Adsorption Kinetics of Zn(II) from Aqueous Solutions onto Epichlorohydrin Crosslinked Chitosan

2012 ◽  
Vol 463-464 ◽  
pp. 7-11 ◽  
Author(s):  
Ming Yan Dang ◽  
Hong Min Guo ◽  
Yan Kun Tan
Keyword(s):  
Aqueous Solutions ◽  
Adsorption Kinetics ◽  
Ph Value ◽  
Crosslinking Agent ◽  
Second Order ◽  
Order Model ◽  
Pseudo Second Order ◽  
Crosslinked Chitosan ◽  
Kinetics Of ◽  
Second Order Model

Chitosan was crosslinked using epichlorohydrin as crosslinking agent to prepare crosslinked chitosan which was used as an adsorbent for the removal of Zn(II) from aqueous solutions. The adsorption prosperities of Zn(II) on crosslinked chitosan were studied, including the influence of pH value and the adsorption kinetics. The kinetics of adsorption was discussed using two kinetic models, the pseudo first-order and the pseudo second-order model. Results reveal that the crosslinked chitosan is suitable as adsorbent to remove Zn(II) from dilute solution. The rate parameters for the Zn(II) by crosslinked chitosan were also determined. It was shown that the adsorption kinetics of Zn(II) could be best described by the pseudo second-order model and the adsorption process may involve a physical adsorption.

Adsorption Kinetics of Pb2+ Ions Using Chitosan Nanoparticles

2013 ◽  
Vol 367 ◽  
pp. 45-49
Author(s):  
Ying Hong ◽  
Ze Hui Zhong ◽  
You Shi Liu
Keyword(s):  
Adsorption Kinetics ◽  
Chitosan Nanoparticles ◽  
Second Order ◽  
Isotherm Model ◽  
Order Model ◽  
Adsorption Characteristics ◽  
Pseudo Second Order ◽  
Kinetics Of ◽  
Second Order Model

Chitosan nanoparticles were prepared by crosslinkingusing TPP. SEM showed that chitosan nanoparticles were successfully obtained.The adsorption characteristics of chitosan nanoparticles were evaluated. Theresults demonstrated that chitosan nanoparticles were suitable for adsorbent toremoval Pb2+. The parameters for the adsorption of Pb2+by chitosan nanoparticles were also determined. It was shown that chitosannanoparticles were fit for Langmuir’s isotherm model and that the adsorptionkinetics of Pb2+ described by the pseudo-second-order model could bebest.

Adorption and Kinetics Studies of Baritite on Cr (VI) from Aqueous Solutions

2011 ◽  
Vol 347-353 ◽  
pp. 281-284
Author(s):  
Peng Ge ◽  
Li Juan Wan ◽  
Ya Jing Xu
Keyword(s):  
Experimental Data ◽  
Aqueous Solutions ◽  
Adsorption Capacity ◽  
Adsorption Kinetics ◽  
Natural Zeolite ◽  
Second Order ◽  
Order Model ◽  
Kinetics Studies ◽  
Pseudo Second Order ◽  
Kinetics Of

Among the investigated clays and minerals (kaolinite, natural zeolite, manual zeolite, bentonite, sepiolite, sepiolite amianthus, tremolite amianthus, vermiculite and baritite), the baritite clay was selected as the optimal adsorbent for aqueous Cr (VI). The Cr (VI) adsorption capacity on baritite clay reached as high as 39.01 mg∙g−1 at 20°C. Then the adsorption kinetics of Cr (VI) by the baritite clay were investigated in details. Results showed that the pseudo-second-order model was a suitable description for the adsorption kinetics and fitted well with the experimental data.

scholarly journals Study of Fluoride Affinity by Zirconium Impregnated Walnut Shell Carbon in Aqueous Phase: Kinetic and Isotherm Evaluation

2013 ◽  
Vol 2013 ◽  
pp. 1-8 ◽  
Author(s):  
M. Rajan ◽  
G. Alagumuthu
Keyword(s):  
Ph Value ◽  
Freundlich Isotherm ◽  
Second Order ◽  
Walnut Shell ◽  
Fluoride Removal ◽  
Order Model ◽  
Intraparticle Diffusion Model ◽  
Bicarbonate Ions ◽  
Pseudo Second Order ◽  
Second Order Model

