scholarly journals Evaluation of the lipid fraction of pyrochars organic matter in the aspect of negative effects on soil

2020 ◽  
Vol 17 ◽  
pp. 00156
Author(s):  
Rodion Okunev ◽  
Elena Smirnova ◽  
Kamil Giniyatullin ◽  
Irina Guseva

The evaluation of the possible negative effect of pyrochars on soils based on the analysis of the content of lipid fraction and polycyclic aromatic hydrocarbons (PAHs) of organic matter was evaluated. Eight species of pyrochar were obtained from the crop and wood residues (linden, willow, corn, millet) by two pyrolysis regimes: low-temperature pyrolysis (<400°C) and high-temperature pyrolysis (400–600°C). The largest amount of lipid fraction (from 0.54 to 2.78%) and PAHs were found in pyrochars obtained at a low pyrolysis temperature. The total content of PAHs in the studied samples ranged from 8.49 to 603.21 μg/kg. According to the PAHs content, pyrochar was the most adverse for application to the soil, obtained from the residues of millet of low-temperature pyrolysis, however, at a high pyrolysis temperature, the safest product with the lowest PAHs concentration and a significant amount of lipid fraction was formed. Using an incubation experiment by measuring substrate-induced respiration in soil-pyrochar mixtures, it was shown that the application of this meliorant can also increase the emission of carbon dioxide from soils in a short time. The results of the experiments showed that it is necessary to precisely control the conditions of pyrolysis and carefully select the material for pyrochar in order to obtain the products with most favourable amounts of lipid fraction and PAHs content.

2002 ◽  
Vol 59 (1) ◽  
pp. 85-95 ◽  
Author(s):  
Jennifer L Klug

Dissolved organic matter (DOM) can have both positive and negative effects on phytoplankton growth. The magnitude of these effects may vary depending on the source of DOM and the composition of the phytoplankton community. Here, I address the relative importance of the positive and negative effects of DOM extracts on phytoplankton growth. In short-term experiments with phytoplankton from West Long Lake, a small, moderately coloured lake in northern Michigan, U.S.A., the net effect of doubling ambient DOM on phytoplankton growth was positive. Increasing DOM concentrations from ~10 mg C·L–1 to ~20 mg C·L–1 had a negative effect on total phytoplankton growth by reducing irradiance and thus reducing the depth to which growth was positive. However, inorganic nutrients in the DOM extracts increased growth at each irradiance level. The positive effect on phytoplankton growth owing to the nutrients associated with DOM was greater than the negative effect caused by shading. Although the positive effects of allochthonous DOM inputs outweighed the negative effects for the nutrient-limited phytoplankton in these experiments, the net effect depends on the concentration and availability of nutrients associated with allochthonous DOM as well as the physiological status of the phytoplankton community.


2017 ◽  
Vol 25 (3) ◽  
pp. 2495-2505 ◽  
Author(s):  
Jianjun Zhou ◽  
Hongrui Ma ◽  
Mao Gao ◽  
Wenyue Sun ◽  
Chao Zhu ◽  
...  

mSphere ◽  
2017 ◽  
Vol 2 (2) ◽  
Author(s):  
Zhongmin Dai ◽  
Albert Barberán ◽  
Yong Li ◽  
Philip C. Brookes ◽  
Jianming Xu

ABSTRACT Pyrogenic organic matter (PyOM) is widely distributed in soil and fluvial ecosystems and plays an important role in biogeochemical cycling. Many studies have reported changes in soil microbial communities stimulated by PyOM, but very little is known about the microbial communities associated with PyOM. The microbes that colonize PyOMs can participate in the mineralization of PyOM, so changing its structure affects the fate of PyOMs and contributes to soil biogeochemical cycling. This study identified the bacterial community composition associated with PyOMs on the basis of high-throughput sequencing and demonstrated that both PyOM pyrolysis temperature and the colonization environment determined the bacterial community composition. Our work increases our understanding of the dominant phylogenetic taxa associated with PyOMs, demonstrates mechanisms mediating microbial metabolism and growth in PyOMs, and expands a new research area for pyrogenic organic matter. This study identified the bacterial community composition associated with PyOM, which is widely distributed in the environment. Most bacterial OTUs preferentially thrived on PyOM pyrolyzed at low temperature, while some specific OTUs thrived on PyOM pyrolyzed at high temperature. Microbes that colonize pyrogenic organic matter (PyOM) (also called biochar) play an important role in PyOM mineralization and crucially affect soil biogeochemical cycling, while the microbial community composition associated with PyOM particles is poorly understood. We generated two manure-based PyOMs with different characteristics (PyOM pyrolyzed at the low temperature of 300°C [i.e., PyOM300] and at the high temperature of 700°C [i.e., PyOM700]) and added them to high-carbon (4.15%) and low-C (0.37%) soil for microbial colonization. 16S rRNA gene sequencing showed that Actinobacteria, particularly Actinomycetales, was the dominant taxon in PyOM, regardless of the PyOM pyrolysis temperature and soil type. Bacterial communities associated with PyOM particles from high-C soils were similar to those in non-PyOM-amended soils. PyOM300 had higher total microbial activity and more differential bacterial communities than PyOM700. More bacterial operational taxonomic units (OTUs) preferentially thrived on the low-pyrolysis-temperature PyOM, while some specific OTUs thrived on high-pyrolysis-temperature PyOM. In particular, Chloroflexi species tended to be more prevalent in high-pyrolysis-temperature PyOM in low-C soils. In conclusion, the differences in colonized bacterial community composition between the different PyOMs were strongly influenced by the pyrolysis temperatures of PyOM, i.e., under conditions of easily mineralizable C or fused aromatic C, and by other properties, e.g., pH, surface area, and nutrient content. IMPORTANCE Pyrogenic organic matter (PyOM) is widely distributed in soil and fluvial ecosystems and plays an important role in biogeochemical cycling. Many studies have reported changes in soil microbial communities stimulated by PyOM, but very little is known about the microbial communities associated with PyOM. The microbes that colonize PyOMs can participate in the mineralization of PyOM, so changing its structure affects the fate of PyOMs and contributes to soil biogeochemical cycling. This study identified the bacterial community composition associated with PyOMs on the basis of high-throughput sequencing and demonstrated that both PyOM pyrolysis temperature and the colonization environment determined the bacterial community composition. Our work increases our understanding of the dominant phylogenetic taxa associated with PyOMs, demonstrates mechanisms mediating microbial metabolism and growth in PyOMs, and expands a new research area for pyrogenic organic matter. This study identified the bacterial community composition associated with PyOM, which is widely distributed in the environment. Most bacterial OTUs preferentially thrived on PyOM pyrolyzed at low temperature, while some specific OTUs thrived on PyOM pyrolyzed at high temperature.


