The effect of RF power and deposition temperature on the structure and electrical properties of Mg4Ta2O9 thin films prepared by RF magnetron sputtering

2009 ◽  
Vol 311 (3) ◽  
pp. 627-633 ◽  
Author(s):  
Cheng-Liang Huang ◽  
Jhih-Yong Chen
Keyword(s):  
Thin Films ◽  
Electrical Properties ◽  
Magnetron Sputtering ◽  
Deposition Temperature ◽  
Rf Magnetron Sputtering ◽  
Rf Power

scholarly journals Residual Oxygen Effects on the Properties of MoS2 Thin Films Deposited at Different Temperatures by Magnetron Sputtering

Crystals ◽  
2021 ◽  
Vol 11 (10) ◽  
pp. 1183
Author(s):  
Peiyu Wang ◽  
Xin Wang ◽  
Fengyin Tan ◽  
Ronghua Zhang
Keyword(s):  
Thin Films ◽  
Electrical Properties ◽  
Magnetron Sputtering ◽  
Deposition Rate ◽  
Deposition Temperature ◽  
Energy Dispersive Spectrometer ◽  
Rf Magnetron Sputtering ◽  
Glass Substrates ◽  
Different Temperatures ◽  
Oxygen Atoms

Molybdenum disulfide (MoS2) thin films were deposited at different temperatures (150 °C, 225 °C, 300 °C, 375 °C, and 450 °C) on quartz glass substrates and silicon substrates using the RF magnetron sputtering method. The influence of deposition temperature on the structural, optical, electrical properties and deposition rate of the obtained thin films was investigated by X-ray diffraction (XRD), Energy Dispersive Spectrometer (EDS), Raman, absorption and transmission spectroscopies, a resistivity-measuring instrument with the four-probe method, and a step profiler. It was found that the MoS2 thin films deposited at the temperatures of 150 °C, 225 °C, and 300 °C were of polycrystalline with a (101) preferred orientation. With increasing deposition temperatures from 150 °C to 300 °C, the crystallization quality of the MoS2 thin films was improved, the Raman vibrational modes were strengthened, the deposition rate decreased, and the optical transmission and bandgap increased. When the deposition temperature increased to above 375 °C, the molecular atoms were partially combined with oxygen atoms to form MoO3 thin film, which caused significant changes in the structural, optical, and electrical properties of the obtained thin films. Therefore, it was necessary to control the deposition temperature and reduce the contamination of oxygen atoms throughout the magnetron sputtering process.

scholarly journals Performance Analysis of Ti-Doped In2O3 Thin Films Prepared by Various Doping Concentrations Using RF Magnetron Sputtering for Light-Emitting Device

2020 ◽  
Vol 2020 ◽  
pp. 1-9
Author(s):  
Wittawat Poonthong ◽  
Narong Mungkung ◽  
Pakpoom Chansri ◽  
Somchai Arunrungrusmi ◽  
Toshifumi Yuji
Keyword(s):  
Thin Films ◽  
Electrical Properties ◽  
Magnetron Sputtering ◽  
High Performance ◽  
Cost Effective ◽  
Rf Magnetron Sputtering ◽  
Rf Power ◽  
Light Emitting ◽  
Display Devices ◽  
Ecl Cell

The influences of doping amounts of TiO2 on the structure and electrical properties of In2O3 films were experimentally studied. In this study, titanium-doped indium oxide (ITiO) conductions were deposited on glass substrate by the dual-target-type radio frequency magnetron sputtering (RFS) system under different conditions of Ti-doped In2O3 targets, from Ti-0.5 wt% to Ti-5.0 wt%, along with 10 mTorr and 300 W pressure of RF power control that was used as a cost-effective transparent electrochemiluminescence (ECL) cell. From this process, the correlation between structural, optical, and electrical properties is reported. It was found that the best 1.14×10−4 Ω cm of resistivity was from Ti-2.5 wt% with the highest carrier concentration (1.15 × 1021 cm-3), Hall mobility (46.03 cm2/V·s), relatively transmittance (82%), and ECL efficiency (0.43 lm·W-1) with well crystalline structured and smooth morphology. As a result, researchers can be responsible for preparing ITiO thin films with significantly improved microstructure and light intensity performance for the effectiveness of the display devices, as well as its simple process and high performance.

Silicon Germanium Oxide (SixGeyO1-x-y) Infrared Sensitive Material for Uncooled Detectors

2010 ◽  
Vol 1245 ◽  
Author(s):  
Reza Anvari ◽  
Qi Cheng ◽  
Muhammad Lutful Hai ◽  
Truc Phan Bui ◽  
A. J. Syllaios ◽  
...  
Keyword(s):  
Thin Films ◽  
Electrical Properties ◽  
Magnetron Sputtering ◽  
Silicon Germanium ◽  
Room Temperature ◽  
Rf Magnetron Sputtering ◽  
Germanium Oxide ◽  
Temperature Coefficient Of Resistance ◽  
Sensitive Material

AbstractThis paper presents the formation and the characterization of silicon germanium oxide (SixGeyO1-x-y) infrared sensitive material for uncooled microbolometers. RF magnetron sputtering was used to simultaneously deposit Si and Ge thin films in an Ar/O2 environment at room temperature. The effects of varying Si and O composition on the thin film's electrical properties which include temperature coefficient of resistance (TCR) and resistivity were investigated. The highest achieved TCR and the corresponding resistivity at room temperature were -5.41 %/K and 3.16×103 ohm cm using Si0.039Ge0.875O0.086 for films deposited at room temperature.

RF Magnetron Sputtering Processed Transparent Conductive Aluminum Doped ZnO thin Films with Excellent Optical and Electrical Properties

2021 ◽  
Author(s):  
Chunhu Zhao ◽  
Junfeng Liu ◽  
Yixin Guo ◽  
Yanlin Pan ◽  
Xiaobo Hu ◽  
...  
Keyword(s):  
Thin Films ◽  
Electrical Properties ◽  
Magnetron Sputtering ◽  
Carrier Concentration ◽  
Rf Magnetron Sputtering ◽  
Zno Thin Films ◽  
Band Model ◽  
Deposition Condition ◽  
Optical And Electrical Properties ◽  
Doped Zno

Abstract Aluminum doped ZnO thin films (AZO), which simultaneously transmit light and conduct electrical current, are widely applied in photovoltaic devices. To achieve high performance AZO thin films, the effects of RF magnetron sputtering conditions on the optical and electrical properties of the films has been explored. The optimized AZO thin films exhibit strong (002) orientated growth with hexagonal wurtzite structure. The minimum resistivity of 0.9Í10-3 Ω·cm, the highest carrier concentration of 2.8Í1020 cm-3, the best Hall mobility of 22.8 cm2·(V·s)-1 and average transmittance above 85% can be achieved at the optimum deposition condition of 0.2 Pa, 120 W and 200 °C. Considering the single parabolic band model, the bandgap shift by carrier concentration of the films can be attributed to the Burstein-Moss effect. The results indicate that RF magnetron sputtered AZO thin films are promising for solar cell applications relying on front contact layers.

Sign in / Sign up

Export Citation Format

Share Document