scholarly journals Merging Pd 0 /Pd II Redox and Pd II /Pd II Non‐redox Catalytic Cycles for the Allylarylation of Electron‐Deficient Alkenes

Author(s):  
Kazuhiko Semba ◽  
Naoki Ohta ◽  
Fritz Paulus ◽  
Masaki Ohata ◽  
Yoshiaki Nakao
Keyword(s):  
2019 ◽  
Vol 16 (1) ◽  
pp. 173-180
Author(s):  
Mingwei Chen ◽  
Jinyu Hu ◽  
Xiaoli Tang ◽  
Qiming Zhu

Aim and Objective: The synthesis of bipyridines, especially 2, 2’-bipyridines, remains challenging because the catalytic cycle can be inhibited due to coordination of bipyridine to transition metal. Thus, the development of efficient methods for the synthesis of bipyridines is highly desirable. In the present work, we presented a promising approach for preparation of bipyridines via a Pd-catalyzed reductive homocoupling reaction with simple piperazine as a ligand. Materials and Methods: Simple and inexpensive piperazine was used as a ligand for Pd-catalyzed homocoupling reaction. The combination of Pd(OAc)2 and piperazine in dimethylformamide (DMF) was observed to form an excellent catalyst and efficiently catalyzed the homocoupling of azaarenyl halides, in which DMF was used as the solvent without excess reductants although stoichiometric reductant was generally required to generate the low-oxidation-state active metal species in the catalytic cycles. </P><P> Results: In this case, good to excellent yields of bipyridines and their (hetero) aromatic analogues were obtained in the presence of 2.5 mol% of Pd(OAc)2 and 5 mol% of piperazine, using K3PO4 as a base in DMF at 140°C. Conclusion: According to the results, piperazine as an inexpensive and efficient ligand was used in the Pd(OAc)2-catalyzed homocoupling reaction of heteroaryl and aryl halides. The coupling reaction was operationally simple and displayed good substrate compatibility.


Author(s):  
Jakub Zdarta ◽  
Katarzyna Jankowska ◽  
Karolina Bachosz ◽  
Oliwia Degórska ◽  
Karolina Kaźmierczak ◽  
...  

Abstract Purpose of Review In the presented review, we have summarized recent achievements on the use of immobilized oxidoreductases for biodegradation of hazardous organic pollutants including mainly dyes, pharmaceuticals, phenols, and bisphenols. In order to facilitate process optimization and achievement of high removal rates, effect of various process conditions on biodegradation has been highlighted and discussed. Recent Findings Current reports clearly show that immobilized oxidoreductases are capable of efficient conversion of organic pollutants, usually reaching over 90% of removal rate. Further, immobilized enzymes showed great recyclability potential, allowing their reuse in numerous of catalytic cycles. Summary Collected data clearly indicates immobilized oxidoreductases as an efficient biocatalytic tools for removal of hazardous phenolic compounds, making them a promising option for future water purification. Data shows, however, that both immobilization and biodegradation conditions affect conversion efficiency; therefore, process optimization is required to achieve high removal rates. Nevertheless, we have demonstrated future trends and highlighted several issues that have to be solved in the near-future research, to facilitate large-scale application of the immobilized oxidoreductases in wastewater treatment.


2014 ◽  
Vol 14 (7) ◽  
pp. 3247-3276 ◽  
Author(s):  
R. Hommel ◽  
K.-U. Eichmann ◽  
J. Aschmann ◽  
K. Bramstedt ◽  
M. Weber ◽  
...  

Abstract. Record breaking loss of ozone (O3) in the Arctic stratosphere has been reported in winter–spring 2010/2011. We examine in detail the composition and transformations occurring in the Arctic polar vortex using total column and vertical profile data products for O3, bromine oxide (BrO), nitrogen dioxide (NO2), chlorine dioxide (OClO), and polar stratospheric clouds (PSC) retrieved from measurements made by SCIAMACHY (Scanning Imaging Absorption SpectroMeter for Atmospheric CHartography) on-board Envisat (Environmental Satellite), as well as total column ozone amount, retrieved from the measurements of GOME-2 (Global Ozone Monitoring Experiment) on MetOp-A (Meteorological Experimental Satellite). Similarly we use the retrieved data from DOAS (Differential Optical Absorption Spectroscopy) measurements made in Ny-Ålesund (78.55° N, 11.55° E). A chemical transport model (CTM) has been used to relate and compare Arctic winter–spring conditions in 2011 with those in the previous year. In late winter–spring 2010/2011 the chemical ozone loss in the polar vortex derived from SCIAMACHY observations confirms findings reported elsewhere. More than 70% of O3 was depleted by halogen catalytic cycles between the 425 and 525 K isentropic surfaces, i.e. in the altitude range ~16–20 km. In contrast, during the same period in the previous winter 2009/2010, a typical warm Arctic winter, only slightly more than 20% depletion occurred below 20 km, while 40% of O3 was removed above the 575 K isentrope (~23 km). This loss above 575 K is explained by the catalytic destruction by NOx descending from the mesosphere. In both Arctic winters 2009/2010 and 2010/2011, calculated O3 losses from the CTM are in good agreement to our observations and other model studies. The mid-winter 2011 conditions, prior to the catalytic cycles being fully effective, are also investigated. Surprisingly, a significant loss of O3 around 60%, previously not discussed in detail, is observed in mid-January 2011 below 500 K (~19 km) and sustained for approximately 1 week. The low O3 region had an exceptionally large spatial extent. The situation was caused by two independently evolving tropopause elevations over the Asian continent. Induced adiabatic cooling of the stratosphere favoured the formation of PSC, increased the amount of active chlorine for a short time, and potentially contributed to higher polar ozone loss later in spring.


