scholarly journals Temperature effect on structural and optical properties of V2O5 thin films prepared by spray pyrolysis technique

2020 ◽  
Vol 307 ◽  
pp. 01033
Author(s):  
Asmaa Mrigal ◽  
Lahocine El Gana ◽  
Mouhamed Addou ◽  
Khadija Bahedi ◽  
Rajae Temsamani ◽  
...  

In this work, the effect of substrate temperature on structural and optical properties of V2O5 thin films has been characterized by X-ray diffraction (XRD); SEM and transmission. The films mince has been prepared by Reactive Chemical Spraying technology in Liquid Phase (RCSLP) on glass substrates preheated at (350, 400, 450 and 500 °C). The X-ray diffraction analysis confirms that all layers are polycrystalline, and the preferred orientation of V2O5 is the (001) plane. The morphology of V2O5 thin films are porous nature and their particle’s shape is three-dimensional. The transmittance and absorbance of thin film were measured from which the optical constants (Energy gap, Refractive index, Absorption coefficient, Extinction coefficient and Optical dielectric constant) were determined.

2019 ◽  
Vol 397 ◽  
pp. 81-87 ◽  
Author(s):  
Farid Khediri ◽  
Abdelkader Hafdallah ◽  
Mouna Bouhelal

In this work Zinc oxide thin films prepared by spray pyrolysis technique. A set of ZnO thin films were deposited with various deposition times, on glass substrate at 350 °C. The precursor solution is formed with zinc acetate in distilled methanol with 0.1 molarity. The deposition time was ranged from 2 to 8 min. The structural and optical properties of those films were examined by X-ray diffraction (XRD) and ultraviolet-visible spectrometer (UV). X-ray diffraction patterns of the ZnO thin films showed polycrystalline hexagonal wurtzite structure and the preferred orientation was along (002) plane when the grain size varied between 9.66 and 16.67nm. ZnO thin films were highly transparent in the visible with the maximum transmittance of 85% and the optical band gap was found between 3.25 and 3.28 eV.


2020 ◽  
pp. 333-340
Author(s):  
Donia Yas Khudair ◽  
Ramiz Ahmed Al Ansari

In this work, SnO2 and (SnO2)1-x(ZnO)x composite thin films with different ZnO atomic ratios (x=0, 5, 10, 15 and 20%) were prepared by pulsed laser deposition technique on clean glass substrates at room temperature without any treatment. The deposited thin films were characterized by x-ray diffraction atomic force microscope  and UV-visible spectrophotometer to study the effect of the ZnO atomic ratio on their structural, morphological and optical properties. It was found that the crystallinety and the crystalline size vary according to ZnO atomic ratio. The surface appeared as longitudinal structures which was convert to spherical shapes with increasing ZnO atomic ratio. The optical transmission and energy gap increased with increasing ZnO atomic ratio. 


2021 ◽  
Vol 13 (01) ◽  
pp. 33-42
Author(s):  
Mushtaq Talib Al-Helaly ◽  
◽  
Nathera A .Al-Tememee ◽  

The research included the preparation and then studying the structural and optical properties of the cobalt dioxide (CoO2)films. The latter films were prepared using a semi-computerized spray pyrolysis technique (SCSPT),. The X-ray diffraction gave polycrystalline nature with crystal system trigonal (hexagonal axes), and the Energy Dispersive X-ray spectroscopy (EDX) showed that all films contain the elements (Co and O) indicating formation of (CoO2) films with high purity. FTIR measurements showed of chemical bonds of CoO2 clearly. Scanning Electron Microscopy (SEM ) Showed clearly that the formed thin films under the optimum conditions were homogeneous, dense and compact, and Atomic Force Microscopy(AFM) results showed that the topography of the film surface where surface roughness was found to be 7.91 nm, root mean square was 9.69 nm., and the average granularity diameter was 78.00 nm. The optical properties (absorbance, absorption coefficient, extinction coefficient, refractive index, optical Conductivity, the real ε_(1 ) and imaginary ε_2 part of the dielectric constant )were decreased with increasing the wavelength, while the transmittance increases with increasing wavelength. The optical energy gap was (1.98eV) and this is a good optical energy gap values for photovoltaic applications.


2011 ◽  
Vol 306-307 ◽  
pp. 265-268
Author(s):  
Xue Yan Zhang ◽  
Xiao Yu Liu ◽  
Han Bin Wang ◽  
Xi Jian Zhang ◽  
Qing Pu Wang ◽  
...  

Cadmium sulfide (CdS) thin films with (111) preferential orientation were grown on glass substrates at room temperature by radio frequency (R.F.) magnetron sputtering. The structural and optical properties of CdS films have been investigated by X-ray diffraction, Scanning Electron Microscope micrographs, PL spectra and transmittance spectra. The grain sizes have been evaluated. The transmission spectra of the obtained films reveal a relatively high transmission coefficient (80%) in the visible range. All these results show that the grain sizes increased while the optical band gap decreased with increasing the thickness of CdS films.


2016 ◽  
Vol 12 (3) ◽  
pp. 4394-4399
Author(s):  
Sura Ali Noaman ◽  
Rashid Owaid Kadhim ◽  
Saleem Azara Hussain

Tin Oxide and Indium doped Tin Oxide (SnO2:In) thin films were deposited on glass and Silicon  substrates  by  thermal evaporation technique.  X-ray diffraction pattern of  pure SnO2 and SnO2:In thin films annealed at 650oC and the results showed  that the structure have tetragonal phase with preferred orientation in (110) plane. AFM studies showed an inhibition of grain growth with increase in indium concentration. SEM studies of pure  SnO2 and  Indium doped tin oxide (SnO2:In) ) thin films showed that the films with regular distribution of particles and they have spherical shape.  Optical properties such as  Transmission , optical band-gap have been measured and calculated.


