scholarly journals Thermodynamic Performance Analysis of Solar Based Organic Rankine Cycle Coupled with Thermal Storage for a Semi-Arid Climate

Machines ◽  
2021 ◽  
Vol 9 (5) ◽  
pp. 88
Author(s):  
Nasser Mohammed A. Almefreji ◽  
Babras Khan ◽  
Man-Hoe Kim
Keyword(s):  
Performance Analysis ◽  
Solar Radiation ◽  
Power Output ◽  
Thermal Efficiency ◽  
Organic Rankine Cycle ◽  
Rankine Cycle ◽  
Thermal Storage ◽  
Moderate Temperature ◽  
Thermodynamic Performance ◽  
Net Power Output

This study focuses on the thermodynamic performance analysis of the solar organic Rankine cycle (SORC) that uses solar radiation over a moderate temperature range. A compound parabolic collector (CPC) was adjusted to collect solar radiation because of its long-lasting nature and featured low concentration ratios, which are favorable for moderate temperature applications. A thermal storage tank was fixed to preserve the solar energy and ensure the system’s continuous performance during unfavorable weather. However, water was used as the heat transfer fluid and R245fa was used as the working fluid in this system. The performance in both the hottest and coldest months was analyzed using the average hourly profile in MATLAB using weather data from Riyadh, Saudi Arabia. Variations in the tank temperature during the charging and discharging modes were found. The hourly based thermal efficiency and net power output for both configurations were also compared. The results show that at 17:00, when the cycle was about to shut down, the thermal efficiency was 12.79% and the network output was 16 kW in July, whereas in January, the efficiency was ~12.80% and the net power output was 15.54 kW.

Performance Investigation of Solar Organic Rankine Cycle System With Zeotropic Working Fluid Mixtures for Use in Micro-Cogeneration

2021 ◽  
Vol 143 (9) ◽  
Author(s):  
Wahiba Yaïci ◽  
Evgueniy Entchev ◽  
Pouyan Talebizadehsardari ◽  
Michela Longo
Keyword(s):  
Low Temperature ◽  
Power Output ◽  
Organic Rankine Cycle ◽  
Rankine Cycle ◽  
Working Fluid ◽  
Condensation Temperature ◽  
Source Temperature ◽  
Thermodynamic Performance ◽  
Net Power Output ◽  
Cycle Efficiency

Abstract Overall, there are numerous sustainable sources of renewable, low-temperature heat, principally solar energy, geothermal energy, and energy produced from industrial wastes. Extended utilization of these low-temperature alternatives has a certain capacity of decreasing fossil fuel use with its associated very hazardous greenhouse gas emissions. Researchers have commonly recognized the organic Rankine cycle (ORC) as a feasible and suitable system to produce electrical power from renewable sources based on its advantageous use of volatile organic fluids as working fluids (WFs). Researchers have similarly shown an affinity to the exploitation of zeotropic mixtures as ORC WFs due to their capability to enhance the thermodynamic performance of ORC systems, an achievement supported by improved fits of the temperature profiles of the WF and the heat source/sink. This paper determines both the technical feasibility and the benefits of using zeotropic mixtures as WFs by means of a simulation study of an ORC system. This study analyzes the thermodynamic performance of ORC systems using zeotropic WF mixtures to produce electricity driven by low-temperature solar heat sources for use in buildings. A thermodynamic model is created with an ORC system with and without a regenerator. Five zeotropic mixtures with diverse compositions between 0 and 1 in 0.2 increments of R245fa/propane, R245fa/hexane, R245fa/heptane, pentane/hexane, and isopentane/hexane are assessed and compared with identify the best blends of mixtures that are able to produce superior efficiency in their system cycles. Results disclosed that R245fa/propane (0.4/0.6) with regenerator produces the highest net power output of 7.9 kW and cycle efficiency of 9.4% at the operating condition with a hot source temperature of 85 °C. The study also investigates the effects of the volume flow ratio, and evaporation and condensation temperature glide on the ORC’s thermodynamic performance. Following a thorough analysis of each mixture, R245fa/propane is chosen for a parametric study to examine the effects of operating factors on the system’s efficiency and sustainability index. It was found that the highest cycle efficiency and highest second law cycle efficiency of around 10.5% and 84.0%, respectively, were attained with a mass composition of 0.6/0.4 at the hot source temperature of 95 °C and cold source temperature of 20 °C with a net power output of 9.6 kW. Moreover, results revealed that for zeotropic mixtures, there is an optimal composition range within which binary mixtures are tending to work more efficiently than the component pure fluids. In addition, a significant increase in cycle efficiency can be achieved with a regenerative ORC, with cycle efficiency in the range 3.1–9.8% versus 8.6–17.4% for ORC both without and with regeneration, respectively. In conclusion, utilizing zeotropic mixtures may well expand the restriction faced in choosing WFs for solar-powered ORC-based micro-combined heat and power (CHP) systems.

