scholarly journals Comparison of efficacies of full and abbreviated cascade impactors in aerosol characterization of nebulized salbutamol sulfate produced by a jet nebulizer

Pharmacia ◽  
2021 ◽  
Vol 68 (4) ◽  
pp. 899-905
Author(s):  
Nattika Nimmano ◽  
Safura Binti Mohd Mohari
Keyword(s):  
Fine Particle ◽  
High Performance ◽  
Sulfate Solution ◽  
Salbutamol Sulfate ◽  
Human Respiratory Tract ◽  
Experimental Conditions ◽  
Air Jet ◽  
Jet Nebulizer ◽  
Aerosol Characterization

The properties of aerosols generated from salbutamol sulfate solution (1 mg/mL) using an air-jet nebulizer were evaluated using Next Generation Impactor (NGI), a full cascade impactor, and Fast Screening Impactor (FSI), an abbreviated impactor measurement (AIM). Both impactors were operated under the same experimental conditions. The samples were recovered and assayed using validated high performance liquid chromatography (HPLC). The study investigated AIM-Human Respiratory Tract (HRT) concept by comparing key parameters of aerosolization i.e. fine particle dose (FPD) and fine particle fraction (FPF) measured using FSI, with NGI as baseline. The results showed that FSI yielded different but comparable values for FPD and FPF, indicating that it is alternative impactor to NGI. Despite the fact that FSI could not replace NGI, it may be used as an alternative impactor for simple and rapid aerosol characterization of formulations in some pharmaceutical development and quality control processes.

Preparation and Characterization of NH2-Terminal Fibrinogen Bβ Fragments from N-DSK of Human Fibrinogen

1984 ◽  
Vol 51 (01) ◽  
pp. 016-021 ◽  
Author(s):  
S Birken ◽  
G Agosto ◽  
B Lahiri ◽  
R Canfield
Keyword(s):  
High Performance ◽  
Gel Filtration ◽  
Ion Exchange Chromatography ◽  
Exchange Chromatography ◽  
Reverse Phase ◽  
Human Fibrinogen ◽  
Human Volunteers ◽  
Cnbr Cleavage ◽  
Two Peaks

SummaryIn order to investigate the early release of NH2-terminal plasmic fragments from the Bβ chain of fibrinogen, substantial quantities of Bβ 1-42 and Bβ 1-21 are required as immunogens, as radioimmunoassay standards and for infusion into human volunteers to determine the half-lives of these peptides. Towards this end methods that employ selective proteolytic cleavage of these fragments from fibrinogen have been developed. Both the N-DSK fragment, produced by CNBr cleavage of fibrinogen, and Bβ 1-118 were employed as substrates for plasmin with the finding of higher yields from N-DSK. Bβ 1-42 and Bβ 1-21 were purified by gel filtration and ion-exchange chromatography on SP-Sephadex using volatile buffers. When the purified preparation of Bβ 1-42 was chromatographed on reverse-phase high performance liquid chromatography, two peaks of identical amino acid composition were separated, presumably due either to pyroglutamate or to amide differences.

179. Characterization of Fine Particle Emissions in an Engine Plant

2006 ◽  
Author(s):  
W. Heitbrink ◽  
T. Peters ◽  
D. Evans ◽  
T. Slavin
Keyword(s):  
Fine Particle ◽  
Particle Emissions

Preparation and Characterization of the High Molecular Weight [3H]Hyaluronic Acid

1992 ◽  
Vol 57 (10) ◽  
pp. 2151-2156 ◽  
Author(s):  
Peter Chabreček ◽  
Ladislav Šoltés ◽  
Hynek Hradec ◽  
Jiří Filip ◽  
Eduard Orviský
Keyword(s):  
Molecular Weight ◽  
Hyaluronic Acid ◽  
High Molecular Weight ◽  
Methyl Bromide ◽  
High Performance ◽  
Hydrogen Atoms ◽  
Isolation And Characterization ◽  
Labelling Procedure ◽  
Enzymatic Depolymerization

Two methods for the preparation of high molecular weight [3H]hyaluronic acid were investigated. In the first one, hydrogen atoms in the molecule were replaced by tritium. This isotopic substitution was performed in aqueous solution using Pd/CaCO3 as the catalyst. In the second method, the high molecular weight hyaluronic acid was alkylated with [3H]methyl bromide in liquid ammonia at a temperature of -33.5 °C. High-performance gel permeation chromatographic separation method was used for the isolation and characterization of the high molecular weight [3H]hyaluronic acid. Molecular weight parameters for the labelled biopolymers were Mw = 128 kDa, Mw/Mn = 1.88 (first method) and Mw = 268 kDa, Mw/Mn = 1.55 (second method). The high molecular weight [3H]hyaluronic acid having Mw = 268 kDa was degraded further by specific hyaluronidase. Products of the enzymatic depolymerization were observed to be identical for both, labelled and cold biopolymer. This finding indicates that the described labelling procedure using [3H]methyl bromide does not induce any major structural rearrangements in the molecule.