2021 ◽  
Vol 19 (5) ◽  
pp. 132-138
Author(s):  
Maan Abd-Alameer Salih ◽  
Q.S. Kareem ◽  
Mohammed Hadi Shinen

In this exploration Poly lactic corrosive (PLA) was orchestrated the ring-opening polymerization Poly lactic corrosive (PLA) blended with poly(3-hexylthiophene) (P3HT) which prepared by solution. Blends thin films Synthesis by spin coating technique and using Tetrahydrofuran (THF) as solvent. PLA powder was 'characterized by' 'X-ray' 'diffraction', '(FT-IR)'. pure Optical properties (PLA), (PLA)/P3HT blends thin films with different percentage of P3HT (0, 1, 2, and 3) wt% were investigated using UV-VS spectroscopy The results showed that the absorption, absorption coefficient, extinction coefficient and conductivity increase with increasing the rate of deformation P3HT, The energy gap decreases with increasing deformation.


2010 ◽  
Vol 7 (1) ◽  
pp. 69-75
Author(s):  
Baghdad Science Journal

Undoped and Co-doped zinc oxide (CZO) thin films have been prepared by spray pyrolysis technique using solution of zinc acetate and cobalt chloride. The effect of Co dopants on structural and optical properties has been investigated. The films were found to exhibit maximum transmittance (~90%) and low absorbance. The structural properties of the deposited films were examined by x-ray diffraction (XRD). These films, deposited on glass substrates at (400? C), have a polycrystalline texture with a wurtzite hexagonal structure, and the grain size was decreased with increasing Co concentration, and no change was observed in lattice constants while the optical band gap decreased from (3.18-3.02) eV for direct allowed transition. Other parameters such as Texture Coefficient (Tc), dislocation density (?) and number of crystals (M) were also calculated .


2021 ◽  
Vol 2114 (1) ◽  
pp. 012012
Author(s):  
Tamara S. Hussein ◽  
Ala F. Ahmed

Abstract In this study, the effect of grafting with Iron (Fe) ratios (0.1, 0.3 and 0.5) on the structural and optical properties of cadmium oxide films (CdO) was studied, as these films were prepared on glass bases using the method of pulse laser deposition (PLD). The crystallization nature of the prepared films was examined by X-ray diffraction technique (XRD), which showed that the synthesis of the prepared films is polycrystalline, and Atomic Force Microscope (AFM) images also showed that the increased vaccination with Iron led to an increase in the crustal size ratio and a decrease in surface roughness, The absorption coefficient was calculated and the optical energy gap for the prepared thin films. It was found the absorption decreases and the energy gap decreases with the increase of doping ratio.


2013 ◽  
Vol 591 ◽  
pp. 297-300
Author(s):  
Huan Ke ◽  
Shu Wang Duo ◽  
Ting Zhi Liu ◽  
Hao Zhang ◽  
Xiao Yan Fei

ZnS films have been deposited on glass substrates by chemical bath deposition (CBD). The optical and structural properties were analyzed by UV-VIS spectrophotometer and X-ray diffraction (XRD). The results showed that the prepared thin films from the solution using N2H4 as second complexing agent were thicker than those from the solution without adding N2H4 in; this is due to using second complexing agent of N2H4, the deposition mechanisms change which is conductive to heterogeneous deposition. When using N2H4 as second complexing agent, the crystallinity of ZnS thin films improved with a significant peak at 2θ=28.96°which can be assigned to the (111) reflection of the sphalerite structure. The transmittances of the prepared films from the solution adding N2H4 in as second complexing agent were over 85%, compared to those from the solution without N2H4 (over 95%). The band gaps of the ZnS films from the solution using N2H4 as second complexing agent were larger (about 4.0eV) than that from those from the solution without N2H4 (about 3.98eV), which indicated that the prepared ZnS films from the solution adding N2H4 in as second complexing agent were better used as buffer layer of solar cells with adequate optical properties. In short, using N2H4 as second complexing agent, can greatly improve the optical and structural properties of the ZnS thin films.


2014 ◽  
Vol 986-987 ◽  
pp. 47-50
Author(s):  
Jin Shang ◽  
Huan Ke ◽  
Shu Wang Duo ◽  
Ting Zhi Liu ◽  
Hao Zhang

ZnS thin films were deposited at three different radios of V(NH3·H2O)/V(N2H4) on glass substrates by chemical bath deposition (CBD) method without stirring the deposition bath during the deposition process. The structural and optical properties were analyzed by X-ray diffraction (XRD) and UV-VIS spectrophotometer. The results showed that ZnS thin film deposited at the radio of V(NH3·H2O)/V(N2H4)=15:15 is higher than that of the other two different solutions. With the radio of V(NH3·H2O)/V(N2H4) decreasing from 15:5 to 15:15, homogenous precipitation of Zn (OH)2easily forms in the bath, but ZnS precipitation first become suppressed and then easily forms in solution. It means that the concentration of OH-ion increases with the volume of N2H4increasing, which accelerates the formation of Zn (OH)2. However, when the volume of N2H4increases to 15mL, relatively high concentration of OH-ion not only accelerates the formation of Zn (OH)2, but also be used to the hydrolysis of thiourea. The average transmissions of all the ZnS films from three different solutions (V(NH3·H2O)/V(N2H4)=15:5, 15:10 and 15:15) are greater than 90% for wavelength values in visible region. The direct band gaps range from 3.80 to 4.0eV. The ZnS film deposited for 2.5h with the radio of V(NH3·H2O)/V(N2H4)=15:15 has the cubic structure only after single deposition.


Sign in / Sign up

Export Citation Format

Share Document