scholarly journals Development of a Mating Disruption Program for a Mealybug, Planococcus ficus, in Vineyards

Insects ◽  
2020 ◽  
Vol 11 (9) ◽  
pp. 635 ◽  
Author(s):  
Kent M. Daane ◽  
Glenn Y. Yokota ◽  
Vaughn M. Walton ◽  
Brian N. Hogg ◽  
Monica L. Cooper ◽  
...  

The vine mealybug (VMB), Planococcus ficus (Hemiptera: Pseudococcidae), is a key insect pest of vineyards, and improvements in sustainable control of this pest are needed to meet increasing consumer demand for organically farmed products. One promising option is mating disruption. In a series of experiments conducted from 2004 to 2007, we tested the effects of mating disruption on trap captures of Pl. ficus males in pheromone-baited traps, on Pl. ficus numbers and age structure on vines, and on damage to grape clusters. From 2004 to 2005, the effects of dispenser load (mg active ingredient per dispenser) were also assessed, and dispensers were compared to a flowable formulation. Across all trials, mating disruption consistently reduced pheromone trap captures and often reduced mealybug numbers on vines and/or crop damage, regardless of the pheromone dose that was applied. Reductions in Pl. ficus densities in mating disruption plots were not accompanied by clear effects on mealybug population age structure; however, production of non-viable ovisacs by unmated females may have obscured differences in proportional representation of ovisacs. Pheromone trap captures were never lowered to zero (often called trap shut down), possibly because trials were conducted in vineyards with unusually high Pl. ficus densities. Trap-capture patterns in both treated and control plots commonly began low in April–May, increased in mid-July or August, and often decreased in September–October when post-harvest insecticides were applied. During the four-year trial, the release rate from plastic sachet dispensers was improved by industry cooperators as pheromone was released too quickly (2004) or not completely released during the season (2005–2006). The flowable formulation performed slightly better than dispensers at the same application dose. Results over all years suggest season-long coverage or late-season coverage may be as or more important than dose per hectare. Development of a dispenser with optimized season-long pheromone emission or targeted seasonal periods should be a future goal.

1999 ◽  
Vol 89 (4) ◽  
pp. 339-345 ◽  
Author(s):  
M. Kehat ◽  
L. Anshelevich ◽  
D. Gordon ◽  
M. Harel ◽  
L. Zilberg ◽  
...  

AbstractThe effect of density of the Shin-Etsu twist-tie rope pheromone formulation (PBW rope L®) on mating of female pink bollworm, Pectinophora gossypiella(Saunders) was tested in Israel. The success of mating disruption was evaluated during 1997 by the mating table technique, comparing the percentage of mating of virgin sentinel females in pheromone-treated and control plots. Under low pest population pressure application of ‘long-life’ formulation of P. gossypiellapheromone, PBW rope L®, spaced 9 m, 11 m and 14 m apart, resulted in very high suppression of mating (96.5–100%) and complete shut-down of pheromone trap catch. These application rates were much lower than those now prevailing in Israel and elsewhere. Spacing of ropes 20 m apart resulted in less effective mating disruption of 65% only, and shut-down of pheromone traps was also incomplete. The tests during 1998 were carried out at high pest population and efficacy of treatments was assessed by the reduction of male capture in traps in pheromone-treated plots relative to catches in the control. The distance between pheromone sources proved to be the most critical factor determining success. In both years, any spacing significantly greater than 10 m gave markedly less than complete trap catch shutdown/mating suppression. Pheromone dosages and population density were also important in determining mating success. Results obtained in this study indicate the possibility of reducing the number of pheromone sources per unit area and the total amount of pheromone as compared with that in use today, only at very low pest populations. However at high population levels, dispensers closely-spaced, with increased dosages of pheromone, are required.


