The critical load concept for emission abatement strategies in Europe: a review

1997 ◽  
Vol 24 (1) ◽  
pp. 5-13 ◽  
Author(s):  
VLADIMIR N. BASHKIN

Critical loads studies (critical load is ‘a quantitative estimate of an exposure to one or more pollutants below which no harmful effects may occur’) have been used as the basis for assessing European strategies for reduction of sulphur emissions within the United Nations (UN) Economic Commission for Europe (ECE) Convention on Long-Range Transboundary Air Pollution (LRTAP). It is expected that the critical loads method will be applied to future international agreements under the Convention. Mapping of European critical loads conducted for the LRTAP Convention have progressed notably in recent years.The concept of designing pollution control measures with the aim of protecting the most sensitive ecosystems, led to the creation of the Task Force on Mapping and Coordination Centre for Effects to implement these concepts on a European scale together with the corresponding National Focal Centres. The Russian National Focal Centre is used to illustrate how critical load data can be applied at the scale of a large country.The policy implications resulting from the methods described in this review would support the development of an acidification protocol. While this has been suggested in the past, it is only now that scientific knowledge has advanced sufficiently to consider the feasibility of such a policy.

2018 ◽  
Author(s):  
Paul A. Makar ◽  
Ayodeji Akingunola ◽  
Julian Aherne ◽  
Amanda S. Cole ◽  
Yayne-abeba Aklilu ◽  
...  

Abstract. Estimates of potential harmful effects to ecosystems in the Canadian provinces of Alberta and Saskatchewan due to acidifying deposition were calculated, using a one year simulation of a high resolution implementation of the Global Environmental Multiscale – Modelling Air-quality and Chemistry (GEM-MACH) model, and estimates of aquatic and terrestrial ecosystem critical loads. The model simulation was evaluated against two different sources of deposition data; total deposition in precipitation and total deposition to snowpack in the vicinity of the Athabasca oil sands. The model captured much of the variability of observed ions in wet deposition in precipitation (observed versus model sulphur, nitrogen and base cation R2 values of 0.90, 0.76 and 0.72, respectively), while being biased high for sulphur deposition, and low for nitrogen and base cations (slopes 2.2, 0.89 and 0.40, respectively). Aircraft-observation-based estimates of fugitive dust emissions, shown to be a factor of ten higher than reported values (Zhang et al., 2017), were used to estimate the impact of increased levels of fugitive dust on model results. Model comparisons to open snowpack observations were shown to be biased high, but in reasonable agreement for sulphur deposition when observations were corrected to account for throughfall in needleleaf forests. The model-observation relationships for precipitation deposition data, along with the expected effects of increased (unreported) base cation emissions, were used to provide a simple observation-based correction to model deposition fields. Base cation deposition was estimated using published observations of base cation fractions in surface collected particles (Wang et al., 2015). Both original and observation-corrected model estimates of sulphur, nitrogen and base cation deposition were used in conjunction with critical load data created using the NEG-ECP (2001) and CLRTAP (2004, 2016, 2017) protocols for critical loads, using variations on the Simple Mass Balance model for forest and terrestrial ecosystems, and the Steady State Water Chemistry and the First-order Acidity Balance models for aquatic ecosystems. Potential ecosystem damage at 2013/14 emissions and deposition levels was predicted for regions within each of the ecosystem critical load datasets examined here. The spatial extent of the regions in exceedance of critical loads varied between 1 × 104 and 3.3 × 105 km2, for the more conservative observation-corrected estimates of deposition, with the variation dependant on the ecosystem and critical load protocol. The larger estimates (for aquatic ecosystems) represent a substantial fraction of the area of the provinces examined. Base cation deposition was shown to have a neutralizing effect on acidifying deposition, and the use of the aircraft and precipitation observation-based corrections to base cation deposition resulted in reasonable agreement with snowpack data collected in the oil sands area. However, critical load exceedances calculated using both observations and observation-corrected deposition suggest that the neutralization effect is limited in spatial extent, decreasing rapidly with distance from emissions sources, due to the rapid deposition of emitted primary particles dust particles as a function of their size.


