scholarly journals Technical Note: An implementation of the dry removal processes DRY DEPosition and SEDImentation in the Modular Earth Submodel System (MESSy)

2006 ◽  
Vol 6 (12) ◽  
pp. 4617-4632 ◽  
Author(s):  
A. Kerkweg ◽  
J. Buchholz ◽  
L. Ganzeveld ◽  
A. Pozzer ◽  
H. Tost ◽  
...  

Abstract. We present the submodels DRYDEP and SEDI for the Modular Earth Submodel System (MESSy). Dry deposition of gases and aerosols is calculated within DRYDEP, whereas SEDI deals with aerosol particle sedimentation. Dry deposition velocities depend on the near-surface turbulence and the physical and chemical properties of the surface cover (e.g. the roughness length, soil pH or leaf stomatal exchange). The dry deposition algorithm used in DRYDEP is based on the big leaf approach and is described in detail within this Technical Note. The sedimentation submodel SEDI contains two sedimentation schemes: a simple upwind zeroth order scheme and a first order approach.

2006 ◽  
Vol 6 (4) ◽  
pp. 6853-6901 ◽  
Author(s):  
A. Kerkweg ◽  
J. Buchholz ◽  
L. Ganzeveld ◽  
A. Pozzer ◽  
H. Tost ◽  
...  

Abstract. We present the submodels DRYDEP and SEDI for the Modular Earth Submodel System (MESSy). Gas phase and aerosol dry deposition are calculated within DRYDEP, whereas SEDI deals with aerosol particle sedimentation. Dry deposition velocities depend on the near-surface turbulence and the physical and chemical properties of the surface cover (e.g. the roughness length, soil pH or leaf stomatal exchange). The dry deposition algorithm used in DRYDEP is based on the big leaf approach and is described in detail within this Technical Note. The sedimentation submodel SEDI contains two sedimentation schemes: a simple upwind zeroth order scheme and a first order approach.


2013 ◽  
Vol 7 (4) ◽  
pp. 1139-1160 ◽  
Author(s):  
C. M. Carmagnola ◽  
F. Domine ◽  
M. Dumont ◽  
P. Wright ◽  
B. Strellis ◽  
...  

Abstract. The broadband albedo of surface snow is determined both by the near-surface profile of the physical and chemical properties of the snowpack and by the spectral and angular characteristics of the incident solar radiation. Simultaneous measurements of the physical and chemical properties of snow were carried out at Summit Camp, Greenland (72°36´ N, 38°25´ W, 3210 m a.s.l.) in May and June 2011, along with spectral albedo measurements. One of the main objectives of the field campaign was to test our ability to predict snow spectral albedo by comparing the measured albedo to the albedo calculated with a radiative transfer model, using measured snow physical and chemical properties. To achieve this goal, we made daily measurements of the snow spectral albedo in the range 350–2200 nm and recorded snow stratigraphic information down to roughly 80 cm. The snow specific surface area (SSA) was measured using the DUFISSS instrument (DUal Frequency Integrating Sphere for Snow SSA measurement, Gallet et al., 2009). Samples were also collected for chemical analyses including black carbon (BC) and dust, to evaluate the impact of light absorbing particulate matter in snow. This is one of the most comprehensive albedo-related data sets combining chemical analysis, snow physical properties and spectral albedo measurements obtained in a polar environment. The surface albedo was calculated from density, SSA, BC and dust profiles using the DISORT model (DIScrete Ordinate Radiative Transfer, Stamnes et al., 1988) and compared to the measured values. Results indicate that the energy absorbed by the snowpack through the whole spectrum considered can be inferred within 1.10%. This accuracy is only slightly better than that which can be obtained considering pure snow, meaning that the impact of impurities on the snow albedo is small at Summit. In the near infrared, minor deviations in albedo up to 0.014 can be due to the accuracy of radiation and SSA measurements and to the surface roughness, whereas deviations up to 0.05 can be explained by the spatial heterogeneity of the snowpack at small scales, the assumption of spherical snow grains made for DISORT simulations and the vertical resolution of measurements of surface layer physical properties. At 1430 and around 1800 nm the discrepancies are larger and independent of the snow properties; we propose that they are due to errors in the ice refractive index at these wavelengths. This work contributes to the development of physically based albedo schemes in detailed snowpack models, and to the improvement of retrieval algorithms for estimating snow properties from remote sensing data.