Author(s):  
Svitlana Lobchenko ◽  
Tetiana Husar ◽  
Viktor Lobchenko

The results of studies of the viability of spermatozoa with different incubation time at different concentrations and using different diluents are highlighted in the article. (Un) concentrated spermatozoa were diluented: 1) with their native plasma; 2) medium 199; 3) a mixture of equal volumes of plasma and medium 199. The experiment was designed to generate experimental samples with spermatozoa concentrations prepared according to the method, namely: 0.2; 0.1; 0.05; 0.025 billion / ml. The sperm was evaluated after 2, 4, 6 and 8 hours. The perspective of such a study is significant and makes it possible to research various aspects of the subject in a wide range. In this regard, a series of experiments were conducted in this area. The data obtained are statistically processed and allow us to highlight the results that relate to each stage of the study. In particular, in this article it was found out some regularities between the viability of sperm, the type of diluent and the rate of rarefaction, as evidenced by the data presented in the tables. As a result of sperm incubation, the viability of spermatozoa remains at least the highest trend when sperm are diluted to a concentration of 0.1 billion / ml, regardless of the type of diluent used. To maintain the viability of sperm using this concentration of medium 199 is not better than its native plasma, and its mixture with an equal volume of plasma through any length of time incubation of such sperm. Most often it is at this concentration of sperm that their viability is characterized by the lowest coefficient of variation, regardless of the type of diluent used, which may indicate the greatest stability of the result under these conditions. The viability of spermatozoa with a concentration of 0.1 billion / ml is statistically significantly reduced only after 6 or even 8 hours of incubation. If the sperm are incubated for only 2 hours, regardless of the type of diluent used, the sperm concentrations tested do not affect the viability of the sperm. Key words: boar, spermatozoa, sperm plasma, concentration, incubation, medium 199, activity, viability, rarefaction.


Insects ◽  
2021 ◽  
Vol 12 (4) ◽  
pp. 343
Author(s):  
Carolina Ballesteros ◽  
Alda Romero ◽  
María Colomba Castro ◽  
Sofía Miranda ◽  
Jan Bergmann ◽  
...  

Pseudococcus calceolariae, the citrophilous mealybug, is a species of economic importance. Mating disruption (MD) is a potential control tool. During 2017–2020, trials were conducted to evaluate the potential of P. calceolariae MD in an apple and a tangerine orchard. Two pheromone doses, 6.32 g/ha (2017–2018) and 9.45 g/ha (2019–2020), were tested. The intermediate season (2018–2019) was evaluated without pheromone renewal to study the persistence of the pheromone effect. Male captures in pheromone traps, mealybug population/plant, percentage of infested fruit at harvest and mating disruption index (MDI) were recorded regularly. In both orchards, in the first season, male captures were significantly lower in MD plots compared to control plots, with an MDI > 94% in the first month after pheromone deployment. During the second season, significantly lower male captures in MD plots were still observed, with an average MDI of 80%. At the third season, male captures were again significant lower in MD than control plots shortly after pheromone applications. In both orchards, population by visual inspection and infested fruits were very low, without differences between MD and control plots. These results show the potential use of mating disruption for the control of P. calceolariae.


2021 ◽  
Vol 10 (8) ◽  
pp. 525
Author(s):  
Wenmin Yao ◽  
Tong Chu ◽  
Wenlong Tang ◽  
Jingyu Wang ◽  
Xin Cao ◽  
...  

As one of China′s most precious cultural relics, the excavation and protection of the Terracotta Warriors pose significant challenges to archaeologists. A fairly common situation in the excavation is that the Terracotta Warriors are mostly found in the form of fragments, and manual reassembly among numerous fragments is laborious and time-consuming. This work presents a fracture-surface-based reassembling method, which is composed of SiamesePointNet, principal component analysis (PCA), and deep closest point (DCP), and is named SPPD. Firstly, SiamesePointNet is proposed to determine whether a pair of point clouds of 3D Terracotta Warrior fragments can be reassembled. Then, a coarse-to-fine registration method based on PCA and DCP is proposed to register the two fragments into a reassembled one. The above two steps iterate until the termination condition is met. A series of experiments on real-world examples are conducted, and the results demonstrate that the proposed method performs better than the conventional reassembling methods. We hope this work can provide a valuable tool for the virtual restoration of three-dimension cultural heritage artifacts.