2020 ◽  
pp. 135-147
Author(s):  
Yurii Shcatula ◽  
Volodymyr Votyk

Nowadays no herbicide has been approved for use on chickpea crops has been officially registered in Ukraine. Weed control measures are mainly used. However, many years of experience in the use of a number of herbicides in our country and in other countries. In this regard, the effectiveness and selectivity of soil preparations such as Harnes, 90% k.e., and Frontier Optima, 72% k.e. were studied in chickpea crops. These herbicides were applied after sowing chickpeas until the emergence of seedlings. Application of Harness herbicide, 90% k.e., at a rate of 3.0 l / ha in the soil before the emergence of chickpea seedlings leads to a decrease in weed vegetation a month after application of the herbicide to 88% compared to control areas where measures to protect against storms vegetation was not carried out. The regulation of the number of weeds and their harmful effects in chickpea agrophytocenoses to an economically harmless level is an important condition in the technology of its cultivation. The most relevant weed control is at the beginning of the growing season of the crop, since this the chickpea grows very slowly, is in the rosette phase for a long time, and therefore does not withstand competition from weeds. To increase the yield of chickpea seeds, an important place in the technology of growing crops is the use of herbicides and biological products. Inoculation of chickpea seeds with Rizobofitt at a consumption rate of 1 l / t and with a biofungicidal preparation Biopolycide at a consumption rate of 100 ml/t, by introducing a soil herbicide Frontier Optima, 72% k.e., at a consumption rate of 1,2 l/ha, contribute to the reduction of weeds to 91%, and the ability to obtain the yield of chickpea seeds at the level of 2,12 t/ha.


2000 ◽  
Vol 4 (1) ◽  
pp. 125-140 ◽  
Author(s):  
C. Curtis ◽  
T. Allott ◽  
J. Hall ◽  
R. Harriman ◽  
R. Helliwell ◽  
...  

Abstract. The critical loads approach is widely used within Europe to assess the impacts of acid deposition on terrestrial and freshwater ecosystems. Recent work in Great Britain has focused on the national application of the First-order Acidity Balance (FAB) model to a freshwaters dataset of 1470 lake and stream water chemistry samples from sites across Britain which were selected to represent the most sensitive water bodies in their corresponding 10 km grid square. A ``Critical Load Function" generated for each site is compared with the deposition load of S and N at the time of water chemistry sampling. The model predicts that when catchment processes reach steady-state with these deposition levels, increases in nitrate leaching will depress acid neutralizing capacity (ANC) below the critical threshold of 0 μeql-1 at more than a quarter of the sites sampled, i.e. the critical load of acid deposition is exceeded at these sites. The critical load exceedances are generally found in upland regions of high deposition where acidification has been previously recognised, but critical loads in large areas of western Scotland are also exceeded where little biological evidence of acidification has yet been found. There is a regional variation in the deposition reduction requirements for protection of the sampled sites. The FAB model indicates that in Scotland, most of the sampled sites could be protected by sufficiently large reductions in S deposition alone. In the English and Welsh uplands, both S and N deposition must be reduced to protect the sites. Current international commitments to reduce S deposition throughout Europe will therefore be insufficient to protect the most sensitive freshwaters in England and Wales. Keywords: critical loads; acidification; nitrate; FAB model; acid deposition


2018 ◽  
Vol 219 ◽  
pp. 02015
Author(s):  
Piątkowski Michał

The article presents graphical methods for determine critical loads of column and beam elements based on experimental results. The author presents the principles of using each method and the results of author's experimental tests on the instability phenomenon of planar steel truss with imperfections. The discussed methods were used to determine critical load of the tested truss, next compared with the results of numerical analysis. The validity of methods for determining the critical moment in the truss analysis has been confirmed.


