Reduction of Nitrous Oxide on Iridium Single-Crystal Electrodes

С помощью полевой десорбционной микроскопии исследована десорбция атомов цезия с квазисферической науглероженной поверхности монокристалла иридия. Получены полевые электронные и десорбционные изображения поверхности при образовании графена на грани (100) иридия. Полевые электронные изображения поверхности эмиттера до интеркалирования и после интеркалирования графена атомами цезия не изменяются. Электрическое поле стимулирует десорбцию атомов цезия из интеркалированного состояния, вследствие разрыва связей крайних атомов углерода с поверхностью грани (100) иридия. С помощью покадровой регистрации показана возможность наблюдения локализации дефектов графенового слоя на поверхности полевого эмиттера. Показано, что полевая десорбция атомов цезия из интеркалированного состояния начинается с дефектов графена расположенных по периметру островка графена. Обнаружено, что десорбционные центры могут располагаться не только по периметру графенового островка, но и в центральной его части в случае образования неупорядоченного графена. The desorption of caesium atoms from the quasi-spherical carbonized surface of an iridium single crystal was studied using the field desorption microscopy. Field electron and desorption images of the surface during the formation of graphene on the (100) iridium face are obtained. The field electron images of the emitter surface before intercalation and after intercalation of graphene with caesium atoms do not change. The electric field stimulates the desorption of caesium atoms from the intercalated state, due to the breaking of the bonds of the extreme carbon atoms with the surface of the face (100) of iridium. Using frame-by-frame recording, the possibility is shown of observing the localization of graphene layer defects on the surface of the field emitter. It is also shown that the field desorption of caesium atoms from the intercalated state begins with graphene defects located along the perimeter of the graphene island. It is found that desorption centers can be located not only along the perimeter of the graphene island, but also in its central part in the case of the disordered graphene formation.

Download Full-text

Hydrogen adsorption on iridium single-crystal surfaces

Surface Science ◽

10.1016/0039-6028(90)90487-s ◽

1990 ◽

Vol 226 (3) ◽

pp. 221-225 ◽

Cited By ~ 29

Author(s):

Nagakazu Furuya ◽

Shoichiro Koide

Keyword(s):

Single Crystal ◽

Hydrogen Adsorption ◽

Crystal Surfaces ◽

Single Crystal Surfaces ◽

Iridium Single Crystal

Download Full-text

Atomic arrangement dependence of reduction rates of carbon dioxide on iridium single crystal electrodes

Journal of Electroanalytical Chemistry ◽

10.1016/0022-0728(94)03722-f ◽

1995 ◽

Vol 381 (1-2) ◽

pp. 261-264 ◽

Cited By ~ 20

Author(s):

Nagahiro Hoshi ◽

Tomoo Uchida ◽

Takeshi Mizumura ◽

Yoshio Hori

Keyword(s):

Carbon Dioxide ◽

Single Crystal ◽

Atomic Arrangement ◽

Iridium Single Crystal

Download Full-text

A Preparation of High Resolution Standards for Electron Microscopy. Part II

Proceedings, annual meeting, Electron Microscopy Society of America ◽

10.1017/s0424820100064852 ◽

1971 ◽

Vol 29 ◽

pp. 160-161

Author(s):

Akira Tanaka ◽

David F. Harling

Keyword(s):

Electron Microscopy ◽

High Resolution ◽

Carbon Black ◽

Single Crystal ◽

Dark Field ◽

Graphitized Carbon Black ◽

Graphitized Carbon ◽

Dark Field Imaging ◽

Crystal Films ◽

Micro Holes

In the previous paper, the author reported on a technique for preparing vapor-deposited single crystal films as high resolution standards for electron microscopy. The present paper is intended to describe the preparation of several high resolution standards for dark field microscopy and also to mention some results obtained from these studies. Three preparations were used initially: 1.) Graphitized carbon black, 2.) Epitaxially grown particles of different metals prepared by vapor deposition, and 3.) Particles grown epitaxially on the edge of micro-holes formed in a gold single crystal film.The authors successfully obtained dark field micrographs demonstrating the 3.4Å lattice spacing of graphitized carbon black and the Au single crystal (111) lattice of 2.35Å. The latter spacing is especially suitable for dark field imaging because of its preparation, as in 3.), above. After the deposited film of Au (001) orientation is prepared at 400°C the substrate temperature is raised, resulting in the formation of many square micro-holes caused by partial evaporation of the Au film.