Micro-Thermal Field-Flow Fractionation

2002 ◽  
Vol 67 (11) ◽  
pp. 1596-1608 ◽  
Author(s):  
Josef Janča
Keyword(s):  
High Performance ◽  
Thermal Field ◽  
Temperature Drop ◽  
Point Of View ◽  
Constant Field ◽  
Field Flow Fractionation ◽  
Operational Mode ◽  
Experimental Conditions ◽  
Standard Size ◽  
Flow Fractionation

The effect of miniaturization of the separation channel on the performance of thermal field-flow fractionation (TFFF) is substantiated theoretically. The experiments carried out under carefully chosen experimental conditions proved the high performance of the separation of polymers within an extended range of molar masses from relatively low up to ultrahigh-molar-mass (UHMM) samples. The new micro-TFFF allows to achieve high resolution when applying constant field force operation, it makes easy the programming of the temperature drop which is an advantageous operational mode from the point of view of the time of analysis, and it extends considerably the range of perfectly controlled temperature of the cold wall due to a substantial decrease in the heat energy flux compared with standard size channels.

scholarly journals Adsorption Studies on Magnetic Nanoparticles Functionalized with Silver to Remove Nitrates from Waters

Water ◽  
2021 ◽  
Vol 13 (13) ◽  
pp. 1757
Author(s):  
Yesica Vicente-Martínez ◽  
Manuel Caravaca ◽  
Antonio Soto-Meca ◽  
Miguel Ángel Martín-Pereira ◽  
María del Carmen García-Onsurbe
Keyword(s):  
Magnetic Nanoparticles ◽  
Nitrate Content ◽  
Adsorption Efficiency ◽  
Experimental Conditions ◽  
Dependent Behavior ◽  
Before And After ◽  
Naoh Solution ◽  
High Concentrations ◽  
Interference Studies

This paper presents a novel procedure for the treatment of contaminated water with high concentrations of nitrates, which are considered as one of the main causes of the eutrophication phenomena. For this purpose, magnetic nanoparticles functionalized with silver (Fe3O4@AgNPs) were synthesized and used as an adsorbent of nitrates. Experimental conditions, including the pH, adsorbent and adsorbate dose, temperature and contact time, were analyzed to obtain the highest adsorption efficiency for different concentration of nitrates in water. A maximum removal efficiency of 100% was reached for 2, 5, 10 and 50 mg/L of nitrate at pH = 5, room temperature, and 50, 100, 250 and 500 µL of Fe3O4@AgNPs, respectively. The characterization of the adsorbent, before and after adsorption, was performed by energy dispersive X-ray spectroscopy, scanning electron microscopy, Brunauer-Emmett-Teller analysis and Fourier-transform infrared spectroscopy. Nitrates can be desorbed, and the adsorbent can be reused using 500 µL of NaOH solution 0.01 M, remaining unchanged for the first three cycles, and exhibiting 90% adsorption efficiency after three regenerations. A deep study on equilibrium isotherms reveals a pH-dependent behavior, characterized by Langmuir and Freundlich models at pH = 5 and pH = 1, respectively. Thermodynamic studies were consistent with physicochemical adsorption for all experiments but showed a change from endothermic to exothermic behavior as the temperature increases. Interference studies of other ions commonly present in water were carried out, enabling this procedure as very selective for nitrate ions. In addition, the method was applied to real samples of seawater, showing its ability to eliminate the total nitrate content in eutrophized waters.

scholarly journals Ultrafiltration Method for Plasma Protein Binding Studies and Its Limitations

Processes ◽  
2021 ◽  
Vol 9 (2) ◽  
pp. 382
Author(s):  
Camelia-Maria Toma ◽  
Silvia Imre ◽  
Camil-Eugen Vari ◽  
Daniela-Lucia Muntean ◽  
Amelia Tero-Vescan
Keyword(s):  
Protein Binding ◽  
Plasma Protein Binding ◽  
Plasma Protein ◽  
Specific Binding ◽  
Critical Role ◽  
Volume Ratio ◽  
Binding Studies ◽  
Experimental Conditions ◽  
Key Aspects

