Effects of beach morphodynamic features on production and P/B ratio of the crab Emerita brasiliensis Schmitt, 1935 (Decapoda: Hippidae) in sandy beaches of South America

2016 ◽  
Vol 97 (6) ◽  
pp. 1215-1221 ◽  
Author(s):  
Marcelo Petracco ◽  
Ricardo Silva Cardoso ◽  
José Eduardo Martinelli Filho ◽  
Alexander Turra

The mole crab Emerita brasiliensis inhabits exposed sandy beaches, both reflective and dissipative, along the Atlantic coast of South America, where it usually attains high biomass and production. We assessed the effects of physical characteristics of beaches (mean grain size, beach width and slope) on production and turnover rate (P/B ratio) of E. brasiliensis. Six production and P/B ratio datasets, estimated with cohort-based and size-based methods, were gathered from studies carried out on subtropical (~25°S) and temperate beaches (~32°S). Based on the estimates available, general trends were identified. Production was positively related to the intermediate/dissipative conditions of wider beaches with finer sand grains and gentler slopes. P/B ratio was negatively related to grain size (mm) and positively related to beach width. These results suggest that P/B ratios also increase towards intermediate/dissipative features due to higher growth rate, as indicated by higher values of the curvature parameter of the von Bertalanffy growth function (K) in more benign conditions (wider beaches with finer grains). In addition, the recurrent pattern of size structure on intermediate/dissipative beaches, with high frequency of recruits, leads to higher P/B ratio estimates on these beaches than on reflective beaches. The relationship of production and P/B ratio with physical features, such as mean grain size, beach width and slope indicates that a ‘short-cut’ approach to estimate Emerita brasiliensis production is a promising prospect and, therefore, more data on the production of this species should be provided.

Author(s):  
В. Крыленко ◽  
V. Krylenko ◽  
Р. Косьян ◽  
R. Kos'yan ◽  
М. Крыленко ◽  
...  

The results of realized in 2010 field researches of the spatial and time grain-size structure variability of beach and bottom sediments of the bay-bar Anapskaya southern part are presented in this paper. Irretrievable carrying out of sediment particles to depths more than 7 m intensifies with their size decrease to 0,1 mm. As over 70 % bottom and about 60 % beach sediments are presented by fractions less 0,16 mm on bay-bar Anapskaya southern part, namely at this part there is sand material massive carrying out to depth. Potential danger of the investigated site geosystem degradation is revealed.


1984 ◽  
Vol 16 (3-4) ◽  
pp. 399-406
Author(s):  
Y Monbet

A study was conducted to gain insight on actual sedimentological and biological effects associated with the construction of an oil Terminal designed to receive 500 000 d.w.t. tankers. Field investigations and subsequent laboratory analyses were organized to evaluate the nature and magnitude of environmental changes on benthic macrofauna, three years after the end of the construction. Sediments were found to decrease dramatically in medium grain size in area sheltered by the newly built breakwater. Increase of percentage of silt and clays (90 % against 20 %) was observed leeward of the jetty. The benthic fauna showed significant modifications. Although the same community (Pectinaria kareni Abra alba) recolonized the bottom after the dredging of up to 30 × 106 m3 of sediments, increase in abundance occured. Biomass remained at a constant level and decrease of diversity was observed. Considering the rate of siltation, and assuming a constant siltation rate equal to the rate observed from 1975 to 1978, a simple regressive model relating biomass to mean grain size of sediments has been developped. This model allowed the prediction of biomass and production of the two principal species for the period 1978 – 1981. Continuous siltation within the harbor leads to a maximum of biomass from years after the end of the construction, followed by a decrease of standing stock. This process may be explained by the respective tolerance of the two principal species to increase silt contant and also probably by the accumulation of organic matter which may impede the development of natural populations.


