scholarly journals Surface topology modification of organic substrates using material jetting technologies

2020 ◽  
Vol 196 ◽  
pp. 109116
Author(s):  
Tiffany Chen ◽  
Jessirie Dilag ◽  
Stuart Bateman
Keyword(s):  
Surface Topology ◽  
Organic Substrates ◽  
Topology Modification

Processing of human melanoma cells for correlative TEM, LVSEM, and LM

1991 ◽  
Vol 49 ◽  
pp. 106-107
Author(s):  
Marek Malecki ◽  
J. Victor Small ◽  
James Pawley
Keyword(s):  
Electron Microscopy ◽  
Low Voltage ◽  
Fluorescent Microscopy ◽  
Blood Stream ◽  
Surface Topology ◽  
Integrin Receptors ◽  
Transmission Electron ◽  
Develop Technology ◽  
Voltage Scanning ◽  
Mechanisms Of Adhesion

The relative roles of adhesion and locomotion in malignancy have yet to be clearly established. In a tumor, subpopulations of cells may be recognized according to their capacity to invade neighbouring tissue,or to enter the blood stream and metastasize. The mechanisms of adhesion and locomotion are themselves tightly linked to the cytoskeletal apparatus and cell surface topology, including expression of integrin receptors. In our studies on melanomas with Fluorescent Microscopy (FM) and Cell Sorter(FACS), we noticed that cells in cultures derived from metastases had more numerous actin bundles, then cells from primary foci. Following this track, we attempted to develop technology allowing to compare ultrastructure of these cells using correlative Transmission Electron Microscopy(TEM) and Low Voltage Scanning Electron Microscopy(LVSEM).

Fractionation of polymethylene chains: An electron crystallographic investigation

1986 ◽  
Vol 44 ◽  
pp. 794-795
Author(s):  
Douglas L. Dorset
Keyword(s):  
Cross Section ◽  
Binary Systems ◽  
Linear Chain ◽  
Pure Component ◽  
Organic Substrates ◽  
Crystallographic Investigation ◽  
X Ray Diffraction ◽  
X Ray ◽  
Molecular Sizes ◽  
The Stability

A variety of linear chain materials exist as polydisperse systems which are difficultly purified. The stability of continuous binary solid solutions assume that the Gibbs free energy of the solution is lower than that of either crystal component, a condition which includes such factors as relative molecular sizes and shapes and perhaps the symmetry of the pure component crystal structures.Although extensive studies of n-alkane miscibility have been carried out via powder X-ray diffraction of bulk samples we have begun to examine binary systems as single crystals, taking advantage of the well-known enhanced scattering cross section of matter for electrons and also the favorable projection of a paraffin crystal structure posited by epitaxial crystallization of such samples on organic substrates such as benzoic acid.

Surface topology

2001 ◽  
Author(s):  
Peter A. Firby ◽  
Cyril F. Gardiner
Keyword(s):  
Surface Topology

Development of High Permeability Core Materials for Embeddable Inductors in Flexible Organic Substrates

2003 ◽  
Vol 769 ◽  
Author(s):  
C. K. Liu ◽  
P. L. Cheng ◽  
S. Y. Y. Leung ◽  
T. W. Law ◽  
D. C. C. Lam
Keyword(s):  
Low Temperature ◽  
Sol Gel ◽  
Circuit Board ◽  
Organic Substrates ◽  
Circuit Boards ◽  
High Permeability ◽  
Electrical Measurements ◽  
Different Temperatures ◽  
Spiral Inductors ◽  
Ceramic Tape

AbstractCapacitors, resistors and inductors are surface mounted components on circuit boards, which occupy up to 70% of the circuit board area. For selected applications, these passives are packaged inside green ceramic tape substrates and sintered at temperatures over 700°C in a co-fired process. These high temperature processes are incompatible with organic substrates, and low temperature processes are needed if passives are to be embedded into organic substrates. A new high permeability dual-phase Nickel Zinc Ferrite (DP NZF) core fabricated using a low temperature sol-gel route was developed for use in embedded inductors in organic substrates. Crystalline NZF powder was added to the sol-gel precursor of NZF. The solution was deposited onto the substrates as thin films and heat-treated at different temperatures. The changes in the microstructures were characterized using XRD and SEM. Results showed that addition of NZF powder induced low temperature transformation of the sol-gel NZF phase to high permeability phase at 250°C, which is approximately 350°C lower than transformation temperature for pure NZF sol gel films. Electrical measurements of DP NZF cored two-layered spiral inductors indicated that the inductance increased by three times compared to inductors without the DP NZF cores. From microstructural observations, the increase is correlated with the changes in microstructural connectivity of the powder phase.

