Behavior and Distribution of Nonylphenol Ethoxylates and their Metabolites in Sediments of Nansi Lake, China

2011 ◽  
Vol 356-360 ◽  
pp. 1733-1738
Author(s):  
Fang He ◽  
Aya Obara ◽  
Shi Long Wang ◽  
Li Guo Wang
Keyword(s):  
Water Flow ◽  
Flow Direction ◽  
Sediment Cores ◽  
Sewage Treatment ◽  
Vertical Direction ◽  
Total Content ◽  
Horizontal Distribution ◽  
Nansi Lake ◽  
Increasing Trend ◽  
Vertical And Horizontal Distribution

The vertical and horizontal distribution of NPEOn and their metabolites of NP and NPEnC in the Upper Nansi Lake, North China were investigated using LC-MS and LC-MS/MS methods, sampling at three sites (St.1, St.2 and St.3) along the water flow direction. The total content of NPEOn (n=1–15) bound onto the sediment of this lake changed in the range of 60.7–631.5 μg/kg-dry with the horizontal flow direction and the vertical direction of the sediment cores with sediment thickness up to 35 cm. Compared to the presence levels of all detected NPEOn species, the content of NP was much higher, falling in 26.5–1,998.4 μg/kg-dry. A general increasing trend of the NP content along the water flow direction of this lake was revealed. NPEnC showed a roughly increasing trend from the upstream to the downstream, with the total concentrations being obviously lower than NPEOn and NP and falling in 2.13–23.1 μg/kg-dry. The short chain NPEOn dominant in NPEO mixtures in these sedimentary cores indicated that this lake received some effluents from STPs, and the sewage treatment ratio is relatively low in this area. Furthermore, the computed magnitudes of NPEO 1-2/NPEO1-15, NP/NPEO 1-15 and NPEC 1-10/NPEO 1-15 suggested that the non-oxidative hydrolytic transformation seemed to be a major process occurring within the sediment phase of Nansi Lake, while the oxidative hydrolytic transformation pathway was probably less involved.

Analytical solution for estimating the influence of a pre-existing ground water flow on a geothermal heat production-injection well system

2011 ◽  
Vol 2 (1) ◽  
pp. 13-17
Author(s):  
I. David ◽  
M. Visescu
Keyword(s):  
Ground Water ◽  
Water Flow ◽  
Geothermal Energy ◽  
Flow Direction ◽  
Energy Resource ◽  
Hot Water ◽  
Injection Well ◽  
Production Well ◽  
Ground Water Flow ◽  
The Earth

Abstract Geothermal energy source is the heat from the Earth, which ranges from the shallow ground (the upper 100 m of the Earth) to the hot water and hot rock which is a few thousand meters beneath the Earth's surface. In both cases the so-called open systems for geothermal energy resource exploitation consist of a groundwater production well to supply heat energy and an injection well to return the cooled water, from the heat pump after the thermal energy transfer, in the underground. In the paper an analytical method for a rapid estimation of the ground water flow direction effect on the coupled production well and injection well system will be proposed. The method will be illustrated with solutions and images for representative flow directions respect to the axis of the production/injection well system.

scholarly journals Comparative Analysis of Different Mobile LiDAR Mapping Systems for Ditch Line Characterization

2021 ◽  
Vol 13 (13) ◽  
pp. 2485
Author(s):  
Yi-Chun Lin ◽  
Raja Manish ◽  
Darcy Bullock ◽  
Ayman Habib
Keyword(s):  
Flow Direction ◽  
Sediment Accumulation ◽  
Digital Terrain Model ◽  
Vertical Direction ◽  
Point Clouds ◽  
Lidar Data ◽  
Cross Sectional ◽  
Premature Failure ◽  
3D Point Clouds ◽  
Mapping Systems

