Effect of Au Doped WO3 Gas Sensors for NO2 Detection

2011 ◽  
Vol 492 ◽  
pp. 308-311 ◽  
Author(s):  
Wu Bin Gao ◽  
Cheng Dong ◽  
Xu Liu ◽  
Yun Han Ling ◽  
Jia Lin Sun
Keyword(s):  
Gas Sensors ◽  
Gas Sensing ◽  
Point Contact ◽  
X Ray ◽  
Sensing Properties ◽  
Gas Sensing Properties ◽  
Tungsten Filaments ◽  
Gas Response ◽  
Contact Sensors

Gas sensor based on point contact tungsten trioxide (WO3) was prepared by in-situ induction-heating thermal oxidation of tungsten filaments. X-ray diffractometry (XRD) and field emission scanning electron microscopy (FESEM) were employed to analyze the phase and the morphology of the fabricated thin films. The results showed that the WO3films exhibited a monoclinic phase and were composed of hierarchical micro and nano crystals. The NO2(1-8 ppm) sensing properties of the point contact sensors based on Pure and Au-sputtering doped (2.5 at%) WO3films were investigated. The results showed that the gas sensing properties of the Au (2.5 at%) doped WO3sensors were superior to those of the undoped. The obtained point contact WO3sensor exhibited the maximum NO2gas response at 100°C.

The Characterization and Gas Sensing Properties of Polythiophene Coated V2O5 Nanotubes

2010 ◽  
Vol 654-656 ◽  
pp. 1154-1157 ◽  
Author(s):  
Yu Lu ◽  
Wei Jin ◽  
Wen Chen
Keyword(s):  
Electron Microscopy ◽  
Gas Sensing ◽  
In Situ Polymerization ◽  
X Ray Diffraction ◽  
X Ray ◽  
Sensing Properties ◽  
Transmission Electron ◽  
Gas Sensing Properties ◽  
Higher Sensitivity

Polythiophene (PTP) coated V2O5 nanotubes were prepared by an in-situ polymerization of thiophene monomers in the presence of prepared V2O5 nanotubes. The nanotubes were characterized by X-ray diffraction (XRD), scanning electron microscopy (SEM) and transmission electron microscopy (TEM), which proved the polymerization of thiophene monomer and the strong interaction between polythiophene and V2O5 nanotubes (VONTs). The gas sensing properties of PTP coated V2O5 nanotubes were studied at room temperature, which was found that PTP coated V2O5 nanotubes could detect ethanol with much higher sensitivity than pure VONTs. The sensing mechanism of PTP coated V2O5 nanotubes to ethanol is presumed to be the synergetic interaction between polythiophene (PTP) and V2O5 nanotubes.

scholarly journals Preparation of Nanostructured SnO2-NiO Composite Semiconductor for Gas Sensor Applications

2021 ◽  
pp. 391-403
Author(s):  
S. Kumar ◽  
P. Gowthaman ◽  
J. Deenathayalan
Keyword(s):  
Gas Sensor ◽  
Composite Nanofibers ◽  
Volume Fraction ◽  
Gas Sensing ◽  
Precipitation Method ◽  
Response Sensitivity ◽  
X Ray ◽  
Sensing Properties ◽  
Working Temperature ◽  
Gas Sensing Properties

Electro spinning technology combined with chemical precipitation method and high-temperature calcination was used to prepare SnO2-NiO composite semiconductor nanofibers with different Sn content. Scanning electron microscope (SEM), X-ray diffractometer (XRD) and energy dispersive X-ray spectrometer (EDS) were used to characterize the morphology, structure and content of various elements of the sample. Using ethanol as the target gas, the gas sensing properties of SnO2-NiO nanofibers and the influence of Sn content on the gas sensing properties of composite nanofibers were explored. The research results show that SnO2-NiO composite nanofibers have a three-dimensional network structure, and the SnO2 composite can significantly enhance the gas sensitivity of NiO nanofibers. With increase of SnO2 content, the response sensitivity of composite fibers to ethanol gas increases, and the response sensitivity of composite nanofibers with the highest response to ethanol gas with a volume fraction of 100×10-6 at the optimal working temperature of 160℃ are13.4;It is 8.38 times the maximum response sensitivity of NiO nanofibers. Compared with the common ethanol gas sensor MQ-3 on the market, SnO2-NiO composite nanofibers have a lower optimal working temperature and higher response sensitivity, which has certain practical application value