2002 ◽  
Vol 48 (160) ◽  
pp. 149-158 ◽  
Author(s):  
Martin Sharp ◽  
Mark Skidmore ◽  
Peter Nienow

AbstractThis paper describes the physical and chemical properties of the snow- pack on John Evans Glacier, Ellesmere Island, Canadian Arctic Archipelago, and investigates the controls on snowpack solute concentrations and atmospheric deposition. The snowpack contains three layers that are traceable across the whole glacier. These represent fall accumulation that has been metamorphosed to depth hoar, winter accumulation mixed with snow reworked by wind from the underlying depth hoar, and spring accumulation mixed with wind-reworked snow. The seasonal cycle in snow chemistry closely reflects changes in the composition of the atmospheric aerosol at Alert, with some modification of NO3− concentrations by post-depositional processes. Mean water-weighted solute concentrations in the snowpack are largely independent of accumulation, while atmospheric deposition tends to increase with accumulation. This suggests that, for most species, wet deposition is the dominant depositional process throughout the year. However, concentrations of Ca2+ and K+ increase with both accumulation and elevation, implying an enhanced input from dry deposition of soil dust above 800 m elevation. Concentrations of SO42− are inversely related to accumulation, especially in the winter layer, suggesting a significant input from non-precipitating events, such as dry deposition or riming, during this period of very limited snowfall.


2012 ◽  
Vol 6 (6) ◽  
pp. 5119-5167 ◽  
Author(s):  
C. M. Carmagnola ◽  
F. Domine ◽  
M. Dumont ◽  
P. Wright ◽  
B. Strellis ◽  
...  

Abstract. The albedo of surface snow is determined both by the near-surface profile of the physical and chemical properties of the snowpack and by the spectral and angular characteristics of the incident solar radiation. Simultaneous measurements of the physical and chemical properties of snow were carried out at Summit Camp, Greenland (72°36´ N, 38°25´ W, 3210 m a.s.l.) in May and June 2011, along with spectral albedo measurements. One of the main objectives of the field campaign was to test our ability to predict snow albedo comparing measured snow spectral albedo to the albedo calculated with a radiative transfer model. To achieve this goal, we made daily measurements of the snow spectral albedo in the range 350–2200 nm and recorded snow stratigraphic information down to roughly 80 cm. The snow specific surface area (SSA) was measured using the DUFISSS instrument (DUal Frequency Integrating Sphere for Snow SSA measurement, Gallet et al., 2009). Samples were also collected for chemical analyses including black carbon (BC) and trace elements, to evaluate the impact of light absorbing particulate matter in snow. This is one of the most comprehensive albedo-related data sets combining chemical analysis, snow physical properties and spectral albedo measurements obtained in a polar environment. The surface albedo was calculated from density, SSA, BC and dust profiles using the DISORT model (DIScrete Ordinate Radiative Transfer, Stamnes et al., 1988) and compared to the measured values. Results indicate that the energy absorbed by the snowpack through the whole spectrum considered can be inferred within 1.35%. This accuracy is only slightly better than that which can be obtained considering pure snow, meaning that the impact of impurities on the snow albedo is small at Summit. In the visible region, the discrepancies between measured and simulated albedo are mostly due to the lack of correction of the cosine collector deviation from a true cosine response. In the near-infrared, minor deviations up to 0.014 can be due the accuracy of SSA measurements and to the surface roughness, whereas deviations up to 0.05 can be explained by the vertical resolution of measurements of surface layer physical properties. At 1430 and around 1800 nm the discrepancies are larger and independent of the snow properties; they may be due to the uncertainties in the ice refractive index at these wavelengths. This work contributes to the development of physically-based albedo schemes in detailed snowpack models, and to the improvement of retrieval algorithms for estimating snow properties from remote sensing data.


