RELATIONS OF ANISOTROPIC ELASTIC MODULI TO DENSITY AND CT NUMBER IN BOVINE CORTICAL BONE

2008 ◽  
Vol 20 (03) ◽  
pp. 139-143 ◽  
Author(s):  
Jui-Ting Hsu ◽  
Ming-Tzu Tsai ◽  
Heng-Li Huang

It would be useful to be able to determine the mechanical properties of bone using a noninvasive technique such as computed tomography (CT). However, in contrast to cancellous bone tissue, quantifying the elastic modulus of cortical bone from bone density and CT number has not been investigated extensively. This study measured the elastic moduli of cortical bone from eight bovine femora in the longitudinal, circumferential, and radial directions using mechanical compressive testing. Before testing, the CT number and wet apparent bone density were obtained. The experimentally determined coefficient of determination between CT number and bone density was around 0.6. Bone density was a good predictor of the elastic modulus of cortical bone in the longitudinal direction (r2 > 0.79), but it could not be used to predict the elastic moduli in the circumferential (r2 < 0.4) and radial (r2 < 0.22) directions. The coefficient of determination between CT number and the elastic modulus in the longitudinal direction was higher than 0.41. However, the correlations between CT number and elastic moduli were weak in the circumferential (r2 < 0.21) and radial (r2 < 0.19) directions. Moreover, the elastic modulus was much higher in the longitudinal direction than the circumferential and radial directions, and hence cortical bone can be considered a transversely isotropic property.

Author(s):  
Justin M. Deuerling ◽  
Weimin Yue ◽  
Alejandro A. Espinoza ◽  
Ryan K. Roeder

The elastic constants of cortical bone are orthotropic or transversely isotropic depending on the anatomic origin of the tissue. Micromechanical models have been developed to predict anisotropic elastic properties from structural information. Many have utilized microstructural features such as osteons, cement lines and Haversian canals to model the tissue properties [1]. Others have utilized nanoscale features to model the mineralized collagen fibril [2]. Quantitative texture analysis using x-ray diffraction techniques has shown that elongated apatite crystals exhibit a preferred orientation in the longitudinal axis of the bone [3]. The orientation distribution of apatite crystals provides fundamental information influencing the anisotropy of the extracellular matrix (ECM) but has not been utilized in existing micromechanical models.


2004 ◽  
Vol 844 ◽  
Author(s):  
Amanpreet K. Bembey ◽  
Vanessa Koonjul ◽  
Andrew J. Bushby ◽  
Virginia L. Ferguson ◽  
Alan Boyde

ABSTRACTCortical bone is an anisotropic material, and its mechanical properties are determined by its composition as well as its microstructure. Mechanical properties of bone are a consequence of the proportions of, and the interactions between, mineral, collagen and water. Mid-shaft palmar cortical tissue from the equine third metacarpal bone is relatively dense and uniform with low porosity. The mainly primary osteons are aligned to within a few degrees of the long axis of the bone. Beams of compact cortical bone were prepared to examine effects of dehydration and embedding and to study contribution of collagen and mineral to nano-scale material properties. Five beams were tested: untreated (hydrated); 100% ethanol (dehydrated); or embedded in poly-methylmethacrylate (PMMA) for one normal, one decalcified, and one deproteinated bone sample. Elastic modulus was obtained by nanoindentation using spherical indenters, with the loading direction transverse [1] and longitudinal to the bone axis. By selectively removing water, mineral and organic components from the composite, insights into the ultrastructure of the tissue can be gained from the corresponding changes in the experimentally determined elastic moduli.


2004 ◽  
Vol 841 ◽  
Author(s):  
Amanpreet K. Bembey ◽  
Vanessa Koonjul ◽  
Andrew J. Bushby ◽  
Virginia L. Ferguson ◽  
Alan Boyde

ABSTRACTCortical bone is an anisotropic material, and its mechanical properties are determined by its composition as well as its microstructure. Mechanical properties of bone are a consequence of the proportions of, and the interactions between, mineral, collagen and water. Mid-shaft palmar cortical tissue from the equine third metacarpal bone is relatively dense and uniform with low porosity. The mainly primary osteons are aligned to within a few degrees of the long axis of the bone. Beams of compact cortical bone were prepared to examine effects of dehydration and embedding and to study contribution of collagen and mineral to nano-scale material properties. Five beams were tested: untreated (hydrated); 100% ethanol (dehydrated); or embedded in poly-methylmethacrylate (PMMA) for one normal, one decalcified, and one deproteinated bone sample. Elastic modulus was obtained by nanoindentation using spherical indenters, with the loading direction transverse [1] and longitudinal to the bone axis. By selectively removing water, mineral and organic components from the composite, insights into the ultrastructure of the tissue can be gained from the corresponding changes in the experimentally determined elastic moduli.


