Growth and characterization of InAs epitaxial layer onGaAs(111)B

2004 ◽  
Vol 70 (20) ◽  
Author(s):  
H. Wen ◽  
Zh. M. Wang ◽  
J. L. Shultz ◽  
B. L. Liang ◽  
G. J. Salamo
Keyword(s):  
2003 ◽  
Vol 798 ◽  
Author(s):  
Atsushi Motogaito ◽  
Kazumasa Hiramatsu ◽  
Yasuhiro Shibata ◽  
Hironobu Watanabe ◽  
Hideto Miyake ◽  
...  

ABSTRACTCharacterizations of transparent Schottky barrier GaN and AlGaN UV detectors in the vacuum UV (VUV) and soft X-ray (SX) region using synchrotron radiation are described. In the GaN UV detectors, the responsivity achieved about 0.05 A/W at 95 eV (13 nm). Thus, their device performance is shown between 3.4 and 100 eV (10 and 360 nm). Furthermore, the high responsivity spectra were realized by using AlGaN Schottky UV detectors consisting of Al0.5Ga0.5N on AlN epitaxial layer.


2005 ◽  
Vol 891 ◽  
Author(s):  
Tomohiko Takeuchi ◽  
Suzuka Nishimura ◽  
Tomoyuki Sakuma ◽  
Satoru Matumoto ◽  
Kazutaka Terashima

ABSTRACTBoronmonophosphide(BP) is one of the suitable materials for a buffer layer between the c-GaN(100) and Si(100) substrates. The growth of BP layer was carried out by MOCVD on Si(100) substrate of 2 inch in diameter. The growth rate was over 2 μm/h without any troubles such as the bowing or cracking. In addition, the thickness of BP epitaxial layer was uniform over a wide area. A careful analysis of x-ray diffraction suggested that the growth of BP epitaxial layer inherited the crystal orientation from Si(100) substrate. Cross-sectional TEM images showed some defects like dislocations near the interface between BP layer and Si substrate. The Hall effect measurements indicated that the conduction type of BP films grown on the both n-Si and p-Si substrates was n-type without impurity doping, and that the mobility and carrier concentrations were typically 357cm2/Vs and 1.5×1020cm−3(on n-Si) and 63cm2/Vs and 1.9×1019cm−3(on p-Si), respectively. In addition, c-GaN was grown on the substrate of BP/Si(100) by RF-MBE.


2014 ◽  
Vol 778-780 ◽  
pp. 800-803 ◽  
Author(s):  
Run Hua Huang ◽  
Gang Chen ◽  
Song Bai ◽  
Rui Li ◽  
Yun Li ◽  
...  

4H-SiC JBS diode with breakdown voltage higher than 4.5 kV, has been successfully fabricated on 4H-SiC wafers with epitaxial layer. In this paper we report the design, the fabrication, and the electrical characteristics of 4H-SiC JBS diode. Numerical simulations have been performed to select the doping level and thickness of the drift layer and the effectiveness of the edge termination technique. The epilayer properties of the N-type are 55 μm with a doping of 9×1014cm−3. The diodes were fabricated with a floating guard rings edge termination. The on-state voltage was 4V at JF=80 A/cm2


2010 ◽  
Vol 645-648 ◽  
pp. 303-306 ◽  
Author(s):  
Isaho Kamata ◽  
Masahiro Nagano ◽  
Hidekazu Tsuchida

Burgers vector directions of threading edge dislocations (TEDs) in 4H-SiC epitaxial layer are distinguished by grazing incidence high resolution topography. Based on comparison between appearance of KOH etch pits and direction of TED Burgers vector, the size difference of the TED etch pits is found to be dependent on their Burgers vector directions. Examining TEDs in the epilayer by topography, the Burgers vector direction of basal plane dislocations (BPDs) in the substrate is identified. Correspondence between the topography contrast and the sense of a BPD is also investigated.


2009 ◽  
Vol 924-926 ◽  
pp. 285-290 ◽  
Author(s):  
M. Balarin ◽  
O. Gamulin ◽  
M. Ivanda ◽  
M. Kosović ◽  
D. Ristić ◽  
...  

Sign in / Sign up

Export Citation Format

Share Document