Adsorption of hazardous dye crystal violet from industrial waste using low-cost adsorbent Chenopodium album

2019 ◽  
Vol 167 ◽  
pp. 324-332 ◽  
Author(s):  
Charu Arora ◽  
Deepti Sahu ◽  
Dipti Bharti ◽  
Vinita Tamrakar ◽  
Sanju Soni ◽  
...  
2019 ◽  
Vol 7 (2) ◽  
pp. 240-246
Author(s):  
Kaur Harpreet ◽  
Kaur Harpreet ◽  
Vandana Kamboj ◽  
Vandana Kamboj

Water is the most crucial thing to mankind and so its contamination by various agencies is posing a threat to the natural balance. So, in the present work, the efficiency of various adsorbents derived from plant waste, to remove different dyes from aqueous solution was evaluated. Parameters for study were contact time, concentration and pH. Various combinations of plant ashes were used for the study. It was found that adsorbent prepared from the combination of orange peels, pomegranate and banana peels ashes, exhibited good adsorption capacity for methylene blue, congo red and crystal violet. All these dyes were completely removed from the aqueous solution while methyl orange was not removed. Congo red was removed completely within 40 min of contact with the adsorbent while methyl orange took 3 hrs to be removed to the extent of 48% only. The adsorption coefficient of congo red was found to be 2.33 while value for methylene blue and crystal violet was 1 and 1.66 respectively. The characterization of adsorbent was done by Scanning Electron Microscopy and IR spectroscopy. SEM image revealed the surface of adsorbent to be made of differential pores. From the results it became evident that the low-cost adsorbent could be used as a replacement for costly traditional methods of removing colorants from water.


2018 ◽  
Vol 930 ◽  
pp. 254-257 ◽  
Author(s):  
Francisca Pereira de Araújo ◽  
Josy Anteveli Osajima ◽  
Mônica Regina Silva de Araujo ◽  
Edson Cavalcanti da Silva Filho ◽  
João Sammy Nery de Souza

Polystyrene is commercial polymer of extensive use in industrial scale due to great physical and chemical properties and low cost. Lifespan of polymer materials can be changed by incorporation of additions to polymeric matrix.The present study aimed to evaluate the influence of crystal violet dye in polystyrene matrices when irradiated by visible radiation. The samples were studied in the form of films, in which solution of crystal violet (5.0x10-4mol.L-1) was added to the PS solution (8% w / w). The films were irradiated with commercial lamp for 150 hours and analyzed with UV-Vis and FTIR. The results showed that the dye degraded at a rate of 16%, however the FTIR analysis revealed that polystyrene did not degrade under the conditions studied, since no formation of carbonyl compounds was observed.


Clay Minerals ◽  
1999 ◽  
Vol 34 (3) ◽  
pp. 469-477 ◽  
Author(s):  
A. Garcia Sanchez ◽  
E. Alvarez Ayuso ◽  
O. Jimenez de Blas

AbstractThe adsorption by different silicate minerals of some heavy metals, present in industrial waste water, has been studied. These adsorbents (mainly clay minerals) are readily available, inexpensive materials and offer a cost-effective alternative to conventional treatment of wastes from the metal finishing industry. The results show that some mineral species are suitable for the purification of such residual waters down to the limits prescribed by current legislation concerning industrial wastes. The Langmuir model was found to describe such adsorption processes best. Sepiolite (Orera, Spain) has an adsorption capacity of 8.26 mg g-1 for Cd2+, the capacities depending on the metal adsorbed in the order: Cd2+ > Cu2+ > Zn2+ > Ni2+. This mineral shows the highest sorption capacity relative to the other minerals studied. Factors in the reaction medium such as pH and ionic strength influenced the adsorption process.


Sign in / Sign up

Export Citation Format

Share Document