Photon-trapping array for enhanced midwave infrared photoresponse

2021 ◽  
Vol 54 (50) ◽  
pp. 505105
Author(s):  
Fei Suo ◽  
Jinchao Tong ◽  
Dao Hua Zhang
2021 ◽  
Vol 13 (7) ◽  
pp. 1249
Author(s):  
Sungho Kim ◽  
Jungsub Shin ◽  
Sunho Kim

This paper presents a novel method for atmospheric transmittance-temperature-emissivity separation (AT2ES) using online midwave infrared hyperspectral images. Conventionally, temperature and emissivity separation (TES) is a well-known problem in the remote sensing domain. However, previous approaches use the atmospheric correction process before TES using MODTRAN in the long wave infrared band. Simultaneous online atmospheric transmittance-temperature-emissivity separation starts with approximation of the radiative transfer equation in the upper midwave infrared band. The highest atmospheric band is used to estimate surface temperature, assuming high emissive materials. The lowest atmospheric band (CO2 absorption band) is used to estimate air temperature. Through onsite hyperspectral data regression, atmospheric transmittance is obtained from the y-intercept, and emissivity is separated using the observed radiance, the separated object temperature, the air temperature, and atmospheric transmittance. The advantage with the proposed method is from being the first attempt at simultaneous AT2ES and online separation without any prior knowledge and pre-processing. Midwave Fourier transform infrared (FTIR)-based outdoor experimental results validate the feasibility of the proposed AT2ES method.


2016 ◽  
Author(s):  
Marc-André Gagnon ◽  
Jean-Philippe Gagnon ◽  
Pierre Tremblay ◽  
Simon Savary ◽  
Vincent Farley ◽  
...  

2003 ◽  
Vol 02 (06) ◽  
pp. 527-534
Author(s):  
YUEH-NAN CHEN ◽  
DER-SAN CHUU

We propose to measure Purcell effect by observing the current through a semeiconductor quantum dot embedded inside a microcavity. The stationary current is shown to be altered if one varies the cavity length. For the double-dot system, we find that the stationary current shows oscillatory behavior as one varies the inter-dot distance. Furthermore, the current is suppressed if the dot distance is small compared to the wavelength of the emitted photon. This photon trapping phenomenon generates the entangled state and may be used to control the emission of single photons at predetermined times.


2016 ◽  
Vol 108 (26) ◽  
pp. 263504 ◽  
Author(s):  
L. Höglund ◽  
D. Z. Ting ◽  
A. Khoshakhlagh ◽  
A. Soibel ◽  
A. Fisher ◽  
...  

2021 ◽  
Author(s):  
Maxime Bouschet ◽  
Vignesh Arounassalame ◽  
Rodolphe Alchaar ◽  
Clara Bataillon ◽  
Jean-Philippe Perez ◽  
...  

2020 ◽  
Vol 49 (11) ◽  
pp. 6957-6962
Author(s):  
Edouard Huard ◽  
Sophie Derelle ◽  
Julien Jaeck ◽  
Olivier Gravrand ◽  
Jérôme Primot

Photonics ◽  
2020 ◽  
Vol 7 (3) ◽  
pp. 76
Author(s):  
U. Zavala-Moran ◽  
M. Bouschet ◽  
J. Perez ◽  
R. Alchaar ◽  
S. Bernhardt ◽  
...  

In this paper, a full set of structural, optical and electrical characterizations performed on midwave infrared barrier detectors based on a Ga-free InAs/InAsSb type-II superlattice, grown by molecular beam epitaxy (MBE) on a GaSb substrate, are reported and analyzed. a Minority carrier lifetime value equal to 1 µs at 80 K, carried out on dedicated structure showing photoluminescence peak position at 4.9 µm, is extracted from a time resolved photoluminescence measurement. Dark current density as low as 3.2 × 10−5 A/cm2 at 150 K is reported on the corresponding device exhibiting a 50% cut-off wavelength around 5 µm. A performance analysis through normalized spectral response and dark current density-voltage characteristics was performed to determine both the operating bias and the different dark current regimes.


Sign in / Sign up

Export Citation Format

Share Document