Maintenance of roadside ditches is important to avoid localized flooding and premature failure of pavements. Scheduling effective preventative maintenance requires a reasonably detailed mapping of the ditch profile to identify areas in need of excavation to remove long-term sediment accumulation. This study utilizes high-resolution, high-quality point clouds collected by mobile LiDAR mapping systems (MLMS) for mapping roadside ditches and performing hydrological analyses. The performance of alternative MLMS units, including an unmanned aerial vehicle, an unmanned ground vehicle, a portable backpack system along with its vehicle-mounted version, a medium-grade wheel-based system, and a high-grade wheel-based system, is evaluated. Point clouds from all the MLMS units are in agreement within the ±3 cm range for solid surfaces and ±7 cm range for vegetated areas along the vertical direction. The portable backpack system that could be carried by a surveyor or mounted on a vehicle is found to be the most cost-effective method for mapping roadside ditches, followed by the medium-grade wheel-based system. Furthermore, a framework for ditch line characterization is proposed and tested using datasets acquired by the medium-grade wheel-based and vehicle-mounted portable systems over a state highway. An existing ground-filtering approach—cloth simulation—is modified to handle variations in point density of mobile LiDAR data. Hydrological analyses, including flow direction and flow accumulation, are applied to extract the drainage network from the digital terrain model (DTM). Cross-sectional/longitudinal profiles of the ditch are automatically extracted from the LiDAR data and visualized in 3D point clouds and 2D images. The slope derived from the LiDAR data turned out to be very close to the highway cross slope design standards of 2% on driving lanes, 4% on shoulders, and a 6-by-1 slope for ditch lines.

Effect of temperature on streambed vertical hydraulic conductivity

2013 ◽  
Vol 45 (1) ◽  
pp. 89-98 ◽  
Author(s):  
Weihong Dong ◽  
Gengxin Ou ◽  
Xunhong Chen ◽  
Zhaowei Wang
Keyword(s):  
Hydraulic Conductivity ◽  
Water Temperature ◽  
Sediment Cores ◽  
Effect Of Temperature ◽  
In Situ Tests ◽  
Effect Of Water ◽  
Vertical Hydraulic Conductivity ◽  
Increasing Trend ◽  
Streambed Vertical Hydraulic Conductivity

In this study, in situ and on-site permeameter tests were conducted in Clear Creek, Nebraska, USA to evaluate the effect of water temperature on streambed vertical hydraulic conductivity Kv. Fifty-two sediment cores were tested. Five of them were transferred to the laboratory for a series of experiments to evaluate the effect of water temperature on Kv. Compared with in situ tests, 42 out of the 52 tests have higher Kv values for on-site tests. The distribution of water temperature at the approximately 50 cm depth of streambed along the sand bar was investigated in the field. These temperatures had values in the range 14–19 °C with an average of 16 °C and had an increasing trend along the stream flow. On average, Kv values of the streambed sediments in the laboratory tests increase by 1.8% per 1 °C increase in water temperature. The coarser sandy sediments show a greater increase extent of the Kv value per 1 °C increase in water temperature. However, there is no distinct increasing trend of Kv value for sediment containing silt and clay layers.

scholarly journals Wątrobowce (Hepaticae) Beskidu Żywiecko-Orawskiego (Karpaty Zachodnie) [Liverworts (Hepaticae) of the Beskid Żywiecko-Orawski Range (Polish Western Carpathians)]

2014 ◽  
Vol 79 ◽  
pp. 1-144 ◽  
Author(s):  
Henryk Klama
Keyword(s):  
Endangered Species ◽  
Habitat Preferences ◽  
Horizontal Distribution ◽  
Western Carpathians ◽  
Vulnerable Species ◽  
Floristic Analysis ◽  
Vertical And Horizontal Distribution

