scholarly journals Modified Dubinin–Astakhov Model for the Accurate Estimation of Supercritical Methane Sorption on Shales

ACS Omega ◽  
2020 ◽  
Vol 5 (26) ◽  
pp. 16189-16199
Author(s):  
Ying Sun ◽  
Shuxia Li ◽  
Renyuan Sun ◽  
Shikai Yang ◽  
Xiaoqiang Liu
Keyword(s):  
Accurate Estimation ◽  
Methane Sorption

An Efficient Statistic for Determining the Diameter of Thin Sectioned Uniform Spheres from Measurements of Biological Samples

1974 ◽  
Vol 32 ◽  
pp. 114-115
Author(s):  
W. R. Schucany ◽  
G. H. Kelsoe ◽  
V. F. Allison
Keyword(s):  
Biological Samples ◽  
Traditional Method ◽  
Cell Types ◽  
Accurate Estimation ◽  
Morphological Identification ◽  
Sectioned Material ◽  
Maximal Diameter ◽  
Similar Cell

Accurate estimation of the size of spheroid organelles from thin sectioned material is often necessary, as uniquely homogenous populations of organelles such as vessicles, granules, or nuclei often are critically important in the morphological identification of similar cell types. However, the difficulty in obtaining accurate diameter measurements of thin sectioned organelles is well known. This difficulty is due to the extreme tenuity of the sectioned material as compared to the size of the intact organelle. In populations where low variance is suspected the traditional method of diameter estimation has been to measure literally hundreds of profiles and to describe the “largest” as representative of the “approximate maximal diameter”.

Under- and Over-Estimation

2011 ◽  
Vol 58 (1) ◽  
pp. 39-49 ◽  
Author(s):  
Virginie Crollen ◽  
Julie Castronovo ◽  
Xavier Seron
Keyword(s):  
Empirical Data ◽  
Accurate Estimation ◽  
Numerical Estimation ◽  
Production Task ◽  
Estimation Task ◽  
Reproduction Task ◽  
Perception Task ◽  
Adult Participants ◽  
Mapping Hypothesis ◽  
Task Perception

Over the last 30 years, numerical estimation has been largely studied. Recently, Castronovo and Seron (2007) proposed the bi-directional mapping hypothesis in order to account for the finding that dependent on the type of estimation task (perception vs. production of numerosities), reverse patterns of performance are found (i.e., under- and over-estimation, respectively). Here, we further investigated this hypothesis by submitting adult participants to three types of numerical estimation task: (1) a perception task, in which participants had to estimate the numerosity of a non-symbolic collection; (2) a production task, in which participants had to approximately produce the numerosity of a symbolic numerical input; and (3) a reproduction task, in which participants had to reproduce the numerosity of a non-symbolic numerical input. Our results gave further support to the finding that different patterns of performance are found according to the type of estimation task: (1) under-estimation in the perception task; (2) over-estimation in the production task; and (3) accurate estimation in the reproduction task. Moreover, correlation analyses revealed that the more a participant under-estimated in the perception task, the more he/she over-estimated in the production task. We discussed these empirical data by showing how they can be accounted by the bi-directional mapping hypothesis ( Castronovo & Seron, 2007 ).

LABORATORY TESTS OF THYROID FUNCTION IN HYPERTHYROIDISM II.

1969 ◽  
Vol 62 (4_Suppla) ◽  
pp. S23-S35
Author(s):  
B.-A. Lamberg ◽  
O. P. Heinonen ◽  
K. Liewendahl ◽  
G. Kvist ◽  
M. Viherkoski ◽  
...  
Keyword(s):  
Thyroid Function ◽  
Laboratory Tests ◽  
Goodness Of Fit ◽  
Point Of View ◽  
Accurate Estimation ◽  
Diagnostic Efficiency ◽  
Normal Limits ◽  
Significant Difference ◽  
Crossing Point ◽  
Hyperthyroid Patients

ABSTRACT The distributions of 13 variables based on 10 laboratory tests measuring thyroid function were studied in euthyroid controls and in patients with toxic diffuse or toxic multinodular goitre. Density functions were fitted to the empirical data and the goodness of fit was evaluated by the use of the χ2-test. In a few instances there was a significant difference but the material available was in some respects too small to allow a very accurate estimation. The normal limits for each variable was defined by the 2.5 and 97.5 percentiles. It appears that in some instances these limits are too rigorous from the practical point of view. It is emphasized that the crossing point of the functions for euthyroid controls and hyperthyroid patients may be a better limit to use. In a preliminary analysis of the diagnostic efficiency the variables of total or free hormone concentration in the blood proved clearily superior to all other variables.