Geosciences ◽  
2020 ◽  
Vol 10 (4) ◽  
pp. 122
Author(s):  
Nikolay I. Akulov ◽  
Varvara V. Akulova

The paper presents the results of a study of epigenetic changes in technogenic-redeposited coal-bearing rocks of Irkutsk and Kuznetsk coal basin spoil heaps (Russia). Hydrocarbon products formed under high-temperature and low-temperature pyrolysis of coal-bearing rocks were studied by using a chromatography-mass spectrometer GCMS-QP2010NC Plus (made by Shimadzu Company). The average temperature of low-temperature natural pyrolysis does not exceed 120 °C, and its average speed is approximately 2 m/year. In this case, three pyrolysis zones gradually built metamorphic rock mass (from bottom to top) are clearly established: heating (focal) activated and enriched. The average temperature of high-temperature pyrolysis reaches 850 °C, and its average speed is approximately 20 m/year. Unlike low-temperature pyrolysis, high-temperature pyrolysis is accompanied by the presence of two major zones (from bottom to top): pyrogenic (focal) and enriched (coke). The chemical composition of the enriched pyrolysis zone was studied in detail. It has been established that hydrocarbon compounds in samples of the pyrolysis zone are presented by six classes: asphaltic-resinous substances; polycyclic aromatic hydrocarbons, heterocyclic compounds, organic sulphur compounds; pyrolytic hydrocarbon and heavy hydrocarbon residue. Quantitative content of hydrocarbon compounds in the analyzed samples varies from 0.35% to 41.88%.


2013 ◽  
Vol 291-294 ◽  
pp. 827-831
Author(s):  
Jun Guan ◽  
De Min He ◽  
Fan Hu Zeng ◽  
Qiu Min Zhang

At the pyrolysis temperature range of 460°C to 560°C, the pyrolysis of Wulagai lignite and the acid-washed lignite is completed on the fixed-bed reactor. The phenols are detected by GC. Study shows that the minerals in coal may influence the decomposition of the phenols intermediates or suppress the producing of final phenols, acid-washing helps improving the yield of phenols. The minerals in lignite have no effect on the generation of low boiling-point phenols in the lower pyrolysis temperature, but have significant effect on the yield of high boiling-point phenols. The minerals in Wulagai lignite have a significant effect on the distribution of the fixed bed low temperature pyrolysis phenols.


MRS Advances ◽  
2020 ◽  
Vol 5 (61) ◽  
pp. 3123-3131
Author(s):  
Mario Flores Nicolas ◽  
Marina Vlasova ◽  
Pedro Antonio Márquez Aguilar ◽  
Mykola Kakazey ◽  
Marcos Mauricio Chávez Cano ◽  
...  

AbstractThe low-temperature synthesis of bricks prepared from high-siliceous clays by the method of plastic molding of blanks was used. For the preparation of brick blanks, binary and ternary mixtures of high-siliceous clays, black sand, and bottle glass cullet were used. Gray-black low-porosity and high-porosity ceramics was obtained by sintering under conditions of oxygen deficiency. It has been established that to initiate plastic in mixtures containing high-siliceous clay, it is necessary to add montmorillonite/bentonite additives, carry out low-temperature sintering, and introduce low-melting glass additives with a melting point ranging from 750 to 800 °C. The performed investigations have shown that the sintering of mixtures with a total content of iron oxide of about 5 wt% under reducing conditions at Tsint. = 800°C for 8 h leads to the formation of glass ceramics consisting of quartz, feldspars, and a phase. The main sources of the appearance of a dark color is the formation of [Fe3+O4]4- and [Fe3+O6]9- anions in the composition of the glass phase and feldspars. By changing the contents of clay, sand, and glass in sintering, it is possible to obtain two types of ceramic materials: (a) in the form of building bricks and (b) in the form of porous fillers.


2009 ◽  
Author(s):  
Qirong Fu ◽  
Dimitris Argyropolous ◽  
Lucian Lucia ◽  
David Tilotta ◽  
Stan Lebow

Sign in / Sign up

Export Citation Format

Share Document