In vitro validation of a 3-dimensional transrectal ultrasound system for prostate biopsiess

2007 ◽  
Vol 30 (4) ◽  
pp. 77
Author(s):  
Derek Cool ◽  
Shi Sherebrin ◽  
Jonathan Izawa ◽  
Joseph Chin ◽  
Aaron Fenster
Keyword(s):  
Prostate Biopsy ◽  
3D Model ◽  
Transrectal Ultrasound ◽  
Surface Topology ◽  
Sufficient Information ◽  
Needle Guidance ◽  
3 Dimensional ◽  
High Incidence ◽  
3D Information

Introduction: Transrectal ultrasound (TRUS) prostate biopsy (Bx) is currently confined to 2D information to both target and record 3D Bx locations. Accurate placement of Bx needles cannot be verified without 3D information, and recording Bx sites in 2D does not provide sufficient information to accurately guide the high incidence of repeat Bx. We have designed a 3D TRUS prostate Bx system that augments the current 2D TRUS system and provides tools for biopsy-planning, needle guidance, and recording of the biopsy core locations entirely in 3D. Methods: Our Bx system displays a 3D model of the patient’s prostate, which is generated intra-procedure from a collection of 2D TRUS images, representative of the particular prostate shape. Bx targets are selected, needle guidance is facilitated, and 3D Bx sites are recorded within the 3D context of the prostate model. The complete 3D Bx system was validated, in vitro, by performing standard ten-core Bx on anatomical phantoms of two patient’s prostates. The accuracy of the needle-guidance, Bx location recording, and 3D model volume and surface topology were validated against a CT gold standard. Results: The Bx system successfully reconstructed the 3D patient prostate models with a mean volume error of 3.2 ± 7.6%. Using the 3D system, needles were accurately guided to the pre-determined targets with a mean error of 2.26 ± 1.03 mm and the 3D locations of the Bx cores were accurately recorded with a mean distance error of 1.47 ± 0.79 mm. Conclusion: We have successfully developed a 3D TRUS prostate biopsy system and validated the system in vitro. A pilot study has been initiated to apply the system clinically.

Fe-N-C Artificial Enzyme: Activation of Oxygen for Dehydrogenation and Monoxygenation of Organic Substrates under Mild Condition and Cancer Therapeutic Application

2018 ◽  
Author(s):  
Fei He ◽  
Li Mi ◽  
Yanfei Shen ◽  
Toshiyuki Mori ◽  
Songqin Liu ◽  
...  
Keyword(s):  
Mild Condition ◽  
Enzyme Activation ◽  
Artificial Enzymes ◽  
Organic Substrates ◽  
Artificial Enzyme ◽  
Therapeutic Application ◽  
Highly Efficient ◽  
Activation Of Oxygen

Developing highly efficient artificial enzymes that directly employ O<sub>2</sub> as terminal oxidant has long been pursued but has rarely achieved yet. We report Fe-N-C has unusual enzyme-like activity in both dehydrogenation and monoxygenation of organic substrates with ~100% selectivity by direct using O<sub>2</sub>.

Regime of soil humus rural residential areas organic farming systems

2018 ◽  
Vol 2 (95) ◽  
pp. 78-81
Author(s):  
L.I. Shkarivska
Keyword(s):  
Organic Farming ◽  
Rural Areas ◽  
Humus Content ◽  
Farming Systems ◽  
Farming System ◽  
Organic Substrates ◽  
Residential Areas ◽  
Typical Chernozem ◽  
Podzolic Soils ◽  
Organic Farming System

The changes of the soil’s humus soil within the rural areas are investigated for the organic farming system. The most significant impact of organic agriculture on humus content over 55% was observed on soddy podzolic soils (V>75%), the lowest –7,5% on typical chernozem (V≈16%). Changes in the qualitative composition of humus for the introduction of various types of organic substrates are analyzed.

Sign in / Sign up

Export Citation Format

Share Document