Effect of 30 % hydrogen peroxide on mineral chemical composition and surface morphology of bovine enamel

Odontology ◽  
2014 ◽  
Vol 104 (1) ◽  
pp. 44-52 ◽  
Author(s):  
Santiago González-López ◽  
Carolina Torres-Rodríguez ◽  
Victoria Bolaños-Carmona ◽  
Purificación Sanchez-Sanchez ◽  
Alejandro Rodríguez-Navarro ◽  
...  
2020 ◽  
Vol 02 ◽  
Author(s):  
RM Garcia ◽  
WF Vieira-Junior ◽  
JD Theobaldo ◽  
NIP Pini ◽  
GM Ambrosano ◽  
...  

Objective: To evaluate color and roughness of bovine enamel exposed to dentifrices, dental bleaching with 35% hydrogen peroxide (HP), and erosion/staining by red wine. Methods: Bovine enamel blocks were exposed to: artificial saliva (control), Oral-B Pro-Health (stannous fluoride with sodium fluoride, SF), Sensodyne Repair & Protect (bioactive glass, BG), Colgate Pro-Relief (arginine and calcium carbonate, AR), or Chitodent (chitosan, CHI). After toothpaste exposure, half (n=12) of the samples were bleached (35% HP), and the other half were not (n=12). The color (CIE L*a* b*, ΔE), surface roughness (Ra), and scanning electron microscopy were evaluated. Color and roughness were assessed at baseline, post-dentifrice and/or -dental bleaching, and after red wine. The data were subjected to analysis of variance (ANOVA) (ΔE) for repeated measures (Ra), followed by Tukey ́s test. The L*, a*, and b* values were analyzed by generalized linear models (a=0.05). Results: The HP promoted an increase in Ra values; however, the SF, BG, and AR did not enable this alteration. After red wine, all groups apart from SF (unbleached) showed increases in Ra values; SF and AR promoted decreases in L* values; AR demonstrated higher ΔE values, differing from the control; and CHI decreased the L* variation in the unbleached group. Conclusion: Dentifrices did not interfere with bleaching efficacy of 35% HP. However, dentifrices acted as a preventive agent against surface alteration from dental bleaching (BG, SF, and AR) or red wine (SF). Dentifrices can decrease (CHI) or increase (AR and SF) staining by red wine.


2012 ◽  
Vol 184-185 ◽  
pp. 1167-1170
Author(s):  
Guang Yu Du ◽  
Zhen Tan ◽  
Kun Liu ◽  
Hao Chai ◽  
De Chun Ba

In this paper TiN coating was prepared on stainless steel substrate using arc ion plating technique. The coating samples’ phases, surface morphology, micro-determination chemical composition, loss factor and damping ratio were tested. The phases of TiN coating were determined by X-ray diffraction (XRD) technique. The surface morphology and chemical composition of the TiN coating were analyzed by scanning electron microscope (SEM) and Energy Dispersive Spectrometer (EDS), respectively. The damping performance of the samples was measured by hammering activation according half power bandwidth method. The loss factor or damping ratio of samples were obtained according frequency response curve. The results showed that damping performance of samples was considerably improved by TiN coatings.


2012 ◽  
Vol 37 (5) ◽  
pp. 518-525 ◽  
Author(s):  
AM de Arruda ◽  
PH dos Santos ◽  
RH Sundfeld ◽  
SB Berger ◽  
ALF Briso

SUMMARY This study evaluated the microhardness and histomorphology of bovine enamel when 35% hydrogen peroxide is used. A total of 44 specimens were adapted to removable devices used by 11 individuals subjected to dental caries challenge. A decrease in microhardness was observed for all groups after the cariogenic challenge. Microscopic analysis revealed that fragments subjected to cariogenic challenge associated with bleaching had more intense superficial histologic changes, but the depth of the lesions remained unchanged. It was concluded that 35% hydrogen peroxide enhanced the reduction in hardness and histomorphologic changes in the enamel surface exposed to cariogenic challenge.


2014 ◽  
Vol 15 (4) ◽  
pp. 392-398 ◽  
Author(s):  
Wilcilene Costa Nascimento ◽  
Yasmin do Socorro Batista de Lima Gomes ◽  
Larissa Dias Alexandrino ◽  
Hilton Tulio Costi ◽  
José Otávio Carrera Silva ◽  
...  

