scholarly journals Effect of stand-off distance and spatial resolution on the pressure impact of near-wall vapor bubble collapses

Author(s):  
Theresa Trummler ◽  
Steffen J. Schmidt ◽  
Nikolaus A. Adams
Author(s):  
Dongmei Zhou ◽  
Kenneth S. Ball

This paper has two objectives, (1) to examine the effects of spatial resolution, (2) to examine the effects of computational box size, upon turbulence statistics and the amount of drag reduction with and without the control scheme of wall oscillation. Direct numerical simulation (DNS) of the fully developed turbulent channel flow was performed at Reynolds number of 200 based on the wall-shear velocity and the channel half-width by using spectral methods. For the first objective, four different grids were applied to the same computational domain and the biggest impact was observed on the logarithmic law of mean velocity profiles and on the amount of drag reduction with 28.3% for the coarsest mesh and 35.4% for the finest mesh. Other turbulence features such as RMS velocity fluctuations, RMS vorticity fluctuations, and bursting events were either overpredicted or underpredicted through coarse grids. For the second objective, two different minimal channels and one natural full channel were studied and 3% drag reduction difference was observed between the smallest minimal channel of 39.1% and the natural full channel of 36.2%. In the near-wall region, however, the minimal channel flow did not exhibit significant difference in the mean velocity profiles and other lower-order statistics. Finally, from this systematical study, it showed that the accuracy of DNS depends more on the spanwise resolution, and it also confirmed that a minimal channel model is able to catch key structures of turbulence in the near-wall region but is much less expensive.


2009 ◽  
Vol 635 ◽  
pp. 103-136 ◽  
Author(s):  
N. HUTCHINS ◽  
T. B. NICKELS ◽  
I. MARUSIC ◽  
M. S. CHONG

Careful reassessment of new and pre-existing data shows that recorded scatter in the hot-wire-measured near-wall peak in viscous-scaled streamwise turbulence intensity is due in large part to the simultaneous competing effects of the Reynolds number and viscous-scaled wire length l+. An empirical expression is given to account for these effects. These competing factors can explain much of the disparity in existing literature, in particular explaining how previous studies have incorrectly concluded that the inner-scaled near-wall peak is independent of the Reynolds number. We also investigate the appearance of the so-called outer peak in the broadband streamwise intensity, found by some researchers to occur within the log region of high-Reynolds-number boundary layers. We show that the ‘outer peak’ is consistent with the attenuation of small scales due to large l+. For turbulent boundary layers, in the absence of spatial resolution problems, there is no outer peak up to the Reynolds numbers investigated here (Reτ = 18830). Beyond these Reynolds numbers – and for internal geometries – the existence of such peaks remains open to debate. Fully mapped energy spectra, obtained with a range of l+, are used to demonstrate this phenomenon. We also establish the basis for a ‘maximum flow frequency’, a minimum time scale that the full experimental system must be capable of resolving, in order to ensure that the energetic scales are not attenuated. It is shown that where this criterion is not met (in this instance due to insufficient anemometer/probe response), an outer peak can be reproduced in the streamwise intensity even in the absence of spatial resolution problems. It is also shown that attenuation due to wire length can erode the region of the streamwise energy spectra in which we would normally expect to see kx−1 scaling. In doing so, we are able to rationalize much of the disparity in pre-existing literature over the kx−1 region of self-similarity. Not surprisingly, the attenuated spectra also indicate that Kolmogorov-scaled spectra are subject to substantial errors due to wire spatial resolution issues. These errors persist to wavelengths far beyond those which we might otherwise assume from simple isotropic assumptions of small-scale motions. The effects of hot-wire length-to-diameter ratio (l/d) are also briefly investigated. For the moderate wire Reynolds numbers investigated here, reducing l/d from 200 to 100 has a detrimental effect on measured turbulent fluctuations at a wide range of energetic scales, affecting both the broadband intensity and the energy spectra.


