Effect of pressure and composition on lattice parameters and unit-cell volume of (Fe,Mg)SiO3 post-perovskite

2012 ◽  
Vol 317-318 ◽  
pp. 120-125 ◽  
Author(s):  
Li Zhang ◽  
Yue Meng ◽  
Wendy L. Mao
2017 ◽  
Vol 9 (2) ◽  
pp. 60 ◽  
Author(s):  
Sudirman Sudirman ◽  
Indriyati Indriyati ◽  
Wisnu Ari Adi ◽  
Rike Yudianti ◽  
Emil Budianto

Synthesis of Pt/CNT composite by using sol gel method has been performed which the composition of CNT on the composite are vary, (x = 20, 40, 60 and 80 wt%). Performance of composite was characterized by Transmission Electron Microscope (TEM) and X-Ray Diffraction (XRD), respectively. In the refinement results of X-ray diffraction pattern, the composite consists of two phases, namely, carbon and platinum phases. Carbon phase has a structure hexagonal (P 63 m c) with lattice parameters a = b = 2.451(2) Å and c = 6.89(1) Å, α = β = 90° and γ = 120°, the unit cell volume of V = 35.8(1) A3, and the atomic density of ρ = 2.224 g.cm-3. While platinum phase has the structure of cubic (F m -3 m) with lattice parameters a = b = c = 3.921(2) Å, α = β = γ = 90°, the unit cell volume of V = 60.3(1) A3, and the atomic density of ρ = 21.487 g.cm-3.According to the image of TEM, the average particle size for Pt nano particle is estimated to range from 4.1-4.3 nm. While the cavity diameter average of CNT is estimated to range from 5.9-7.5 nm. Based on the calculation, the crystallite size of the Pt particle was around 4.31 nm. The optimum value of dispersed Pt into CNT occurred at 60 wt% CNT with the best composition of Pt in the unit cell of cystal structure. We concluded that this study successfully dispersed Pt nanoparticles onto CNT formed Pt/CNT composite. This was a great opportunity that the composite can be applied as electrocatalyst system on fuel cell application.


2020 ◽  
Vol 75 (3) ◽  
pp. 309-315
Author(s):  
Christiane Stoll ◽  
David van Gerven ◽  
Hubert Huppertz

AbstractK15NaSn5F36 crystallizes in the hexagonal crystal system with space group P63/m and lattice parameters of a = 1060.3(2) and c = 2011.9(4) pm. The unit-cell volume amounts to 1.9588(7) nm3. Its fundamental building blocks are quasi-isolated [SnF6]2− and [NaF6]5− octahedra, which are imbedded into a matrix of potassium cations. Within the structure, these units form a layer-like arrangement consisting either of mixed [SnF6]2−/[NaF6]5− or pure [SnF6]2− layers. The structural model was further confirmed by BLBS and CHARDI calculations.


2022 ◽  
Vol 905 ◽  
pp. 91-95
Author(s):  
Fei Wang ◽  
Hui Hui Chen ◽  
Shi Wei Zhang

A series of luminescence phosphors M0.955Al2 –xGaxSi2O8∶Eu2+ (M=Ca, Sr, Ba, x = 0~1.0) were prepared via solid-state reaction in weak reductive atmosphere. The lattice positions were discussed. It was found that when Ga3+ entered MAl2Si2O8 lattice and substituted Al3+, complete solid solutions formed. The lattice parameters (a, b, c) and unit cell volume of phosphors M 0.955Al2 –xGaxSi2O8: Eu2+ (M=Ca, Sr, Ba, x = 0~1.0) increased linearly, the lattice parameters (α, β,γ) of Ca0.955Al2–xGaxSi2O8∶Eu2+(CAS) decreased linearly and the lattice parameter β of Sr0.955Al2–xGaxSi2O8∶Eu2+(SAS) and Ba0.955Al2–xGaxSi2O8∶Eu2+(BAS) increased linearly as Ga3+ content increased.


2013 ◽  
Vol 665 ◽  
pp. 37-42
Author(s):  
G.K. Solanki ◽  
Dipika B. Patel ◽  
Sandip Unadkat ◽  
N.N. Gosai ◽  
Yunus Gafur Mansur

The orthorhombic semi-conducting compound GeS0.25Se0.75 and GeS0.75Se0.25 possess interesting electrical properties and can been the subject of numerous investigations. The changes in solids under high pressure can reveal several new features of interatomic forces, which are responsible for their diverse physical properties. Authors have carried out growth of GeS0.25Se0.75 and GeS0.75Se0.25 crystals by Direct Vapor Transport (DVT) technique. For compositional confirmation energy dispersive analysis of X-ray (EDAX) has been used. EDAX results show that the grown crystals are nearly stoichiometrycally perfect. The grown crystals have been characterized by X-ray diffraction technique (using Philips X Pert MPD diffractometer) for structural characterization. These crystals are crystallized in orthorhombic structure. The values of lattice parameters, unit cell volume and X-ray density are calculated and presented. It is observed from lattice parameters, unit cell volume and X-ray density, that as the content of sulfur increases the value of all the lattice parameters decreases. High pressure study is also of great importance to visualize the mechanism governing the structural changes and to reveal solid state properties associated with different structure. For the room temperature measurement of resistance as a function of pressure, up to 7 GPa, the sample was set at the centre of the talc disc on the lower anvil. The pressure was generated by a hydraulic press on the Bridgman type tungsten carbide opposed anvil apparatus with in-situ Bismuth pressure calibration. The resistance was measured in several independent runs on these crystals as a function of pressure and was found to be reproducible. The results of variation of electrical resistance do not show presence of any phase transition up to 7 GPa. We investigate in GeS0.25Se0.75 and GeS0.75Se0.25 single crystals that as sulfur content increases, resistance of this compound increases.


