Microstructural Constraints on Magmatic Mushes under Kīlauea Volcano, Hawai'i

Author(s):  
Penny Wieser ◽  
Marie Edmonds ◽  
John Maclennan ◽  
John Wheeler

<p>Distorted olivines of enigmatic origin are ubiquitous in erupted products from a wide range of volcanic systems (e.g., Hawai'i, Iceland, Andean Southern Volcanic Zone). At Kīlauea volcano, distorted olivines are commonly attributed to ductile creep within dunitic bodies located around the central conduit, or within the deep rift zones (~5–9 km depth). However, a recent suggestion that lattice distortions are produced by an early phase of branching dendritic growth, followed by textural ripening and the merging of misoriented crystal buds, has gained considerable traction.</p><p>A quantitative examination of the microstructures in distorted olivines by electron backscatter diffraction (EBSD) reveals striking similarities to microstructures observed in deformed mantle peridotites, but significant differences to the crystallographic signatures of dendritic growth. This suggests that lattice distortions record the application of differential stresses at high temperatures within the magmatic plumbing system, rather than rapid crystal growth. Previous petrological work has suggested that differential stresses are produced by ductile creep within Kīlauea’s deep rift zones. Crucially, this has fuelled suggestions that significant quantities of magma must travel along these rift zones in order to acquire distorted olivines, despite the paucity of geophysical evidence for these magma transport paths. In contrast, we show that the spatial distribution of eruptions containing distorted olivines is consistent with their derivation from the main magma storage reservoir. This model not only aligns petrological and geophysical observations at Kīlauea, but also accounts for the occurrence of distorted olivines in a wide variety of basaltic systems worldwide (which lack deep rift zones).</p><p>Application of piezometers developed for mantle peridotites reveals that distorted olivines have experienced differential stresses of ~3–12 MPa. Assuming that mush piles behave as granular materials, and form force chains, these stresses can be generated within cumulate piles of ~180–720 m. Based on available constraints on the magma supply rate and the geometry of Kīlauea’s summit reservoir, these thicknesses accumulate in a few centuries (consistent with residence times inferred from melt inclusion records).</p><p>Overall, we demonstrate that microstructural investigations of erupted olivine crystals by EBSD generates rich datasets which provide quantitative insights into crystal storage within mush piles. Under the increasingly prevalent view that crustal magmatic systems are mush-dominated, constraining the geometry and dynamics of crystal storage regions is crucial to further our understanding of magmatic plumbing systems. The presence of distorted olivines in many different volcanic settings highlights the global applicability of the methods developed in this study. Furthermore, assessments of deformation conditions using EBSD need not be restricted to olivine-bearing lavas. Microstructural fabrics types in natural and experimental samples have been established for a wide variety of igneous phases (e.g. diopside, plagioclase, hornblende), so similar approaches may be utilized in more evolved volcanic systems.</p>

2020 ◽  
Vol 11 (1) ◽  
Author(s):  
Penny E. Wieser ◽  
Marie Edmonds ◽  
John Maclennan ◽  
John Wheeler

AbstractDistorted olivines of enigmatic origin are ubiquitous in erupted products from a wide range of volcanic systems (e.g., Hawaiʻi, Iceland, Andes). Investigation of these features at Kīlauea Volcano, Hawaiʻi, using an integrative crystallographic and chemical approach places quantitative constraints on mush pile thicknesses. Electron backscatter diffraction (EBSD) reveals that the microstructural features of distorted olivines, whose chemical composition is distinct from undistorted olivines, are remarkably similar to olivines within deformed mantle peridotites, but inconsistent with an origin from dendritic growth. This, alongside the spatial distribution of distorted grains and the absence of adcumulate textures, suggests that olivines were deformed within melt-rich mush piles accumulating within the summit reservoir. Quantitative analysis of subgrain geometry reveals that olivines experienced differential stresses of ∼3–12 MPa, consistent with their storage in mush piles with thicknesses of a few hundred metres. Overall, our microstructural analysis of erupted crystals provides novel insights into mush-rich magmatic systems.


2013 ◽  
Vol 19 (S4) ◽  
pp. 103-104
Author(s):  
C.B. Garcia ◽  
E. Ariza ◽  
C.J. Tavares