The Influences of the Rank of Coal on Methane Sorption Capacity in Coals/Wpływ Rzędu Węgla Na Pojemność Sorpcyjną Metanu W Węglach

2014 ◽  
Vol 59 (2) ◽  
pp. 509-516
Author(s):  
Andrzej Olajossy
Keyword(s):  
Sorption Capacity ◽  
Coalbed Methane ◽  
Vitrinite Reflectance ◽  
Sorption Isotherms ◽  
Volatile Matter ◽  
Low Rank ◽  
Hard Coal ◽  
Petrographic Composition ◽  
Methane Sorption ◽  
Indian Coals

Abstract Methane sorption capacity is of significance in the issues of coalbed methane (CBM) and depends on various parameters, including mainly, on rank of coal and the maceral content in coals. However, in some of the World coals basins the influences of those parameters on methane sorption capacity is various and sometimes complicated. Usually the rank of coal is expressed by its vitrinite reflectance Ro. Moreover, in coals for which there is a high correlation between vitrinite reflectance and volatile matter Vdaf the rank of coal may also be represented by Vdaf. The influence of the rank of coal on methane sorption capacity for Polish coals is not well understood, hence the examination in the presented paper was undertaken. For the purpose of analysis there were chosen fourteen samples of hard coal originating from the Upper Silesian Basin and Lower Silesian Basin. The scope of the sorption capacity is: 15-42 cm3/g and the scope of vitrinite reflectance: 0,6-2,2%. Majority of those coals were of low rank, high volatile matter (HV), some were of middle rank, middle volatile matter (MV) and among them there was a small number of high rank, low volatile matter (LV) coals. The analysis was conducted on the basis of available from the literature results of research of petrographic composition and methane sorption isotherms. Some of those samples were in the form (shape) of grains and others - as cut out plates of coal. The high pressure isotherms previously obtained in the cited studies were analyzed here for the purpose of establishing their sorption capacity on the basis of Langmuire equation. As a result of this paper, it turned out that for low rank, HV coals the Langmuire volume VL slightly decreases with the increase of rank, reaching its minimum for the middle rank (MV) coal and then increases with the rise of the rank (LV). From the graphic illustrations presented with respect to this relation follows the similarity to the Indian coals and partially to the Australian coals.

Napfmarathon versus Stadtmarathon: Eine Annäherung an das Konzept des Leistungskilometers

2015 ◽  
Vol 63 (1) ◽  
Keyword(s):  
Accurate Estimation ◽  
Horizontal Distance ◽  
First Approximation ◽  
The City

The aim of this study was to investigate differences in course times of a mountainmarathon (Napfmarathon) versus a city Marathon. Therefore all participants of Napfmarathon were screened concerning a double participation on a city marathon (Zürich, Winterthur, Lausanne, Luzern) and the course time were compared. Of key interest was the influence of ascents and descents which were quantified according to ­guidelines of Youth & Sport (Jugend + Sport / Jeunesse et Sport), whereby in first approximation 100 meter of ascent, 150 meter of descent (more than 20%) and 1 km of horizontal distance were taken as a simallar performance correlat. For the identified double starter different average times per km resulted. For the city marathon with an average time of 4 min 52 sec and for the Napfmarathon with 4 min 28 sec. If speed per km was calculated only with ascent and horizontal distances having performance relevance an average time of 4 min 56 sec per km was identified. This effect seems to be independet from distance absolved, resulting for Halbmarathon on an average time of distance of 4 min 13 sec, for Napfmarathon of 4 min 4 sec and for the performance concept only with ascent an average time per km of 4 min 16 sec. These analysis reveal, that if only ascent is taxed average course times differ less than 5 sec for both distances. For these particular reasons we recommend for running events to calculate only based on ascent and horizontal distances making necessary adjustments based on length of course, steepness of ascent and descent, character of terain (middle-country, pre-alps, alpes) for accurate estimation of course times.

scholarly journals When, How, and to What Extent Are Individuals with Unresponsive Wakefulness Syndrome Able to Progress? Neurobehavioral Progress

2021 ◽  
Vol 11 (1) ◽  
pp. 126
Author(s):  
Enrique Noé ◽  
Joan Ferri ◽  
José Olaya ◽  
María Dolores Navarro ◽  
Myrtha O’Valle ◽  
...  
Keyword(s):  
Clinical Decision Making ◽  
Minimally Conscious State ◽  
Clinical Decision ◽  
Total Sample ◽  
Conscious State ◽  
Accurate Estimation ◽  
Functional Communication ◽  
Unresponsive Wakefulness Syndrome ◽  
Object Use ◽  
Minimally Conscious