Zootaxa ◽  
2019 ◽  
Vol 4576 (1) ◽  
pp. 109 ◽  
Author(s):  
ALEXANDRE PIRES MARCENIUK ◽  
RODRIGO ANTUNES CAIRES ◽  
LEONARDO MACHADO ◽  
NAJILA NOLIE CATARINE DANTAS CERQUEIRA ◽  
RAYLA ROBERTA M. DE S. SERRA ◽  
...  

The genus Orthopristis includes seven valid species, three from the western Atlantic and five from eastern Pacific, while the available identification guides and taxonomic keys incorrectly recognize Orthopristis ruber as the only valid species found on the Atlantic coast of South America. Efforts to expand the inventory of fish species from the northern coast of Brazil led to the identification of two distinct species of Orthopristis from Atlantic South America, based on the analysis of coloration patterns and meristic data, as well as DNA. In the present study, the limits of Orthopristis ruber are reviewed, while Orthopristis scapularis is recognized as a valid species for the northern and northeastern coasts of South America. Based on intermediate morphological characteristics and nuclear DNA markers, a hybrid zone was identified off the state of Espírito Santo, on the eastern Brazilian coast. Additionally, considerations are made on the diversity and biogeography of the coastal marine and estuarine fishes found on the Brazilian coast. 


2021 ◽  
Vol 56 (19) ◽  
pp. 11237-11247 ◽  
Author(s):  
Johannes Pötschke ◽  
Manisha Dahal ◽  
Mathias Herrmann ◽  
Anne Vornberger ◽  
Björn Matthey ◽  
...  

AbstractDense (Hf, Ta, Nb, Ti, V)C- and (Ta, Nb, Ti, V, W)C-based high-entropy carbides (HEC) were produced by three different sintering techniques: gas pressure sintering/sinter–HIP at 1900 °C and 100 bar Ar, vacuum sintering at 2250 °C and 0.001 bar as well as SPS/FAST at 2000 °C and 60 MPa pressure. The relative density varied from 97.9 to 100%, with SPS producing 100% dense samples with both compositions. Grain size measurements showed that the substitution of Hf with W leads to an increase in the mean grain size of 5–10 times the size of the (Hf, Ta, Nb, Ti, V,)C samples. Vacuum-sintered samples showed uniform grain size distribution regardless of composition. EDS mapping revealed the formation of a solid solution with no intermetallic phases or element clustering. X-ray diffraction analysis showed the structure of mostly single-phase cubic high-entropy carbides. Hardness measurements revealed that (Hf, Ta, Nb, Ti, V)C samples possess higher hardness values than (Ta, Nb, Ti, V, W)C samples.


The Holocene ◽  
2021 ◽  
pp. 095968362110032
Author(s):  
Boo-Keun Khim ◽  
Sunghan Kim ◽  
Yu-Hyeon Park ◽  
Jongmin Lee ◽  
Sangbeom Ha ◽  
...  

Various sediment properties, such as mean grain size, total organic carbon, total nitrogen, C/N ratio, CaCO3, and biogenic opal content, were analyzed for a box core (BC02; 45 cm long) and a gravity core (GC02; 628 cm long), which were collected from the western margin of the Hupo Trough located off the eastern coast of Korea. The study area has been affected by the East Korea Warm Current (EKWC), a branch of the Tsushima Warm Current (TWC). The analytical results obtained for BC02 and the upper part of GC02 were in agreement, affirming the core-top preservation of GC02. Based on the corrected calibrated AMS 14C dates, the sedimentation rate of GC02 changed abruptly at ~8.2 ka from ~4.0–10.2 cm/kyr in the lower part to ~56.6–91.0 cm/kyr in the middle to upper part. This corresponds to the lithologic change from sandy mud to mud sediments showing the mean grain size change from 6.9 to 46.0 μm. Diverse paleoceanographic proxies representing the surface water condition exhibited varying degree of change at ~8.2 ka, after which all the properties remain almost unchanged, implying stable and continuous depositional conditions following the complete development of the EKWC. Furthermore, it indicated that the sediment depositional conditions in the Hupo Trough in response to the EKWC might have stabilized at ~8.2 ka since the opening of the Korea Strait during the Holocene sea level rise. Moreover, microfossil data from previous studies on the establishment of the TWC in the East Sea (Japan Sea) support our interpretation that the sediment properties revealed the Holocene development of the EKWC in the Hupo Trough.


