Graphene-Ta2O5 Heterostructure Enabled High Performance, Deep-Ultraviolet to Mid-Infrared Photodetection

Nanoscale ◽  
2021 ◽  
Author(s):  
Vinh Ho ◽  
Yifei Wang ◽  
Michael Cooney ◽  
Nguyen Q Vinh

Ultrafast, high sensitive, low cost photodetectors operating at room temperature sensitive from the deep-ultraviolet to mid-infrared region remain a significant challenge in optoelectronics. Achievements in traditional semiconductors using cryogenic operation...

Nanomaterials ◽  
2021 ◽  
Vol 11 (6) ◽  
pp. 1489
Author(s):  
Bhaskar Parida ◽  
Saemon Yoon ◽  
Dong-Won Kang

Materials and processing of transparent electrodes (TEs) are key factors to creating high-performance translucent perovskite solar cells. To date, sputtered indium tin oxide (ITO) has been a general option for a rear TE of translucent solar cells. However, it requires a rather high cost due to vacuum process and also typically causes plasma damage to the underlying layer. Therefore, we introduced TE based on ITO nanoparticles (ITO-NPs) by solution processing in ambient air without any heat treatment. As it reveals insufficient conductivity, Ag nanowires (Ag-NWs) are additionally coated. The ITO-NPs/Ag-NW (0D/1D) bilayer TE exhibits a better figure of merit than sputtered ITO. After constructing CsPbBr3 perovskite solar cells, the device with 0D/1D TE offers similar average visible transmission with the cells with sputtered ITO. More interestingly, the power conversion efficiency of 0D/1D TE device was 5.64%, which outperforms the cell (4.14%) made with sputtered-ITO. These impressive findings could open up a new pathway for the development of low-cost, translucent solar cells with quick processing under ambient air at room temperature.


ACS Photonics ◽  
2017 ◽  
Vol 4 (3) ◽  
pp. 482-488 ◽  
Author(s):  
Jaeseok Kim ◽  
Sungjoon Park ◽  
Houk Jang ◽  
Nikesh Koirala ◽  
Jae-Bok Lee ◽  
...  

2011 ◽  
Vol 393-395 ◽  
pp. 1024-1028 ◽  
Author(s):  
Hong Zhang ◽  
Jun Wei Wang ◽  
Sheng Zhong Dong ◽  
Fang Xu Xu ◽  
Sheng Hou Wang

The optimization of extraction of cordycepin from fruiting body of Cordyceps militaris YCC-01 by water extraction, ethanol extraction, ultrasonic extraction, and synergistic extraction is studied in this paper. The optimal conditions, water extraction at 85°C for 2.5h plus ultrasonic extraction at 600W for 35min, were determined through high performance liquid chromatography (HPLC). The dried fruiting body of cordycepin content was 9.559 mg/g by this synergistic extraction method. The yield was 66.2% higher than the control group 85°C water extraction 2.5h and 11.3% higher than the room temperature ultrasonic extraction 35min. This method has a short extraction time, low cost, low loss of active ingredients and other characteristics with good prospects.


2020 ◽  
Vol 32 (10) ◽  
pp. 105705
Author(s):  
Shi Luo ◽  
JiaLu Li ◽  
Tai Sun ◽  
Xiangzhi Liu ◽  
Dacheng Wei ◽  
...  

2018 ◽  
Vol 9 (1) ◽  
Author(s):  
Xuechao Yu ◽  
Yangyang Li ◽  
Xiaonan Hu ◽  
Daliang Zhang ◽  
Ye Tao ◽  
...  

2018 ◽  
Vol 53 (18) ◽  
pp. 13010-13017 ◽  
Author(s):  
Jinchao Tong ◽  
Landobasa Y. M. Tobing ◽  
Li Qian ◽  
Fei Suo ◽  
Dao Hua Zhang

2020 ◽  
Vol 11 (1) ◽  
Author(s):  
Luigi Romano ◽  
Alberto Portone ◽  
Maria-Beatrice Coltelli ◽  
Francesco Patti ◽  
Rosalba Saija ◽  
...  

AbstractSpoiled perishable products, such as food and drugs exposed to inappropriate temperature, cause million illnesses every year. Risks range from intoxication due to pathogen-contaminated edibles, to suboptimal potency of temperature-sensitive vaccines. High-performance and low-cost indicators are needed, based on conformable materials whose properties change continuously and irreversibly depending on the experienced time-temperature profile. However, these systems can be limited by unclear reading, especially for colour-blind people, and are often difficult to be encoded with a tailored response to detect excess temperature over varying temporal profiles. Here we report on optically-programmed, non-colorimetric indicators based on nano-textured non-wovens encoded by their cross-linking degree. This combination allows a desired time-temperature response to be achieved, to address different perishable products. The devices operate by visual contrast with ambient light, which is explained by backscattering calculations for the complex fibrous material. Optical nanomaterials with photo-encoded thermal properties might establish new design rules for intelligent labels.


Sign in / Sign up

Export Citation Format

Share Document