scholarly journals Hot water drilling in the firn layer of Greenland's percolation zone

2020 ◽  
pp. 1-4
Author(s):  
Neil Humphrey ◽  
Joel Harper ◽  
Toby Meierbachtol
Keyword(s):  
Hot Water ◽  
Small Field ◽  
Glacier Surface ◽  
Drill Stem ◽  
Rapid Access ◽  
Structural Framework ◽  
Water Saturated ◽  
Percolation Zone

Abstract The intermixed thermal and structural framework of cold firn, water-saturated firn and ice layers in Greenland's percolation zone can be challenging to penetrate with core drills. Here, we present our experiences using a hot water drill for research on the firn layer of the percolation zone. We built and deployed a lightweight and easily transportable system for drilling a transect of ~15 cm diameter boreholes through the full firn column thickness, to depths exceeding 100 m. An instrumented drill stem provides a scientific measurement of the firn properties while drilling. The system was successful at gaining rapid access to the firn column with mixed wet and cold conditions, was easily transported to the site and across the glacier surface, and required a small field crew to operate. The boreholes are well suited for in situ investigations of firn processes in Greenland percolation zone.

scholarly journals Thrusting and debris entrainment in a surging glacier: Bakaninbreen, Svalbard

1996 ◽  
Vol 22 ◽  
pp. 241-248 ◽  
Author(s):  
Michael J. Hambrey ◽  
Julian A. Dowdeswell ◽  
Tavi Murray ◽  
Philip R. Porter
Keyword(s):  
Tectonic Evolution ◽  
Sedimentary Facies ◽  
Shear Zones ◽  
Hot Water ◽  
Important Process ◽  
High Angle ◽  
Glacier Surface ◽  
Structural Investigations ◽  
Fine Grained ◽  
Drill Stem

Bakaninbreen, a 17 km long glacier terminating in fjord waters in central Spitsbergen (77°45′ N, 17°20′E), began to surge between the springs of 1985 and 1986. By summer 1994 the surge front had reached a position 3 km from the terminus and had almost ceased propagation. Structural investigations were undertaken to characterise the tectonic evolution of this thermally complex surge-type glacier, and the role played by thrusting and its effect on debris entrainment. Much of the glacier surface, particularly within and below the surge front, displayed transverse high-angle thrusts, defined by discrete fractures bounded by coarse clear ice. Some fractures were associated with a film of mud, whereas in others a discrete laver of diamicton, with interstitial ice several decimetres thick, was evident. Within the surge front, and genetically related to the thrusts, was a number of shear zones several metres wide. These were defined by fine-grained ice that was the product of the grinding up of crystals during shear (mylonitization). Three main sedimentary facies are associated with the thrusts: mud, gravelly mud and clast-rich muddy diamicton. The diamicton has the character of basal glacial debris: grain-size distribution ranging from clay to cobble size, clasts with a predominance in the sub-angular and sub-rounded classes, and striated and faceted clasts. Hot-water drilling through the glacier revealed several englacial layers above the surge front, and debris brought up on the drill stem suggests a basal origin. At least some of these englacial layers are probably the sub-surface continuations of the thrusts. The observed facies indicate that the glacier is moving over a soft, deformable bed and that thrusting is an important process in transferring debris to the surface, especially when the surge front is propagating down-glacier.

scholarly journals Thrusting and debris entrainment in a surging glacier: Bakaninbreen, Svalbard

1996 ◽  
Vol 22 ◽  
pp. 241-248 ◽  
Author(s):  
Michael J. Hambrey ◽  
Julian A. Dowdeswell ◽  
Tavi Murray ◽  
Philip R. Porter
Keyword(s):  
Tectonic Evolution ◽  
Sedimentary Facies ◽  
Shear Zones ◽  
Hot Water ◽  
Important Process ◽  
High Angle ◽  
Glacier Surface ◽  
Structural Investigations ◽  
Fine Grained ◽  
Drill Stem

