A Composite System for Real-Time Robust Whistle Recognition

2006 ◽  
pp. 130-141 ◽  
Author(s):  
Andrea Bonarini ◽  
Daniele Lavatelli ◽  
Matteo Matteucci
Keyword(s):  
Real Time ◽  
Composite System

INS real-time data processing composite system using large scale general purpose computers

1983 ◽  
Vol 213 (2-3) ◽  
pp. 317-327 ◽  
Author(s):  
Jun Kokame ◽  
Motonobu Takano ◽  
Tomoko Oshikubo ◽  
Kurazo Chiba ◽  
Kumataro Ukai ◽  
...  
Keyword(s):  
Data Processing ◽  
Real Time ◽  
Large Scale ◽  
Composite System ◽  
General Purpose ◽  
Time Data ◽  
Real Time Data ◽  
Real Time Data Processing

Some Recent Results in Quiescent Prominence Spectrometry

1979 ◽  
Vol 44 ◽  
pp. 41-47
Author(s):  
Donald A. Landman
Keyword(s):  
Real Time ◽  
Computer System ◽  
Spectral Response ◽  
Absolute Intensity ◽  
Solar Observatory ◽  
Target Size ◽  
Small Target ◽  
Signal Averaging ◽  
Quiescent Prominence

This paper describes some recent results of our quiescent prominence spectrometry program at the Mees Solar Observatory on Haleakala. The observations were made with the 25 cm coronagraph/coudé spectrograph system using a silicon vidicon detector. This detector consists of 500 contiguous channels covering approximately 6 or 80 Å, depending on the grating used. The instrument is interfaced to the Observatory’s PDP 11/45 computer system, and has the important advantages of wide spectral response, linearity and signal-averaging with real-time display. Its principal drawback is the relatively small target size. For the present work, the aperture was about 3″ × 5″. Absolute intensity calibrations were made by measuring quiet regions near sun center.

Video real-time imaging of artificial membranes during freeze-drying by cryo-electron microscopy

1988 ◽  
Vol 46 ◽  
pp. 16-17
Author(s):  
Alan S. Rudolph ◽  
Ronald R. Price
Keyword(s):  
Real Time ◽  
Self Assembly ◽  
Freeze Drying ◽  
Video Capture ◽  
Drying Process ◽  
Artificial Membranes ◽  
The Past ◽  
Cryo Electron Microscopy ◽  
Spherical Structures ◽  
Capture Techniques

We have employed cryoelectron microscopy to visualize events that occur during the freeze-drying of artificial membranes by employing real time video capture techniques. Artificial membranes or liposomes which are spherical structures within internal aqueous space are stabilized by water which provides the driving force for spontaneous self-assembly of these structures. Previous assays of damage to these structures which are induced by freeze drying reveal that the two principal deleterious events that occur are 1) fusion of liposomes and 2) leakage of contents trapped within the liposome [1]. In the past the only way to access these events was to examine the liposomes following the dehydration event. This technique allows the event to be monitored in real time as the liposomes destabilize and as water is sublimed at cryo temperatures in the vacuum of the microscope. The method by which liposomes are compromised by freeze-drying are largely unknown. This technique has shown that cryo-protectants such as glycerol and carbohydrates are able to maintain liposomal structure throughout the drying process.

An Interactive Minicomputer Program for the Indexing and Simulation of Electron Diffraction Patterns

1976 ◽  
Vol 34 ◽  
pp. 542-543
Author(s):  
R.P. Goehner ◽  
W.T. Hatfield ◽  
Prakash Rao
Keyword(s):  
Electron Diffraction ◽  
Real Time ◽  
Pattern Analysis ◽  
Flow Diagram ◽  
Hard Copy ◽  
Time Analysis ◽  
Real Time Analysis ◽  
Transmission Electron ◽  
One Step ◽  
Diffraction Patterns

Computer programs are now available in various laboratories for the indexing and simulation of transmission electron diffraction patterns. Although these programs address themselves to the solution of various aspects of the indexing and simulation process, the ultimate goal is to perform real time diffraction pattern analysis directly off of the imaging screen of the transmission electron microscope. The program to be described in this paper represents one step prior to real time analysis. It involves the combination of two programs, described in an earlier paper(l), into a single program for use on an interactive basis with a minicomputer. In our case, the minicomputer is an INTERDATA 70 equipped with a Tektronix 4010-1 graphical display terminal and hard copy unit.A simplified flow diagram of the combined program, written in Fortran IV, is shown in Figure 1. It consists of two programs INDEX and TEDP which index and simulate electron diffraction patterns respectively. The user has the option of choosing either the indexing or simulating aspects of the combined program.