2004 ◽  
Vol 843 ◽  
Author(s):  
Adolfo Franco Júnior ◽  
Steve G. Roberts

ABSTRACTArrays of closely spaced quasi-static indentation were made on specimens of polycrystalline α-Al2O3, mean grain size G=1.2, 3.8 and 14.1 μm. The critical indentation spacing to produce crack coalescence between indentations, and thus significant loss of material from the surface, was determined. These data are compared to results for low-impact-velocity wet erosive wear on the same materials; a good correspondence is found. The indentation data can be used to produce “wear maps”, which provide a guideline for predicting the low-impact-velocity erosive wear resistance of brittle materials.


Materials ◽  
2021 ◽  
Vol 14 (2) ◽  
pp. 334
Author(s):  
Aidong Xia ◽  
Jie Yin ◽  
Xiao Chen ◽  
Zhengren Huang ◽  
Xuejian Liu ◽  
...  

In this work, a (SiC-AlN)/ZrB2 composite with outstanding mechanical properties was prepared by using polymer-derived ceramics (PDCs) and hot-pressing technique. Flexural strength reached up to 460 ± 41 MPa, while AlN and ZrB2 contents were 10 wt%, and 15 wt%, respectively, under a hot-pressing temperature of 2000 °C. XRD pattern-evidenced SiC generated by pyrolysis of polycarbosilane (PCS) was mainly composed by 2H-SiC and 4H-SiC, both belonging to α-SiC. Micron-level ZrB2 secondary phase was observed inside the (SiC-AlN)/ZrB2 composite, while the mean grain size (MGS) of SiC-AlN matrix was approximately 97 nm. This unique nano-micron hybrid microstructure enhanced the mechanical properties. The present investigation provided a feasible tactic for strengthening ceramics from PDCs raw materials.


2019 ◽  
Vol 218 ◽  
pp. 23-30 ◽  
Author(s):  
Marcelo Petracco ◽  
Daiane Aviz ◽  
José Eduardo Martinelli Filho ◽  
Ricardo Silva Cardoso ◽  
Alexander Turra

2011 ◽  
Vol 9 (3) ◽  
pp. 571-578 ◽  
Author(s):  
Oscar Lasso-Alcalá ◽  
Jorge L. S. Nunes ◽  
Carlos Lasso ◽  
Juan Posada ◽  
Ross Robertson ◽  
...  

We examined 308 specimens of the Indo-Pacific blenniid Omobranchus punctatus deposited in four museum collections, and analyzed data on their collection locations to assess its invasion on the Atlantic coast of Central and South America. This species occurs in shoreline estuarine and marine habitats in the Indo-West Pacific. Previous sampling and recent records in the Tropical West Atlantic from 1930 to 2004 produced 20 records for: Panamá, Colombia, Venezuela, Trinidad and Brazil. In this work, we provide data on 17 new records for the Gulfs of Venezuela and Paria in Venezuela, as well as four records for Maranhão and Pará states in NE Brazil. The temporal pattern of collections (1930 - 2009) and the proximity of most localities to ports and zones of ship traffic indicate that O. punctatus was initially introduced to the Atlantic by ships travelling from India to Trinidad. Within Brazil the introduction is linked to shipping connected to petroleum platforms. In Maranhão and Pará the introduction may have occurred as a result of fish sheltering in fouling on hulls of ships moving between ports around the mouth of the Amazon River. Alternatively, the spread of this species along of the American coast may reflect the expansion of the range of O. puntactus through larval dispersal in northward flowing currents. We recommend monitoring of this introduced species, and studies of its ecology in West Atlantic areas.


Sign in / Sign up

Export Citation Format

Share Document