Bakaninbreen, a 17 km long glacier terminating in fjord waters in central Spitsbergen (77°45′ N, 17°20′E), began to surge between the springs of 1985 and 1986. By summer 1994 the surge front had reached a position 3 km from the terminus and had almost ceased propagation. Structural investigations were undertaken to characterise the tectonic evolution of this thermally complex surge-type glacier, and the role played by thrusting and its effect on debris entrainment. Much of the glacier surface, particularly within and below the surge front, displayed transverse high-angle thrusts, defined by discrete fractures bounded by coarse clear ice. Some fractures were associated with a film of mud, whereas in others a discrete laver of diamicton, with interstitial ice several decimetres thick, was evident. Within the surge front, and genetically related to the thrusts, was a number of shear zones several metres wide. These were defined by fine-grained ice that was the product of the grinding up of crystals during shear (mylonitization). Three main sedimentary facies are associated with the thrusts: mud, gravelly mud and clast-rich muddy diamicton. The diamicton has the character of basal glacial debris: grain-size distribution ranging from clay to cobble size, clasts with a predominance in the sub-angular and sub-rounded classes, and striated and faceted clasts. Hot-water drilling through the glacier revealed several englacial layers above the surge front, and debris brought up on the drill stem suggests a basal origin. At least some of these englacial layers are probably the sub-surface continuations of the thrusts. The observed facies indicate that the glacier is moving over a soft, deformable bed and that thrusting is an important process in transferring debris to the surface, especially when the surge front is propagating down-glacier.

scholarly journals MABEL photon-counting laser altimetry data in Alaska for ICESat-2 simulations and development

2016 ◽  
Vol 10 (4) ◽  
pp. 1707-1719 ◽  
Author(s):  
Kelly M. Brunt ◽  
Thomas A. Neumann ◽  
Jason M. Amundson ◽  
Jeffrey L. Kavanaugh ◽  
Mahsa S. Moussavi ◽  
...  
Keyword(s):  
New Technology ◽  
Photon Counting ◽  
Sampling Strategy ◽  
Laser Altimeter ◽  
Glacier Surface ◽  
Algorithm Development ◽  
In Situ Data ◽  
Melt Ponds ◽  
Water Saturated

Abstract. Ice, Cloud, and land Elevation Satellite-2 (ICESat-2) is scheduled to launch in late 2017 and will carry the Advanced Topographic Laser Altimeter System (ATLAS), which is a photon-counting laser altimeter and represents a new approach to satellite determination of surface elevation. Given the new technology of ATLAS, an airborne instrument, the Multiple Altimeter Beam Experimental Lidar (MABEL), was developed to provide data needed for satellite-algorithm development and ICESat-2 error analysis. MABEL was deployed out of Fairbanks, Alaska, in July 2014 to provide a test dataset for algorithm development in summer conditions with water-saturated snow and ice surfaces. Here we compare MABEL lidar data to in situ observations in Southeast Alaska to assess instrument performance in summer conditions and in the presence of glacier surface melt ponds and a wet snowpack. Results indicate the following: (1) based on MABEL and in situ data comparisons, the ATLAS 90 m beam-spacing strategy will provide a valid assessment of across-track slope that is consistent with shallow slopes (< 1°) of an ice-sheet interior over 50 to 150 m length scales; (2) the dense along-track sampling strategy of photon counting systems can provide crevasse detail; and (3) MABEL 532 nm wavelength light may sample both the surface and subsurface of shallow (approximately 2 m deep) supraglacial melt ponds. The data associated with crevasses and melt ponds indicate the potential ICESat-2 will have for the study of mountain and other small glaciers.

In-situ automatic observations of ice thickness of seas

2012 ◽  
Vol 19 (3) ◽  
pp. 583-592 ◽  
Author(s):  
Yinke Dou ◽  
Xiaomin Chang
Keyword(s):  
Sea Ice ◽  
New Technologies ◽  
Capacitive Sensor ◽  
Automatic Monitoring ◽  
Ice Thickness ◽  
In Situ Observation ◽  
Glacier Surface ◽  
Sea Ice Thickness ◽  
Surface Ice

Abstract Ice thickness is one of the most critical physical indicators in the ice science and engineering. It is therefore very necessary to develop in-situ automatic observation technologies of ice thickness. This paper proposes the principle of three new technologies of in-situ automatic observations of sea ice thickness and provides the findings of laboratory applications. The results show that the in-situ observation accuracy of the monitor apparatus based on the Magnetostrictive Delay Line (MDL) principle can reach ±2 mm, which has solved the “bottleneck” problem of restricting the fine development of a sea ice thermodynamic model, and the resistance accuracy of monitor apparatus with temperature gradient can reach the centimeter level and research the ice and snow substance balance by automatically measuring the glacier surface ice and snow change. The measurement accuracy of the capacitive sensor for ice thickness can also reach ±4 mm and the capacitive sensor is of the potential for automatic monitoring the water level under the ice and the ice formation and development process in water. Such three new technologies can meet different needs of fixed-point ice thickness observation and realize the simultaneous measurement in order to accurately judge the ice thickness.

scholarly journals Application of an improved surface energy balance model to two large valley glaciers in the St. Elias Mountains, Yukon