2021 ◽  
Vol 48 (9) ◽  
Author(s):  
G. Diego Gatta ◽  
Francesco Pagliaro ◽  
Paolo Lotti ◽  
Alessandro Guastoni ◽  
Laura Cañadillas-Delgado ◽  
...  

AbstractThe thermal behaviour of a natural allanite-(Ce) has been investigated up to 1073 K (at room pressure) by means of in situ synchrotron powder X-ray diffraction and single-crystal neutron diffraction. Allanite preserves its crystallinity up to 1073 K. However, up to 700 K, the thermal behaviour along the three principal crystallographic axes, of the monoclinic β angle and of the unit-cell volume follow monotonically increasing trends, which are almost linear. At T > 700–800 K, a drastic change takes place: an inversion of the trend is observed along the a and b axes (more pronounced along b) and for the monoclinic β angle; in contrast, an anomalous increase of the expansion is observed along the c axis, which controls the positive trend experienced by the unit-cell volume at T > 700–800 K. Data collected back to room T, after the HT experiments, show unit-cell parameters significantly different with respect to those previously measured at 293 K: allanite responds with an ideal elastic behaviour up to 700 K, and at T > 700–800 K its behaviour deviates from the elasticity field. The thermo-elastic behaviour up to 700 K was modelled with a modified Holland–Powell EoS; for the unit-cell volume, we obtained the following parameters: VT0 = 467.33(6) Å3 and αT0(V) = 2.8(3) × 10–5 K−1. The thermal anisotropy, derived on the basis of the axial expansion along the three main crystallographic directions, is the following: αT0(a):αT0(b):αT0(c) = 1.08:1:1.36. The T-induced mechanisms, at the atomic scale, are described on the basis of the neutron structure refinements at different temperatures. Evidence of dehydroxylation effect at T ≥ 848 K are reported. A comparison between the thermal behaviour of allanite, epidote and clinozoisite is carried out.


2021 ◽  
Vol 7 (3) ◽  
pp. 42
Author(s):  
Jiba N. Dahal ◽  
Kalangala Sikkanther Syed Ali ◽  
Sanjay R. Mishra

Intermetallic compounds of Dy2Fe16Ga1−xNbx (x = 0.0 to 1.00) were synthesized by arc melting. Samples were investigated for structural, magnetic, and hyperfine properties using X-ray diffraction, vibration sample magnetometer, and Mossbauer spectrometer, respectively. The Rietveld analysis of room temperature X-ray diffraction data shows that all the samples were crystallized in Th2Fe17 structure. The unit cell volume of alloys increased linearly with an increase in Nb content. The maximum Curie temperature Tc ~523 K for x = 0.6 sample is higher than Tc = 153 K of Dy2Fe17. The saturation magnetization decreased linearly with increasing Nb content from 61.57 emu/g for x = 0.0 to 42.46 emu/g for x = 1.0. The Mössbauer spectra and Rietveld analysis showed a small amount of DyFe3 and NbFe2 secondary phases at x = 1.0. The hyperfine field of Dy2Fe16Ga1−xNbx decreased while the isomer shift values increased with the Nb content. The observed increase in isomer shift may have resulted from the decrease in s electron density due to the unit cell volume expansion. The substantial increase in Tc of thus prepared intermetallic compounds is expected to have implications in magnets used for high-temperature applications.


2014 ◽  
Vol 70 (a1) ◽  
pp. C1746-C1746
Author(s):  
Kazuo Kurihara ◽  
Katsuaki Tomoyori ◽  
Taro Tamada ◽  
Ryota Kuroki

The structural information of hydrogen atoms and hydration waters obtained by neutron protein crystallography is expected to contribute to elucidation of protein function and its improvement. However, many proteins, especially membrane proteins and protein complexes, have larger molecular weight and then unit cells of their crystals have larger volume, which is out of range of measurable unit cell volume for conventional diffractometers. Therefore, our group had designed the diffractometer which can cover such crystals with large unit cell volume (target lattice length: 250 Å). This diffractometer is dedicated for protein single crystals and has been proposed to be installed at J-PARC (Japan Proton Accelerator Research Complex). Larger unit cell volume causes a problem to separate spots closer to each other in spatial as well as time dimension in diffraction images. Therefore, our proposed diffractometer adopts longer camera distance (L2 = 800mm) and selects decoupled hydrogen moderator as neutron source which has shorter pulse width. Under the conditions that L1 is 33.5m, beam divergence 0.40and crystal edge size 2mm, this diffractometer is estimated to be able to resolves spots diffracted from crystals with a lattice length of 220 Å in each axis at d-space of 2.0 Å. In order to cover large neutron detecting area due to long camera distance, novel large-area detector (larger than 300mm × 300mm) with a spatial resolution of better than 2.5mm is under development. More than 40 these detectors plan to be installed, providing the total solid angle coverage of larger than 33%. For neutron guide, ellipsoidal supermirror is considered to be adopted to increase neutron flux at the sample position. The final gain factor of this diffractometer is estimated to be about 20 or larger as compared with BIX-3/4 diffractometers operated in the research reactor JRR-3 at JAEA (Japan Atomic Energy Agency) [1,2].


2021 ◽  
pp. 1-3
Author(s):  
J. Maixner ◽  
J. Ryšavý

X-ray powder diffraction data, unit-cell parameters, and space group for tetrazene nitrate monohydrate, C2H9N11O4, are reported [a = 5.205(1) Å, b = 13.932(3) Å, c = 14.196(4) Å, β = 97.826(3)°, unit-cell volume V = 1019.8(4) Å3, Z = 4, and space group P21/c]. All measured lines were indexed and are consistent with the P21/c space group. No detectable impurities were observed.


Sign in / Sign up

Export Citation Format

Share Document