Diapause in the Eggs of Austroicetes cruciata, Sauss. (Acrididae) with particular Reference to the Influence of Temperature on the Elimination of Diapause

1943 ◽  
Vol 34 (1) ◽  
pp. 1-17 ◽  
Author(s):  
H. G. Andrewartha

Diapause should not be confused with simple inhibition of growth due to cold.The embryo of the grasshopper, Austroicetes cruciata, enters a state of diapause a few days after the egg is laid. The diapause is obligate like that found in the eggs of Circotettix, rather than facultative like that found in the larvae of Platyedra. These types of diapause should be regarded as two extremes of the one phenomenon rather than two distinct phenomena.Diapause was eliminated when the egg was exposed to adequate low temperature for an adequate period when the embryo was at a suitable stage of development. If the period at low temperature was inadequate, or if the embryo was not at a suitable stage of development when the exposure to low temperature occurred, diapause was only partially eliminated. In such cases, the exposure to low temperature resulted in an abnormal growth by the embryo when the egg was returned to a favourable high temperature, but development was not completed.The influence of low temperature on the elimination of diapause was due chiefly to changes which occurred in the yolk during exposure to low temperature. Thus yolk which had been modified in this way became suitable for the nourishment of the embryo, and it no longer obstructed katatrepsis. This explanation of the nature of the obligate diapause in the eggs of Austroicetes brings this phenomenon into line with the facultative diapause in the larvae of Platyedra, which has been shown to be associated with the nourishment of the larva.Diapause was eliminated most rapidly at temperatures between 6°C. and 13°C. The embryo grew most rapidly at about 30°C. ; below 13°C. growth practically ceased. The absence of overlapping of the temperature ranges for these two processes may explain the presence of diapause in Austroicetes. The occurrence of a less pronounced diapause in the eggs of Melanoplus may be due to a partial overlapping of the temperature range for the two processes. Similarly the absence of diapause in the eggs of Locusta may be explained on the assumption that in this species the two processes proceed over the same temperature range.

2013 ◽  
Vol 687 ◽  
pp. 130-135
Author(s):  
Si Feng Liu ◽  
Si Jun Guo ◽  
Pei Ming Wang

The hydration heat of polymer modified mortar were measured at 5°C、10°C、20°C and 40°C using Multi-channel Isothermal calorimeter. The effects of temperature on hydration heat of polymer modified mortars with 0.1% methyl hydroxylpropyl cellulose (MHPC), 3% ethylene vinyl acetate (EVA) and 0.1%MHPC+3%EVA were investigated. The curves of hydration heat show that the polymer reduces the hydration heat of mortars and it is related to the temperature. The effects will be more and more remarkable with the increasing of temperature; Temperature also affects the exothermic rate peak of polymer modified mortars. The exothermic rate peak of polymer modified mortar at low temperature is almost equal to that of the ordinary cement mortar. However, it is obviously lower than that of ordinary cement mortar at high temperature ; The time to the exothermic rate peak of polymer modified mortar is also related to the temperature.


2012 ◽  
Vol 706-709 ◽  
pp. 768-773
Author(s):  
Masahiro Nishida ◽  
Koichi Hayashi ◽  
Junichi Nakagawa ◽  
Yoshitaka Ito

The influence of temperature on crater formation and ejecta composition in thick aluminum alloy targets were investigated for impact velocities ranging from approximately 1.5 to 3.5 km/s using a two-stage light-gas gun. The diameter and depth of the crater increased with increasing temperature. The ejecta size at low temperature was slightly smaller than that at high temperature and room temperature. Temperature did not affect the size ratio of ejecta. The scatter diameter of the ejecta at high temperature was slightly smaller than those at low and room temperatures.


1952 ◽  
Vol 5 (1) ◽  
pp. 112 ◽  
Author(s):  
TO Browning

The eggs of GryUulus commodus, if incubated at high temperature (26.8�C.), soon after laying, did not develop and hatch promptly. Instead hatching was spread over a long period and many eggs died. If the eggs were given a period of exposure to low temperature (12.8�C.) before incubation at high temperature,� prompt hatching occurred. This was due to diapause, which occurred at an early stage in the morphological development of the egg.


Author(s):  
Rawanne Farsakouri

By referring to the fact that corrosion rates alter upon variation of different conditions and no research relevant to Lebanon address corrosion issues yet, this study was conducted based on accurate Lebanese offshore data and water composition. Based on "Alloy Select Software", identifying the most suitable material from different alloys was revealed, which turned out to be Copper and Aluminum based alloys. Moreover, corrosion rates were detected under different conditions of Temperature, CO₂, and H₂S and then repeated in the presence of a corrosion inhibitor. Results of these studies proved the significant influence of high temperature accompanied with high CO₂ percentage. However, different results concerning low temperature with different percentages of H₂S were obtained.


1997 ◽  
Vol 506 ◽  
Author(s):  
W. J. Cho ◽  
J. O. Lee ◽  
K. S. Chun

ABSTRACTThe hydraulic conductivities in water saturated bentonites at different densities were measured within temperature range of 20 to 80 °C. The results show that the hydraulic conductivities increase with increasing temperature. The hydraulic conductivities of bentonites at the temperature of 80 °C increase up to about 3 times as high as those at 20 °C. The measured values are in good agreement with those predicted. The change in viscosity of water with temperature contributes greatly to increase of hydraulic conductivity.


Author(s):  
Tomohiro Furukawa ◽  
Yasushi Hirakawa

As a preliminary investigation into the establishment of a lithium removal technique for the components used at the International Fusion Materials Irradiation Facility (IFMIF), experiments were performed on the dissolution of lithium in three solvents: ethanol, pure water, and ethanol–water. In these experiments, hemispherical lithium was immersed in the solvents at constant temperatures, and the degree of dissolution was measured continuously from the height of the sample. From the obtained data, the average dissolution rate in the solvents at each testing temperature (10–90 °C) and the amount of hydrogen generated by the chemical reaction were calculated. The average dissolution rates in ethanol, pure water, and ethanol–water at 30 °C were 0.01, 1.6, and 0.43 mm/min, respectively. Although the average dissolution rate increased with the testing temperature in the low-temperature range (10–50 °C) for all solvents, this increase was saturated in the high-temperature range (50–90 °C) in experiments with pure water and ethanol–water as solvents. The volume of gas collected during each experiment was in good agreement with the volume of hydrogen assumed to be generated from the chemical reaction of lithium with the solvents.


Sign in / Sign up

Export Citation Format

Share Document