Graphene–Magnetic Spinel Ferrite Nanocomposite: Facile Synthesis and Excellent Photocatalytic Performance

2019 ◽  
Vol 72 (4) ◽  
pp. 267 ◽  
Author(s):  
Yuhang Wang ◽  
Hongxia Yan ◽  
Qiuyu Zhang

Spinel ferrite structured ZnFe2O4 nanoparticles anchored on reduced graphene oxide (rGO) sheets have been prepared via a facile hydrothermal method combined with a solvothermal approach. For the synthesis of the ZnFe2O4/rGO nanocomposites, the rGO nanosheet contains epoxy functional groups serving as the active sites, which allowed the formation of uniform ZnFe2O4 nanoparticles. Due to the structure of the ZnFe2O4/RGO nanocomposites, the aggregation of the ZnFe2O4 nanoparticles can be readily disrupted and electronic transfer through the rGO nanosheets is accelerated. This could in turn enhance the photocatalytic efficiency. It was also demonstrated that ZnFe2O4/rGO (40 wt-%) hybrid nanocomposites almost reached adsorption equilibrium in the RhB dye within 60min. The Langmuir equation model showed that the photodegradation of RhB was well fitted to first order reaction kinetics with k=0.6254min−1. This illustrated that the addition of GO could reduce the bandgap of pure ZnFe2O4, which avoided the combination of electrons and holes. The ZnFe2O4/rGO nanocomposites could also enhance the utilisation of sunlight. In addition, the ZnFe2O4/rGO nanocomposite photocatalyst also demonstrated a supramagnetic property, holding potential to be utilised for water treatment.

Nanomaterials ◽  
2021 ◽  
Vol 11 (5) ◽  
pp. 1112
Author(s):  
Raghvendra Singh Yadav ◽  
Anju ◽  
Thaiskang Jamatia ◽  
Ivo Kuřitka ◽  
Jarmila Vilčáková ◽  
...  

Superparamagnetic ZnFe2O4 spinel ferrite nanoparticles were prepared by the sonochemical synthesis method at different ultra-sonication times of 25 min (ZS25), 50 min (ZS50), and 100 min (ZS100). The structural properties of ZnFe2O4 spinel ferrite nanoparticles were controlled via sonochemical synthesis time. The average crystallite size increases from 3.0 nm to 4.0 nm with a rise of sonication time from 25 min to 100 min. The change of physical properties of ZnFe2O4 nanoparticles with the increase of sonication time was observed. The prepared ZnFe2O4 nanoparticles show superparamagnetic behavior. The prepared ZnFe2O4 nanoparticles (ZS25, ZS50, and ZS100) and reduced graphene oxide (RGO) were embedded in a polyurethane resin (PUR) matrix as a shield against electromagnetic pollution. The ultra-sonication method has been used for the preparation of nanocomposites. The total shielding effectiveness (SET) value for the prepared nanocomposites was studied at a thickness of 1 mm in the range of 8.2–12.4 GHz. The high attenuation constant (α) value of the prepared ZS100-RGO-PUR nanocomposite as compared with other samples recommended high absorption of electromagnetic waves. The existence of electric-magnetic nanofillers in the resin matrix delivered the inclusive acts of magnetic loss, dielectric loss, appropriate attenuation constant, and effective impedance matching. The synergistic effect of ZnFe2O4 and RGO in the PUR matrix led to high interfacial polarization and, consequently, significant absorption of the electromagnetic waves. The outcomes and methods also assure an inventive and competent approach to develop lightweight and flexible polyurethane resin matrix-based nanocomposites, consisting of superparamagnetic zinc ferrite nanoparticles and reduced graphene oxide as a shield against electromagnetic pollution.


RSC Advances ◽  
2015 ◽  
Vol 5 (7) ◽  
pp. 4905-4908 ◽  
Author(s):  
Yan Wu ◽  
Hanjin Luo ◽  
Xiaolu Jiang ◽  
Hou Wang ◽  
Junjie Geng

To improve the utilization efficiency of the Bi25FeO40 catalyst, Bi25FeO40-reduced graphene oxide (rGO) composite photo-catalysts were prepared by a facile hydrothermal method.


Nanomaterials ◽  
2021 ◽  
Vol 11 (3) ◽  
pp. 662 ◽  
Author(s):  
Guangsheng Liu ◽  
Kunyapat Thummavichai ◽  
Xuefeng Lv ◽  
Wenting Chen ◽  
Tingjun Lin ◽  
...  

Molybdenum disulfide (MoS2) has been universally demonstrated to be an effective electrocatalytic catalyst for hydrogen evolution reaction (HER). However, the low conductivity, few active sites and poor stability of MoS2-based electrocatalysts hinder its hydrogen evolution performance in a wide pH range. The introduction of other metal phases and carbon materials can create rich interfaces and defects to enhance the activity and stability of the catalyst. Herein, a new defect-rich heterogeneous ternary nanocomposite consisted of MoS2, NiS and reduced graphene oxide (rGO) are synthesized using ultrathin αNi(OH)2 nanowires as the nickel source. The MoS2/rGO/NiS-5 of optimal formulation in 0.5 M H2SO4, 1.0 M KOH and 1.0 M PBS only requires 152, 169 and 209 mV of overpotential to achieve a current density of 10 mA cm−2 (denoted as η10), respectively. The excellent HER performance of the MoS2/rGO/NiS-5 electrocatalyst can be ascribed to the synergistic effect of abundant heterogeneous interfaces in MoS2/rGO/NiS, expanded interlayer spacings, and the addition of high conductivity graphene oxide. The method reported here can provide a new idea for catalyst with Ni-Mo heterojunction, pH-universal and inexpensive hydrogen evolution reaction electrocatalyst.


