Properties of concrete prepared with crushed fine stone, furnace bottom ash and fine recycled aggregate as fine aggregates

2009 ◽  
Vol 23 (8) ◽  
pp. 2877-2886 ◽  
Author(s):  
Shi-Cong Kou ◽  
Chi-Sun Poon
Keyword(s):  
Bottom Ash ◽  
Recycled Aggregate ◽  
Furnace Bottom ◽  
Fine Aggregates

scholarly journals Environmental Evaluation of Concrete Containing Recycled and By-Product Aggregates Based on Life Cycle Assessment

2020 ◽  
Vol 10 (21) ◽  
pp. 7503
Author(s):  
Seungjun Roh ◽  
Rakhyun Kim ◽  
Won-Jun Park ◽  
Hoki Ban
Keyword(s):  
Life Cycle Assessment ◽  
Life Cycle ◽  
Environmental Impact ◽  
Environmental Impacts ◽  
Bottom Ash ◽  
Environmental Cost ◽  
Recycled Aggregate ◽  
Coarse Aggregates ◽  
Fine Aggregates ◽  
Depletion Potential

This study aims to compare the potential environmental impact of the manufacture and production of recycled and by-product aggregates based on a life cycle assessment and to evaluate the environmental impact and cost when they are used as aggregates in concrete. To this end, the six potential environmental impacts (i.e., abiotic depletion potential, global warming potential, ozone-layer depletion potential, acidification potential, photochemical ozone creation potential, and eutrophication potential) of the manufacture and production of natural sand, natural gravel, recycled aggregate, slag aggregate, bottom ash aggregate, and waste glass aggregate were compared using information from life cycle inventory databases. Additionally, the environmental impacts and cost were evaluated when these aggregates were used to replace 30% of the fine and coarse aggregates in concrete with a design strength of 24 MPa. The environmental impact of concrete that incorporated slag aggregate as the fine aggregates or bottom ash aggregate as the coarse aggregates were lower than that of concrete that incorporated natural aggregate. However, concrete that incorporated bottom ash aggregate as the fine aggregates demonstrated relatively high environmental impacts. Based on these environmental impacts, the environmental cost was found to range from 5.88 to 8.79 USD/m3.

scholarly journals Use of Coal Bottom Ash and CaO-CaCl2-Activated GGBFS Binder in the Manufacturing of Artificial Fine Aggregates through Cold-Bonded Pelletization

Materials ◽  
2020 ◽  
Vol 13 (24) ◽  
pp. 5598
Author(s):  
Dongho Jeon ◽  
Woo Sung Yum ◽  
Haemin Song ◽  
Seyoon Yoon ◽  
Younghoon Bae ◽  
...  
Keyword(s):  
Early Stage ◽  
Bottom Ash ◽  
Relative Weight ◽  
Main Reaction ◽  
Reaction Products ◽  
Coal Bottom Ash ◽  
Heavy Metal Leaching ◽  
Granulated Blast Furnace Slag ◽  
Fine Aggregates ◽  
Cementless Binder

This study investigated the use of coal bottom ash (bottom ash) and CaO-CaCl2-activated ground granulated blast furnace slag (GGBFS) binder in the manufacturing of artificial fine aggregates using cold-bonded pelletization. Mixture samples were prepared with varying added contents of bottom ash of varying added contents of bottom ash relative to the weight of the cementless binder (= GGBFS + quicklime (CaO) + calcium chloride (CaCl2)). In the system, the added bottom ash was not simply an inert filler but was dissolved at an early stage. As the ionic concentrations of Ca and Si increased due to dissolved bottom ash, calcium silicate hydrate (C-S-H) formed both earlier and at higher levels, which increased the strength of the earlier stages. However, the added bottom ash did not affect the total quantities of main reaction products, C-S-H and hydrocalumite, in later phases (e.g., 28 days), but simply accelerated the binder reaction until it had occurred for 14 days. After considering both the mechanical strength and the pelletizing formability of all the mixtures, the proportion with 40 relative weight of bottom ash was selected for the manufacturing of pilot samples of aggregates. The produced fine aggregates had a water absorption rate of 9.83% and demonstrated a much smaller amount of heavy metal leaching than the raw bottom ash.

scholarly journals Durability and Shrinkage Characteristics of Self-Compacting Concretes Containing Recycled Coarse and/or Fine Aggregates

2015 ◽  
Vol 2015 ◽  
pp. 1-18 ◽  
Author(s):  
Mehmet Gesoglu ◽  
Erhan Güneyisi ◽  
Hatice Öznur Öz ◽  
Mehmet Taner Yasemin ◽  
Ihsan Taha
Keyword(s):  
Coarse Aggregate ◽  
Gas Permeability ◽  
Drying Shrinkage ◽  
Recycled Aggregate ◽  
Fine Aggregate ◽  
Restrained Shrinkage ◽  
Durability Properties ◽  
Recycled Fine Aggregate ◽  
Restrained Shrinkage Cracking ◽  
Fine Aggregates