Download Full-text

Structure of Palladium Single-Crystal Films Prepared by Flash Evaporation onto (001) NaCl Substrates

Proceedings, annual meeting, Electron Microscopy Society of America ◽

10.1017/s0424820100069272 ◽

1970 ◽

Vol 28 ◽

pp. 456-457

Author(s):

L. E. Murr ◽

G. Wong

Keyword(s):

Single Crystal ◽

High Vacuum ◽

Ultra High Vacuum ◽

High Rate ◽

Flash Evaporation ◽

Optimum Load ◽

Single Crystal Films ◽

Crystal Films ◽

A Current

Palladium single-crystal films have been prepared by Matthews in ultra-high vacuum by evaporation onto (001) NaCl substrates cleaved in-situ, and maintained at ∼ 350° C. Murr has also produced large-grained and single-crystal Pd films by high-rate evaporation onto (001) NaCl air-cleaved substrates at 350°C. In the present work, very large (∼ 3cm2), continuous single-crystal films of Pd have been prepared by flash evaporation onto air-cleaved (001) NaCl substrates at temperatures at or below 250°C. Evaporation rates estimated to be ≧ 2000 Å/sec, were obtained by effectively short-circuiting 1 mil tungsten evaporation boats in a self-regulating system which maintained an optimum load current of approximately 90 amperes; corresponding to a current density through the boat of ∼ 4 × 104 amperes/cm2.

Download Full-text

Dislocations, Ordering and Antiferromagnetic Domains in MnO

Proceedings, annual meeting, Electron Microscopy Society of America ◽

10.1017/s0424820100069600 ◽

1970 ◽

Vol 28 ◽

pp. 522-523

Author(s):

D. J. Barber ◽

R. G. Evans

Keyword(s):

Electron Diffraction ◽

Single Crystal ◽

Optical Microscopy ◽

Defect Chemistry ◽

Magnetic Structures ◽

Optically Transparent ◽

Magnetic Features ◽

Antiferromagnetic Domains

Manganese (II) oxide, MnO, in common with CoO, NiO and FeO, possesses the NaCl structure and shows antiferromagnetism below its Neel point, Tn∼ 122 K. However, the defect chemistry of the four oxides is different and the magnetic structures are not identical. The non-stoichiometry in MnO2 small (∼2%) and below the Tn the spins lie in (111) planes. Previous work reported observations of magnetic features in CoO and NiO. The aim of our work was to find explanations for certain resonance results on antiferromagnetic MnO.Foils of single crystal MnO were prepared from shaped discs by dissolution in a mixture of HCl and HNO3. Optical microscopy revealed that the etch-pitted foils contained cruciform-shaped precipitates, often thick and proud of the surface but red-colored when optically transparent (MnO is green). Electron diffraction and probe microanalysis indicated that the precipitates were Mn2O3, in contrast with recent findings of Co3O4 in CoO.

Download Full-text

Electron Microscopy of Shock Loaded Polycrystalline Beryllium

Proceedings, annual meeting, Electron Microscopy Society of America ◽

10.1017/s0424820100052547 ◽

1974 ◽

Vol 32 ◽

pp. 506-507 ◽

Cited By ~ 1

Author(s):

J. M. Galbraith ◽

L. E. Murr ◽

A. L. Stevens

Keyword(s):

Electron Microscopy ◽

Wave Propagation ◽

Structural Change ◽

Single Crystal ◽

Diffraction Pattern ◽

Shock Loading ◽

Slip Systems ◽

Compression Tests ◽

X Ray Diffraction ◽

X Ray

Uniaxial compression tests and hydrostatic tests at pressures up to 27 kbars have been performed to determine operating slip systems in single crystal and polycrystal1ine beryllium. A recent study has been made of wave propagation in single crystal beryllium by shock loading to selectively activate various slip systems, and this has been followed by a study of wave propagation and spallation in textured, polycrystal1ine beryllium. An alteration in the X-ray diffraction pattern has been noted after shock loading, but this alteration has not yet been correlated with any structural change occurring during shock loading of polycrystal1ine beryllium.This study is being conducted in an effort to characterize the effects of shock loading on textured, polycrystal1ine beryllium. Samples were fabricated from a billet of Kawecki-Berylco hot pressed HP-10 beryllium.

Download Full-text

Studies of Oxide Formation on Copper Thin Films by Electron Microscopy

Proceedings, annual meeting, Electron Microscopy Society of America ◽

10.1017/s0424820100079103 ◽

1977 ◽

Vol 35 ◽

pp. 316-317

Author(s):

G. G. Hembree ◽

M. A. Otooni ◽

J. M. Cowley

Keyword(s):

Electron Microscopy ◽

Electron Diffraction ◽

Single Crystal ◽

Crystal Surface ◽

Crystal Defects ◽

Diffraction Reflection ◽

Reaction Products ◽

Intermediate Energies ◽

Crystal Films ◽

Reflection Electron Microscopy

The formation of oxide structures on single crystal films of metals has been investigated using the REMEDIE system (for Reflection Electron Microscopy and Electron Diffraction at Intermediate Energies) (1). Using this instrument scanning images can be obtained with a 5 to 15keV incident electron beam by collecting either secondary or diffracted electrons from the crystal surface (2). It is particularly suited to studies of the present sort where the surface reactions are strongly related to surface morphology and crystal defects and the growth of reaction products is inhomogeneous and not adequately described in terms of a single parameter. Observation of the samples has also been made by reflection electron diffraction, reflection electron microscopy and replication techniques in a JEM-100B electron microscope.A thin single crystal film of copper, epitaxially grown on NaCl of (100) orientation, was repositioned on a large copper single crystal of (111) orientation.

Download Full-text