NANO ◽  
2013 ◽  
Vol 08 (05) ◽  
pp. 1350052 ◽  
Author(s):  
BIN ZENG ◽  
XIAOHUA CHEN ◽  
XUTAO NING ◽  
CHUANSHENG CHEN ◽  
HUI LONG

Novel flower-like composite architecture was successfully synthesized by spray drying and post-calcinating method for the first time. Scanning electron microscopy and transmission electron microscopy observations confirmed that reduced graphene oxides/carbon nanotubes hybrid (rGO/CNTs) formed a flower-like micrometer structure and Cu2O , CuO ( Cu x O , x = 1 or 2) nanoparticles were decorated inside them. The photocatalytic properties were further investigated by evaluating the photodegradation of a pollutant methyl orange (MO). The experimental results indicated that this novel architecture enhanced photocatalytic performance with 96.2% decomposition of MO after 25 min in the presence of H 2 O 2 under visible light irradiation, which was much higher than that of Cu x O powders (33.2%). This could be attributed to the more efficient adsorption of MO molecules on flower-like rGO/CNTs and provide a high concentration of MO near to the Cu x O nanoparticles, thus promoting the photocatalytic degradation process.


2021 ◽  
pp. 1-20
Author(s):  
STEPHEN TAYLOR ◽  
XUESHAN YANG

Abstract The functional partial differential equation (FPDE) for cell division, $$ \begin{align*} &\frac{\partial}{\partial t}n(x,t) +\frac{\partial}{\partial x}(g(x,t)n(x,t))\\ &\quad = -(b(x,t)+\mu(x,t))n(x,t)+b(\alpha x,t)\alpha n(\alpha x,t)+b(\beta x,t)\beta n(\beta x,t), \end{align*} $$ is not amenable to analytical solution techniques, despite being closely related to the first-order partial differential equation (PDE) $$ \begin{align*} \frac{\partial}{\partial t}n(x,t) +\frac{\partial}{\partial x}(g(x,t)n(x,t)) = -(b(x,t)+\mu(x,t))n(x,t)+F(x,t), \end{align*} $$ which, with known $F(x,t)$ , can be solved by the method of characteristics. The difficulty is due to the advanced functional terms $n(\alpha x,t)$ and $n(\beta x,t)$ , where $\beta \ge 2 \ge \alpha \ge 1$ , which arise because cells of size x are created when cells of size $\alpha x$ and $\beta x$ divide. The nonnegative function, $n(x,t)$ , denotes the density of cells at time t with respect to cell size x. The functions $g(x,t)$ , $b(x,t)$ and $\mu (x,t)$ are, respectively, the growth rate, splitting rate and death rate of cells of size x. The total number of cells, $\int _{0}^{\infty }n(x,t)\,dx$ , coincides with the $L^1$ norm of n. The goal of this paper is to find estimates in $L^1$ (and, with some restrictions, $L^p$ for $p>1$ ) for a sequence of approximate solutions to the FPDE that are generated by solving the first-order PDE. Our goal is to provide a framework for the analysis and computation of such FPDEs, and we give examples of such computations at the end of the paper.


Author(s):  
Hang Lei ◽  
Shangjing Yang ◽  
Runquan Lei ◽  
Qing Zhong ◽  
Qixiang Wan ◽  
...  

Insufficient catalytic activity and self-restacking of 2D MXenes during catalytic processes would lead to limited number of active sites, sluggish ionic kinetics and poor durability, extremely restricting its application in...


2018 ◽  
Vol 38 ◽  
pp. 02014
Author(s):  
Yu Zhang ◽  
Jian Gu ◽  
Mengqi Zhang

The wool-ball-like TiO2 microspheres on carbon fabric (TiO2-CF) and FTO substrates (TiO2-FTO) have been synthesized by a facile hydrothermal method in alkali environment, using commercial TiO2 (P25) as precursors. The XRD results indicate that the as-prepared TiO2 have good crystallinity. And the SEM images show that the wool-ball-like TiO2 microspheres with a diameter of 2-3 μm are composed of TiO2 nanowires, which have a diameter of ~50 nm. The photocatalytic behavior of the wool-ball-like TiO2 microspheres, TiO2-CF and TiO2-FTO under ultraviolet light was investigated by a pseudo first-order kinetic model, using methyl orange (MO) as pollutant. The wool-ball-like TiO2 microspheres obtained a degradation rate constant (Kap) of 6.91×10-3 min-1 . The Kap values of TiO2-FTO and TiO2-CF reach 13.97×10-3 min-1 and 11.80×10-3 min-1, which are 2.0 and 1.7 times higher than that of pristine wool-ball-like TiO2 microspheres due to the “sum effect” between TiO2 and substrates. This study offers a facile hydrothermal method to prepare wool-ball-like TiO2 microspheres on CF and FTO substrates, which will improve the recyclability of phtocatalysts and can be extended to other fields.


Sign in / Sign up

Export Citation Format

Share Document