Energy-Saturated Materials Based on Technological Biomaterials

2017 ◽  
Vol 25 ◽  
pp. 80-87
Author(s):  
Olena Svietkina ◽  
Svitlana Lysytska ◽  
Vsevolod Franchuk
Keyword(s):  
Granulometric Composition ◽  
Continuous Mode ◽  
Vibratory Mill

The article considers the problem of improving the technology of obtaining energy-saturated materials, which results in an improvement of the characteristics of energy granules. We developed a technique for pretreatment of raw matirual in a continuous mode on a vertical vibratory mill. This contributes to the production of particles of the optimal granulometric composition.

Substantiation of parameters for bimodal granulometric composition of structured suspension solid phase

2017 ◽  
pp. 76-87
Author(s):  
Ye.V. Semenenko ◽  
◽  
V.D. Ruban ◽  
K.K. Podoliak ◽  
◽  
...  
Keyword(s):  
Granulometric Composition ◽  
Solid Phase

THEORETICAL STUDY OF THE EFFECT OF GEOMETRICAL PARAMETERS AND LOCATION OF ROTOR IMPACT ELEMENTS OF AN IMPACT-CENTRIFUGAL GRINDER ON SPEED AND ANGLES OF CRUSHED PARTICLES FLIGHT

2020 ◽  
Keyword(s):  
Granulometric Composition ◽  
Theoretical Study ◽  
Process Efficiency ◽  
Geometrical Parameters ◽  
Grinding Process ◽  
Main Work ◽  
Impact Element ◽  
The Impact ◽  
Positive Effect ◽  
Efficiency Indicators

One of efficiency indicators of grain grinders is grain granulometric composition. The basis of mixed fodder is crushed grain, the particles of which must have a leveled granulometric composition for subsequent mixing and obtaining a high-quality feed mixture. In agricultural production, hammer crushers are widely used, in which the destruction of grain occurs due to the impact of a hinged hammer. The main disadvantage of these crushers is that not the entire surface of the hammers is involved in grinding, thus reduces grinding process efficiency. A slightly different principle of material destruction is laid down in the basis of the proposed design of the shock-centrifugal grinder. Main work is performed by flat impact elements located on the rotor, which serve to accelerate crushed particles with subsequent impact of them on the bump elements. An important step in the design of new constructions of shock-centrifugal grinders is to determine size and location of the impact elements on the rotor, without which the grinding process is not possible. In the calculation method presented, the dependencies for determining the velocities and angles of a single particle flight from the surface of a flat impact element for its specified dimensions are proposed. Two variants of an impact element location on the rotor are considered and analyzed: radial and at an angle in the direction of rotor rotation. As a result of research carried out, it is noted that in the case of inclined position of an impact element on the rotor an increase in flight speed and flight angles change in crushed particles, which gives the opportunity to have a positive effect on grinding process.

Growth Characteristics of Activated Sludges Acclimated to para-Nitrophenol in Batch and Continuous Modes

1994 ◽  
Vol 29 (7) ◽  
pp. 327-333
Author(s):  
Y. Matsui ◽  
F. Yamaguchi ◽  
Y. Suwa ◽  
Y. Urushigawa
Keyword(s):  
Growth Characteristics ◽  
The Other ◽  
Operational Mode ◽  
Continuous Mode ◽  
Relative Resistance ◽  
Batch Mode ◽  
The Given ◽  
Operational Modes ◽  
Very High ◽  
Sensitive Group

Activated sludges were acclimated to p-nitrophenol (PNP) in two operational modes, a batch and a continuous. The operational mode of the PNP acclimation of activated sludges strongly affected the physiological characteristics of predominant microorganisms responsible for PNP degradation. Predominant PNP degraders in the sludge in batch mode (Sludge B) had lower PNP affinity and were relatively insensitive to PNP concentration. Those of the sludge in continuous mode (Sludge C), on the other hand, had very high PNP affinity and were sensitive to PNP. MPN enumeration of PNP degraders in sludge B and C using media with different PNP concentrations (0.05, 0.2,0.5 and 2.0 mM) supported the above results. Medium with 0.2 mM of PNP did not recover PNP degraders in sludge C well, while it recovered PNP degraders in sludge B as well as the medium with 0.05 mM did. When switching from one operational mode to the other, the predominant population in sludge B shifted to the sensitive group, but that of sludge C did not shift at the given loading of PNP, showing relative resistance to inhibitive concentration.

Analysis of the system precipitation reactor-separation unit. Porosity of the filtration cake as a function of properties of the solid phase

1981 ◽  
Vol 46 (11) ◽  
pp. 2640-2649 ◽  
Author(s):  
Otakar Söhnel
Keyword(s):  
Linear Function ◽  
Surface Area ◽  
Granulometric Composition ◽  
Solid Phase ◽  
Separation Unit ◽  
Initial Concentration ◽  
Actual Surface ◽  
Suspension Concentration

Porosity of the filtration cake, formed at filtration of model suspensions of CaCO3, BaCrO4 and ZnO is not a function of suspension concentration as long as the solid phase forming the suspension is of the same granulometric composition. The calculated surface area of the solid phase, effective as concerns filtration at ΔP = 30 kPa, is smaller than the actual surface area determined by absorption of nitrogen. Porosity of the filtration cake formed at filtration of suspensions of Mg(OH)2, CaCO3, SrCO3 and BaCO3 prepared by precipitation is a linear function of the initial concentration of precipitated solutions since it is affected by the size and polydispersity of originating particles in dependence on concentration of precipitated solutions. The cakes formed at filtration of precipitated suspensions of CaCO3, SrCO3 and BaCO3 aged for up to 2 hours from the instant of their preparation have a constant porosity which is independent of the time of suspension aging.