This paper examines the kinetics of fluoride removal from water by the adsorbent zirconium-impregnated walnut-shell carbon (ZIWSC), exploring the mechanisms involved. The dependence of the adsorption of fluoride on the pH of the solution has been studied to achieve the optimum pH value and a better understanding of the adsorption mechanism. The presence of bicarbonate ions in aqueous solution was found to affect the fluoride removal indicating that these anions compete with the sorption of fluoride on adsorbents. The kinetic profile has been modeled using pseudo-first-order model, pseudo-second-order model, and intraparticle diffusion model. The kinetic sorption profiles offered excellent fit with pseudo-second-order model. Adsorption isotherms have been modeled by Langmuir, Freundlich, and Temkin equations, and their constants were determined. The equilibrium adsorption data were fitted reasonably well for Freundlich isotherm model. XRD and SEM patterns of the ZIWSC were recorded to get better insight into the mechanism of adsorption process.

scholarly journals Kinetic and Thermodynamic Studies on the Phosphate Adsorption Removal by Dolomite Mineral

2015 ◽  
Vol 2015 ◽  
pp. 1-8 ◽  
Author(s):  
Xiaoli Yuan ◽  
Wentang Xia ◽  
Juan An ◽  
Jianguo Yin ◽  
Xuejiao Zhou ◽  
...  
Keyword(s):  
Adsorption Kinetics ◽  
Removal Rate ◽  
Second Order ◽  
Phosphate Removal ◽  
Phosphate Adsorption ◽  
Maximum Adsorption Capacity ◽  
Order Model ◽  
Thermodynamic Studies ◽  
Pseudo Second Order ◽  
Second Order Model

The efficiency of dolomite to remove phosphate from aqueous solutions was investigated. The experimental results showed that the removal of phosphate by dolomite was rapid (the removal rate over 95% in 60 min) when the initial phosphate concentration is at the range of 10–50 mg/L. Several kinetic models including intraparticle diffusion model, pseudo-first-order model, Elovich model, and pseudo-second-order model were employed to evaluate the kinetics data of phosphate adsorption onto dolomite and pseudo-second-order model was recommended to describe the adsorption kinetics characteristics. Further analysis of the adsorption kinetics indicated that the phosphate removal process was mainly controlled by chemical bonding or chemisorption. Moreover, both Freundlich and Langmuir adsorption isotherms were used to evaluate the experimental data. The results indicated that Langmuir isotherm was more suitable to describe the adsorption characteristics of dolomite. Maximum adsorption capacity of phosphate by dolomite was found to be 4.76 mg phosphorous/g dolomite. Thermodynamic studies showed that phosphate adsorption was exothermic. The study implies that dolomite is an excellent low cost material for phosphate removal in wastewater treatment process.

Adsorption of Cu(II) from Aqueous Solutions by Ammoniated Cotton Fiber

2016 ◽  
Vol 11 (4) ◽  
pp. 155892501601100
Author(s):  
Chuanfeng Zang ◽  
Yu Ren ◽  
Fangfang Wang ◽  
Hong Lin ◽  
Yuyue Chen
Keyword(s):  
Aqueous Solutions ◽  
Cotton Fiber ◽  
Photoelectron Spectroscopy ◽  
Metal Ion ◽  
Second Order ◽  
Order Model ◽  
Amine Content ◽  
Pseudo Second Order ◽  
Adsorption Amount ◽  
Second Order Model

This study describes the preparation of a novel chelating cotton fiber adsorbent, ammoniated cotton fiber (ACF), which was prepared by modifying cotton fiber with amino-HBP using glutaraldehyde as a cross-linking agent. This new adsorbent was characterized and analyzed for amine content, and by scanning electron microscopy, Fourier transform infrared spectroscopy and X-ray photoelectron spectroscopy. The capacity of ACF to adsorb Cu(II) from aqueous solution was evaluated at different pHs, contact times and initial metal ion concentrations. The results showed that ACF was effective in removing of Cu(II) from aqueous solutions and the adsorption amount of Cu(II) reached 16.7374 mg g-1. The adsorption isotherm and kinetics were well fitted to the Langmuir model and the pseudo-second-order model, respectively. The adsorption amount calculated using the pseudo-second-order model was in good agreement with the experimental data.