2020 ◽  
pp. 1-16
Author(s):  
Tim Hill ◽  
Christine F. Dow ◽  
Eleanor A. Bash ◽  
Luke Copland
Keyword(s):  
Energy Balance ◽  
Surface Energy ◽  
Surface Energy Balance ◽  
Shortwave Radiation ◽  
Balance Model ◽  
Landsat 8 ◽  
Glacier Surface ◽  
Ice Dynamics ◽  
Surface Melt

Abstract Glacier surficial melt rates are commonly modelled using surface energy balance (SEB) models, with outputs applied to extend point-based mass-balance measurements to regional scales, assess water resource availability, examine supraglacial hydrology and to investigate the relationship between surface melt and ice dynamics. We present an improved SEB model that addresses the primary limitations of existing models by: (1) deriving high-resolution (30 m) surface albedo from Landsat 8 imagery, (2) calculating shadows cast onto the glacier surface by high-relief topography to model incident shortwave radiation, (3) developing an algorithm to map debris sufficiently thick to insulate the glacier surface and (4) presenting a formulation of the SEB model coupled to a subsurface heat conduction model. We drive the model with 6 years of in situ meteorological data from Kaskawulsh Glacier and Nàłùdäy (Lowell) Glacier in the St. Elias Mountains, Yukon, Canada, and validate outputs against in situ measurements. Modelled seasonal melt agrees with observations within 9% across a range of elevations on both glaciers in years with high-quality in situ observations. We recommend applying the model to investigate the impacts of surface melt for individual glaciers when sufficient input data are available.

scholarly journals Glacier Surface Mass Balance in the Suntar-Khayata Mountains, Northeastern Siberia

Water ◽  
2019 ◽  
Vol 11 (9) ◽  
pp. 1949 ◽  
Author(s):  
Yong Zhang ◽  
Xin Wang ◽  
Zongli Jiang ◽  
Junfeng Wei ◽  
Hiroyuki Enomoto ◽  
...  
Keyword(s):  
Mass Loss ◽  
Mass Balance ◽  
Surface Mass Balance ◽  
Negative Mass ◽  
Glacier Surface ◽  
Surface Mass ◽  
Northeastern Siberia ◽  
Response To Temperature ◽  
Rapid Mass

Arctic glaciers comprise a small fraction of the world’s land ice area, but their ongoing mass loss currently represents a large cryospheric contribution to the sea level rise. In the Suntar-Khayata Mountains (SKMs) of northeastern Siberia, in situ measurements of glacier surface mass balance (SMB) are relatively sparse, limiting our understanding of the spatiotemporal patterns of regional mass loss. Here, we present SMB time series for all glaciers in the SKMs, estimated through a glacier SMB model. Our results yielded an average SMB of −0.22 m water equivalents (w.e.) year−1 for the whole region during 1951–2011. We found that 77.4% of these glaciers had a negative mass balance and detected slightly negative mass balance prior to 1991 and significantly rapid mass loss since 1991. The analysis suggests that the rapidly accelerating mass loss was dominated by increased surface melting, while the importance of refreezing in the SMB progressively decreased over time. Projections under two future climate scenarios confirmed the sustained rapid shrinkage of these glaciers. In response to temperature rise, the total present glacier area is likely to decrease by around 50% during the period 2071–2100 under representative concentration pathway 8.5 (RCP8.5).

scholarly journals Short-term surface ice motion variations measured with a ground-based portable real aperture radar interferometer

2011 ◽  
Vol 57 (201) ◽  
pp. 53-60 ◽  
Author(s):  
Patrick Riesen ◽  
Tazio Strozzi ◽  
Andreas Bauder ◽  
Andreas Wiesmann ◽  
Martin Funk
Keyword(s):  
Line Of Sight ◽  
Interferometric Imaging ◽  
Short Term ◽  
Glacier Surface ◽  
Fast Acquisition ◽  
Surface Ice ◽  
The Impact ◽  
Real Aperture Radar ◽  
Aperture Radar

AbstractWe report measurements using a portable real aperture radar (Gamma Portable Radar Interferometer (GPRI)) for interferometric imaging of the surface ice motion on Gornergletscher, Switzerland, during the drainage of the adjacent ice-marginal lake Gornersee. The GPRI tracked the surface ice motion in line of sight over an area of ∼3 km2 down-glacier of Gornersee almost continuously during the drainage event. The displacement maps derived from the acquired interferograms capture the spatial distribution of the surface ice motion. Due to fast acquisition times of the microwave images, the GPRI was able to record sub-daily variations of the ice displacements, most likely caused by the impact of the Gornersee drainage on the ice motion of Gornergletscher. In situ point measurements of the ice displacement agree reasonably well with the results obtained by the GPRI and highlight the use of the GPRI for high-resolution measurements of glacier surface ice motion.

Sign in / Sign up

Export Citation Format

Share Document