorption capacity order of Zn(II)>Fe(II)> Ni(II). Iron oxide-coated gravel column removed 58.24% of Zn(II), 47.71% of Fe(II), and 39.45% of Ni(II). Desorption process was studied in order to test the regeneration capability of iron oxidecoated gravel. It was seen that 99.64 % of Ni(II), 99.54% of Fe(II) and 6.75% of Zn (II) were recovered through the first cycle of adsorption/desorption. In the second cycle, the recovery rates dropped to 81.4% for Ni(II), 80% for Fe(II) and 4% for Zn(II). Based on these results, iron oxide coated gravel has potential to remove mixed metal ions simultaneously in aqueous solutions.

scholarly journals Magnetic Fe3O4@Chitosan Carbon Microbeads: Removal of Doxycycline from Aqueous Solutions through a Fixed Bed via Sequential Adsorption and Heterogeneous Fenton-Like Regeneration

2018 ◽  
Vol 2018 ◽  
pp. 1-14 ◽  
Author(s):  
Bo Bai ◽  
Xiaohui Xu ◽  
Changchuan Li ◽  
Jianyu Xing ◽  
Honglun Wang ◽  
...  
Keyword(s):  
Aqueous Solutions ◽  
High Efficiency ◽  
Low Cost ◽  
Fixed Bed ◽  
Breakthrough Curves ◽  
Chitosan Hydrogel ◽  
Fixed Bed Column ◽  
Adsorptive Removal ◽  
Sequential Adsorption ◽  
Cracking Process

The adsorptive removal of antibiotics from aqueous solutions is recognized as the most suitable approach due to its easy operation, low cost, nontoxic properties, and high efficiency. However, the conventional regeneration of saturated adsorbents is an expensive and time-consuming process in practical wastewater treatment. Herein, a scalable adsorbent of magnetic Fe3O4@chitosan carbon microbeads (MCM) was successfully prepared by embedding Fe3O4 nanoparticles into chitosan hydrogel via an alkali gelation-thermal cracking process. The application of MCM composites for the adsorptive removal of doxycycline (DC) was evaluated using a fixed-bed column. The results showed that pH, initial concentration, flow rate, and bed depth are found to be important factors to control the adsorption capacity of DC. The Thomas and Yoon-Nelson models showed a good agreement with the experimental data and could be applied for the prediction of the fixed-bed column properties and breakthrough curves. More importantly, the saturated fixed bed can be easily recycled by H2O2 which shows excellent reusability for the removal of doxycycline. Thus, the combination of the adsorption advantage of chitosan carbon with catalytic properties of magnetic Fe3O4 nanoparticles might provide a new tool for addressing water treatment challenges.

Sign in / Sign up

Export Citation Format

Share Document