Fowler-Nordheim tunneling from quantum wires of different cross-sections

AbstractDeep levels and luminescence in SiGe/Si heterostructures and quantum wells have been investigated. We have studied the effects of Be- and B-doping on the luminescent properties of Si1−xGex/Si single and multiquantum wells. No new levels, or enhancement of luminescence, from that in undoped samples, is detected in samples which are selectively doped in the well-regions, implying that the observed luminescence in the undoped quantum wells is a result of alloy disordering. Slight enhancement of luminescence is observed in disordered wells and in quantum wires made by electron beam lithography and dry etching. Deep levels have been identified and characterized in undoped Si1-xGex alloys. Hole traps in the p-type layers have activation energies ranging from 0.029-0.45 eV and capture cross sections (σ∞) ranging from 10−9 to 10−20 cm2. Possible origins of these centers are discussed. Some possibilities of obtaining enhanced electro-optic coefficients in SiGe/Si heterostructures are discussed.

Download Full-text

Finite-element analysis of quantum wires with arbitrary cross sections

Journal of Applied Physics ◽

10.1063/1.368478 ◽

1998 ◽

Vol 84 (6) ◽

pp. 3242-3249 ◽

Cited By ~ 18

Author(s):

M. Ogawa ◽

T. Kunimasa ◽

T. Ito ◽

T. Miyoshi

Keyword(s):

Finite Element Analysis ◽

Finite Element ◽

Cross Sections ◽

Quantum Wires ◽

Element Analysis

Download Full-text

Anisotropic optical properties of arbitrarily oriented quantum wires with arbitrary cross-sections

Solid-State Electronics ◽

10.1016/s0038-1101(98)00005-7 ◽

1998 ◽

Vol 42 (7-8) ◽

pp. 1205-1209 ◽

Cited By ~ 4

Author(s):

M. Ogawa ◽

M. Ito ◽

S. Fukushima ◽

T. Miyoshi

Keyword(s):

Optical Properties ◽

Cross Sections ◽

Quantum Wires

Download Full-text

Analysis of STEM micrographs of thick objects

Proceedings, annual meeting, Electron Microscopy Society of America ◽

10.1017/s0424820100081395 ◽

1978 ◽

Vol 36 (2) ◽

pp. 106-107

Author(s):

S. Golladay

Keyword(s):

Inelastic Scattering ◽

Multiple Scattering ◽

Mass Distribution ◽

Cross Sections ◽

Phase Contrast ◽

Image Point ◽

Contrast Effects ◽

Total Cross Sections ◽

Elastic And Inelastic Scattering

The theory of multiple scattering has been worked out by Groves and comparisons have been made between predicted and observed signals for thick specimens observed in a STEM under conditions where phase contrast effects are unimportant. Independent measurements of the collection efficiencies of the two STEM detectors, calculations of the ratio σe/σi = R, where σe, σi are the total cross sections for elastic and inelastic scattering respectively, and a model of the unknown mass distribution are needed for these comparisons. In this paper an extension of this work will be described which allows the determination of the required efficiencies, R, and the unknown mass distribution from the data without additional measurements or models. Essential to the analysis is the fact that in a STEM two or more signal measurements can be made simultaneously at each image point.

Download Full-text

Direct Observation of Heat Exchanger Deposits by Cross Sectioning

Proceedings, annual meeting, Electron Microscopy Society of America ◽

10.1017/s0424820100061835 ◽

1967 ◽

Vol 25 ◽

pp. 364-365

Author(s):

R. W. Anderson ◽

D. L. Senecal

Keyword(s):

Electron Microscopy ◽

Transmission Electron Microscopy ◽

Heat Exchanger ◽

Direct Observation ◽

Cross Sections ◽

Preparation Method ◽

Specimen Preparation ◽

Flowing Water ◽

Transmission Electron ◽

Deposit Layer

A problem was presented to observe the packing densities of deposits of sub-micron corrosion product particles. The deposits were 5-100 mils thick and had formed on the inside surfaces of 3/8 inch diameter Zircaloy-2 heat exchanger tubes. The particles were iron oxides deposited from flowing water and consequently were only weakly bonded. Particular care was required during handling to preserve the original formations of the deposits. The specimen preparation method described below allowed direct observation of cross sections of the deposit layers by transmission electron microscopy.The specimens were short sections of the tubes (about 3 inches long) that were carefully cut from the systems. The insides of the tube sections were first coated with a thin layer of a fluid epoxy resin by dipping. This coating served to impregnate the deposit layer as well as to protect the layer if subsequent handling were required.

Download Full-text

An Analysis of Dissociation of Molecules in a High Resolution Electron Microscope

Proceedings, annual meeting, Electron Microscopy Society of America ◽

10.1017/s0424820100072873 ◽

1973 ◽

Vol 31 ◽

pp. 486-487

Author(s):

Mihir Parikh

Keyword(s):

Electron Microscope ◽

High Resolution ◽

Cross Sections ◽

Resolving Power ◽

Peak Intensity ◽

Molecular Film ◽

Resolution Electron ◽

Dissociation Cross Section ◽

High Resolution Electron Microscope ◽

The Stability

It is well known that the resolution of bio-molecules in a high resolution electron microscope depends not just on the physical resolving power of the instrument, but also on the stability of these molecules under the electron beam. Experimentally, the damage to the bio-molecules is commo ly monitored by the decrease in the intensity of the diffraction pattern, or more quantitatively by the decrease in the peaks of an energy loss spectrum. In the latter case the exposure, EC, to decrease the peak intensity from IO to I’O can be related to the molecular dissociation cross-section, σD, by EC = ℓn(IO /I’O) /ℓD. Qu ntitative data on damage cross-sections are just being reported, However, the microscopist needs to know the explicit dependence of damage on: (1) the molecular properties, (2) the density and characteristics of the molecular film and that of the support film, if any, (3) the temperature of the molecular film and (4) certain characteristics of the electron microscope used

Download Full-text

Surface ultrastructure of danazol treated rat endometrium: A SEM study

Proceedings, annual meeting, Electron Microscopy Society of America ◽

10.1017/s042482010007641x ◽

1983 ◽

Vol 41 ◽

pp. 556-557

Author(s):

R.P. Apkarian ◽

J.S. Sanfilippo

Keyword(s):

Cross Sections ◽

Reproductive Tract ◽

Preliminary Investigation ◽

Breast Disease ◽

Distal Segment ◽

Uterine Horn ◽

Female Reproductive Tract ◽

Ultrastructural Changes ◽

Cycle Phase ◽

Sprague Dawley

The synthetic androgen danazol, is an isoxazol derivative of ethisterone. It is utilized in the treatment of endometriosis, fibrocystic breast disease, and has a potential use as a contraceptive. A study was designed to evaluate the ultrastructural changes associated with danazol therapy in a rat model. The preliminary investigation of the distal segment of the rat uterine horn was undertaken as part of a larger study intended to elucidate the effects of danazol on the female reproductive tract.Cross-sections (2-3 mm in length) of the distal segment of the uterine horn from sixteen Sprague-Dawley rats were prepared for SEM. Ten rats in estrus served as controls and six danazol treated rats were noted to have alterations of the estrus cycle i.e. a lag in cycle phase or noncycling patterns. Specimens were fixed in 3% glutaraldehyde in 0.05M phosphate buffer containing CaCl2 at pH 7.0-7.4 and chilled to 4°C. After a brief wash in distilled water, specimens were passed through a graded series of ethanol, critical point dryed in CO2 from absolute ethanol, and coated with 6nm Au. Observations were made with an IS1-40 SEM operated at 15kV.

Download Full-text