scholarly journals Comparison of single and double stage regenerative organic rankine cycle for medium grade heat source through energy and exergy estimation

2019 ◽  
Vol 8 (2) ◽  
pp. 141 ◽  
Author(s):  
Ghalya Pikra ◽  
Nur Rohmah
Keyword(s):  
Heat Source ◽  
Flow Rate ◽  
Power Output ◽  
Thermal Efficiency ◽  
Organic Rankine Cycle ◽  
Rankine Cycle ◽  
Exergy Efficiency ◽  
Working Fluid ◽  
Energy And Exergy ◽  
Net Power Output

Regenerative organic Rankine cycle (RORC) can be used to improve organic Rankine cycle (ORC) performance. This paper presents a comparison of a single (SSRORC) and double stage regenerative organic Rankine cycle (DSRORC) using a medium grade heat source. Performance for each system is estimated using the law of thermodynamics I and II through energy and exergy balance. Solar thermal is used as the heat source using therminol 55 as a working fluid, and R141b is used as the organic working fluid. The initial data for the analysis are heat source with 200°C of temperature, and 100 L/min of volume flow rate. Analysis begins by calculating energy input to determine organic working fluid mass flow rate, and continued by calculating energy loss, turbine power and pump power consumption to determine net power output and thermal efficiency. Exergy analysis begins by calculating exergy input to determine exergy efficiency. Exergy loss, exergy destruction at the turbine, pump and feed heater is calculated to complete the calculation. Energy estimation result shows that DSRORC determines better net power output and thermal efficiency for 7.9% than SSRORC, as well as exergy estimation, DSRORC determines higher exergy efficiency for 7.69%. ©2019. CBIORE-IJRED. All rights reserved

Waste Heat Recovery in a Cruise Vessel in the Baltic Sea by Using an Organic Rankine Cycle: A Case Study

2015 ◽  
Author(s):  
Fredrik Ahlgren ◽  
Maria E. Mondejar ◽  
Magnus Genrup ◽  
Marcus Thern
Keyword(s):  
Power Output ◽  
Heat Recovery ◽  
Waste Heat Recovery ◽  
Waste Heat ◽  
Organic Rankine Cycle ◽  
Rankine Cycle ◽  
Operating Conditions ◽  
Maritime Transportation ◽  
Working Fluid ◽  
Net Power Output

Maritime transportation is a significant contributor to SOx, NOx and particle matter emissions, even though it has a quite low CO2 impact. New regulations are being enforced in special areas that limit the amount of emissions from the ships. This fact, together with the high fuel prices, is driving the marine industry towards the improvement of the energy efficiency of current ship engines and the reduction of their energy demand. Although more sophisticated and complex engine designs can improve significantly the efficiency of the energy systems in ships, waste heat recovery arises as the most influent technique for the reduction of the energy consumption. In this sense, it is estimated that around 50% of the total energy from the fuel consumed in a ship is wasted and rejected in fluid and exhaust gas streams. The primary heat sources for waste heat recovery are the engine exhaust and the engine coolant. In this work, we present a study on the integration of an organic Rankine cycle (ORC) in an existing ship, for the recovery of the main and auxiliary engines exhaust heat. Experimental data from the operating conditions of the engines on the M/S Birka Stockholm cruise ship were logged during a port-to-port cruise from Stockholm to Mariehamn over a period of time close to one month. The ship has four main engines Wärtsilä 5850 kW for propulsion, and four auxiliary engines 2760 kW used for electrical consumers. A number of six load conditions were identified depending on the vessel speed. The speed range from 12–14 knots was considered as the design condition, as it was present during more than 34% of the time. In this study, the average values of the engines exhaust temperatures and mass flow rates, for each load case, were used as inputs for a model of an ORC. The main parameters of the ORC, including working fluid and turbine configuration, were optimized based on the criteria of maximum net power output and compactness of the installation components. Results from the study showed that an ORC with internal regeneration using benzene would yield the greatest average net power output over the operating time. For this situation, the power production of the ORC would represent about 22% of the total electricity consumption on board. These data confirmed the ORC as a feasible and promising technology for the reduction of fuel consumption and CO2 emissions of existing ships.

scholarly journals Thermodynamic Investigation of an Integrated Solar Combined Cycle with an ORC System