A Novel Tungsten Trioxide Based Gas Sensor for Indoor Formaldehyde Detection

2021 ◽  
Vol 16 (3) ◽  
pp. 363-367
Author(s):  
Gaoqi Zhang ◽  
Fan Zhang ◽  
Kaifang Wang ◽  
Tao Tian ◽  
Shanyu Liu ◽  
...  
Keyword(s):  
Electron Microscope ◽  
Gas Sensor ◽  
Indoor Air ◽  
Gas Sensing ◽  
X Ray Diffraction ◽  
X Ray ◽  
Sensing Material ◽  
Transmission Electron ◽  
Gas Sensing Properties ◽  
Gas Response

Accurate and real-time detection of formaldehyde (HCHO) in indoor air is urgently needed for human health. In this work, a ceramic material (WO3·H2O) with unique structure was successfully prepared using an efficient hydrothermal method. The crystallinity, morphology and microstructure of the as-prepared sensing material were analyzed by X-ray diffraction (XRD), field emission scanning electron microscope (FESEM) as well as transmission electron microscope (TEM). The characterization results suggest that the as-prepared sample is composed of square-like nanoplates with uneven surface. Formaldehyde vapor is utilized as the target gas to investigate gas sensing properties of the synthesized novel nanoplates. The testing results indicate that the as-fabricated gas sensor exhibit high gas response and excellent repeatability to HCHO gas. The response value (Ra/Rg) is 24.5 towards 70 ppm HCHO gas at 350 °C. Besides, the gas sensing mechanism was described.

The effect of Nb doping on hydrogen gas sensing properties of capacitor-like Pt/Nb-TiO2/Pt hydrogen gas sensors

2019 ◽  
Vol 806 ◽  
pp. 1052-1059 ◽  
Author(s):  
Zhong Li ◽  
ZhengJun Yao ◽  
Azhar Ali Haidry ◽  
Tomas Plecenik ◽  
Branislav Grancic ◽  
...  
Keyword(s):  
Gas Sensors ◽  
Gas Sensing ◽  
Hydrogen Gas ◽  
Sensing Properties ◽  
Gas Sensing Properties ◽  
Hydrogen Gas Sensors ◽  
Nb Doping

scholarly journals Gas Sensing Properties of Mg-Incorporated Metal–Organic Frameworks

Sensors ◽  
2019 ◽  
Vol 19 (15) ◽  
pp. 3323 ◽  
Author(s):  
Jae-Hyoung Lee ◽  
Thanh-Binh Nguyen ◽  
Duy-Khoi Nguyen ◽  
Jae-Hun Kim ◽  
Jin-Young Kim ◽  
...  
Keyword(s):  
Pore Size ◽  
Gas Sensors ◽  
Gas Sensing ◽  
High Surface ◽  
Metal Organic Frameworks ◽  
Kinetic Properties ◽  
Sensing Properties ◽  
Sensing Applications ◽  
Gas Sensing Properties ◽  
Metal Organic

The gas sensing properties of two novel series of Mg-incorporated metal–organic frameworks (MOFs), termed Mg-MOFs-I and -II, were assessed. The synthesized iso-reticular type Mg-MOFs exhibited good crystallinity, high thermal stability, needle-shape morphology and high surface area (up to 2900 m2·g−1), which are promising for gas sensing applications. Gas-sensing studies of gas sensors fabricated from Mg-MOFs-II revealed better sensing performance, in terms of the sensor dynamics and sensor response, at an optimal operating temperature of 200 °C. The MOF gas sensor with a larger pore size and volume showed shorter response and recovery times, demonstrating the importance of the pore size and volume on the kinetic properties of MOF-based gas sensors. The gas-sensing results obtained in this study highlight the potential of Mg-MOFs gas sensors for the practical monitoring of toxic gases in a range of environments.

scholarly journals NOx Gas Sensing Properties and Mechanism of ZnO-Based Varistor-Type Gas Sensors

1999 ◽  
Vol 119 (2) ◽  
pp. 103-107 ◽  
Author(s):  
Takeo Hyodo ◽  
Keiko Okamoto ◽  
Yuji Takao ◽  
Yasuhiro Shimizu ◽  
Makoto Egashira
Keyword(s):  
Gas Sensors ◽  
Gas Sensing ◽  
Sensing Properties ◽  
Gas Sensing Properties

New Insight into Gas Sensing Properties of SnO2 and Cu2o/CuO Based Gas Sensors By Near Ambient Pressure XPS