2005 ◽  
Vol 898 ◽  
Author(s):  
Gabriel Converse ◽  
Ryan Roeder

AbstractPolyetheretherketone (PEEK) was reinforced with 0-40 vol% hydroxyapatite (HA) whiskers using a novel powder processing and compression molding technique. A powder mixture was uniaxially pressed into a composite powder compact and compression molded into a flat composite bar using an open-channel die, such that the HA whiskers exhibited a preferred orientation along the length of the bar and tensile specimens. As expected, increased HA whisker reinforcement resulted in increased elastic modulus, but decreased ultimate tensile strength and strain- or work-to-failure. PEEK reinforced with 40 vol% HA whiskers exhibited an elastic modulus of 16-18 GPa. PEEK reinforced with 20 vol% HA whiskers had an ultimate tensile strength of 70-80 MPa. Human cortical bone exhibits an elastic modulus of 17-26 GPa and an ultimate tensile strength of 80-150 MPa in the longitudinal direction (direction of principal stress). Stiffness coefficients measured by ultrasonic wave propagation indicated a level orthotropy also similar to that of human cortical bone tissue.


2021 ◽  
Vol 80 (Suppl 1) ◽  
pp. 825.2-826
Author(s):  
M. Jansen ◽  
A. Ooms ◽  
T. D. Turmezei ◽  
J. W. Mackay ◽  
S. Mastbergen ◽  
...  

Background:In addition to cartilage degeneration, knee osteoarthritis (OA) causes bone changes, including cortical bone thickening, subchondral bone density decrease, and bone shape changes as a result of widening and flattening condyles and osteophyte formation. Knee joint distraction (KJD) is a joint-preserving treatment for younger (<65 years) knee OA patients that has been shown to reverse OA cartilage degradation. On radiographs, KJD showed a decrease in subchondral bone density and an increase in osteophyte formation. However, these bone changes have never been evaluated with a 3D imaging technique.Objectives:To evaluate cortical bone thickness, subchondral trabecular bone density, and bone shape on CT scans before and one year after KJD treatment.Methods:19 KJD patients were included in an extended imaging protocol, undergoing a CT scan before and one year after treatment. Stradview v6.0 was used for semi-automatic tibia and femur segmentation from axial thin-slice (0.45mm) CT scans. Cortical bone thickness (mm) and trabecular bone density (Hounsfield units, HU) were measured with an automated algorithm. Osteophytes were excluded. Afterwards, wxRegSurf v18 was used for surface registration. Registration data was used for bone shape measurements. MATLAB R2020a and the SurfStat MATLAB package were used for data analysis and visualization. Two-tailed F-tests were used to calculate changes over time. Two separate linear regression models were used to show the influence of baseline Kellgren-Lawrence grade and sex on the changes over time. Statistical significance was calculated with statistical parametric mapping; a p-value <0.05 was considered statistically significant. Bone shape changes were explored visually using vertex by vertex displacements between baseline and follow-up. Patients were separated into two groups based on whether their most affected compartment (MAC) was medial or lateral. Only patients with axial CT scans at both time points available for analysis were included for evaluation.Results:3 Patients did not have complete CTs and in 1 patient the imaged femur was too short, leaving 16 patients for tibial analyses and 15 patients for femoral analyses. The MAC was predominantly the medial side (medial MAC n=14; lateral n=2). Before treatment, the MAC cortical bone was compared to the rest of the joint (Figure 1). One year after treatment, MAC cortical thickness decreased, although this decrease of up to approximately 0.25 mm was not statistically significant. The trabecular bone density was also higher before treatment in the MAC, and a decrease was seen throughout the entire joint, although statistically significant only for small areas on mostly the MAC where this decrease was up to approximately 80 HU (Figure 1). Female patients and patients with a higher Kellgren-Lawrence grade showed a somewhat larger decrease in cortical bone thickness. Trabecular density decreased less for patients with a higher Kellgren-Lawrence grade, and female patients showed a higher density decrease interiorly while male patients showed a higher decrease exteriorly. None of this was statistically significant. The central areas of both compartments showed an outward shape change, while the outer ring showed inward changes.Conclusion:MAC cortical bone thickness shows a partial decrease after KJD. Trabecular bone density decreased on both sides of the joint, likely as a direct result of the bicompartmental unloading. For both subchondral bone parameters, MAC values became more similar to the LAC, indicating (partial) subchondral bone normalization in the most affected parts of the joint. The bone shape changes may indicate a reversal of typical OA changes, although the inward difference that was seen on the outer edges may be a result of osteophyte-related changes that might have affected the bone segmentation. In conclusion, KJD treatment shows subchondral bone normalization in the first year after treatment, and longer follow-up might show whether these changes are a temporary result of joint unloading or indicate more prolonged bone changes.Disclosure of Interests:None declared.


Sign in / Sign up

Export Citation Format

Share Document