Accurate estimation of the neurobehavioral progress of patients with unresponsive wakefulness syndrome (UWS) is essential to anticipate their most likely clinical course and guide clinical decision making. Although different studies have described this progress and possible predictors of neurobehavioral improvement in these patients, they have methodological limitations that could restrict the validity and generalization of the results. This study investigates the neurobehavioral progress of 100 patients with UWS consecutively admitted to a neurorehabilitation center using systematic weekly assessments based on standardized measures, and the prognostic factors of changes in their neurobehavioral condition. Our results showed that, during the analyzed period, 34% of the patients were able to progress from UWS to minimally conscious state (MCS), 12% of the total sample (near one third from those who progressed to MCS) were able to emerge from MCS, and 10% of the patients died. Transition to MCS was mostly denoted by visual signs, which appeared either alone or in combination with motor signs, and was predicted by etiology and the score on the Coma Recovery Scale-Revised at admission with an accuracy of 75%. Emergence from MCS was denoted in the same proportion by functional communication and object use. Predictive models of emergence from MCS and mortality were not valid and the identified predictors could not be accounted for.

The prediction of vehicle vibration transmitted to the occupant using a modular transfer matrix

2021 ◽  
pp. 107754632199759
Author(s):  
Jianchun Yao ◽  
Mohammad Fard ◽  
John L Davy ◽  
Kazuhito Kato
Keyword(s):  
Finite Element ◽  
Transfer Matrix ◽  
Dynamic Performance ◽  
Complex Structure ◽  
Vehicle Body ◽  
Computational Time ◽  
Accurate Estimation ◽  
Finite Element Models ◽  
Transfer Matrices ◽  
Body Vibration

Industry is moving towards more data-oriented design and analyses to solve complex analytical problems. Solving complex and large finite element models is still challenging and requires high computational time and resources. Here, a modular method is presented to predict the transmission of vehicle body vibration to the occupants’ body by combining the numerical transfer matrices of the subsystems. The transfer matrices of the subsystems are presented in the form of data which is sourced from either physical tests or finite element models. The structural dynamics of the vehicle body is represented using a transfer matrix at each of the seat mounting points in three triaxial (X–Y–Z) orientations. The proposed method provides an accurate estimation of the transmission of the vehicle body vibration to the seat frame and the seated occupant. This method allows the combination of conventional finite element analytical model data and the experimental data of subsystems to accurately predict the dynamic performance of the complex structure. The numerical transfer matrices can also be the subject of machine learning for various applications such as for the prediction of the vibration discomfort of the occupant with different seat and foam designs and with different physical characteristics of the occupant body.

scholarly journals Determination of Environmental Factors for the Implementation of the Exploitability Index in Industrial Aggregate Mining Using Multi-Criteria Analysis

2021 ◽  
Vol 10 (4) ◽  
pp. 196
Author(s):  
Julio Manuel de Luis-Ruiz ◽  
Benito Ramiro Salas-Menocal ◽  
Gema Fernández-Maroto ◽  
Rubén Pérez-Álvarez ◽  
Raúl Pereda-García
Keyword(s):  
Environmental Factors ◽  
Environmental Factor ◽  
Human Life ◽  
Accurate Estimation ◽  
Analytic Hierarchy ◽  
Main Components ◽  
Hierarchy Process ◽  
Made In

The quality of human life is linked to the exploitation of mining resources. The Exploitability Index (EI) assesses the actual possibilities to enable a mine according to several factors. The environment is one of the most constraining ones, but its analysis is made in a shallow way. This research is focused on its determination, according to a new preliminary methodology that sets the main components of the environmental impact related to the development of an exploitation of industrial minerals and its weighting according to the Analytic Hierarchy Process (AHP). It is applied to the case of the ophitic outcrops in Cantabria (Spain). Twelve components are proposed and weighted with the AHP and an algorithm that allows for assigning a normalized value for the environmental factor to each deposit. Geographic Information Systems (GISs) are applied, allowing us to map a large number of components of the environmental factors. This provides a much more accurate estimation of the environmental factor, with respect to reality, and improves the traditional methodology in a substantial way. It can be established as a methodology for mining spaces planning, but it is suitable for other contexts, and it raises developing the environmental analysis before selecting the outcrop to be exploited.

Sign in / Sign up

Export Citation Format

Share Document