Isolation enhancement effect on the measured channel capacity of a printed MIMO antenna system

2014 ◽  
Author(s):  
Muhammad U. Khan ◽  
Wajih A. Abu Al-Saud ◽  
Mohammad S. Sharawi
Keyword(s):  
Channel Capacity ◽  
Antenna System ◽  
Enhancement Effect ◽  
Mimo Antenna

scholarly journals Modified MIMO Cube for Enhanced Channel Capacity

2012 ◽  
Vol 2012 ◽  
pp. 1-10
Author(s):  
Lajos Nagy
Keyword(s):  
Frequency Dependence ◽  
Channel Capacity ◽  
Indoor Environment ◽  
Antenna System ◽  
Mimo Antenna ◽  
Simulation Results

This paper deals with the optimization of MIMO antenna elements' position in modified MIMO cube for getting maximal channel capacity in indoor environment. The dependence of the channel capacity on the antenna orientation was analyzed by simulations. We have also examined the effect of the frequency dependence of the antenna system (in case of conjugate matching and nonconjugate matching) for the channel capacity. Based on the simulation results in the created and measured antenna system, the antennas were at a right angle to each other. At the two chosen different structures, we measured the antenna parameters and the channel capacity. In this paper, we present the results of the measurements which clearly confirm our simulations. We will point out the differences between the two antenna structures.

scholarly journals Full-Azimuth Beam Steering MIMO Antenna Arranged in a Daisy Chain Array Structure

Micromachines ◽  
2020 ◽  
Vol 11 (9) ◽  
pp. 871
Author(s):  
Kazuhiro Honda ◽  
Taiki Fukushima ◽  
Koichi Ogawa
Keyword(s):  
Channel Capacity ◽  
Transmission Rate ◽  
Beam Steering ◽  
Multiple Input Multiple Output ◽  
Antenna System ◽  
Noise Power ◽  
Mimo Antenna ◽  
Input Multiple Output ◽  
Array Structure ◽  
Incident Waves

This paper presents a multiple-input, multiple-output (MIMO) antenna system with the ability to perform full-azimuth beam steering, and with the aim of realizing greater than 20 Gbps vehicular communications. The MIMO antenna described in this paper comprises 64 elements arranged in a daisy chain array structure, where 32 subarrays are formed by pairing elements in each subarray; the antenna yields 32 independent subchannels for MIMO transmission, and covers all communication targets regardless of their position relative to the array. Analytical results reveal that the proposed antenna system can provide a channel capacity of more than 200 bits/s/Hz at a signal-to-noise power ratio (SNR) of 30 dB over the whole azimuth, which is equivalent to 20 Gbps for a bandwidth of 100 MHz. This remarkably high channel capacity is shown to be due to two significant factors; the improved directivity created by the optimum in-phase excitation and the low correlation between the subarrays due to the orthogonal alignment of the array with respect to the incident waves. Over-the-air (OTA) experiments confirm the increase in channel capacity; the proposed antenna can maintain a constant transmission rate over all azimuth angles.

scholarly journals Design of a Compact Dual-Band MIMO Antenna System with High-Diversity Gain Performance in Both Frequency Bands

Micromachines ◽  
2021 ◽  
Vol 12 (4) ◽  
pp. 383
Author(s):  
Wazie M. Abdulkawi ◽  
Waqar Ahmad Malik ◽  
Sajjad Ur Rehman ◽  
Abdul Aziz ◽  
Abdel Fattah A. Sheta ◽  
...  
Keyword(s):  
Channel Capacity ◽  
Frequency Band ◽  
Wide Band ◽  
Antenna System ◽  
Dual Band ◽  
Frequency Bands ◽  
Mimo Antenna ◽  
Capacity Loss ◽  
Lower Frequency Band ◽  
Code Division Multiple

A compact four-element dual-band multiple-input and multiple-output (MIMO) antenna system is proposed to achieve high isolation and low channel capacity loss. The MIMO antenna was designed and optimized to cover the dual-frequency bands; the first frequency band is a wide band, and it covers the frequency range of 1550–2650 MHz, while the other frequency band covers the 3350–3650 MHz range. The measured wide-band impedance bandwidths of 1.1 GHz and 300 MHz were achieved in the lower and upper frequency bands, respectively. The proposed structure consists of four novel antenna elements, along with a plus-sign-shaped ground structure on an FR4 substrate. The overall electrical size of the whole dual-band MIMO antenna system is 0.3λ(W) × 0.3λ(L) × 0.008λ(H) for the lower frequency band. It achieved greater than 10 and 19 dB isolation in the lower and upper frequency bands, respectively. The antenna system accomplished an envelope correlation coefficient of |ρ|≤0.08 in the lower frequency band, while it achieved |ρ|≤0.02 in the higher frequency band. The computed channel capacity loss remained less than almost 0.4 bits/s/Hz in both frequency bands. Therefore, it achieved good performance in both frequency bands, with the additional advantage of a compact size. The proposed MIMO antenna is suitable for compact handheld devices and smartphones used for GSM (Global System for Mobiles), UMTS (Universal Mobile Telecommunications Service), WCDMA (Wideband Code Division Multiple Access), LTE (Long Term Evolution), 5G sub-6 GHz, PCS (Personal Communications Service), and WLAN (wireless local area network) applications.