The study area comprises two mountain groups – Wielka Racza and Pilsko – situated in western part of the Beskid Żywiecko-Orawski Range in Polish Western Carpathians. The flora of this area includes 111 species of liverworts and 2 species of hornworts. 81 species of liverworts and 2 species of hornworts were found in the area of the Wielka Racza group, 108 species of liverworts and 2 species of hornworts – in the area of the Pilsko group. The species new for the Polish part of the Beskid Żywiecki Range were found (27), as well as for the whole Range including the Slovakian part (22) and for the Western Beskids (2). Moreover, 20 species rare in the Western Beskids as well as 11 species rare in the whole area of the Western Carpathians were recorded. 6 species regarded as threatened in the Polish flora occur in the study area. Four of them belong to the category of endangered species (E):<em> Fossombronia wondraczekii, Frullania tamarisci, Porella baueri</em> and <em>P. platyphylla</em>, the remaining two belong to the category of vulnerable species (V): <em>Geocalyx graveolens</em> and <em>Metzgeria conjugata</em>. A particular attention should be payed to the species threatened on European scale: <em>Lophozia ascendens</em> (R category), <em>Porella baueri</em> (T) and <em>Scapania parvifolia</em> (T). The floristic analysis of habitats covered by liverworts as well as habitat groups of liverworts and habitat preferences of particular species arę presented in the paper. The phytogeographic characteristics of the flora is also given, including vertical and horizontal distribution of liverworts in the study area.

Experimental Study on the Avoidance and Suppression Criteria for the Vortex-Induced Vibration of a Cantilever Cylinder

2002 ◽  
Vol 124 (2) ◽  
pp. 187-195 ◽  
Author(s):  
Takaaki Sakai ◽  
Masaki Morishita ◽  
Koji Iwata ◽  
Seiji Kitamura
Keyword(s):  
Experimental Data ◽  
Experimental Study ◽  
Water Flow ◽  
Experimental Validation ◽  
Flow Direction ◽  
High Viscosity ◽  
Design Guideline ◽  
Vortex Induced Vibration ◽  
High Viscosity Oil ◽  
Effect Of Structure

Experimental validation of the design guideline to prevent the failure of a thermometer well by vortex-induced vibration is presented, clarifying the effect of structure damping on displacement amplitudes of a cantilever cylinder. The available experimental data in piping are limited to those with small damping in water flow, because of the difficulty in increasing structure damping of the cantilever cylinders in experiments. In the present experiment, high-viscosity oil within cylinders is used to control their structure damping. Resulting values of reduced damping Cn are 0.49, 0.96, 1.23, 1.98, and 2.22. The tip displacements of the cylinder induced by vortex vibration were measured in the range of reduced velocity Vr from 0.7 to 5 (Reynolds number is 7.8×104 at Vr=1). Cylinders with reduced damping 0.49 and 0.96 showed vortex-induced vibration in the flow direction in the Vr>1 region. However, in cases of reduced damping of 1.23, 1.98, and 2.22, the vibration was suppressed to less than 1 percent diameter. It is confirmed that the criteria of “Vr<3.3 and Cn>1.2” for the prevention of vortex-induced vibration is reasonably applicable to a cantilever cylinder in a water flow pipe.

scholarly journals Occurrence and ecological notes on Rocinela signata (Isopoda, Flabellifera) off Brazil

1977 ◽  
Vol 26 (2) ◽  
pp. 293-301 ◽  
Author(s):  
Plínio Soares Moreira
Keyword(s):  
Host Specificity ◽  
Horizontal Distribution ◽  
Maximum Depth ◽  
Fish Parasite ◽  
Southern Brazil ◽  
Santa Catarina ◽  
Free Living ◽  
Southern Limit ◽  
Vertical And Horizontal Distribution

This paper discuss the vertical and horizontal distribution of the marine isopod Rocinela signata Schiödte & Meinert, 1879, along Brazil. Published records and new data gathered in recent years were used. The species, widely distributed along Brazil, has its most southern limit of occurrence considerably extended to off State of Santa Catarina (27º08'S, 48º11'W) . It is typically a shelf species. So far it was recorded off Brazil at a maximum depth of 73 m, while particularly in southern Brazil at 53 m. The species has been collected free living on the bottom or as a fish parasite, and a few times has been reported attacking and sucking swimmers. Available data suggest any host specificity. R. signata seems a facultative and not an obligate fish parasite.

Sign in / Sign up

Export Citation Format

Share Document