Zinc Oxide is a wide band-gap compound semiconductor that has been used in optoelectronic and photovoltaic applications due to its good electrical and optical properties. Aluminium has been an efficient n-type dopant for ZnO to produce low resistivity films and high transparency to visible light. In addition, the improvement of these properties also depends on the morphology, crystalline structure and deposition parameters. In this work, ZnO:Al films were produced by d.c. pulsed magnetron sputtering deposition from a ZnO ceramic target (2.0 wt% Al2O3) on glass substrates, at a temperature of 250 ºC.The crystallographic orientation of aluminum doped zinc oxide (ZnO:Al) thin films has been studied by Electron Backscatter Diffraction (EBSD) technique. EBSD coupled with Scanning Electron Microscopy (SEM) is a powerful tool for the microstructural and crystallographic characterization of a wide range of materials.The investigation by EBSD technique of such films presents some challenges since this analysis requires a flat and smooth surface. This is a necessary condition to avoid any shadow effects during the experiments performed with high tilting conditions (70º). This is also essential to ensure a good control of the three dimensional projection of the crystalline axes on the geometrical references related to the sample.Crystalline texture is described by the inverse pole figure (IPF) maps (Figure 1). Through EBSD analysis it was observed that the external surface of the film presents a strong texture on the basal plane orientation (grains highlighted in red colour). Furthermore it was possible to verify that the grain size strongly depends on the deposition time (Figure 1 (a) and (b)). The electrical and optical film properties improve with increasing of the grain size, which can be mainly, attributed to the decrease in scattering grain boundaries which leads to an increasing in carrier mobility (Figure 2).The authors kindly acknowledge the financial support from the Portuguese Foundation for Science and Technology (FCT) scientific program for the National Network of Electron Microscopy (RNME) EDE/1511/RME/2005.


2021 ◽  
pp. SP518-2021-167
Author(s):  
Rajesh K. Srivastava ◽  
Richard E. Ernst ◽  
Kenneth L. Buchan ◽  
Michiel de Kock

AbstractIdentification of large volume, short duration mafic magmatic events of intraplate affinity in both continental and oceanic settings on the Earth and other planets provides invaluable clues for understanding several vital geological issues of current concern. Of particular importance is understanding the assembly and dispersal of supercontinents through Earth's history, dramatic climate change events including mass extinctions, and processes that have produced a wide range of LIP-related resources such as Ni-Cu-PGE, Au, U, base metals, and petroleum. This current volume presents some of the latest developments and new information on the temporal and spatial distribution of LIPs in both the Precambrian and Phanerozoic, their origin, the plumbing system of mafic dyke swarms, sill provinces, and layered inrusions, and links to mantle plumes/superplumes events, supercontinent reconstructions and associated metallogeny.


Geology ◽  
2019 ◽  
Vol 47 (10) ◽  
pp. 948-952 ◽  
Author(s):  
Penny E. Wieser ◽  
Zoja Vukmanovic ◽  
Rüdiger Kilian ◽  
Emilie Ringe ◽  
Marian B. Holness ◽  
...  

Abstract Crystal aggregates in igneous rocks have been variously ascribed to growth processes (e.g., twinning, heterogeneous nucleation, epitaxial growth, dendritic growth), or dynamical processes (e.g., synneusis, accumulation during settling). We tested these hypotheses by quantifying the relative orientation of adjacent crystals using electron backscatter diffraction. Both olivine aggregates from Kīlauea volcano (Hawaiʻi, USA) and chromite aggregates from the Bushveld Complex (South Africa) show diverse attachment geometries inconsistent with growth processes. Near-random attachments in chromite aggregates are consistent with accumulation by settling of individual crystals. Attachment geometries and prominent geochemical differences across grain boundaries in olivine aggregates are indicative of synneusis.


2020 ◽  
Vol 53 (4) ◽  
pp. 1060-1072 ◽  
Author(s):  
Edward L. Pang ◽  
Peter M. Larsen ◽  
Christopher A. Schuh

Resolving pseudosymmetry has long presented a challenge for electron backscatter diffraction and has been notoriously challenging in the case of tetragonal ZrO2 in particular. In this work, a method is proposed to resolve pseudosymmetry by building upon the dictionary indexing method and augmenting it with the application of global optimization to fit accurate pattern centers, clustering of the Hough-indexed orientations to focus the dictionary in orientation space and interpolation to improve the accuracy of the indexed solution. The proposed method is demonstrated to resolve pseudosymmetry with 100% accuracy in simulated patterns of tetragonal ZrO2, even with high degrees of binning and noise. The method is then used to index an experimental data set, which confirms its ability to efficiently and accurately resolve pseudosymmetry in these materials. The present method can be applied to resolve pseudosymmetry in a wide range of materials, possibly even some more challenging than tetragonal ZrO2. Source code for this implementation is available online.


1995 ◽  
Vol 119 (4) ◽  
pp. 331-344
Author(s):  
R. Hickey-Vargas ◽  
Mohammad J. Abdollahi ◽  
Miguel A. Parada ◽  
Leopoldo L�pez-Escobar ◽  
Fred A. Frey

Author(s):  
Stanislav Yesypovych ◽  
Olga Titarenko ◽  
Alla Bondarenko ◽  
Andrii Bubniak

Connection between geotectonic zoning of the territory and its oil and gas potential is shown on example of the actual drilling data of Dnieper-Donets Rift. First of all, the zones of connection of different geotectonic elements are the most promising, which is confirmed by their modern geodynamic activity. In this article, such transition zones are called seam rift zones (SRZ) for combining compression (seam) and stretching (rift) conditions. SRZs are distinguished by a wide range of aerospace, morphometric, geological and geophysical data.


Sign in / Sign up

Export Citation Format

Share Document