Efficient and optimized six- port MIMO antenna system for 5G smartphones

Frequenz ◽  
2021 ◽  
Vol 0 (0) ◽  
Author(s):  
Kumar D. Rajesh ◽  
Babu G. Venkat
Keyword(s):  
Antenna Array ◽  
Channel Capacity ◽  
Specific Absorption Rate ◽  
Ground Plane ◽  
Antenna System ◽  
Impedance Bandwidth ◽  
Mimo Antenna ◽  
High Isolation ◽  
Capacity Loss ◽  
Four Corners

Abstract In this paper, six-port MIMO antenna is presented for 5G mobile handsets. The proposed six-port antenna array is designed by making four L shaped monopole slots at four corners and two at the middle side edges of the ground plane which is printed on the backside of 0.8 mm thick FR4 substrate. High isolation (>−18 dB) between any pair of antenna elements is achieved without deploying dedicated isolation enhancing mechanisms. The antenna is working from 3.4–3.6 GHz (LTE Band 42) with 200 MHz bandwidth in the 2:1 VSWR (−10 dB impedance bandwidth). The proposed six-port MIMO antenna array is fabricated and measured. Significant radiation efficiency is obtained from 70 to 74 % in desired band of operation. Further, the MIMO parameters such as Envelope Correlation Co-efficient (ECC), Channel Capacity, Channel Capacity Loss (CLL) and Total Active Reflection Co-Efficient (TARC) are calculated. The robustness of the antenna is estimated by analyzing the user hand effects and Specific Absorption Rate (SAR). The measured results are well agreed with the simulated results.

scholarly journals PENGARUH PENYUSUNAN POLARISASI PADA SISTEM ANTENA MIMO TERHADAP KAPASITAS KANAL

2020 ◽  
Vol 5 (1) ◽  
pp. 13
Author(s):  
Abdurrahman Rizki ◽  
Alloysius Adya Pramudita ◽  
Trasma Yunita
Keyword(s):  
Circular Polarization ◽  
Channel Capacity ◽  
Mimo System ◽  
Signal To Noise Ratio ◽  
Multiple Input Multiple Output ◽  
Antenna System ◽  
Mimo Antenna ◽  
Left Hand ◽  
Multiple Input ◽  
Input Multiple Output

Multiple Input Multiple Output (MIMO) system is a technology that has the potential to be developed to increase channel capacity. The increase in channel capacity in the MIMO system is not only determined by the number of antennas, but is determined by the characteristics and arrangement of the antenna concept. This study identifies the effect of circular polarization on the MIMO antenna system on channel capacity. Co-polarization consists of a Left Hand Circular Polarization (LHCP) and Right Hand Circular Polarization (RHCP) configuration, while cross-polarization consists of an RHCP-LHCP configuration. The co-polarization of the antenna with the LHCP configuration results in an estimated channel capacity of 11,578 bps / Hz when it is at the lowest Signal to Noise Ratio (SNR) is 5 dB

Cuboidal quad-port UWB-MIMO antenna with WLAN rejection using spiral EBG structures

2021 ◽  
pp. 1-8
Author(s):  
Sumon Modak ◽  
Taimoor Khan
Keyword(s):  
Close Agreement ◽  
Ground Plane ◽  
Antenna System ◽  
Ultra Wideband ◽  
Electromagnetic Bandgap ◽  
Mimo Antenna ◽  
Simulated Performance ◽  
Notched Band ◽  
Multiple Input ◽  
Band Characteristic

Abstract This study presents a novel configuration of a cuboidal quad-port ultra-wideband multiple-input and multiple-output antenna with WLAN rejection characteristics. The designed antenna consists of four F-shaped elements backed by a partial ground plane. A 50 Ω microstrip line is used to feed the proposed structure. The geometry of the suggested antenna exhibits an overall size of 23 × 23 × 19 mm3, and the antenna produces an operational bandwidth of 7.6 GHz (3.1–10.7 GHz). The notched band characteristic at 5.4 GHz is accomplished by loading a pair of spiral electromagnetic bandgap structures over the ground plane. Besides this, other diversity features such as envelope correlation coefficient, and diversity gain are also evaluated. Furthermore, the proposed antenna system provides an isolation of −15 dB without using any decoupling structure. Therefore, to validate the reported design, a prototype is fabricated and characterized. The overall simulated performance is observed in very close agreement with it's measured counterpart.

scholarly journals A Graphene-Assembled Film Based MIMO Antenna Array with High Isolation for 5G Wireless Communication

2021 ◽  
Vol 11 (5) ◽  
pp. 2382
Author(s):  
Rongguo Song ◽  
Xiaoxiao Chen ◽  
Shaoqiu Jiang ◽  
Zelong Hu ◽  
Tianye Liu ◽  
...  
Keyword(s):  
Antenna Array ◽  
Antenna Arrays ◽  
Multiple Input Multiple Output ◽  
Frequency Selective Surface ◽  
Antenna System ◽  
Antenna Element ◽  
Mimo Antenna ◽  
High Isolation ◽  
Input Multiple Output ◽  
Alternative Material

With the development of 5G, Internet of Things, and smart home technologies, miniaturized and compact multi-antenna systems and multiple-input multiple-output (MIMO) antenna arrays have attracted increasing attention. Reducing the coupling between antenna elements is essential to improving the performance of such MIMO antenna system. In this work, we proposed a graphene-assembled, as an alternative material rather than metal, film-based MIMO antenna array with high isolation for 5G application. The isolation of the antenna element is improved by a graphene assembly film (GAF) frequency selective surface and isolation strip. It is shown that the GAF antenna element operated at 3.5 GHz has the realized gain of 2.87 dBi. The addition of the decoupling structure improves the isolation of the MIMO antenna array to more than 10 dB and corrects the antenna radiation pattern and operating frequency. The isolation between antenna elements with an interval of 0.4λ is above 25 dB. All experimental results show that the GAF antenna and decoupling structure are efficient devices for 5G mobile communication.

Sign in / Sign up

Export Citation Format

Share Document