ABSTRACT Aim The aim of this in vitro study was to evaluate the effects of different sodium fluoride (NaF) concentrations and pH values on the Knoop hardness (KHN), surface roughness (SR), and morphology of bovine incisors bleached with 35% hydrogen peroxide (HP). Materials and methods Sixty-five bovine incisors were fragmented (5 mm2 × 2 mm) and distributed in 5 groups: Control (unbleached), Low NaF/Acidic (35% HP + 1.3% NaF, pH 5.5), Low NaF/Neutral (35% HP + 1.3% NaF, pH 7.0), High NaF/ Acidic (35% HP + 2% NaF, pH 5.5), and High NaF/Neutral (35% HP + 2% NaF, pH 7.0). KHN analysis was performed with a microhardness tester under a load of 25 gf for 5 seconds. The average SR was obtained with a rugosimeter. KHN and SR were analyzed before and after treatments. For morphological analysis, specimens were dehydrated and gold-sputtered, and scanning electron micrographs were obtained and analyzed by 3 examiners with a double-blinded technique. KHN and SR results were analyzed by one-way ANOVA and Tukey's test (p < 0.05). Results Only the Low NaF/Acidic and Low NaF/Neutral groups showed significant differences between the initial and final KHN values. All bleached groups presented significant differences between the initial and final SR values. Among the bleached groups, the least and most morphological changes were shown by the High NaF/Neutral and the Low NaF/Acidic group, respectively. Conclusion Treatment with 35% HP and 2% NaF at pH 7.0 promoted the least changes in morphology, hardness and roughness among the bleached groups. Clinical significance In-office bleaching with high-concentration HP and 2% NaF at neutral pH promoted the least changes in enamel hardness, SR, and morphology compared to other treatments. How to cite this article Nascimento WC, Gomes YSBL, Alexandrino LD, Costi HT, Silva JOC Jr, Silva CM. Influence of Fluoride Concentration and pH Value of 35% Hydrogen Peroxide on the Hardness, Roughness and Morphology of Bovine Enamel. J Contemp Dent Pract 2014;15(4):392-398.


2004 ◽  
Vol 23 (4) ◽  
pp. 517-521 ◽  
Author(s):  
Hyun-Jin PARK ◽  
Tae-Yub KWON ◽  
Soon-Hyun NAM ◽  
Hyun-Jung KIM ◽  
Kyo-Han KIM ◽  
...  

2012 ◽  
Vol 488-489 ◽  
pp. 76-81 ◽  
Author(s):  
Subramani Shanmugan ◽  
Mutharasu Devarajan ◽  
Kamarulazizi Ibrahim

Sb layered Te/Cd thin films have been prepared by using Stacked Elemental Layer (SEL) method. The presence of mixed phases (CdTe and Sb2Te3) in the films was confirmed by the x-ray diffraction technique. The calculated structural parameters demonstrated the feasibility of Sb doping via SEL method. The topographical and electrical studies of the synthesized thin films depicted the influence of Sb on both surface morphology and conductivity. The values of conductivity of the annealed films were in between 2 x 10-3 and 175 x 10-2 Scm-2. A desired chemical composition of films was confirmed from spectrum shape analysis using energy dispersive x-ray.


Author(s):  
N.N. Malushin ◽  
◽  
D.A. Romanov ◽  
A.P. Kovalev ◽  
L.P. Bashchenko ◽  
...  

Microhardness distributions, surface morphology, and elemental composition of a deposited layer of a heat-resistant alloy of the type P2M8U steel formed by plasma surfacing in a protective-alloying nitrogen medium are studied. It was established that the surfacing technology and surfacing material allows to obtain a high-quality deposited alloy without cracks, pores, slag inclusions and defects of macro- and microstructure. It has been established that the deposited material is pearlite grains at the boundaries and grain junctions of which are carbonitrides based on iron, tungsten, chromium, molybdenum, aluminum (Fe6 W6 NC and AlN).


Sign in / Sign up

Export Citation Format

Share Document