Mechanical Study of Shear Failure of Vertical Goaf Drainage Hole

Author(s):  
Manoj Khanal ◽  
Deepak Adhikary ◽  
Rao Balusu ◽  
Andy Wilkins ◽  
Bharath Belle
1992 ◽  
Vol 36 (5) ◽  
pp. 1087-1091
Author(s):  
Takashi Nakamura ◽  
Tatsuo Matsumoto ◽  
Aogu Imanishi ◽  
Toshizumi Hino ◽  
Takao Maruyama

Author(s):  
Yosuke HIGO ◽  
Shinichiro ONDA ◽  
Daiki TAKANO ◽  
Toshiki YAMAUCHI

Materials ◽  
2021 ◽  
Vol 14 (11) ◽  
pp. 2743
Author(s):  
Seongnoh Ahn ◽  
Jae-Eun Ryou ◽  
Kwangkuk Ahn ◽  
Changho Lee ◽  
Jun-Dae Lee ◽  
...  

Ground reinforcement is a method used to reduce the damage caused by earthquakes. Usually, cement-based reinforcement methods are used because they are inexpensive and show excellent performance. Recently, however, reinforcement methods using eco-friendly materials have been proposed due to environmental issues. In this study, the cement reinforcement method and the biopolymer reinforcement method using sodium alginate were compared. The dynamic properties of the reinforced ground, including shear modulus and damping ratio, were measured through a resonant-column test. Also, the viscosity of sodium alginate solution, which is a non-Newtonian fluid, was also explored and found to increase with concentration. The maximum shear modulus and minimum damping ratio increased, and the linear range of the shear modulus curve decreased, when cement and sodium alginate solution were mixed. Addition of biopolymer showed similar reinforcing effect in a lesser amount of additive compared to the cement-reinforced ground, but the effect decreased above a certain viscosity because the biopolymer solution was not homogeneously distributed. This was examined through a shear-failure-mode test.


Metals ◽  
2021 ◽  
Vol 11 (6) ◽  
pp. 888
Author(s):  
Paula Alvaredo-Olmos ◽  
Jon Molina-Aldareguía ◽  
Alvaro Vaz-Romero ◽  
Estela Prieto ◽  
Jesús González-Julián ◽  
...  

This work presents two new compositions of high entropy alloys (HEAs) that were designed with the aim of obtaining a body-centered cubic (BCC) phase with high hardness values and a moderate density. Sintering was performed using Spark Plasma Sintering (SPS) with different heating rates to determine the influence of the processing parameters on the phase formation. The microstructural study revealed that the presence of Ni in the composition promoted phase separation, and the mechanical study confirmed a clear influence on the mechanical properties of both the composition and heating rate. The combination of microscopy with compression and nanoindentation tests at room and high temperature made it possible to advance our understanding of the relationships between the composition, processing, and properties of this emerging group of alloys.


Sign in / Sign up

Export Citation Format

Share Document