Microstructure Evolution and Mechanical Properties of Medium Carbon Martensitic Steel during Warm Rolling and Annealing Process

The microstructure evolution and mechanical properties of medium carbon martensitic steel during the warm rolling and annealing process were studied by scanning electron microscope (SEM), electron back scattering diffraction (EBSD), and electronic universal testing machine. The results showed that the microstructure of ferrite matrix with mass dispersive cementite particles was obtained by decomposition of martensitic in medium-carbon martensitic steel after warm rolling. The grain size of ferrite was ~ 0.53 μm, the yield strength and tensile strength were 951 MPa and 968 MPa, respectively, and the total elongation rate was 11.5% after warm rolling at 600 °C. Additionally, after the next 4 h of annealing, the grain size of ferrite and particle size of cementite increased to ~1.35 μm and ~360 nm and the yield strength and tensile strength decreased to 600 MPa and 645 MPa, respectively, with a total elongation increases of 20.9%. The strength of the material increased with increasing strain rate in tension, and the yield-to-tensile strength ratio increased from 0.92 to 0.94 and maintained good plasticity.

Isothermal Heat Treatment of the Low-Carbon Martensitic Steel

A study of the low-carbon steel with high hardenability was carried out. The steel contained the following alloying elements, wt. %: C – 0.20; Cr – 2.0; Mn – 2.0; Si – 1.04 Ni – 1.0; Mo – 0.3. The quenching – partitioning treatment of the studied steel was implemented. The microstructure of the steel consisted of the tempered martensite laths, bainite and martensite-austenite regions. The amount of the residual austenite and the carbon concentration in the residual austenite were estimated. The possibility of the quenching – partitioning treatment of the carburized steel was shown.

Effect of autogenous GTAW on the reciprocating sliding wear behavior of a carbon martensitic steel

Martensitic steels have been successfully employed in resource-based industries where components must endure aggressive conditions. In industrial practice, many parts of these components are joined by welding techniques. The aim of this work was to understand the influence of welding on the wear resistance of quenched and tempered carbon martensitic steel subjected to dry linear reciprocating sliding micro-wear tests. Weld-joints were produced using autogenous Gas Tungsten Arc Welding process (GTAW). Micro-wear tests were performed at base metal (BM), weld metal (WM), coarse grained heat affected zone (CG-HAZ) and lowest hardness region of heat affected zone (LHR-HAZ). LHR-HAZ was softened during welding process so plastic deformation was facilitated, and consequently adhesion, material displacement and micro-ploughing. WM and CG-HAZ presented a similar martensitic structure, which explain the similarities found on wear behavior. These regions presented the lowest worn volume average values (w). It was interesting to note that despite its highest microhardness value, the highest w was observed for BM. For some BM samples, debris had a key role promoting material loss by micro-cutting which causes great extent of material removal compared to other micro-wear mechanisms as micro-ploughing and adhesion. Due to debris action BM also presented a great dispersion in w results. The results suggest that material loss of welded joint and BM was strongly controlled by micro-wear mechanisms.