Plasma protein binding plays a critical role in drug therapy, being a key part in the characterization of any compound. Among other methods, this process is largely studied by ultrafiltration based on its advantages. However, the method also has some limitations that could negatively influence the experimental results. The aim of this study was to underline key aspects regarding the limitations of the ultrafiltration method, and the potential ways to overcome them. The main limitations are given by the non-specific binding of the substances, the effect of the volume ratio obtained, and the need of a rigorous control of the experimental conditions, especially pH and temperature. This review presents a variety of methods that can hypothetically reduce the limitations, and concludes that ultrafiltration remains a reliable method for the study of protein binding. However, the methodology of the study should be carefully chosen.

scholarly journals Development and characterization of Nb3Sn/Al2O3 superconducting multilayers for particle accelerators

2021 ◽  
Vol 11 (1) ◽  
Author(s):  
Chris Sundahl ◽  
Junki Makita ◽  
Paul B. Welander ◽  
Yi-Feng Su ◽  
Fumitake Kametani ◽  
...  
Keyword(s):  
High Performance ◽  
High Energy ◽  
Particle Accelerators ◽  
Quality Factors ◽  
Critical Fields ◽  
Linear Accelerators ◽  
Cross Sectional ◽  
Low Field ◽  
Superconducting Radio Frequency

AbstractSuperconducting radio-frequency (SRF) resonator cavities provide extremely high quality factors > 1010 at 1–2 GHz and 2 K in large linear accelerators of high-energy particles. The maximum accelerating field of SRF cavities is limited by penetration of vortices into the superconductor. Present state-of-the-art Nb cavities can withstand up to 50 MV/m accelerating gradients and magnetic fields of 200–240 mT which destroy the low-dissipative Meissner state. Achieving higher accelerating gradients requires superconductors with higher thermodynamic critical fields, of which Nb3Sn has emerged as a leading material for the next generation accelerators. To overcome the problem of low vortex penetration field in Nb3Sn, it has been proposed to coat Nb cavities with thin film Nb3Sn multilayers with dielectric interlayers. Here, we report the growth and multi-technique characterization of stoichiometric Nb3Sn/Al2O3 multilayers with good superconducting and RF properties. We developed an adsorption-controlled growth process by co-sputtering Nb and Sn at high temperatures with a high overpressure of Sn. The cross-sectional scanning electron transmission microscope images show no interdiffusion between Al2O3 and Nb3Sn. Low-field RF measurements suggest that our multilayers have quality factor comparable with cavity-grade Nb at 4.2 K. These results provide a materials platform for the development and optimization of high-performance SIS multilayers which could overcome the intrinsic limits of the Nb cavity technology.

scholarly journals How Relevant Is It to Use Mineral Proxies to Mimic the Atmospheric Reactivity of Natural Dust Samples? A Reactivity Study Using SO2 as Probe Molecule

Minerals ◽  
2021 ◽  
Vol 11 (3) ◽  
pp. 282
Author(s):  
Darya Urupina ◽  
Manolis N. Romanias ◽  
Frederic Thevenet
Keyword(s):  
High Performance ◽  
Real Life ◽  
Complex Mixtures ◽  
Experimental Conditions ◽  
The Real ◽  
Atmospheric Processes ◽  
Real Effects ◽  
Mineral Aerosols ◽  
Life Impact ◽  
Reactivity Study

The experimental investigation of heterogeneous atmospheric processes involving mineral aerosols is extensively performed in the literature using proxy materials. In this work we questioned the validity of using proxies such as Fe2O3, FeOOH, Al2O3, MgO, CaO, TiO2, MnO2, SiO2, and CaCO3 to represent the behavior of complex mixtures of minerals, such as natural desert and volcanic dusts. Five volcanic dusts and three desert dusts were compared to a number of metal oxides, commonly used in the literature to mimic the behavior of desert dusts in the ability to form sulfites and sulfates on the surface exposed to SO2 gas. First, all samples were aged at room temperature, atmospheric pressure, under controlled experimental conditions of 175 ppm SO2 for 1 h under 30% of relative humidity. Second, they were extracted with 1% formalin and analyzed by High-Performance Liquid Chromatography (HPLC) to quantify and compare the amount of sulfites and sulfates formed on their surfaces. It was evidenced that under the experimental conditions of this study neither one selected pure oxide nor a mixture of oxides can adequately typify the behavior of complex mixtures of natural minerals. Therefore, to evaluate the real-life impact of natural dust on atmospheric processes it is of vital importance to work directly with the natural samples, both to observe the real effects of desert and volcanic dusts and to evaluate the relevancy of proposed proxies.

Sign in / Sign up

Export Citation Format

Share Document