This paper addresses durability and shrinkage performance of the self-compacting concretes (SCCs) in which natural coarse aggregate (NCA) and/or natural fine aggregate (NFA) were replaced by recycled coarse aggregate (RCA) and/or recycled fine aggregate (RFA), respectively. A total of 16 SCCs were produced and classified into four series, each of which included four mixes designed with two water to binder (w/b) ratios of 0.3 and 0.43 and two silica fume replacement levels of 0 and 10%. Durability properties of SCCs were tested for rapid chloride penetration, water sorptivity, gas permeability, and water permeability at 56 days. Also, drying shrinkage accompanied by the water loss and restrained shrinkage of SCCs were monitored over 56 days of drying period. Test results revealed that incorporating recycled coarse and/or fine aggregates aggravated the durability properties of SCCs tested in this study. The drying shrinkage and restrained shrinkage cracking of recycled aggregate (RA) concretes had significantly poorer performance than natural aggregate (NA) concretes. The time of cracking greatly prolonged as the RAs were used along with the increase in water/binder ratio.

Fresh Properties of Self-Compacting Concrete Integrating Coal Bottom Ash as a Replacement of Fine Aggregates

2015 ◽  
Vol 1125 ◽  
pp. 370-376
Author(s):  
Ahmad Farhan Hamzah ◽  
Mohd Haziman Wan Ibrahim ◽  
Norwati Jamaluddin ◽  
Ramadhansyah Putra Jaya ◽  
Norul Ernida Zainal Abidin
Keyword(s):  
Bottom Ash ◽  
Resistance Index ◽  
Ash Content ◽  
Fresh Properties ◽  
Self Compacting Concrete ◽  
Segregation Index ◽  
Coal Bottom Ash ◽  
Slump Flow ◽  
Fine Aggregates ◽  
The Stability

The influence of coal bottom ash on fresh properties of self-compacting concrete (SCC) were presented in this paper. Self-compacting concrete mixtures were produced by 0.40 water/powder ratio and coal bottom ash as a replacement of fine aggregates in varying percentages of 0%, 10%, 15%, 20%, 25% and 30%. The fresh concretes were tested for the key workability belongings of self-compacting concrete such as passing and filling abilities and segregation resistance. The fresh properties were investigated by slump flow; T500 spread time, sieve segregation and L-box test. It was found that the slump flow decreased whereas the T500 spread time increased with higher coal bottom ash content. The L-box blocking ratios changed from 0.92 to 0.65 and were mostly showed satisfactory blocking ratio. The presence of coal bottom ash improved the stability of SCC mixture and the segregation index obtained from sieve test reduced with greater bottom ash content. It can be concluding that the filling and passing ability of SCC decreased when the amount of coal bottom ash content increased. In addition, the segregation resistance index decreased with higher coal bottom ash content.

Influence of Recycled Aggregate on the Rheological Behavior of Cement Mortar

2014 ◽  
Vol 600 ◽  
pp. 297-307 ◽  
Author(s):  
Paulo Roberto Lopes Lima ◽  
Romildo Dias Toledo Filho ◽  
Otávio da Fonseca Martins Gomes
Keyword(s):  
Yield Stress ◽  
Plastic Viscosity ◽  
Construction And Demolition Waste ◽  
Recycled Aggregate ◽  
Fine Aggregate ◽  
Demolition Waste ◽  
Cement Ratio ◽  
Recycled Fine Aggregate ◽  
Fine Aggregates ◽  
Physical Tests

In this work it was studied the influence of recycled fine aggregate obtained from construction and demolition waste (CDW) on the rheological properties of Portland cement mortars. The CDW was initially separate in their main constituents (mortar, ceramic and concrete debris) at the laboratory and then grinded separately to the sand size in order to generate more homogeneous fine aggregates. The characterization of the natural and recycled sands was carried out through physical tests, X-ray diffraction, scanning electron microscopy (SEM), and image analysis (shape and texture description parameters). A conventional mortar and three mortars containing recycled sands were produced with a sand/cement ratio of 4 and consistency index of 255±5 mm. The consistency was kept constant by ranging the water-cement ratio from 0.58 to 1.14. The rheological study was performed using a rotating viscometer to obtain torque-rotation ratio and to calculate the yield stress and plastic viscosity. The results indicate that the presence of recycled aggregate causes a lowering of both yield stress and plastic viscosity with respect to the mortar containing natural aggregate.

Sign in / Sign up

Export Citation Format

Share Document