2005 ◽  
Vol 5 (6) ◽  
pp. 1437-1448 ◽  
Author(s):  
J.-U. Grooß ◽  
G. Günther ◽  
R. Müller ◽  
P. Konopka ◽  
S. Bausch ◽  
...  

Abstract. We present simulations with the Chemical Lagrangian Model of the Stratosphere (CLaMS) for the Arctic winter 2002/2003. We integrated a Lagrangian denitrification scheme into the three-dimensional version of CLaMS that calculates the growth and sedimentation of nitric acid trihydrate (NAT) particles along individual particle trajectories. From those, we derive the HNO3 downward flux resulting from different particle nucleation assumptions. The simulation results show a clear vertical redistribution of total inorganic nitrogen ( ), with a maximum vortex average permanent removal of over 5ppb in late December between 500 and 550K and a corresponding increase of of over 2ppb below about 450K. The simulated vertical redistribution of is compared with balloon observations by MkIV and in-situ observations from the high altitude aircraft Geophysica. Assuming a globally uniform NAT particle nucleation rate of 7.8x10-6cm-3h-1 in the model, the observed denitrification is well reproduced. In the investigated winter 2002/2003, the denitrification has only moderate impact (≤14%) on the simulated vortex average ozone loss of about 1.1ppm near the 460K level. At higher altitudes, above 600K potential temperature, the simulations show significant ozone depletion through -catalytic cycles due to the unusual early exposure of vortex air to sunlight.


2017 ◽  
Vol 4 (6) ◽  
pp. 943-950 ◽  
Author(s):  
Dongdong Xu ◽  
Xiaotian Qi ◽  
Meng Duan ◽  
Zhaoyuan Yu ◽  
Lei Zhu ◽  
...  

Thiolate–palladium(iv) intermediates are generated through oxidative addition in our suggested mechanisms, and are the key intermediates in these catalytic cycles.


2020 ◽  
Author(s):  
Diego Garay-Ruiz ◽  
Carles Bo

<div><div><div><p>The computational study of catalytic processes allows discovering really intricate and detailed reaction mechanisms that involve many species and transformations. This increasing level of detail can even result detrimental when drawing conclusions from the computed mechanism, as many co-existing reaction pathways can be in close com- petence. Here we present a reaction network-based implementation of the energy span model in the form of a computational code, gTOFfee, capable of dealing with any user-specified reaction network. This approach, compared to microkinetic simulations, enables a much easier and straightforward analysis of the performance of any catalytic reaction network. In this communication, we will go through the foundations and appli- cability of the underlying model, and will tackle the application to two relevant catalytic systems: homogeneous Co-mediated propene hydroformylation and heterogeneous CO2 hydrogenation over Cu(111).</p></div></div></div>


2020 ◽  
Vol 16 ◽  
pp. 1924-1935
Author(s):  
Edgar Peris ◽  
Raúl Porcar ◽  
María Macia ◽  
Jesús Alcázar ◽  
Eduardo García-Verdugo ◽  
...  

The combination of supported ionic liquids and immobilized NHC–Pd–RuPhos led to active and more stable systems for the Negishi reaction under continuous flow conditions than those solely based on NHC–Pd–RuPhos. The fine tuning of the NHC–Pd catalyst and the SILLPs is a key factor for the optimization of the release and catch mechanism leading to a catalytic system easily recoverable and reusable for a large number of catalytic cycles enhancing the long-term catalytic performance.


2020 ◽  
Vol 74 (3) ◽  
pp. 108-114
Author(s):  
Charlotte E. Bopp ◽  
Hans-Peter E. Kohler ◽  
Thomas B. Hofstetter

Enzymatic oxygenations initiate biodegradation processes of many organic soil and water contaminants. Even though many biochemical aspects of oxygenation reactions are well-known, quantifying rates of oxidative contaminant removal as well as the extent of oxygenation remains a major challenge. Because enzymes use different strategies to activate O2, reactions leading to substrate oxygenation are not necessarily limiting the rate of contaminant removal. Moreover, oxygenases react along unproductive pathways without substrate metabolism leading to O2 uncoupling. Here, we identify the critical features of the catalytic cycles of selected oxygenases that determine rates and extents of biodegradation. We focus most specifically on Rieske dioxygenases, a subfamily of mononuclear non-heme ferrous iron oxygenases, because of their ability to hydroxylate unactivated aromatic structures and thus initiate the transformation of the most persistent organic contaminants. We illustrate that the rate-determining steps in their catalytic cycles range from O2 activation to substrate hydroxylation, depending on the extent of O–O cleavage that is required for generating the reactive Fe-oxygen species. The extent of O2 uncoupling, on the other hand, is highly substrate-specific and potentially modulated by adaptive responses to oxidative stress. Understanding the kinetic mechanisms of oxygenases will be key to assess organic contaminant biotransformation quantitatively.


Sign in / Sign up

Export Citation Format

Share Document