Electrosorption of Methylene Blue from Aqueous Solution on Graphene-Titanium Electrode: Adsorption Kinetics Studies

2018 ◽  
Vol 17 (2) ◽  
Author(s):  
Dan Wu ◽  
Yaxiu Zhao ◽  
Qiang Liu ◽  
Chein-Chi Chang ◽  
Wei Hou
Keyword(s):  
Aqueous Solution ◽  
Methylene Blue ◽  
Adsorption Kinetics ◽  
Graphene Film ◽  
Titanium Substrate ◽  
Second Order ◽  
Applied Potential ◽  
Order Model ◽  
Pseudo Second Order ◽  
Second Order Model

Abstract A graphene film deposited on titanium substrate was successfully prepared by a facile solution evaporation method, as electrode exhibiting superior electrosorption property toward methylene blue (MB) from aqueous solution. The fabricated graphene film on titanium substrate was characterized in detail by scanning electron microscopy (SEM) and FTIR techniques. As electrode (GTE) for electrosorption of MB, some experimental parameters, such as applied potential, concentration of electrolyte, solution initial pH and temperature, were systematically investigated and discussed. The experimental results demonstrated that the maximum adsorption capacity using GTE can reach 86.06 mg· g−1 under the optimized conditions of −600 mV of applied potential, pH of 7.5, 293 K and 0.01 mg· L−1 Na2SO4 solution, which is 1.40 times of that obtained under open circuit condition in 10 mg· L−1 MB solution. The adsorption isotherm of MB on GTE was analyzed with Langmuir and Freundlich isotherm equations, Pseudo-first-order model, pseudo-second-order model, and intra-particle diffusion model were applied to depict the adsorption kinetics process. The electrosorption of MB preferably fitted Langmuir isotherm, indicating a single-layer adsorption of MB molecules on graphene film followed pseudo-second-order model. Moreover the electrosorption of MB on GTE was found to be spontaneous and endothermic process. This work would be helpful to design and fabricate high performance carbon-based electrodes for high efficiency electrosorption treatment of dye wastewaters.

scholarly journals K2CO3-Activated Pomelo Peels as a High-Performance Adsorbent for Removal of Cu(II): Preparation, Characterization, and Adsorption Studies

2021 ◽  
Vol 2021 ◽  
pp. 1-11
Author(s):  
Zheng Liu ◽  
Yuling Wei
Keyword(s):  
Aqueous Solutions ◽  
Adsorption Capacity ◽  
Activated Carbons ◽  
High Surface ◽  
Second Order ◽  
Order Model ◽  
Activation Temperature ◽  
Batch Mode ◽  
Pseudo Second Order ◽  
Second Order Model

Activated carbons (ACs) were prepared from pomelo peels by K2CO3 activation and used as an adsorbent (PAC) for the removal of Cu(II) from aqueous solutions. BET, SEM, and FT-IR were employed for the characterization of the obtained ACs. The optimum ACs were reported at activation temperature of 850°C, activation time of 60 min, and impregnation ratio of 3, which had a high surface area (1213 m2/g) and total pore volume (0.57 cm3/g). The resulting ACs were used for the adsorption of Cu(II) from aqueous solutions in the batch mode and yielded a superior adsorption capacity of 139.08 mg/g. The pH of optimum adsorption was determined as 5. Pseudo first-order model, pseudo second-order model, and intraparticle diffusion model were applied to describe the adsorption processes. The adsorption kinetic data were found to follow the pseudo second-order model. The adsorption isotherms data were analyzed using Langmuir, Freundlich, Temkin, and Dubinin–Radushkevich models. The Langmuir model was found to provide the best fit, and the calculated adsorption capacity was 151.35 mg/g.

Adsorption Kinetics of Pb (II) onto Na-Bentonite/Poly AMPS Composite

2012 ◽  
Vol 528 ◽  
pp. 99-102
Author(s):  
Hai Yan Xiao ◽  
Kai Sha Gao ◽  
Qiu Rong Li
Keyword(s):  
Aqueous Solutions ◽  
Adsorption Kinetics ◽  
Adsorption Mechanism ◽  
Second Order ◽  
Ftir Spectra ◽  
Fast Process ◽  
Pseudo Second Order ◽  
Kinetics Of

Na-bentonite(NB)/poly(2-acrylamido-2-methylpropanesulfonicacid)(AMPS) composite were prepared as an adsorbent for the removal of Pb (Ⅱ) from aqueous solutions. Pb (II) adsorption on the composite is a fast process and follows well the pseudo-second-order kinetics. The FTIR spectra indicate NB and poly(AMPS) are simultaneously operating, and chelation should be the dominating adsorption mechanism.

Sign in / Sign up

Export Citation Format

Share Document