Development and In Vitro/In Vivo Evaluation of pH-Sensitive Polymeric Nanoparticles Loaded Hydrogel for the Management of Psoriasis

Methotrexate (MTX), the gold standard against psoriasis, poses severe problems when administered systemically viz increased toxicity, poor solubility and adverse reactions. Hence, a topical formulation of MTX for the management of psoriasis can be an effective approach. The present study aimed to develop an MTX based nanoparticle-loaded chitosan hydrogel for evaluating its potential efficacy in an imiquimod-induced psoriatic mice model. MTX-NPs loaded hydrogel was prepared and optimized using the o/w emulsion solvent evaporation method. Particle size, zeta potential, entrapment efficiency, in vitro drug release, ex vivo permeation, skin irritation and deposition studies were performed. Psoriatic Area and Severity Index (PASI) score/histopathological examinations were conducted to check the antipsoriatic potential of MTX-NPs loaded hydrogel using an imiquimod (IMQ)-induced psoriatic model. Optimized MTX-NPs showed a particle size of 256.4 ± 2.17 nm and encapsulation efficiency of 86 ± 0.03%. MTX-NPs loaded hydrogel displayed a 73 ± 1.21% sustained drug release in 48 h. Ex vivo permeation study showed only 19.95 ± 1.04 µg/cm2 of drug permeated though skin in 24 h, while epidermis retained 81.33% of the drug. A significant decrease in PASI score with improvement to normalcy of mice skin was observed. The developed MTX-NPs hydrogel displayed negligible signs of mild hyperkeratosis and parakeratosis, while histopathological studies showed healing signs of mice skin. So, the MTX-NPs loaded hydrogel can be a promising delivery system against psoriasis.

Gamma oryzanol niosomal gel for skin cancer: formulation and optimization using quality by design (QbD) approach

Skin cancer is fifth most diagnosed disease in human population due to ultraviolet radiation (UV) exposure. Gamma oryzanol (OZ) is a natural antioxidant, and it also has skin anti-aging properties. OZ is naturally found in rice bran oil. The main aim of the present work was to optimize OZ niosomal formulation using quality by design approach including one variable at a time and full factorial design. Niosomes were prepared by solvent injection method and characterized for size, polydispersity index, drug entrapment, and transmission electron microscopy. The optimized batch obtained at X1 [drug to span 60 molar ratio (1:5)], X2 [volume of hydration (75 mL)], and X3 [stirring speed (2500 rpm)] to Y1 [average vesicle size (196.6 nm)] and Y2 [entrapment efficiency (78.31%)] as dependent variables. The optimized OZ noisomes were formulated by niosomal gel to provide improved physicochemical stability upon topical application against UV. The niosomal gel was characterized using pH meter, viscometer, Draize test for skin irritancy, ex vivo permeation studies, and stability studies. Ex vivo permeation studies of OZ niosomal gel not only showed fourfold higher permeation but also exhibited better drug retention in dermal layers of skin as compared to OZ gel. Quality Target Product Profile of OZ niosomal formulation was generated. Risk analysis of optimized OZ gel suggested most critical quality attributes (CQAs) and critical process parameters (CPPs) to be characterized as low risk. Thus, γ-oryzanol niosomal gel for topical use can serve as a promising prophylactic treatment in skin cancer, and the developed prototype formulation can be further extended to future newly discovered drugs with similar characteristics. Graphical abstract

Solid nanostructured lipid carriers loaded with silymarin for oral delivery: Formulation development and evaluation

The present study was aimed at preparing stable dry adsorbed nanoparticles (DANs) of silymarin loaded nanostructured lipid carriers (NLCs). The prepared silymarin loaded NLCs and DANs were characterized for various quality parameters. Silymarin loaded NLCs were prepared by a modified hot melt emulsification ultra-sonication method using glyceryl monostearate (GMS), capmul MCM C8 EP (CAP) and gelucire 50/13 (G50/13) as solid lipid, liquid lipid and surfactant respectively. For better stability, NLC dispersion was converted into DANs by adsorbing them onto some suitable carriers. NLCs and DANs were characterized for particle size, polydispersity index, zeta potential, entrapment efficiency, drug loading, assay, thermal behavior, crystallinity and morphological study. The optimized NLCs have a mean particle size of 206.1±012.5 nm (size distribution of 0.249±0.058), a zeta potential of -32.5±1.2 mV with high entrapment of 95.60±0.45% and drug loading of 1.90±0.08%. The X-ray diffraction and endothermic peaks confirmed the maximum encapsulation of active in lipid matrices. The particles were spherical with smooth surface morphology. In-vitro release studies showed sustained drug release for up to 24 h. Ex-vivo permeation in the presence and absence of lymphatic blocker indicates the uptake of silymarin loaded NLCs by the lymphatic route. Silymarin loaded NLCs prepared had a nanosize distribution with high entrapment efficiency. The ex-vivo permeation study for optimized NLC formulation exhibited the lymphatic uptake of active. Dispersion stability was increased by preparing the DANs. The solid dry powder is used for oral reconstitution and can be further converted into tablets or filled into capsules.