2012 ◽  
Vol 225 ◽  
pp. 109-117 ◽  
Author(s):  
Zambri Harun ◽  
Mohamad Dali Isa ◽  
Mohammad Rasidi Rasani ◽  
Shahrir Abdullah

Single normal hot-wire measurements of the streamwise component of velocity were taken in boundary layer flows subjected to pressure gradients at matched friction Reynolds numbers Reτ ≈ 3000. To evaluate spatial resolution effects, the sensor lengths are varied in both adverse pressure gradient (APG) and favorable pressure gradient (FPG). A control boundary layer flow in zero pressure gradient ZPG is also presented. It is shown here that, when the sensor length is maintained a constant value, in a contant Reynolds number, the near-wall peak increases with (adverse) pressure gradient. Both increased contributions of the small- and especially large-scale features are attributed to the increased broadband turbulence intensities. The two-mode increase, one centreing in the near-wall region and the other one in the outer region, makes spatial resolution studies in boundary layer flow more complicated. The increased large-scale features in the near-wall region of an APG flow is similar to large-scales increase due to Reynolds number in ZPG flow. Additionally, there is also an increase of the small-scales in the near-wall region when the boundary layer is exposed to adverse pressure gradient (while the Reynolds number is constant). In order to collapse the near-wall peaks for APG, ZPG and FPG flows, the APG flow has to use the longest sensor and conversely, the FPG has to use the shortest sensor. This study recommends that the empirical prediction by Huthins et. al. (2009) to be reevaluated if pressure gradient flows were to be considered such that the magnitude of the near-wall peak is also a function of the adverse pressure gradient parameter.


1983 ◽  
Vol 137 ◽  
pp. 409-421 ◽  
Author(s):  
Arne V. Johansson ◽  
P. Henrik Alfredsson

The effects of imperfect spatial resolution on hot-film and hot-wire measurements of wall-bounded turbulent shear flows were studied. Two hot-film probes of different length were used for measurements of fully developed turbulent channel flow in a water tunnel. In the near-wall region significant effects of spanwise spatial averaging due to finite probe size were found for a probe 32 viscous units long. The maximum turbulence intensity attained a 10% lower value than that for a probe about half as long, and the zero-crossing of the skewness factor was shifted away from the wall. This could be attributed to spatial averaging of narrow low-speed regions. Results for different Reynolds numbers, but with the same sensor length in viscous units, showed that Reynolds-number effects are small, and that much of the reported discrepancies for turbulence measurements in the near-wall region can be ascribed to effects of imperfect spatial resolution. Also the number of events detected with the variable-interval time-averaging (VITA) technique was found to depend strongly on the sensor length, especially for events with short duration.


Author(s):  
R. Hutchings ◽  
I.P. Jones ◽  
M.H. Loretto ◽  
R.E. Smallman

There is increasing interest in X-ray microanalysis of thin specimens and the present paper attempts to define some of the factors which govern the spatial resolution of this type of microanalysis. One of these factors is the spreading of the electron probe as it is transmitted through the specimen. There will always be some beam-spreading with small electron probes, because of the inevitable beam divergence associated with small, high current probes; a lower limit to the spatial resolution is thus 2αst where 2αs is the beam divergence and t the specimen thickness.In addition there will of course be beam spreading caused by elastic and inelastic interaction between the electron beam and the specimen. The angle through which electrons are scattered by the various scattering processes can vary from zero to 180° and it is clearly a very complex calculation to determine the effective size of the beam as it propagates through the specimen.


Author(s):  
R.W. Carpenter

Interest in precipitation processes in silicon appears to be centered on transition metals (for intrinsic and extrinsic gettering), and oxygen and carbon in thermally aged materials, and on oxygen, carbon, and nitrogen in ion implanted materials to form buried dielectric layers. A steadily increasing number of applications of microanalysis to these problems are appearing. but still far less than the number of imaging/diffraction investigations. Microanalysis applications appear to be paced by instrumentation development. The precipitation reaction products are small and the presence of carbon is often an important consideration. Small high current probes are important and cryogenic specimen holders are required for consistent suppression of contamination buildup on specimen areas of interest. Focussed probes useful for microanalysis should be in the range of 0.1 to 1nA, and estimates of spatial resolution to be expected for thin foil specimens can be made from the curves shown in Fig. 1.


Author(s):  
J. R. Michael

X-ray microanalysis in the analytical electron microscope (AEM) refers to a technique by which chemical composition can be determined on spatial scales of less than 10 nm. There are many factors that influence the quality of x-ray microanalysis. The minimum probe size with sufficient current for microanalysis that can be generated determines the ultimate spatial resolution of each individual microanalysis. However, it is also necessary to collect efficiently the x-rays generated. Modern high brightness field emission gun equipped AEMs can now generate probes that are less than 1 nm in diameter with high probe currents. Improving the x-ray collection solid angle of the solid state energy dispersive spectrometer (EDS) results in more efficient collection of x-ray generated by the interaction of the electron probe with the specimen, thus reducing the minimum detectability limit. The combination of decreased interaction volume due to smaller electron probe size and the increased collection efficiency due to larger solid angle of x-ray collection should enhance our ability to study interfacial segregation.


Sign in / Sign up

Export Citation Format

Share Document