Microstructural investigation of surface roughness in MBE-grown AlAs

1995 ◽  
Vol 53 ◽  
pp. 454-455
Author(s):  
R. Rajesh ◽  
R. Droopad ◽  
C. H. Kuo ◽  
R. W. Carpenter ◽  
G. N. Maracas
Keyword(s):  
Thin Film ◽  
Real Time ◽  
Growth Control ◽  
Native Oxide ◽  
Effusion Cell ◽  
Surface Oxide Layer ◽  
Microstructural Investigation ◽  
Mbe Growth ◽  
Film Substrate ◽  
And Control

Knowledge of material pseudodielectric functions at MBE growth temperatures is essential for achieving in-situ, real time growth control. This allows us to accurately monitor and control thicknesses of the layers during growth. Undesired effusion cell temperature fluctuations during growth can thus be compensated for in real-time by spectroscopic ellipsometry. The accuracy in determining pseudodielectric functions is increased if one does not require applying a structure model to correct for the presence of an unknown surface layer such as a native oxide. Performing these measurements in an MBE reactor on as-grown material gives us this advantage. Thus, a simple three phase model (vacuum/thin film/substrate) can be used to obtain thin film data without uncertainties arising from a surface oxide layer of unknown composition and temperature dependence.In this study, we obtain the pseudodielectric functions of MBE-grown AlAs from growth temperature (650°C) to room temperature (30°C). The profile of the wavelength-dependent function from the ellipsometry data indicated a rough surface after growth of 0.5 μm of AlAs at a substrate temperature of 600°C, which is typical for MBE-growth of GaAs.

Real-time observation of vortex lattices in a superconductor

1993 ◽  
Vol 51 ◽  
pp. 1050-1051
Author(s):  
K. Harada ◽  
T. Matsuda ◽  
J.E. Bonevich ◽  
M. Igarashi ◽  
S. Kondo ◽  
...  
Keyword(s):  
Real Time ◽  
Flux Line ◽  
Electron Holography ◽  
Lorentz Microscopy ◽  
Vortex Lattices ◽  
Flux Lines ◽  
Magnetic Flux Lines ◽  
Time Observation ◽  
Thin Superconductor ◽  
Real Time Observation

Previous observations of magnetic flux-lines (vortex lattices) in superconductors, such as the field distribution of a flux-line, and flux-line dynamics activated by heat and current, have employed the high spatial resolution and magnetic sensitivity of electron holography. And recently, the 2-D static distribution of vortices was also observed by this technique. However, real-time observations of the vortex lattice, in spite of scientific and technological interest, have not been possible due to experimental difficulties. Here, we report the real-time observation of vortex lattices in a thin superconductor, by means of Lorentz microscopy using a 300 kV field emission electron microscope. This technique allows us to observe the dynamic motion of individual vortices and record the events on a VTR system.The experimental arrangement is shown in Fig. 1. A Nb thin film for transmission observation was prepared by chemical etching. The grain size of the film was increased by annealing, and single crystals were observed with a thickness of 50∼90 nm.

Processing and characterization of YBa2Cu3O7−x/Ag composites

1990 ◽  
Vol 48 (4) ◽  
pp. 46-47
Author(s):  
Jafar Javadpour ◽  
Bradley L. Thiel ◽  
Sarikaya Mehmet ◽  
Ilhan A. Aksay
Keyword(s):  
Composite System ◽  
Precursor Solution ◽  
Microstructural Development ◽  
Superconducting Properties ◽  
Practical Applications ◽  
Nitrate Precursor ◽  
Cold Pressed ◽  
Tape Cast ◽  
Composite Samples

Practical applications of bulk YBa2Cu3O7−x materials have been limited because of their inadequate critical current density (jc) and poor mechanical properties. Several recent reports have indicated that the addition of Ag to the YBa2Cu3O7−x system is beneficial in improving both mechanical and superconducting properties. However, detailed studies concerning the effect of Ag on the microstructural development of the cermet system have been lacking. Here, we present some observations on the microstructural evolution in the YBa2Cu3O7−x/Ag composite system.The composite samples were prepared by mixing various amounts (2.5 - 50 wt%) AgNO3 in the YBa2Cu3O7−x nitrate precursor solution. These solutions were then spray dried and the resulting powders were either cold pressed or tape cast. The microstructures of the sintered samples were analyzed using SEM (Philips 515) and an analytical TEM (Philips 430T).The SEM micrographs of the compacts with 2.5 and 50 wt% Ag addition sintered at 915°C (below the melting point of Ag) for 1 h in air are displayed in Figs. 1 and 2, respectively.

