Floc-Flotation of Malachite Fines with an Octyl Hydroxamate and Kerosene Mixture

Malachite fines are easily produced in the grinding process, leading to low malachite flotation recovery. Floc-flotation of malachite fines with an octyl hydroxamate and kerosene mixture was studied to improve the flotation recovery, using microflotation, microscopy image observations, contact angle measurements, and Extended Derjguin–Landau–Verwey–Overbeek (EDLVO) analysis. The results showed that the addition of octyl hydroxamate as an emulsifier of kerosene enhanced the aggregation of malachite fines and improved malachite flotation recovery. In addition, when kerosene droplets were smaller and of uniform size distribution, the spreading of kerosene droplets on the malachite surface improved. The enhanced spreading of kerosene droplets led to higher coverage of kerosene on the malachite surface, resulting in improved hydrophobic aggregation and flotation recovery.

Structure and Properties of Hydrophobic Aggregation Hydrogel with Chemical Sensitive Switch

Hydrogels with chemical sensitive switch have control release properties in special environments. A series of polyacrylamide-octadecyl methacrylate hydrogels crosslinked by N,N′-bis (acryloyl) cystamine were synthesized as potential chemical sensitive system. When this hydrogel encounters dithiothreitol it can change its quality. The properties of the hydrogels were characterized by infrared spectroscopy, contact angle, and scanning electron microscopy. The water absorption of the hydrogel has the maximum value of 475%, when the content of octadecyl methacrylate is 5 wt%. The amount of weight loss was changed from 34.6% to 17.2%, as the content of octadecyl methacrylate increased from 3 wt% to 9.4 wt%. At the same time, the stress of the hydrogel decreased from 67.01% to 47.61%; the strength of the hydrogel reaches to the maximum 0.367 Mpa at 7 wt% octadecyl methacrylate. The increasing content of octadecyl methacrylate from 3 wt% to 9.4 wt% can enhance the hydrophobicity of the hydrogel; the contact angle of water to hydrogel changed from 14.10° to 19.62°. This hydrogel has the porous structure which permits loading of oils into the gel matrix. The functionalities of the hydrogel make it have more widely potential applications in chemical sensitive response materials.

From dioxin to dioxin congeners: understanding the differences in hydrophobic aggregation in water and absorption into lipid membranes by means of atomistic simulations

Molecular dynamics simulations indicate that dioxin likely accumulates in cell membranes more than its congeners (anthracene, tetrahydrodioxin, 3,3′,5,5′-tetrachlorobiphenyl, and 1,2-dihydroxytetrahydrodibenzo-p-dioxin).

Hydrophobic aggregation of fine particles in high muddied coal slurry water

The hydrophobic aggregation of fine particles in high muddied coal slurry water in the presence of four quaternary ammonium salts of 1231(dodecyl trimethyl ammonium chloride), 1431(tetradecyl trimethyl ammonium chloride), 1631(cetyl trimethyl ammonium chloride) and 1831(octadecyl trimethyl ammonium chloride) was investigated through the measurement of contact angles, zeta potentials, aggregation observation, adsorption and sedimentation. The results show that quaternary ammonium salts can enhance the hydrophobicity and reduce the electronegativity of particle surface, and thus induce a strong hydrophobic aggregation of slurry fine particles which promotes the settlement of coal slurry water. The adsorption of quaternary ammonium salts on slurry particles increases with the increase of alkyl chain length and reagent dosage, and will reach equilibrium when the dosage reaches a certain value. Weak alkaline conditions also can promote quaternary ammonium salts to be adsorbed on the coal slurry fine particles. In addition, reasonable energy input and a chemical environment of weak alkaline solution are conducive to hydrophobic aggregation settlement of high muddied coal slurry water with quaternary ammonium salts. The main mechanism of hydrophobic aggregation of coal slurry particles with quaternary ammonium salts is ‘adsorption charge neutralization’ and hydrophobic interaction.

Hydrophobic aggregation and collective absorption of dioxin into lipid membranes: insights from atomistic simulations

MD simulations show that dioxin molecules quickly aggregate in water and jointly penetrate into cell membranes.