2020 ◽  
Vol MA2020-01 (28) ◽  
pp. 2114-2114
Author(s):  
Mykhailo Vorokhta ◽  
Pavel Hozak ◽  
Ivan Khalakhan ◽  
Martin Vrnata ◽  
Ján Lančok ◽  
...  
Keyword(s):  
Gas Sensors ◽  
Gas Sensing ◽  
Ambient Pressure ◽  
Sensing Properties ◽  
Ambient Pressure Xps ◽  
Gas Sensing Properties ◽  
Insight Into ◽  
Near Ambient Pressure Xps

scholarly journals Discriminable Sensing Response Behavior to Homogeneous Gases Based on n-ZnO/p-NiO Composites

Nanomaterials ◽  
2020 ◽  
Vol 10 (4) ◽  
pp. 785 ◽  
Author(s):  
Wen-Dong Zhou ◽  
Davoud Dastan ◽  
Jing Li ◽  
Xi-Tao Yin ◽  
Qi Wang
Keyword(s):  
Gas Sensors ◽  
Gas Sensing ◽  
Sol Gel ◽  
High Sensitivity ◽  
Oxide Semiconductor ◽  
Sensing Properties ◽  
Gas Sensing Properties ◽  
P Type ◽  
Type Response ◽  
Properties Of Composites

Metal oxide semiconductor (MOS) gas sensors have the advantages of high sensitivity, short response-recovery time and long-term stability. However, the shortcoming of poor discriminability of homogeneous gases limits their applications in gas sensors. It is well-known that the MOS materials have similar gas sensing responses to homogeneous gases such as CO and H2, so it is difficult for these gas sensors to distinguish the two gases. In this paper, simple sol–gel method was employed to obtain the ZnO–xNiO composites. Gas sensing performance results illustrated that the gas sensing properties of composites with x > 0.425 showed a p-type response to both CO and H2, while the gas sensing properties of composites with x < 0.425 showed an n-type response to both CO and H2. However, it was interesting that ZnO–0.425NiO showed a p-type response to CO but an discriminable response (n-type) to H2, which indicated that modulating the p-type or n-type semiconductor concentration in p-n composites could be an effective method with which to improve the discriminability of this type of gas sensor regarding CO and H2. The phenomenon of the special gas sensing behavior of ZnO–0.425NiO was explained based on the experimental observations and a range of characterization techniques, including XRD, HRTEM and XPS, in detail.

In situ growth of WO3 nanotube arrays and their H2S gas sensing properties for reduced operating temperature

2020 ◽  
Vol 271 ◽  
pp. 127716
Author(s):  
Xiaoguang San ◽  
Yiming Lu ◽  
Guosheng Wang ◽  
Dan Meng ◽  
Xiaohui Gong ◽  
...  
Keyword(s):  
Gas Sensing ◽  
Operating Temperature ◽  
Nanotube Arrays ◽  
In Situ Growth ◽  
Sensing Properties ◽  
Gas Sensing Properties

On the Role of Oxygen Vacancies in the Determination of the Gas-Sensing Properties of Tin-Oxide Nanowires

2006 ◽  
Vol 915 ◽  
Author(s):  
Roberto Mosca ◽  
Mingzheng Zha ◽  
Davide Calestani ◽  
Laura Lazzarini ◽  
Giancarlo Salviati ◽  
...  
Keyword(s):  
Gas Sensors ◽  
Oxygen Vacancies ◽  
Gas Sensing ◽  
Oxide Nanowires ◽  
Sensing Properties ◽  
Sno2 Nanowires ◽  
Gas Sensing Properties ◽  
First Results ◽  
Depth Study

AbstractSnO2 nanowires have been recently employed in the “gas-sensors” field and excellent results of conductometric and optical tests on SnO2 nanowires-based gas sensors have been reported.However, the mechanism that controls the gas-sensing effect in metal oxides nanowires is not fully understood yet. Here the authors present the first results of an in-depth study about the influence of post growth treatments on the physical and gas sensing properties of SnO2 nanowires.In particular, SnO2 nanowires grown by a vapour transport technique were annealed in a oxygen-rich atmosphere and then characterized by different techniques to assess the influence of the treatment on the nanowires properties.The annealing in oxygen atmosphere is shown to strongly affect the PL and CL spectra, the electrical resistivity as well as the gas sensing properties of the nanowires. The obtained results are consistent with a reduction of the oxygen vacancies concentration induced by the O2 treatment and seem to confirm the role of these defects in affecting the gas response of SnO2 nanowires-based sensors.

Sign in / Sign up

Export Citation Format

Share Document