Live Confocal Analysis of Fertilization and Early Development

2001 ◽  
Vol 7 (S2) ◽  
pp. 1012-1013
Author(s):  
Uyen Tram ◽  
William Sullivan
Keyword(s):  
Drosophila Melanogaster ◽  
Embryonic Development ◽  
Real Time ◽  
Early Development ◽  
Fluorescent Probes ◽  
Primary Defect ◽  
Fluorescent Analysis ◽  
Dynamic Event ◽  
Enormous Amount ◽  
Fluorescent Studies

Embryonic development is a dynamic event and is best studied in live animals in real time. Much of our knowledge of the early events of embryogenesis, however, comes from immunofluourescent analysis of fixed embryos. While these studies provide an enormous amount of information about the organization of different structures during development, they can give only a static glimpse of a very dynamic event. More recently real-time fluorescent studies of living embryos have become much more routine and have given new insights to how different structures and organelles (chromosomes, centrosomes, cytoskeleton, etc.) are coordinately regulated. This is in large part due to the development of commercially available fluorescent probes, GFP technology, and newly developed sensitive fluorescent microscopes. For example, live confocal fluorescent analysis proved essential in determining the primary defect in mutations that disrupt early nuclear divisions in Drosophila melanogaster. For organisms in which GPF transgenics is not available, fluorescent probes that label DNA, microtubules, and actin are available for microinjection.

Enhancing Clinical Supervision Using High-Definition Real-Time Digital Recording, Annotation, and Bluetooth Technology

2019 ◽  
Vol 4 (2) ◽  
pp. 356-362
Author(s):  
Jennifer W. Means ◽  
Casey McCaffrey
Keyword(s):  
Graduate Students ◽  
Data Collection ◽  
Real Time ◽  
Clinical Supervision ◽  
Video Recording ◽  
Advanced Technology ◽  
High Definition ◽  
Recording Technology ◽  
Self Confidence ◽  
Additional Data Collection

Purpose The use of real-time recording technology for clinical instruction allows student clinicians to more easily collect data, self-reflect, and move toward independence as supervisors continue to provide continuation of supportive methods. This article discusses how the use of high-definition real-time recording, Bluetooth technology, and embedded annotation may enhance the supervisory process. It also reports results of graduate students' perception of the benefits and satisfaction with the types of technology used. Method Survey data were collected from graduate students about their use and perceived benefits of advanced technology to support supervision during their 1st clinical experience. Results Survey results indicate that students found the use of their video recordings useful for self-evaluation, data collection, and therapy preparation. The students also perceived an increase in self-confidence through the use of the Bluetooth headsets as their supervisors could provide guidance and encouragement without interrupting the flow of their therapy sessions by entering the room to redirect them. Conclusions The use of video recording technology can provide opportunities for students to review: videos of prospective clients they will be treating, their treatment videos for self-assessment purposes, and for additional data collection. Bluetooth technology provides immediate communication between the clinical educator and the student. Students reported that the result of that communication can improve their self-confidence, perceived performance, and subsequent shift toward independence.

Current Issues: Advanced Digital Technology for Supervising Graduate Clinicians

2010 ◽  
Vol 20 (1) ◽  
pp. 9-13 ◽  
Author(s):  
Glenn Tellis ◽  
Lori Cimino ◽  
Jennifer Alberti
Keyword(s):  
Real Time ◽  
Digital Technology ◽  
Clinical Training ◽  
State Of The Art ◽  
Clinical Skills ◽  
Slow Motion ◽  
Video Capture ◽  
Microsoft Excel ◽  
Clinical Supervisors ◽  
Training And Supervision

Abstract The purpose of this article is to provide clinical supervisors with information pertaining to state-of-the-art clinic observation technology. We use a novel video-capture technology, the Landro Play Analyzer, to supervise clinical sessions as well as to train students to improve their clinical skills. We can observe four clinical sessions simultaneously from a central observation center. In addition, speech samples can be analyzed in real-time; saved on a CD, DVD, or flash/jump drive; viewed in slow motion; paused; and analyzed with Microsoft Excel. Procedures for applying the technology for clinical training and supervision will be discussed.

Sign in / Sign up

Export Citation Format

Share Document