Yield responses of wheat and other crops to agronomic practices on duplex soils compared with other soils in Western Australia

1992 ◽  
Vol 32 (7) ◽  
pp. 963 ◽  
Author(s):  
WK Anderson ◽  
RJ French ◽  
M Seymour

A survey of experimental results relating crop management to grain yield was conducted for wheat and other crops on duplex and non-duplex soils in the wheatbelt of Western Australia. Increases in grain yield of wheat due to improved agronomic practices on duplex soils were almost as great as on other soils. Early sowing improved yield more on duplex soils than on other soils, but the response to applied nitrogen was more variable, possibly related to the reduced efficiency of uptake of applied nitrogen. The yield advantage for a semi-dwarf cultivar (Aroona) over a tall cultivar (Garnenya) was less (6%) on duplex soils than on other soils (29%). The optimum seed rate was 27% greater on duplex than on other soils. Increases in both grain yield and grain quality due to the application of potassium were large on 1 duplex soil. Water use efficiency in grain production was similar on duplex and other soils where seasonal water use did not exceed about 350 mm. At 1 location in the eastern wheatbelt, yields of wheat, barley, lupins and peas grown on a duplex soil were compared with yields on 2 other soils. Wheat was the most productive crop on the duplex soil, while barley yielded most on the other soils. All crops, except lupins, yielded less on the duplex soil. Experiments with 2 lupin cultivars grown on duplex and other soils on the south coast of Western Australia (average growing season rainfall >300 mm) showed that both cultivars yielded less on duplex soils, but 1 cultivar required slightly fewer plants to achieve its maximum yield on the duplex soils. This survey of experimental results in Western Australia shows that duplex soils are no less productive than other soils when results are averaged over all crops and locations. We conclude, however, that different management practices may be required to improve yields on duplex compared with other soils.


1997 ◽  
Vol 48 (5) ◽  
pp. 595 ◽  
Author(s):  
K. L. Regan ◽  
K. H. M. Siddique ◽  
D. Tennant ◽  
D. G. Abrecht

Wheat cultivars with very early maturities appropriate for late sowings in low-rainfall (<325 mm) short-season environments are currently unavailable to wheat growers in the eastern margin of the cropping region of Western Australia. A demonstration that very early-maturing genotypes can out-perform current commercial cultivars would open new opportunities for breeding programs to select very early-maturing, high- and stable-yielding cultivars for these environments. Six field experiments were conducted over 4 seasons at 2 low-rainfall sites in Western Australia to investigate crop growth, grain yield, and water use efficiency of very early-maturing genotypes compared with current commercial cultivars when sown after 1 June. Very early-maturing genotypes reached anthesis up to 24 days (328 degree-days) earlier than the current cultivars, produced less leaves, had similar yields and dry matter, and maintained high water use efficiencies. On average across seasons and locations the very early-maturing genotypes (W87–022–511, W87–114–549, W87–410–509) yielded more than the later maturing cultivars Gamenya and Spear (190 v. 160 g/m2) but they were similar to the early-maturing commercial cultivars Kulin and Wilgoyne (191 g/m2). Very early-maturing genotypes generally had a higher harvest index and produced fewer spikelets, but heavier and more grains, than Kulin and Wilgoyne. There were only small differences in total water use between very early-maturing genotypes and commercial cultivars; however, very early-maturing genotypes used less water in the pre-anthesis period and more water in the post-anthesis period than the later maturing genotypes, and hence, experienced less water deficit during the grain-filling period. This study indicates that there is a role for very early-maturing genotypes in low-rainfall short-season environments, when the first autumn rains arrive late (after 1 June).



1978 ◽  
Vol 29 (4) ◽  
pp. 669 ◽  
Author(s):  
RJ French

The effect of fallowing on wheat yields is reported for a South Australian environment where 62% of the variation in yield is ascribed to water supply and where water use efficiency in grain production ranges from 1 to 11 kg/ha/mm. The mean yield response from a fallow (initial tillage 9 months before sowing) compared with a non-fallow (tillage 2 months before sowing) in 28 seasonal, site and fertility situations was 335 kg/ha and the maximum 875 kg/ha. Each additional millimetre of water stored through fallowing gave on average 8 kg grain per ha. Only fine-textured soils stored considerable water through fallowing. The additional nitrate in fallow gave yield responses when the non-fallow soil contained less than 70 kg nitrate nitrogen per ha, but only when water use by the crop exceeded 230 mm. The results are related to responses to fallowing obtained in other wheat-growing districts in Australia.



1976 ◽  
Vol 16 (78) ◽  
pp. 123 ◽  
Author(s):  
JE Schultz ◽  
RJ French

The silicon content in wheat in South Australia was measured in 46 experiments over four seasons. The percentage silicon, silicon uptake and its distribution in the plant tops varied greatly. The maximum uptake was 2.4 per cent of the dry matter production, but high yields were obtained with a lesser percentage than this. Of the total silicon uptake, 16-48 per cent was found in the glumes. The correlations between grain yield and silicon, either in the glumes or in the plant, were generally poor. There were significant relationships between water use and silicon. The relationship with silicon uptake in the tops was best and accounted for 77 per cent of the variation in water use but silicon analyses were not a satisfactory measure of water use efficiency. The effect of agronomic practices on the relationships is discussed.