Formulation and Development of Oral Fast-Dissolving Films Loaded with Nanosuspension to Augment Paroxetine Bioavailability: In Vitro Characterization, Ex Vivo Permeation, and Pharmacokinetic Evaluation in Healthy Human Volunteers

Paroxetine (PX) is the most potent serotonin reuptake inhibitor utilized in depression and anxiety treatment. It has drawbacks, such as having a very bitter taste, low water solubility, and undergoing extensive first pass metabolism, leading to poor oral bioavailability (<50%). This work aimed to develop and optimize palatable oral fast-dissolving films (OFDFs) loaded with a paroxetine nanosuspension. A PX nanosuspension was prepared to increase the PX solubility and permeability via the buccal mucosa. The OFDFs could increase PX bioavailability due to their rapid dissolution in saliva, without needing water, and the rapid absorption of the loaded drug through the buccal mucosa, thus decreasing the PX metabolism in the liver. OFDFs also offer better convenience to patients with mental illness, as well as pediatric, elderly, and developmentally disabled patients. The PX nanosuspension was characterized by particle size, poly dispersity index, and zeta potential. Twelve OFDFs were formulated using a solvent casting technique. A 22 × 31 full factorial design was applied to choose the optimized OFDF, utilizing Design-Expert® software (Stat-Ease Inc., Minneapolis, MN, USA). The optimized OFDF (F1) had a 3.89 ± 0.19 Mpa tensile strength, 53.08 ± 1.28% elongation%, 8.12 ± 0.13 MPa Young’s modulus, 17.09 ± 1.30 s disintegration time, and 96.02 ± 3.46% PX dissolved after 10 min. This optimized OFDF was subjected to in vitro dissolution, ex vivo permeation, stability, and palatability studies. The permeation study, using chicken buccal pouch, revealed increased drug permeation from the optimized OFDF; with a more than three-fold increase in permeation over the pure drug. The relative bioavailability of the optimized OFDF in comparison with the market tablet was estimated clinically in healthy human volunteers and was found to be 178.43%. These findings confirmed the success of the OFDFs loaded with PX nanosuspension for increasing PX bioavailability.

Development, Optimization, and Evaluation of Luliconazole Nanoemulgel for the Treatment of Fungal Infection

The present study aimed to optimize luliconazole nanoemulsion using Box–Behnken statistical design, which was further incorporated into the polymeric gel of Carbopol 934. The formulation was characterized for its size, entrapment efficiency, ex vivo permeation, and mechanism of release. The size of the dispersed globules of the optimized drug-loaded nanoemulsion was found to be 17 ± 3.67 nm with a polydispersity index (PDI) less than 0.5. Although the surface charge was recorded at –9.53 ± 0.251, the stability was maintained by the polymeric matrix that prevented aggregation and coalescence of the dispersed globules. The luliconazole-nanoemulgel (LUL-NEG) was characterized for drug content analysis, viscosity, pH, and refractive index, where the results were found to be 99.06 ± 0.59%, 9.26 ± 0.08 Pa.s, 5.65 ± 0.17, and 1.31 ± 0.08, respectively. The permeation across the rat skin was found to be significantly higher with LUL-NEG when compared with LUL gel. Furthermore, the skin irritation test performed in experimental animals revealed that the blank NEG, as well as the LUL-NEG, did not produce any signs of erythema following 48 h exposure. In addition, the histopathological findings of the experimental skins reported no abnormal signs at the formulation application site. Finally, the NEG formulation was found to create a statistically significant zone of inhibition ( P < 0.05) when compared to all other test groups. Overall, it could be summarized that the nanoemulgel approach of delivering luliconazole across the skin to treat skin fungal infections could be a promising strategy.

Constant Voltage Iontophoresis Technique to Deliver Terbinafine via Transungual Delivery System: Formulation Optimization Using Box–Behnken Design and In Vitro Evaluation

Topical therapy of antifungals is primarily restricted due to the low innate transport of drugs through the thick multi-layered keratinized nail plate. The objective of this investigation was to develop a gel formulation, and to optimize and evaluate the transungual delivery of terbinafine using the constant voltage iontophoresis technique. Statistical analysis was performed using Box–Behnken design to optimize the transungual delivery of terbinafine by examining crucial variables namely concentration of polyethylene glycol, voltage, and duration of application (2–6 h). Optimization data in batches (F1–F17) demonstrated that chemical enhancer, applied voltage, and application time have influenced terbinafine nail delivery. Higher ex vivo permeation and drug accumulation into the nail tissue were noticed in the optimized batch (F8) when compared with other batches (F1–F17). A greater amount of terbinafine was released across the nails when the drug was accumulated by iontophoresis than the passive counterpart. A remarkably higher zone of inhibition was observed in nails with greater drug accumulation due to iontophoresis, as compared to the passive process. The results here demonstrate that the optimized formulation with low voltage iontophoresis could be a viable and alternative tool in the transungual delivery of terbinafine, which in turn could improve the success rate of topical nail therapy in onychomycosis.

Formulation Design and Preclinical Evaluations of Surface Modified Lipid Nanoparticles-Coupled Gel Encapsulating Dihydroartemisinin for Treatment of Localized Inflammation

Previously, it has been claimed that artemisinin derivatives, e.g., dihydroartemisinin, possess very potent anti-inflammatory activity. The study aimed to formulate gels based on surface-modified nanostructured lipid carrier (NLC) and contain dihydroartemisinin (DHA) to treat localized inflammation. NLC was developed using Softisan®154 and Tetracarpidium conophorum oil and structured using PEG 4000. Physicochemical characterization of NLC, including surface charge, particle size, and encapsulation efficiency (EE%), was evaluated. NLCwas dispersed in hydroxypropyl cellulose, and the resulting nanogels were evaluated for drug content, ex vivo permeation, and anti-inflammatory activity. The surface charge and particle size of NLC ranged from -15.3 ± 1.1 to -25.5 ± 2.1 mV and 85.5 ± 8.6 – 108.7 ± 5.5 nm respectively. EE% of NLC was in the range of 90.0 ± 1.21 – 99.3 ± 1.60 %. NLC gels had high drug content (83 – 99 %). Ex vivo permeation study showed sustained-release of DHA over 24 h. The gels produced a sustained-release reduction of egg albumin-induced inflammation in rats up to 8 h for 7 days. Development of surface-modified lipid nanoparticles-based gel containing DHA produced controlled release of the drug localized inflammation.