Energies ◽  
2021 ◽  
Vol 14 (16) ◽  
pp. 4801
Author(s):  
Myroslav Kindrachuk ◽  
Dmytro Volchenko ◽  
Alexander Balitskii ◽  
Karol F. Abramek ◽  
Mykola Volchenko ◽  
...  

We describe the external and internal hydrogen iInteraction on contacting surfaces in the “cylinder–piston rings” friction coupling. Under the influence of high temperatures and pressure, the oil in the combustion chamber at a temperature up to 1473 K decomposes and forms small amounts of water. External hydrogen (H2) is subsequently formed. Hydrogen removal from the piston rings reduces the heterogeneity of the structure, residual stresses, and uneven physical and chemical properties of the near-surface layers, which reduces the stress concentration and, as a consequence, results in an improvement in the performance characteristics of the surface layers of the friction couple “cylinder-piston rings” of the spark ignition engine.


1966 ◽  
Vol 24 ◽  
pp. 101-110
Author(s):  
W. Iwanowska

In connection with the spectrophotometric study of population-type characteristics of various kinds of stars, a statistical analysis of kinematical and distribution parameters of the same stars is performed at the Toruń Observatory. This has a twofold purpose: first, to provide a practical guide in selecting stars for observing programmes, second, to contribute to the understanding of relations existing between the physical and chemical properties of stars and their kinematics and distribution in the Galaxy.


Author(s):  
Mehmet Sarikaya ◽  
Ilhan A. Aksay

Biomimetics involves investigation of structure, function, and methods of synthesis of biological composite materials. The goal is to apply this information to the design and synthesis of materials for engineering applications.Properties of engineering materials are structure sensitive through the whole spectrum of dimensions from nanometer to macro scale. The goal in designing and processing of technological materials, therefore, is to control microstructural evolution at each of these dimensions so as to achieve predictable physical and chemical properties. Control at each successive level of dimension, however, is a major challenge as is the retention of integrity between successive levels. Engineering materials are rarely fabricated to achieve more than a few of the desired properties and the synthesis techniques usually involve high temperature or low pressure conditions that are energy inefficient and environmentally damaging.In contrast to human-made materials, organisms synthesize composites whose intricate structures are more controlled at each scale and hierarchical order.


2017 ◽  
pp. 31-43
Author(s):  
Berta Ratilla ◽  
Loreme Cagande ◽  
Othello Capuno

Organic farming is one of the management strategies that improve productivity of marginal uplands. The study aimed to: (1) evaluate effects of various organic-based fertilizers on the growth and yield of corn; (2) determine the appropriate combination for optimum yield; and (3) assess changes on the soil physical and chemical properties. Experiment was laid out in Randomized Complete Block Design, with 3 replications and 7 treatments, namely; T0=(0-0-0); T1=1t ha-1 Evans + 45-30-30kg N, P2O5, K2O ha-1; T2=t ha-1 Wellgrow + 45-30-30kg N, P2O5, K2O ha-1; T3=15t ha-1 chicken dung; T4=10t ha-1 chicken dung + 45-30-30kg N, P2O5, K2O ha-1; T5=15t ha-1 Vermicast; and T6=10t ha-1 Vermicast + 45-30-30kg N, P2O5, K2O ha-1. Application of organic-based fertilizers with or without inorganic fertilizers promoted growth of corn than the control. But due to high infestation of corn silk beetle(Monolepta bifasciata Horns), its grain yield was greatly affected. In the second cropping, except for Evans, any of these fertilizers applied alone or combined with 45-30-30kg N, P2O5, K2O ha-1 appeared appropriate in increasing corn earyield. Soil physical and chemical properties changed with addition of organic fertilizers. While bulk density decreased irrespective of treatments, pH, total N, available P and exchangeable K generally increased more with chicken dung application.


Sign in / Sign up

Export Citation Format

Share Document