1986 ◽  
Vol 26 (3) ◽  
pp. 361
Author(s):  
MW Perry ◽  
DJ Miers

The effect of chlormequat on the grain yield of wheat was investigated in 24 field experiments between 1981 and 1983. Two times of application (at the 3.5- and 6-leaf growth stages-Zadoks decimal score 13.5 and 16.0) and rates of application up to 0.75 kg/ha a.i. were tested with two chlormequat formulations, Cycocel 750 and Bettaquat. Chlormequat application reduced crop height in all trials, but crop lodging did not occur in any trial. Statistically significant yield responses to rate of application alone were obtained in only three of 24 trials, with maximum yield occurring at 0.19-0.37 kg/ha a.i. and with some indication of a yield depression at 0.75 kg/ha a.i. A significant effect of time of application was observed in only two trials, but the results conflicted. In one trial there was a significant interaction between rate and time, with a response to rate of chlormequat only at the 6-leaf stage. No differences were detected between chlormequat formulations. In individual trials, the mean grain yield from the chlormequat treatments ranged from 92.9 to 116.5% of the control. However, averaging over all trials in each year, chlormequat treatments yielded 102.5, 99.3 and 100.0% of the control, respectively, in the three years. Our results confirm that low application rates of chlormequat, applied early in crop development, can increase grain yield. However, over the 24 trials, the effects of chlormequat were too small and inconsistent to warrant its use to increase wheat grain yields under natural rainfall in south-western Australia.



2017 ◽  
Vol 43 (6) ◽  
pp. 899 ◽  
Author(s):  
Ming HUANG ◽  
Zhao-Hui WANG ◽  
Lai-Chao LUO ◽  
Sen WANG ◽  
Ming BAO ◽  
...  


Agriculture ◽  
2021 ◽  
Vol 11 (4) ◽  
pp. 313
Author(s):  
Guoqiang Zhang ◽  
Bo Ming ◽  
Dongping Shen ◽  
Ruizhi Xie ◽  
Peng Hou ◽  
...  

Achieving optimal balance between maize yield and water use efficiency is an important challenge for irrigation maize production in arid areas. In this study, we conducted an experiment in Xinjiang China in 2016 and 2017 to quantify the response of maize yield and water use to plant density and irrigation schedules. The treatments included four irrigation levels: 360 (W1), 480 (W2), 600 (W3), and 720 mm (W4), and five plant densities: 7.5 (D1), 9.0 (D2), 10.5 (D3), 12.0 (D4), and 13.5 plants m−2 (D5). The results showed that increasing the plant density and the irrigation level could both significantly increase the leaf area index (LAI). However, LAI expansion significantly increased evapotranspiration (ETa) under irrigation. The combination of irrigation level 600 mm (W3) and plant density 12.0 plants m−2 (D4) produced the highest maize yield (21.0–21.2 t ha−1), ETa (784.1–797.8 mm), and water use efficiency (WUE) (2.64–2.70 kg m−3), with an LAI of 8.5–8.7 at the silking stage. The relationship between LAI and grain yield and evapotranspiration were quantified, and, based on this, the relationship between water use and maize productivity was analyzed. Moreover, the optimal LAI was established to determine the reasonable irrigation level and coordinate the relationship between the increase in grain yield and the decrease in water use efficiency.



2021 ◽  
Vol 11 (1) ◽  
Author(s):  
M. A. Gomaa ◽  
Essam E. Kandil ◽  
Atef A. M. Zen El-Dein ◽  
Mamdouh E. M. Abou-Donia ◽  
Hayssam M. Ali ◽  
...  

AbstractIn Egypt, water shortage has become a key limiting factor for agriculture. Water-deficit stress causes different morphological, physiological, and biochemical impacts on plants. Two field experiments were carried out at Etay El-Baroud Station, El-Beheira Governorate, Agriculture Research Center (ARC), Egypt, to evaluate the effect of potassium silicate (K-silicate) of maize productivity and water use efficiency (WUE). A split-plot system in the four replications was used under three irrigation intervals during the 2017 and 2018 seasons. Whereas 10, 15, and 20 days irrigation intervals were allocated in main plots, while the three foliar application treatments of K-silicate (one spray at 40 days after sowing; two sprays at 40 and 60 days; and three sprays at 40, 60, and 80 days, and a control (water spray) were distributed in the subplots. All the treatments were distributed in 4 replicates. The results indicated that irrigation every 15 days gave the highest yield in both components and quality. The highly significant of (WUE) under irrigation every 20 days. Foliar spraying of K-silicate three times resulted in the highest yield. Even under water-deficit stress, irrigation every fifteen days combined with foliar application of K-silicate three times achieved the highest values of grain yield and its components. These results show that K-silicate treatment can increase WUE and produce high grain yield requiring less irrigation.



2021 ◽  
Vol 594 ◽  
pp. 125977
Author(s):  
Liuyang Yu ◽  
Xining Zhao ◽  
Xiaodong Gao ◽  
Ruhao Jia ◽  
Menghao Yang ◽  
...  


Sign in / Sign up

Export Citation Format

Share Document