Entropy ◽  
2019 ◽  
Vol 21 (4) ◽  
pp. 428 ◽  
Author(s):  
Wang ◽  
Fu
Keyword(s):  
Solar Radiation ◽  
Thermal Efficiency ◽  
Unit Cost ◽  
Organic Rankine Cycle ◽  
Rankine Cycle ◽  
Exergy Efficiency ◽  
Combined Cycle ◽  
Exhaust Gas ◽  
Gas Temperature ◽  
Exhaust Gas Temperature

An integrated solar combined cycle (ISCC) with a low temperature waste heat recovery system is proposed in this paper. The combined system consists of a conventional natural gas combined cycle, organic Rankine cycle and solar fields. The performance of an organic Rankine cycle subsystem as well as the overall proposed ISCC system are analyzed using organic working fluids. Besides, parameters including the pump discharge pressure, exhaust gas temperature, thermal and exergy efficiencies, unit cost of exergy for product and annual CO2-savings were considered. Results indicate that Rc318 contributes the highest exhaust gas temperature of 71.2℃, while R113 showed the lowest exhaust gas temperature of 65.89 at 800 W/m2, in the proposed ISCC system. The overall plant thermal efficiency increases rapidly with solar radiation, while the exergy efficiency appears to have a downward trend. R227ea had both the largest thermal efficiency of 58.33% and exergy efficiency of 48.09% at 800W/m2. In addition, for the organic Rankine cycle, the exergy destructions of the evaporator, turbine and condenser decreased with increasing solar radiation. The evaporator contributed the largest exergy destruction followed by the turbine, condenser and pump. Besides, according to the economic analysis, R227ea had the lowest production cost of 19.3 $/GJ.

Energy Recovery Improvement Using Organic Rankine Cycle at Covanta’s Haverhill Facility

2010 ◽  
Author(s):  
Heping Cui ◽  
Jim Lynch ◽  
David McQuillan ◽  
Joseph Becker ◽  
Tim Sundel
Keyword(s):  
Energy Efficiency ◽  
Power Output ◽  
Energy Recovery ◽  
Landfill Gas ◽  
Organic Rankine Cycle ◽  
Rankine Cycle ◽  
Low Grade ◽  
Waste Energy ◽  
City Water ◽  
Net Power Output

Covanta Energy, in cooperation with United Technologies Corporation (UTC), has evaluated, designed, and is in the process of installing an Organic Rankine Cycle (ORC) system at its Haverhill Energy from Waste (EfW) Facility to improve heat recovery and energy efficiency, and to generate more clean renewable energy. ORC systems have been applied in geothermal applications and some other industrial processes to recover low grade and waste energy to generate electricity. This paper describes the design and integration of the ORC system into the Haverhill EfW steam cycle, and the landfill gas engine system, which also operates at the facility. The anticipated energy efficiency improvements and increased net power output have been analyzed and simulated. The results show that the integration of the ORC system could lead to a potential increase in the net power output by as much as 305 kWe in the summer and by 210 kWe in normal weather. It is also anticipated that with the ORC system the facility has the potential to improve the overall plant energy efficiency, as well as save city water.

scholarly journals Investigation of a thermo-fluidic exchange pump in trilateral flash and organic Rankine cycles / trans. from Engl. M. A. Fedorova

2020 ◽  
Vol 4 (4) ◽  
pp. 66-74
Author(s):  
C. R. Baggley ◽  
◽  
M. G. Read ◽  
Keyword(s):  
Low Temperature ◽  
Power Output ◽  
Organic Rankine Cycle ◽  
Rankine Cycle ◽  
Vapour Phase ◽  
Working Fluid ◽  
Positive Displacement ◽  
Wide Range ◽  
Work Input ◽  
Net Power Output

It is well known that large amounts of energy loss occurs at low temperature states in a wide range of industrial processes., The recovery and reuse of this energy is at the forefront of increasing the overall efficiencies of industrial systems. The aim of this paper is to investigate the effectiveness of using a Thermo-Fluidic Exchange (TFE) pump at low temperature conditions in both a SaturatedVapour Organic Rankine Cycle (SORC) and a Trilateral Flash Cycle (TFC). For some low temperature applications, TFCs have been shown to achieve higher net power output than conventional SORCs, due to their ability to extract more heat from the source fluid. This is the subject of current research as a result of advancements made in the design of positive displacement machines for operation as twophase expanders. Conventional turbines cannot be used for TFCs as they must operate in the vapour phase. One drawback of the TFC is the higher working fluid mass flow rate required. Depending on the scale of the system, this can potentially cause difficulties with pump selection. A TFE pump uses heat input to the system to increase the pressure and temperature of the working fluid, rather than the work input in a standard mechanical pump. This paper compares the net power output achievable using both mechanical and TFE pumps with SORC and TFC systems. The results suggest that the TFE pump could be a viable option for TFC systems

Sign in / Sign up

Export Citation Format

Share Document