2001 ◽  
Vol 10 (3) ◽  
pp. 312-330 ◽  
Author(s):  
Bernard Harper ◽  
Richard Latto

Stereo scene capture and generation is an important facet of presence research in that stereoscopic images have been linked to naturalness as a component of reported presence. Three-dimensional images can be captured and presented in many ways, but it is rare that the most simple and “natural” method is used: full orthostereoscopic image capture and projection. This technique mimics as closely as possible the geometry of the human visual system and uses convergent axis stereography with the cameras separated by the human interocular distance. It simulates human viewing angles, magnification, and convergences so that the point of zero disparity in the captured scene is reproduced without disparity in the display. In a series of experiments, we have used this technique to investigate body image distortion in photographic images. Three psychophysical experiments compared size, weight, or shape estimations (perceived waist-hip ratio) in 2-D and 3-D images for the human form and real or virtual abstract shapes. In all cases, there was a relative slimming effect of binocular disparity. A well-known photographic distortion is the perspective flattening effect of telephoto lenses. A fourth psychophysical experiment using photographic portraits taken at different distances found a fattening effect with telephoto lenses and a slimming effect with wide-angle lenses. We conclude that, where possible, photographic inputs to the visual system should allow it to generate the cyclopean point of view by which we normally see the world. This is best achieved by viewing images made with full orthostereoscopic capture and display geometry. The technique can result in more-accurate estimations of object shape or size and control of ocular suppression. These are assets that have particular utility in the generation of realistic virtual environments.


1987 ◽  
Vol 41 (2) ◽  
pp. 200-207 ◽  
Author(s):  
Vahid Majidi ◽  
David M. Coleman

A series of experiments, designed to help characterize the behavior of an analytical spark discharge in an external pulsed magnetic field, is described. Results include controlled formation and deformation of a spark's post-discharge torus utilizing different magnetic field configurations. One manifestation of this research was discovery of a new filamentary structure which extends from the spark conducting channel to the magnet pole face(s). These features were investigated via their refracted light (Schlieren) and spectroscopic (time/space/wavelength-resolved) properties. Practical ramifications of this control are discussed.


2018 ◽  
Vol 8 (8) ◽  
pp. 1317
Author(s):  
Adam Card ◽  
Mohammad Mokim ◽  
Feruz Ganikhanov

We demonstrate and analyze a series of experiments in traditional and soft condensed matter using coherent optical spectroscopy and microscopy with ultrafast time resolution. We show the capabilities of resolving both real and imaginary parts of the third-order nonlinearity in the vicinity of Raman resonances from a medium probed within microscopic volumes with an equivalent spectral resolution of better than 0.1 cm−1. We can differentiate between vibrations of various types within unit cells of crystals, as well as perform targeted probes of areas within biological tissue. Vibrations within the TiO6 octahedron and the ones for the Ti-O-P intergroup were studied in potassium titanyl phosphate crystal to reveal a multiline structure within targeted phonon modes with closely spaced vibrations having distinctly different damping rates (~0.5 ps−1 versus ~1.1 ps−1). We also detected a 1.7–2.6 ps−1 decay of C-C stretching vibrations in fat tissue and compared that with the corresponding vibration in oil.


2013 ◽  
Vol 2013 ◽  
pp. 1-19
Author(s):  
Wai-Yuan Tan ◽  
Hong Zhou

To incorporate biologically observed epidemics into multistage models of carcinogenesis, in this paper we have developed new stochastic models for human cancers. We have further incorporated genetic segregation of cancer genes into these models to derive generalized mixture models for cancer incidence. Based on these models we have developed a generalized Bayesian approach to estimate the parameters and to predict cancer incidence via Gibbs sampling procedures. We have applied these models to fit and analyze the SEER data of human eye cancers from NCI/NIH. Our results indicate that the models not only provide a logical avenue to incorporate biological information but also fit the data much better than other models. These models would not only provide more insights into human cancers but also would provide useful guidance for its prevention and control and for prediction of future cancer cases.


1993 ◽  
Vol 115 (3) ◽  
pp. 347-351 ◽  
Author(s):  
T. Katoh ◽  
E. Urata

This paper deals with an automatic curing process for out-of-straightness of terminal ends of seamless pipes. The developed curing process is composed of a measuring stage and a controlling stage. In the measuring stage, the out-of-straightness pattern of each pipe is measured automatically, then reference pressure points and press strokes are determined to minimize the sum of squares of deflection angles. In the controlling stage, elastic springback of the pipe is predicted by an observer using the calculated press stroke, on-line measured values of reactive force, and deflection of the pipe. Through a series of experiments, the validity of the proposed process was verified.


Sign in / Sign up

Export Citation Format

Share Document