2019 ◽  
Vol 26 (1) ◽  
pp. 5-21 ◽  
Author(s):  
Emmanuel Sotande

Purpose The purpose of this paper is to examine the treats hindering war against illicit financial flows of organised crime in developing economies and Nigeria in particular. The examination shows that the impediments facing the fight against money laundering and organised crime financial flows vary from one country to another. It may be lesser in developed economies where most instruments, treaties and best practice recommendations to curb serious crime originated from. However, the impediments against the proceeds of organised crime in developing economies are overwhelming. Design/methodology/approach The research methodology adopted was qualitative analysis. This was applied through the use and analysis of documents and expert interviews. Findings The impediments jeopardising the success against organised crime and other related serious crime financial flows in developing economies are devastating. Consequently, the study offered some policy implications to help mitigate these impediments in developing countries. The dynamics and the phenomena of organised crime business model are operated with ingenious strategies within the global states. Therefore, staying in control of the menace and the threats originated from the organised criminal activities would require periodic review of the global initiatives, standards and strategies deployed by the standard setters to combat organised crime and its financial flows in developing and evolving economies. Additionally, the implementing countries should be carried along and allow to make inputs when such initiatives and standards are being developed. Social implications In Nigeria, there is a clear evidence of “collateral damage” in terms of social justice as result of financial exclusion of many bankable adults of the country that do not possess unique identities for account opening documentation and customer due diligence of the Financial Action Task Force recommendation 10. Originality/value There have been quite a number of studies on organised crime and still fewer have recognised the need to explore the success or failure of combating the proceeds of crime in developing economies. This study provides answer to these gaps by screening associated risks of fighting the proceeds of organised crime in developing countries and Nigeria in particular.


1990 ◽  
Vol 17 (3) ◽  
pp. 277-286 ◽  
Author(s):  
G. M. L. Gladwell

This paper provides an historical account of Leipholz's research into elastic stability. Emphasis is placed on divergence and flutter instability of follower force systems, the derivation of lower bounds for the critical load for divergence, and estimates for critical loads for flutter. Key words: elastic stability, divergence, flutter, lower bounds, nonconservative systems, symmetrisable matrix.


With present methods of estimating the critical loads of triangulated frameworks by relaxation methods it is difficult to decide near the critical load whether the process is converging and the structure is stable, or whether the process is diverging and the structure unstable. This difficulty does not arise in the method presented here. Each triangle of the framework in turn is replaced by a hypothetical member until finally only one member of the truss remains, and this member has been modified in such a way as to take into account the stiffnesses of all the other members of the truss. A simple criterion for the stability of this final equivalent member is established and an example of the application of the method given.


2001 ◽  
Vol 01 (02) ◽  
pp. 283-291 ◽  
Author(s):  
S. G. LEE ◽  
S. C. KIM ◽  
J. G. SONG

The elastic critical load coefficients of square plates, under different inplane load configurations on opposite plate edges, are determined and the results compared. The stability analysis was performed by a finite element method that was developed by the authors. The parameters considered in the analysis are the Kinney's fixity factor, and the width factor of the patch load. It was found that the coefficients of the critical loads increase with increasing values of fixity and width factors. The opposite tendency is that a plate under a patch loaded towards the two corners of an edge is more stable than a plate loaded concentrically at the center of the edge.


2003 ◽  
Vol 18 (6) ◽  
pp. 1481-1486 ◽  
Author(s):  
Chun-Hway Hsueh ◽  
Jong Ho Kim ◽  
Do Kyung Kim

The effects of soft adhesive interlayers on contact-induced radial cracking in brittle coatings on supporting substrates were investigated recently. A semiempirical equation for the critical load to initiate radial cracking was derived, which used three fitting parameters obtained by comparison with the finite element results. An analytical model is derived in the present study to illustrate the effects of adhesive interlayers. This is achieved by adopting the analogy between the coating/substrate system and a plate on an elastic foundation. In the presence of an adhesive interlayer, the interlayer/substrate bilayer is treated as the effective elastic foundation. The effective modulus of foundation for the bilayer is derived, and the solution for coating/interlayer/substrate systems can be obtained from the existing solution for coating/substrate systems by replacing the modulus of foundation. Specific results are calculated for critical loads to initiate radial cracks in silicon coatings bonded by adhesive interlayers of different materials and thicknesses to glass substrates. The present analytical solution provides an alternative other than the existing semiempirical equation in predicting the effects of adhesive interlayers.


Metals ◽  
2020 ◽  
Vol 10 (10) ◽  
pp. 1395
Author(s):  
Marcos Sánchez ◽  
Sergio Cicero ◽  
Borja Arroyo ◽  
José Alberto Álvarez

This paper validates a methodology for the estimation of critical loads in tubular beams containing notch-type defects. The methodology is particularized for the case of Al6060-T66 tubular cantilever beams containing U-shaped notches. It consists in obtaining the stress field at the notch tip using finite element analysis (FEA) and the subsequent application of the theory of critical distances (TCD) to derive the corresponding critical load (or load-bearing capacity). The results demonstrate that this methodology provides satisfactory predictions of fracture loads.


Sign in / Sign up

Export Citation Format

Share Document