Industrial wastewater treatment using magnesium electrocoagulation in batch and continuous mode

2021 ◽  
pp. 1-16
Author(s):  
Perla Fabiola Carmona-Carmona ◽  
Ivonne Linares-Hernández ◽  
Elia Alejandra Teutli-Sequeira ◽  
Boris Miguel López-Rebollar ◽  
Carolina Álvarez-Bastida ◽  
...  
Keyword(s):  
Wastewater Treatment ◽  
Industrial Wastewater ◽  
Continuous Mode ◽  
Industrial Wastewater Treatment

Influence of precipitation parameters on granulometric composition and shape of chromium hydroxide and oxide particles

2020 ◽  
Author(s):  
Yulia D. Kurasova ◽  
Nina V. Zhirenkina ◽  
Maxim A. Mashkovtsev ◽  
Vadim V. Kartashov ◽  
Evgenie O. Baksheev
Keyword(s):  
Granulometric Composition ◽  
Chromium Hydroxide ◽  
Oxide Particles

scholarly journals Effect of Granulometric Composition of the Soil on the Occurrence of Carrion Beetles (Coleoptera: Silphidae)

2021 ◽  
Vol 11 (3) ◽  
pp. 1017
Author(s):  
Karolina Konieczna ◽  
Zbigniew W. Czerniakowski ◽  
Małgorzata Szostek
Keyword(s):  
Significant Relationship ◽  
Granulometric Composition ◽  
Clay Fraction ◽  
Total Abundance ◽  
Habitat Types ◽  
Sand Fraction ◽  
Positive Correlation ◽  
Nicrophorus Vespilloides ◽  
Carrion Beetle ◽  
Carrion Beetles

The entomological material was collected in the years 2009–2012 and 2014 from 13 different habitat types from three localities in south-eastern Poland. In total, 11,095 Silphidae were collected. This study examined whether the percentage of individual soil granulometric fractions was significantly related to the total abundance of collected Silphidae and individual carrion beetle species. A positive correlation and a statistically significant correlation were found between the total number of specimens collected and the share of the mechanical fraction with a diameter of 0.05–0.002 mm (silt fraction). In three species, a statistically significant correlation was demonstrated between the number of collected Silphidae and the share of the mechanical fraction with a diameter of 2–0.05 mm (sand fraction). The two species Phosphuga atrata atrata and Nicrophorus vespilloides the correlation was positive. A statistically significant relationship was also observed for Thanatophilus sinuatus, but the correlation was negative. With regard to the mechanical fraction with a diameter <0.002 mm (clay fraction), a statistically significant relationship was demonstrated for Oiceoptoma thoracicum and for Nicrophorus vespilloides for which the correlation was negative. However, a positive correlation was found for T. sinuatus in this case.

scholarly journals Batch and Semi-Continuous Anaerobic Digestion of Industrial Solid Citrus Waste for the Production of Bioenergy

Processes ◽  
2021 ◽  
Vol 9 (4) ◽  
pp. 648
Author(s):  
Erik Samuel Rosas-Mendoza ◽  
Andrea Alvarado-Vallejo ◽  
Norma Alejandra Vallejo-Cantú ◽  
Raúl Snell-Castro ◽  
Sergio Martínez-Hernández ◽  
...  
Keyword(s):  
Anaerobic Digestion ◽  
Oxygen Demand ◽  
Continuous Mode ◽  
Citrus Industry ◽  
Batch Mode ◽  
Volatile Solids ◽  
Working Volume ◽  
Plant Level ◽  
Citrus Waste ◽  
Mesophilic Conditions

The aim of this paper is to describe a study of the anaerobic digestion of industrial citrus solid waste (ISCW) in both batch and semi-continuous modes for the production of bioenergy without the elimination of D-limonene. The study was conducted at the pilot plant level in an anaerobic reactor with a working volume of 220 L under mesophilic conditions of 35 ± 2 °C. Cattle manure (CM) was used as the inoculum. Three batches were studied. The first batch had a CM/ISCW ratio of 90/10, and Batches 2 and 3 had CM/ISCW ratios of 80/20 and 70/30, respectively. In the semi-continuous mode an OLR of approximately 8 g total chemical oxygen demand (COD)/Ld (4.43 gVS/Ld) was used. The results showed that 49%, 44%, and 60% of volatile solids were removed in the batch mode, and 35% was removed in the semi-continuous mode. In the batch mode, 0.322, 0.382, and 0.316 LCH4 were obtained at STP/gVSremoved. A total of 24.4 L/d (34% methane) was measured in the semi-continuous mode. Bioenergy potentials of 3.97, 5.66, and 8.79 kWh were obtained for the respective batches, and 0.09 kWh was calculated in the semi-continuous mode. The citrus industry could produce 37 GWh per season. A ton of processed oranges has a bioenergy potential of 162 kWh, which is equivalent to 49 kWh of available electricity ($3.90).

Sign in / Sign up

Export Citation Format

Share Document